Cavalier :: 1998 - Low Beam Headlamps Do Not Work
I have a 98 Cavalier and my problems is that both of my low beams stopped working at the same time. My high beam and day light still work...
View 14 RepliesMazda :: 2006 - Low Beam Headlamps Burning Out
My 2006 Mazda5 has a problem with burning out low beam headlamps. Both sides, but at separate times. I've replaced 8 bulbs in the last 18 months of ownership. I had the wiring harnesses replaced 5 months ago to correct the issue and each side has burned out again. What else should I be looking for?
View 3 RepliesFord F-150 - 1997-2003 :: 2001 - Cruise Control Does Not Work
Ok replaced the front brakes, tie rod ends, and all ball joints today. Also flushed old brake fluid and replaced with new. Now my cruise control does not work. Light on the dash momentarily flashes when I try to set the speed. I have checked all the fuses and the connections and everything appears normal.
2001 Ford F150 5.4L 4x4 off road pkg stock height and tire size.
Ford F-150 - 1997-2003 :: 2001 - Keyless Entry Fobs To Work While The Truck Is Running
I have an 01 F150 SuperCrew with factory keyless entry fobs. I would like to be able to leave my truck running, take the keyless entry fob with me, and then lock the doors. Currently, the keyless entry fobs are disabled when the truck is running and I'd be locked out of the truck. I've had newer Fords that would allow the fobs to stay active with the vehicle running. Do this can be programmed into the truck?
View 5 RepliesFord F-150 - 1997-2003 :: 2001 - Cruise Control Passes Self Check But Doesn't Work
I am stymied by a weird Cruise Control problem on a 2001 F150 Lariat SuperCrew with 5.4L V8 engine that I just purchased. Long story short, the cruise control does not work. That is, when I push the "On" button at any time while the engine is running (even when traveling at highway speed), the dashboard CRUISE light does not come on.
I ran the cruise control "self check" procedure. The first time I ran it, we failed with 3 flashes. So I checked the cutout switch on the brake master cylinder, and it was indeed leaking brake fluid. So I purchased a new switch and cable (Motorcraft SW-6350 Speed Sensor Switch Repair Kit) and installed them.
With the new cutout switch, we seem to pass the self test. That is, after pressing all the buttons in order , I see all the quick flashes of the CRUISE light
(1. On (flash), 2. Resume (flash) 3. Coast (flash), 4. Set/ accel (flash)). Then the accelerator pedal is pulled away from my foot.
However, unfortunately, the cruise control still does not work. That is, when I push the "On' button at any time while the engine is running (even when traveling at highway speed), the dashboard CRUISE light does not come on. What to look at next? I note that horn works, in case that's useful info.
Subaru - Outback :: Low Beam Is Very Dim And High Beam Doesn't Work?
I replaced the low beam and high beam on my Subaru, now the low beam is very dim and the high beam doesn't work. Careful not to touch the bulb.
View 3 RepliesFord F-150 - 1997-2003 :: High Beam Headlights Won't Working?
I added plow lights to my truck and something quit when I had the high beams all on at once. All 4 shut off. Low beams still working. What I fried or where to check? Its a 99 F250 superduty.
View 14 RepliesFord F-150 - 1997-2003 :: 4x4 Does Not Work At All
I have a 2003 Ford F150 XLT 5.4 V8 with about 131,000 on it. The 4wd does not work at all. You move the electronic switch no light in the dash no click at the actuator motor no nothing. I took the switch on the dash off and from the dark blue wire I am getting 11.5 volts from there constant.
View 6 RepliesFord F-150 - 1997-2003 :: Wipers Do Not Work
I have a 2001 ford f150 4.2 five speed with a little over 250,000 miles. The wipers will not do anything. I have gotten a new motor and plugged it in before I installed it and checked it and still nothing. I have changed the switch on the column and they still did not work. I have tried checking with a multimeter and a probe light. I do not know what is wrong with them or where else to go. What to do or what to check next?
View 2 RepliesFord F-150 - 1997-2003 :: 2000 - 4x4 Will Not Work
My 2000 f150's 4x4 won't work, it has esotf, I have replaced everything I can think of, when I turn it to 4hi and 4 low i get nothing, no clicks no dash lights. I have replaced the gem, the switch, the relays, checked the fuses, i bench tested the motor it works, if i put 12v to the shift motor while on the t/c it engages to 4x4 (though I haven't driven it like that because I am not sure if its in 4hi 4 lo or in between the two) so that being said...
View 3 RepliesFord F-150 - 1997-2003 :: Horn Does Not Work - Fuse?
Is there a fuse or some thing? Can I rig it?
