Ford F-150 - 1997-2003 :: Leaking From Where Engine And Transmission Meet
I have 1997 F150 4.6 .... Its leaking from where the engine and transmission mission meet??? And now it only goes in reverse and not forward to check lights. No nothing. And its a automatic trans. I try the torque converter....
View 2 RepliesFord F-150 - 1997-2003 :: 4.6L - Noise Coming From The Manifold Area
So I just installed a fresh 4.6 long-block in my '98 4x4 xlt and I have a noise coming from the manifold area. Thought it was possibly valves or timing chain. Took it to dealer and they diagnosed it as the Intake Manifold Runner Control. Never heard of it!!! Problem is, I can't find that part for this motor. Is it inside the intake? Do I have to replace the whole intake? Dealer didn't tell me, once I said I would do the work myself.
View 3 RepliesFord F-150 - 1997-2003 :: Noise Coming From Serpentine Area After Clutch Disengaged
Have a noise coming from the serpentine area. Sometimes it's a bit of a chirping, other times it's almost like a solid grind.
I pulled the belt off and the idler pulley had a bit of play so I replaced that. The tensioner pulley felt fine. I'm suspecting the fan clutch, as the noise only appears after the clutch has disengaged the fan (although it could be this is just masking the other noise because I've got a heavy duty / loud fan clutch setup).
How can I be sure that the fan clutch is the culprit before replacing it?
Ford F-150 - 1997-2003 :: Popping Noise Coming From Both Sides Around The Wheel Area
Got a 1999 ford f150 2 wheel drive. I have replaced both upper and lower control arms with ball joints on both sides. New shocks, new stablelizer links, new inner and outer tie rod ends. Also, a new steering gear and i still have popping noise coming from both sides around the wheel area when i enter or leave out of drive ways, turning, or running in a hole. Doesn't do in going straight. I don't know what else to do. Driving me insane. I keep spending money on this truck and still where i first started.
View 9 RepliesFord F-150 - 1997-2003 :: Intermittent Grinding / Dragging Noise Coming From Pulley
1997 4.6L.. Have an intermittent grinding / dragging noise coming from the pulley (?timing) area that I'm trying to pin down. Both the alternator and tensioner were replaced prior to the noise starting. The ac compressor and the power steering pump are original. The fan clutch was replaced about 4 years ago and the water pump 8 years ago. Timing chain / guides / tensioner are all original.
I don't notice any of the common ps pump indicators (whine increase when steering) but noticed the fluid level was down slightly and that the pulley seems to have some inward - outward play with the belt off. I also don't have any other engine symptoms like rough idle or any codes being triggered. How to isolate the culprit?
Ford F-150 - 1997-2003 :: Loud Grinding Noise When Braking Coming From Back Tires?
I have another issue. I just started having problems when braking. Every time I brake there is thing loud grinding noise that sounds like it coming from the back tires but there isn't a squeaking noise like there is where you need new brakes what else could this be??
View 2 RepliesFord Transmission :: Grinding Noise Coming From The Transmission
I swapped a t5 transmission from a s-10 into my 52 ford f3. I am trying to rundown a grinding noise coming from the transmission. I replaced the throw out bearing and the input shaft bearing on the transmission. With the transmission partially apart I couldn't find any obvious problems. The noise is only present when the clutch is depressed either in gear out out of gear.
Left in neutral there isn't any noise. I initially thought the throw out bearing was the culprit and replaced both that and the input shaft bearing. What could be wearing out? The transmission shifts perfectly but there is a binding noise when the clutch is released in first and sometimes second gear. another binding noise is present when making a hard left turn while starting out. I am at a loss here....
Golf V R32 :: Low Grinding Noise Coming From Area Of Serpentine Belt
So, when I was leaving work I started my car up and heard what sounds like a low grinding noise coming from the area where the serpentine belt is. Let the car idle and it remained.
Put the car in gear and drove off and the sound was still there. the sound gets louder as I increase my speed. It went away a couple of times when I was braking, then came back.
I stopped at the gas station and could still hear it. After getting gas, fired the car back up and heard nothing. When I drove off, the sound returned.
I got home and put it in park, leaving the car on, opened the hood and could still hear the noise. Pressed and held the gas a few times and the sound did get louder.
I am pretty sure it is coming from some rotating part, but no clue what part. What this could be?
recap:
-get noise on startup
-while driving noise gets louder
-sometimes it stops when braking
-sound coming from area of serpentine belt
Sonata NF (2006-10) :: Slight Grinding Noise Coming From AC Pulley Area
I have a very slight grinding noise coming from the PS pulley area. Its possibly bearing noise although its hard to say. Is there a specific torque requirement. Any good parts...
View 1 RepliesLexus ES 2013+ :: Motor Or Fan Type Noise Coming From Trunk Area While Parked In Garage
I have a 2014 ES300H that I just purchased. After driving around for a while I parked it in the garage. After it had been sitting in the garage for around 6 hours, I hear a motor or fan type noise coming from the trunk area. It lasted for several minutes and then stopped. Is that normal and what the noise might be.
