Ford Escape / Hybrid :: 2013 SE - Squeak From Front Passenger Side
Have had the '13 SE 2.0 for a week. Wife said there was a squeak ?? I drove it today. Seems to be from front passenger side..
View 14 RepliesFord F-150 - 1997-2003 :: Front Driver Side Wheel Bearing Blow While Doing About 70 MPH
I had my front driver side wheel bearing blow on me, out of nowhere, while doing about 70mph on my '03 Supercrew 2wd. it really destroyed my spindle and rotor. i replaced everything from the spindle out (rotor,pad,caliper,caliper mounts, bearings,etc). I packed the bearing really good and put it all back together. Well, it happened again, same thing. Doing about 70 and it just blew out of nowhere. Why it could be happening??
View 14 RepliesFord F-150 - 1997-2003 :: Replacing Passenger Side Front Oxygen Sensor?
At least this is how I did it after a P0133 code.
The back ground on my truck (see sig) is that I am the second owner (my former neighbor was the first) and it has 293K miles on it at the time of this post. The truck is bone stock FWIW.
I searched the internet and couldn't find a good step by step replacement write up. The front oxygen sensor on the passenger side is hard to get to so here is what I did:
Jacked the truck up and placed jack stands under it. Removed the front passenger tire and the plastic wheel well liner.
Tools needed for this part are a 7/32 socket and a trim tool remover (for the plastic push in fittings).
There are 5 screws and 3 or 4 plastic push retainers (don't know actual term) to remove.
Because of the location of the sensor I had to remove the transmission dipstick tube. *If you do this have a pan or bucket under this area as you are going to lose fluid* the dipstick tube is held place by an 8mm bolt about the middle of the exhaust manifold. Unscrew it and with a little pressure the tube will pop up and out, and so will some fluid.
Wheel well liner out and dipstick tube pulled out of the way.
The connector where you will disconnect the old 02 sensor is tucked up behind the engine block and is kind of hard to get to. A little time and patience and you can get it separated.
From underneath the truck I cut the end off of the old 02 sensor (because the closed end of the wrench wouldn't fit over it) and used a 7/8 box wrench to unloosen the sensor a little at a time until I could get it out with my fingers.
I put the new 02 sensor in finger tight and then tightened it down with small turns of the 7/8 wrench until tight
The cord on the new sensor is longer than the factory one so once reconnected I used zip ties to keep the slack up and away from the hot parts.
New 02 sensor installed and dip stick tube back in place. Note the attachment approx 1/2 down the dipstick tube. It is the 8mm bolt I previously mentioned.
Wheel well back in place. Truck lowered back to the ground.
Ford F-150 - 1997-2003 :: 2002 - Oil Leak Coming From The Passenger Side Front
My '02 F150 just developed an oil leak. It appears to be coming from the passenger side front. I'm just assuming here, but could it more than likely be the timing cover? I'm 150 miles from home and I'm debating on getting the timing cover gasket on my way home tomorrow. Also, if it is the timing cover, what other gaskets should I replace? Pretty sure the water pump oring.
View 1 RepliesFord F-150 - 1997-2003 :: Water Leak Somewhere On The Front Of Motor On Passenger Side
I have a f150 with a 5.4L with 354,000 miles on it. It started leaking water somewhere on the front of the motor on the passenger side. it looks like it is under where the heater hose connects to the intake. I guess my question is can the water eat a hole in the intake?
View 1 RepliesFord F-150 - 1997-2003 :: Coolant Bubbling Out Of Front Passenger Side Of Intake
Two weeks ago I was driving home from work and my heat stopped working. I pulled over and saw coolant dripping badly out of the bottom of my truck. I popped the hood and sure enough, coolant was bubbling out of the front passenger side of the intake. I took it to a shop to do the work (quoted at 500-550 out the door with a dorman intake). A week goes by and I get a call from the shop, "After two Dorman Intakes, the truck is not running right", what it could be.
The truck has 367k on it (not sure if original motor). Yesterday I get a call from the owner, " we put the original intake back on and fixed the leak with jb weld. The truck still runs bad. They claim they didnt do anything wrong and will not take any blame for ruining my engine. (Keep in mind the truck ran PERFECT when I took it in there). The truck doesnt throw any codes and they are at a loss of what could have happened. They put in 8 new plugs and 2 coils that they broke while in the process of removing the intake. F150 5.4 ...
