Lexus RX 2004-09 :: 2008 - Brake Failure / Faulty Booster Unit
We recently purchased a 2008 RX350 with 61,000 miles. We had a potentially dangerous brake failure when the brake booster unit failed. It was an expensive repair ($1400.) and Lexus has refused to stand behind the product.
View 3 RepliesToyota - Highlander :: 2007 - Power Brake Booster Broken?
The power brake booster on our 2007 Toyota Highlander is broken and needs to be replaced. We asked our mechanic whether there are any brake-related recalls for our Make/Model/Year, and he said 'no'. Is this just our particular bad luck, or have others experienced similar problems with this SUV? It was scary. My husband was driving on the highway and needed to make a sudden stop due to a traffic slowdown. The brakes didn't respond, and he needed to slam down the brakes several times to get the brakes to work. No warning, the brakes just suddenlt stopped working.
View 8 RepliesLexus GX 2004-09 :: Brake Booster And Accumulator Replacement Required
The wife's 2003 GX470 has some brake issues. High pitched whine and ABS and Brake lights went on, so I took it to my local lexus dealer which is 50 miles away. Anyway, the recommendation is to replace "brake booster" and "accumulator" with brake system bleed.
Then, says "may need master cylinder after that, will not know until that is completed
Then goes on to need timing belt, water pump due to miles (97K)
CV boots
Driveline service
[URL]..................
Ford Excursion :: 2001 - Front Brake Sticking - No Power Assist - A/C Stays On Defrost - Brake Booster?
I have a 2001 ex. 4x4 6.8 v10. I have been having vacuum issues and brake issues lately. My front brakes seem to be sticking, some times they drag some times the don't squeeze when I step on the brake causing uneven wear and pulling when I stop. Also feels like I have no power assist. I also have a vacuum issue with the auto setting on the hubs, they don't engage I have to manually lock them and sometimes my a/c stays on defrost. And my cruise control doesn't work, the light comes on and love done the self check but it doesn't show anything is wrong. Could I have a bad brake booster?
View 5 RepliesFord F-150 - 1997-2003 :: Brake Booster Going Bad?
My 97 F-150 (4.6 L) has developed what sounds like a vacuum leak under the driver's side dash somewhere above the pedals. I can't see anything obvious. It changes sound with various positions of the brake pedal, and I can make it stop with hard acceleration for a few seconds. The brake pedal feels the same. I'm assuming the problem is probably my brake booster, right? Or should I be looking elsewhere? If so, how hard is it to replace?
View 3 RepliesVolvo :: 1993 - Loss Of Brake Booster And Brake Lights On 940 Wagon
My wife was driving my 93 Volvo 940 wagon yesterday, and the brakes suddenly lost power, and brake lights went out. I have heard no hissing from the booster, and I have checked the 10 amp fuse on the relay beneath the instrument panel. Hoping (and praying) it is just one of the relays. I have a meter, but not sure which pins to use to check the relays. Secondary issue: the used radiator I bought did not have the cooling fan sensor, so I have my fan on a toggle inside.
When my wife pulled over because of the brakes, she did not turn the fan on. Yup. Overheated. Now the radiator leaks from the rubber/plastic plug where the sensor goes. Any pliable sealants that could withstand the temps? Cash is in very short supply right now. That is my main issue right now, trying to drive with no brake lights. No ABS light, and no brake light coming on on the dash. Bulbs are good. ABS light does not come on at all with ignition, but bulb tests good. Just hard brakes, and no brake lights.
Ford - Explorer :: Front Brake Pad Clips Keeps Rusting Or Preventing Retraction?
Have a continuing problem with the front brake pad antirattle clips? Mine keep bending or rusting and prevent the pats from retracting. I live in a high salt area but still I shouldn't have all the problems I do.
View 1 RepliesFord 6.7L Power Stroke Diesel :: 2011 F250 - Vacuum Brake Booster Failures
Brake booster failures on 2011 and newer F-250's? I purchased a 2011 last august and the mechanic at the dealer I purchased the truck from stated that he had replaced the vacuum pump, vacuum brake booster and brake master cylinder on the truck just before I bought it as they were bad. Since then I have had two factory Ford vacuum Boosters fail on me. That makes at least three new factory Ford booster assemblies in this truck within the last year. What could be causing the problem? The truck is out of warranty and I am at a loss as to what could be causing them problem. Too much vacuum? Luckily the last two boosters have failed while sitting in a drive through and at a stop light, otherwise I may have had trouble stopping.
View 3 RepliesFord Super Duty (1999-2016) :: 2008 350 - Rusting Over Wheel Wells
I am sick that my 2008 F250 with 107K miles is exhibiting signs of rust this spring.. While filling up the tank saw a bit of a bubble on the left side top of the wheel well. Another one on the passenger side. I've had the truck since new and have tried to keep it as clean as I can being that it is a daily driver in the rust belt. Certainly thought that I'd get more than 6 years before the rot showed up. Don't remember my 1999 F350 exhibiting that, but it was a dually and had the fiberglass fenders that might have hidden it.