View 6 RepliesFord F-150 - 1997-2003 :: Ignition And Accessories Work With Key Out
99 F 250LD 240k miles. I think I know the answer but hope I'm wrong. Started noticing the blower fan staying on when left in the panel position, even with key out. This morning I walked by my truck and noticed the radio on. Opened the door and the door chime started beeping. Is this a case of a leaky windshield and water running down the a-pillar and getting the GEM wet? Hope not but I think that's it. I haven't seen any water leaks yet. Could it be a stuck ignition relay? I've never heard of a relay staying open. Could it be a corroded fuse panel. i also heard a clicking coming from the area of the PCM recently but it stopped.
View 7 RepliesFord F-150 - 1997-2003 :: 1998 - A/C Work Intermittently?
1998 F150 XLT 4x4 4.6L Auto.
Bought this truck two months ago, the lot had the engine rebuilt due to bad bearings, so fresh motor. They forgot to recharge the AC, so I had them charge it when I purchased it. It blew icy cold every things until a few weeks ago. It wouldn't work, then randomly it would, then it would quit, etc. Today it's 97 and I had it on with my kids in the truck, hot air.
I tried turning it off and on, still hot.
I tried seeing if the temperature was stuck and moved it to hot, it got sweltering hot, back to cold, just warm air. There is no difference between vent and max AC.
I went to the store, picked up a refrigerant filler with gauge and a can of R-134. I hooked it to the low end of the system and was surprised that my pressure was about 60PSI. Great, they over filled it at the dealership. I released the pressure down to 40psi and checked, sill hot. I figured maybe something was weird and they might have mixed good refrigerant with bad and that's why it was intermittent.
I released all the pressure down to 0 PSI. I then put on the can of R-134 and filled it to spec. Sill hot air. I removed the harness from the pressure switch and jumped it, getting sparks when I connect the wire, so it's connecting, but still hot air, probably not the switch.
What's going on here? Could they have over filled it and killed the system or something? What is likely broken here? My heater works like a champ, my AC just blows environment temperature air.
Ford F-150 - 1997-2003 :: No Heat And Fan Only Work On High?
I just got the F150 ext cab 5.4 auto 235000 miles, and there is no heat and the fan only work on high. I am also changing all the coils plug and injectors. The guy I got the truck from said he never chanted them. I know it is going to be fun , soak the plugs and be careful. Any thing else I should know or do???
View 5 RepliesFord F-150 (2004-2008) :: One Headlight Dim / High Beam Will Not Work
Why I have one headlight gone dim, high beam will not work. This just happened about a week ago and I changed the bulb and it's still the same.
View 9 RepliesFord F-150 - 1997-2003 :: Blinkers Not Working But Flashers Work?
Got a 2003 F150 4.6 2wd and recently the blinkers dont work. Also some how the 4wd light came on even though the truck is a 2wd. After searching it seems alto of people recommend replacing the Multi Function Switch. The truck is plain jane no tilt wheel.
Is this the MFS everyone is talking about?
Duralast/Windshield Wiper Switch (SW1977) | 2003 Ford F150 1/2 ton P/U 2WD 8 Cylinders W 4.6L EFI |
Ford F-150 - 1997-2003 :: Brakes Do Not Work If Running Lights Are On
Trailer light dont work right. If the running lights are on the brakes dont work. If the running lights are off the brake lights work fine. I cant drive at night this is a huge issue for an up and coming transporter. Its not the trailer lights ive eliminated that with my plug checker. Is it the rely? Blown fuse? Or common ford electrical mess up?
View 2 RepliesFord F-150 - 1997-2003 :: 1998 - Dome Lights Will Not Work?
My brother has this truck. Bought it new. Its crowding 200,0000 miles, hes retired and doesn't want a new truck. Problem is this. I have been thru all i know about this subject..........which is not my arena. When you open the door, the dome lights won't come on. Neither door [three door truck] front doors. It has no switch in the jamb............that I can find, that shuts these lights off and on. Least that's the way they were shut off and on; for many years. I looked at the fuse panel schematics in his owners manual. Doesn't show any fuse for these lights, one relay, is there but that's on a different schematic. I am lost everything else ,on that circuit. Push buttons...... on the light...... its self, works. It just doesn't turn those darn interior lights on.
View 6 RepliesFord F-150 - 1997-2003 :: 2000 - Turn Signals Won't Work
I noticed yesterday morning that my turn signals were not working on my 2000 F150 4.6L 4X4 XL truck and I need diagnosing what the cause is. The hazards, windshield wipers and my brights still work so I was not sure if it was just the switch. I have done the following:
* I went and got a new turn signal flasher at the parts store last night but when I went to put it in under the fuse box under the hood it was to big to fit into the holes. By this time the dealer was closed and I couldnt go and get a new one from them. (I wasn't sure if both needed to be replaced at the same time).
* Since there are two under the hood i just swapped the positions and still nothing happened everything worked accept my turn signals still worked. (by swapping I mean I took the one that was in fuse location 301 and put that one into 304 and 304 into 301.)
* I went to my owners manual and checked every fuse to make sure that anything related to my turn signals and flashers etc were not blown and they werent.
That is were I am at. I don't think its the switch but is that a common thing to go out?