Ford F-150 - 1997-2003 :: Strange Noise Coming From Front Passenger Side Of Truck
Have a 1998 F-150....heard a strange noise coming from the front passenger side of the truck. Parked and turned the wheel and heard something fall off. It appears to be a shield of some sort.
View 2 RepliesFord Excursion :: 2000 - Squeak From Driver Side Front Wheel Area When Turning Right
Started hearing a squeak from drivers front wheel area when turning right, thought maybe pads might need replacing but they were fine as were the pins. So I checked for play with tire off ground and there was def some play pulling from top to bottom, so that lead me to the front hub, I read some posts about pulling the abs sensor and getting some grease in the the hub bearing so I did that but when I replaced the sensor and spun the hub it was scrubbing on the bearing.?
So I shimmed the sensor with a washer but now the abs light comes on but there doesn't seem to be a squeak when turning right anymore. Any example of doing this and had the sensor scrub? And with the play I would assume I need to plan to replace the hub assembly fairly soon...
2000 X 4x4 V10 with 147k
Ford F-150 - 1997-2003 :: 2002 - Coolant Leak On Driver Side Front Right Near The Thermostat Housing
I'm trying to figure where the coolant leak is. Appears to originate on the driver's side front, right near the thermostat housing. Since the engine tilts back the entire drivers side is wet. The thermostat gasket appears to be OK, but it does have a lot of miles on it.
If it's not the thermostat then can coolant leak from the cross over tube. And is the cross over removable without taking off the intake. There appears to be a bolt coming up from underneath on the passenger side.
Also, does coolant flow through this plastic intake. If it does, then the leak could be some where else, if not, then it's probably the thermostat.
Ford F-150 - 1997-2003 :: Crunching Sounds From Front Passenger Side - Wheel Turns Hard
Had crunching sounds from front passenger side. Replaced CVJ shaft and hub bearing/assembly noise gone but tire turns hard by hand drivers side turns freely. Looked on line and guy had same thing going on said maybe 4x4 vacuum actuator might be bad and truck stuck in four wheel .does this sound right? I have manual trans and gear box so I don't understand why the actuator is even there.
View 4 RepliesFord F-150 - 1997-2003 :: Leaking Antifreeze Externally At The Front Of Passenger Side Head Gasket?
Working on a 2000 F150 with the 5.4 and as near as I can determine its leaking antifreeze externally at the front of the passenger side head gasket. Seems a little odd. The coolant is a nasty dirty orange color. With the truck running on the hoist it was dripping very steady off of the very front exhaust manifold bolt.
View 3 RepliesFord F-150 - 1997-2003 :: 2000 XLT - Clunk / Squeak In Steering Wheel
I have a 2000 Ford F150 XLT 4X2 that has a "clunking/squeaking" noise in the steering wheel, intermittent happens driving straight down the road, hitting bumps, breaking. It is very annoying! changed out lower ball joints tightened wheel bearings, greased idler/pitman arm thinking that was the problem and it became worse. Had someone look at it and stated that the steering shaft was welded?!?! Why would the steering shaft be welded what am I looking at in replacing it (cost for parts and labor time) and are there any other additional parts that will have to be replaced as well?
View 1 RepliesFord Super Duty (1999-2016) :: 2009 F350 - Mild Squeak From Front Driver Side Hub
09 F350 with 50,000 miles, just starting to hear a mild squeak from front drivers side hub I believe. Can hear it while in 4 wheel drive, my thoughts is that the original universal in the hub is beginning to give up. My question is how long would you think I have before I need to get this done? Would this be a warranty item? I am not sure anymore.
View 2 RepliesFord F-150 - 1997-2003 :: Vibration Felt In Steering Wheel / Humming Sound Coming From Driver Side Front
I have a 2003 F150 manual 4WD with 4.6L engine and 165000 miles. When i am driving i feel a vibration in the steering wheel and on floor board that intensifies when i press the accelerator. I do hear an irregular humming that sounds like it is coming from the driver side front. I checked the wheel for any play but it was very tight. i check tie rod ends, ball joints no play. i recently changed both u-joints on the rear shaft and the bearing hub on the passenger side front. Also, the steering feels a little 'wobbly' when i make sharp turns. it almost feels like it is giving. What else should i check?
View 1 RepliesFord F-150 - 1997-2003 :: Noisy Serpentine Belt - Crank Pulley Squeak?