Took it to the local body shop and he told me to get used to it, just a matter of time around here. He said he could work on it, but it would never be fixed, rust would eventually return. He suggested sand blasting myself, repairing as I could, oiling the inside behind the tail lights and bolting on some Bushwacker flares. Having driven Ford trucks all my 40 years of driving I'm going to be looking at Dodges next time I buy.
Drivers side ...
Passenger side ...
Passat (B5) :: How To Take Off Booster From Brake Pedal
I'm taking out the brake booster and i need to know how to take off the booster from the brake pedal...
View 2 RepliesFord F-150 - 1997-2003 :: 2000 - Replaced Booster / Master Cylinder / All Calipers Still Spongy Brake Pedal?
I have replaced booster, master cylinder, all four callipers, and bled the brake system a number of times on my 2000 F-150 4x4. and still the pedal is wicked spongy, is there some other problem?
View 6 RepliesFord Super Duty (1999-2016) :: 2001 - No Brakes After Replacement Of Brake Booster And Master Cylinder?
A few years ago I (for him) replaced all 4 calipers, rotors, pads, etc....things were good. Just recently he replaced his Brake Booster and Master Cylinder (not sure what led to this), but long story short everything is back together and he doesn't have brakes.
My GUESS is that the system needs a good flush, new fluid, etc....
My problem is I'm unsure how to bleed the ABS system. A few google searched indicate I need a scan tool, but is there another way? Can I jump something.
So my question, how do I completely bleed the brake system on this truck?
S-10 :: Brake Booster Hooks Up To Create A Vacuum?
After replacing the engine, clutch and pressure plate. Where the brake booster hooks up to create a vacuum, as I now have a very hard to push brake pedal, if indeed that is my problem. The pedal will not go down more than one half inch.
View 5 RepliesGolf IV / Jetta IV :: How To Remove Brake Booster
How do you remove the brake booster rod from the brake pedal? The damn rod won't separate from that plastic housing. I've tried wedging a flathead in there but it's hard to see. I've been fighting with it all evening and finally gave up before I end up breaking it.
Found a DIY that just cut the rod to pull the brake pedal to remove it. I rather not do that as I will be reusing the one I have.
Ford F-150 (2009-2014) :: Low Brake Fluid Dash Lamp Illuminated / Blown Master Cylinder Booster Assembly
Just wanted to report another F150 with the blown master cylinder problem and had a few questions regarding the issue. Its a 2014 Screw EcoBoost with about 12500 miles located in Michigan.
I was driving last Friday (6/19) when the low brake fluid dash lamp illuminated. I made it to my final destination, when I began to back into a parking spot the brake pedal dropped to a position about an inch off the floor. Parked the truck and popped the hood to find almost all of the fluid gone. Only having fluid in the rear axle reservoir of the brake circuit. Pulled the vacuum sensor and the booster is filled with fluid..
Called Ford, had it towed to the dealer and its been sitting there ever since.... They have no loaners and have not even looked at it yet. I'm going to assume no parts are in stock just like all of the other threads I have read on here about this issue.
A few questions I have for those of you who have had this problem or have knowledge about it.
1. How long did it take for your truck to be repaired?
2. When the master cylinder seal leaks all of the fluid into the booster and the booster is pulling engine vacuum; does this mean that brake fluid is then pulled into the crankcase of the engine?
Really looking to get my truck back soon cause I love driving it! But the '74 F250 will have to do for now ....
Volvo :: 1999 - Brake Booster Appears To Be Leaking
I have a 1995 960 station wagon and a brake booster that appears to be leaking. On the passenger side of the firewall. As close as I can tell the leak seems to be right where the gaitor (rubber covering a rod) is.
1995 960 Wagon
Prius (2010-12) :: New Booster Pump Put On, Brake Fade Again
i have a 2010 Prius II that had a recall in 2013 on the brake boosted. I had a new booster pump put on and now three years later it has brake fade again. I am told from the dealer that it will cost 1800 to repair. So how long does a recall last.
View 4 RepliesSonata I45 (YF - 2011+) :: Brake Booster Making Noise
My brake booster is making noise for a few months now. It works ok and brakes are strong but the noise is there. Any way to quiet it down? Or how much the replacement might cost?
View 1 RepliesChevrolet - S-10 :: 1996 - Brake Booster Vacuum Leak
Brake pedal whistles and is hard to push. Only happens intermittently. Mechanic wants to put new brake booster on. This would be 3rd brake booster in 9mos. It's gotta be something else. What does the vacuum hose connect to from the check valve; where on the intake manifold? If no PVC valve...then what else? Truck runs fine...no fast idle or rough idle and no hesitation.
View 4 Replies