View 2 RepliesCorolla / Matrix 2009-13 :: Knocking / Grinding Noise Coming From Water Pump Area
...... 2010 Corolla LE 1.8L ...... View the video I uploaded ....... The noise is seems to be getting worse. My first thought is the bearings in the water pump may have failed. I'm also thinking that there isn't adequate lubrication near the gear assembly or the belt. Could there be a problem with the tension in the belt?
View 7 RepliesSanta FE SM (2001-06) :: 2002 - Grinding Noise Coming From Upper Right Area Of Rear Hatch
My daughter asked me to look at & listen to a horrible grinding noise coming from the upper right area of her Santa Fe's rear hatch. There was a plastic grinding noise coming from THIS:
It's the lock actuator for the rear hatch.
Sometimes it works.
Sometimes it doesn't.
Sometimes it makes that horrible plastic grinding noise.
Ford 7.3L Power Stroke (1999-2003) :: Whining Sound Coming From Transmission Area
So I've been getting a whining sound coming from the transmission area. I checked my transmission fluid and it's nice and pink so I checked my transfer case fluid… It came out like black watery gear oil! How bad is this? I am putting synthetic Dex/Merc back in it. It's got me a tiny bit concerned.
View 9 RepliesFord Super Duty (1999-2016) :: Strange Pop Noise Coming From The Transmission Area
I've got a 2016 250 6.2l and am getting a popping sound coming from the transmission area. the following is what i have figured out so far. the noise is made just before a complete stop, just as the tranny down shifts to 1st and can be felt through the manual floor shifter 100% of the time and heard roughly 90% of the time. sound ranges from not audible to loud and is random in how loud it is. the only way it does not do this is if i come to a stop in neutral or i go slow enough as not to have the tranny shift out of first from my last stop. the only other way is if i do one of those long, slow rolling stops. truck only has 6600 miles on it. i will be taking it in at 7500 for first service and have them look at it ...
View 1 RepliesFord F-150 - 1997-2003 :: 1999 - Transmission Stuck In High Gear And Bogs The Motor Down
I have a 99 F150 4x4 with the 4.6 Motor approx 150000miles. Transmission went out so I decided to try and replace it...
New/rebuilt tranny went in with no problem but something is not right. It will drive but seems like it is stuck in high gear and bogs the motor down. It is giving me error codes P1747, P0750, P0755, P0743, P0102. All the wiring harness is in good shape with no burns or other noticeable problems. Somehow the transmission isn't reading right?
When I bought this rebuilt transmission I was told it was set up for 2wd but he would convert it for 4wd. The only difference i noticed with the new tranny is the shaft coming out of the tranny, where the safety neutral switch is, has a diamond shape instead of the oval shape that connects the shifter cable. No big deal i think, just had to buy a new link for the shifter cable with the diamond.
Also on the passenger side of the tranny there is a nine pin plug. My wire harness from the truck has one pin hole that is opposite of the tranny. Not sure why. Do I need a new harness or wrong tranny?
Ford F-150 - 1997-2003 :: Air Noise Around The Doors Which Is Up In The Window Area
2000 f150 supercab 4x4 offroad. Sometimes in a very strong wind, I get a lot of air noise around the doors which is up in the window area. I occasionally get it if I haven't got the back half door shut tight.
Just wondering if there is a way to puff up those door seals without replacing them? Inject them with something or use a hair dryer to heat them?
Ford F-150 - 1997-2003 :: Chirping Noise From Driveshaft Area
I have a 99 F150 4x4 4.6L automatic trans. The truck has 260,000 miles on it. Saturday, while going down the interstate, this chirping noise started up from the rear. When I got home I jacked the rear up and spun the wheels while listening. There is a chirping noise that, as best as I can tell is coming from around the front of the driveshaft around the u-joint area. I've never known of a u-joint to make this type of noise before. There is no vibration or anything, just the noise. The frequency of the noise increases and decreases as I speed up and slow down. I don't think it's coming from the transmission, but it's hard to tell, as everything echoes. I couldn't imaging the driveshaft itself making this noise, but I guess it's possible.
View 12 RepliesFord F-150 - 1997-2003 :: Howl Going On - Noise From Transfer Case Area
I've got sort of a howl going on, was thinking rear end, but when i jacked up the wheels and spun the driveshaft the noise seemed to come from the transfer case area. I haven't had a chance to check the fluid yet, could it be a bearing in the t-case? Its only when i'm on the gas if i let off its gone. 2001 f150 super crew 4x4
View 4 RepliesFord F-150 - 1997-2003 :: 2000 - Loud Noise From Dash Area?
2000, F-150, 35K +original miles. 4.6L V8
Some weeks ago a noise started that sounded like fan blades striking against heavy plastic fan guard. At first I thought it was coming from the transmission/Transfer case area but after a few weeks of listening to I now believe it's coming from behind the dash area, however, I can't find any reason for it be from there.
The noise usually starts around 45 MPH
I checked the heater fan and it appears to be Okay. I don't know of any other fans in that area.