Been trying to isolate my noisy serpentine belt. Had the belt off and spun everything, only thing I found that made any noise was the alternator. It had a nice churp like a bearing was on its way out in it. So I replaced that figuring my squeak was going to go away. No such luck. Listening to it again while it was idling, I crawled underneath. Almost seems like the churping noise is coming from the Crank Pulley. Is there a bearing on this pulley that goes bad?
View 13 RepliesFord F-150 - 1997-2003 :: Vibration And Thudding In Rear End When Braking / Low Speed Squeak
I recently bought a 2003 F150 sport Scab 4x4 with 75k miles from a Ford dealer with a 4.6l auto. we didn't notice it when we test drove it but it has a squeak when going 0-10 mph in forward or reverse. The story goes a week after getting it home we started noticing a vibration and thudding in the rear end when braking so I take it back to the dealer (50 mile trip 1 way) and when I get there the drivers side rear rim is 30 degrees hotter than the passengers so the tear it apart and find the e-brake was dragging so they lube it up and tell me its good to go. I made it around the building and now I feel it dragging iddling around the parking lot and it is still squeaking so I take it right back in.
Long story short after going through this 2 times that day and bringing it back another day they replaced rear pads, calipers, roters and the hoses going to the caliper and tell me its good to go. Well it no longer had the dragging feel and I had to drive through DC traffic so I beat feet for home and on the way noticed its still sqeaking. I call them and they tell me to put a thousand miles on it and maybe the pads just need to wear in (??). so I took a road trip and 1.2k miles later it still squeaks.
I have tried to tell them it may be the u joints (after searching on here I learned that I am taking it back tomorrow and going to try and get something done but they are still saying its something to do with the brakes and probably won't do the u-joints. Normally, they are filling up the gas tank every trip up there and its all been under warranty (gonna see about getting the warrenty extended tomorrow due to this problem has been ongoing since we got it). Should I just let them run their own course and keep making trips back and forth?
Ford 6.7L Power Stroke Diesel :: Squeak / Rattle Type Sound Coming From Front Driver Side Wheel
I'm having a squeak/rattle type sound coming from my front drivers side wheel (more rattle). It only happens when I go over a quick bump and happens going straight and while turning. 2012 f250. 87k miles. 4x4. I have a two inch block level (southern truck) up front..
View 14 RepliesCivic - Honda :: Slight Squeak From Front Driver Side Wheel
2008 Honda Civic LX. The car has approximately 37,000 miles on it, most of which are highway miles. I live about 400 miles from home and thus, most of those miles have been accumulated from the 4 years of me driving back and forth to school during breaks, etc.
Recently, I've noticed a slight squeak from the front driver's side wheel. It's rhythmic with the rotation of the car and is only audible with the window down (you can't hear it when the window is up). It's most prevalent at really slow speeds, when the car is just rolling forward and then dissipates as I accelerate.
I just had it in for service about two months ago, the usual stuff: I had the oil changed and the tires rotated at the local Honda dealership. I still have the inspection paperwork they did on it and everything checks out. The brakes were shown to be just fine (7mm on the front two) and it's also not coming from the engine itself, thus ruling out the belt, etc.
To make things even more complicated the noise comes and goes. Last night I drove around trying to isolate it but found no consistency. It started right away as I drove away from my apartment, but then randomly went away only to reappear again, this time barely audible as I parked.
Other details: I park the car outside, and I live up in Northern Minnesota. It's gotten cold recently, and with the wind we get up here the dust really gets kicked up. The noise just started appearing last weekend as well.
I've done some preliminary research, and would hope that after 37,000 miles the car's front bearing isn't going bad. My game plan for today was to get it washed, in case there's some build up on the wheel, and then try and spray it with 4D-40.
Golf IV R32 :: Driver Side Front Suspension Developed A Nasty Squeak
I'm a new Mk4 R32 owner in the Portland area and my driver's front suspension developed a nasty squeak on the long drive home after buying the car. When you hit a pothole or any sort of bump it makes a nasty "clink" sound under compression/rebound. It's only on the driver's side front, and it seems to be a bushing/bearing or upper mount in the car when I got it up on Matrix Integrated's lift.
Also - the driver's front spring is squeaking since the powder coating flaked off after all the miles.
Thinking of buying a cheap set of coil overs to remedy this and refresh some of the more worn suspension items. Car drives just fine too.