Ford F-150 - 1997-2003 :: 1998 - Rough Running Truck When Accelerating
I have a 1998 F150 4.6 2wd regular cab with 255,000 miles on it. Lately it has had some problems. The first is that it will run really rough when under a load, meaning when I step on the gas. It runs smooth at idle and at cruise but when I step on the accelerator it bogs way down and almost shuts off. I have changed the spark plugs, spark plug wires, coil packs and fuel filter. Now I'm thinking maybe fuel pump?
The other issue is that when the truck is having to work a little harder (i.e. pulling a trailer or running in the summer with the AC on) it will start to run hot. I have changed the thermostat, flushed the coolant, cleaned out the radiator, etc. and it still does it. Could both of my issues be related to a fuel problem??
Ford F-150 - 1997-2003 :: 1998 Truck Not Starting After Sitting Overnight?
I have a 98 F150. The motor was replaced three months ago and have had no problems until now. The truck had trouble starting so i put an alternator on it. Fixed for a while and then it started blowing fuel relay fuses. I replaced fuel pump and filter. Truck has trouble starting after sitting overnight. When I am driving and floor it, once it hits about 4,000 rpms, the truck bucks like its the transmission but the rpms drop and then pick back up. Fuel pressure is right where its supposed to be.
View 1 RepliesFord F-150 - 1997-2003 :: 1998 - Vacuum Line Hanging Under Truck?
I noticed a vacuum line hanging under my 98 F 150 4x4 I traced it out to my front axle question is where does the other end go I have looked but no luck to where it goes.
View 5 RepliesFord F-150 - 1997-2003 :: 1998 Truck Will Not Start Occasionally And Error Codes
I have been having odd problems with my truck for several weeks now and what the problem may be. Occasionally the truck will not start. This happens after it has been run for an errand or to church. The truck turns over but no ignition. Sometimes if I pump the gas pedal very quickly I can get it to start. Other times I have to sit and wait about 5 minutes. I have gotten the following two error codes - P1506=Cylinder Head Temp Sensor and P1299=Idle Air Control Overspeed Error. For two days the "check engine" light was on, but now it has gone out. I have searched for an answer to this problem on these boards and one possibility may be a vacuum leak. Is this the most likely? 1998 Triton 4.6 ....
View 3 RepliesFord F-150 - 1997-2003 :: 1998 Truck Not Starting / Not Getting Voltage At Fuel Pump
I have a 1998 Ford F150 with 4.2.. Started off a intermittent problem of not starting acct no fuel. Now will not start at all. Checked all fuses and relays.. Am not getting voltage at fuel pump. Changed ECM thinking that was the problem.. Have checked all multi wire connectors for corrosion and tightness. Am at a lost what to try next.
Also, not sure if its related or not. The turn signals and hazard flashers do not work. When I turn on the hazard flashers, nothing happens. If I leave the flashers switch on, the turn signal work. Checked all fuses and relays and they appear good.
Ford F-150 - 1997-2003 :: 1998 - Brake Shift Interlock - Truck Stuck In Park
having problem w/ 98 f-150. first truck stuck in park. figured out how to get around that (turn key 1 position, shift to neutral, start vehicle, then engage transmission). but no brake lights! I have turn signals, driving lights, hazards, etc in rear. I disconnected harness from brake light switch. there are 2 leads, 1 hot, 1 not. i jumped them and no brake lights. i tested the switch and it functions properly (it's reconnected now). i changed my bulbs in tail lights. I unplugged the solenoid (which is impossibly located behind/beside steering column). this allowed me to shift like an old truck (without having to brake first), but doesn't solve my lack of brake lights (i've reattached the solenoid harness to remind me of my problems).
i am putting my money on a broken wire somewhere between the brake light switch (b/c that was good) and the solenoid (i am not hearing that faint click when i step on brake). but a broken wire should work by accident some of the time (unless cut cleanly and completely). there is a green wire with red stripe leaving the brake light switch and 3 wires at the solenoid harness (1 green and maybe a smaller gauge than those at the switch and 2 others which i don't recall their colors). Ford service manager doesn't think it's the solenoid but wasn't otherwise useful except to say, "hey, why don't you bring it in to me." What to look for before i plunk down for someone to perform what I already have before completing the job!
can i splice a wire from something (? brake light switch?) to something (?wire in solenoid harness?) or does that "electronic signal" get processed somewhere else first?
Ford F-150 - 1997-2003 :: 1998 F250 - Service Engine Soon Light And Truck Will Not Start
I have a little more detail on when the truck starts and does not . I have gone out the past two days and put the key in the ignition and turn it to the on position and all the lights come on except Service Engine Soon light and truck will not start. I bought a ceramic electric heater and placed it on the floor directing the heat under the dash. after ten to fifteen minutes I go out and put the key in the ignition turn the key to the on position and the service engine soon light is on and the truck starts right up. I let it warm up for about a half hour and then shut it off. I then try to start it right back up and the service engine soon light comes on momentarily then goes off and the truck does not start?
View 5 RepliesFord F-150 - 1997-2003 :: 1998 - Coolant Reservoir Smells Like Gas And Truck Smokes Slightly
I have a 98 f150 2wd 4.6 the truck began showing signs that it needed a head gasket about 2k miles ago, my coolant reservoir smells like gas and the coolant is a rusty brown color the truck smokes slightly and the oil cap has chocolate moose like substance from the oil mixing with water. I dont care to keep the truck to much longer however i need it to last me to the end of year. I purchased some k-seal and new oil/coolant etc but after thinking about it all of that chocolate moose up in the valve covers will still be in my motor after i perform the oil change and coolant flush. How should I go about attempting to clean the motor out ? seafoam scares me because i do not know if my rings are already damaged from driving while needing the head gasket, Or should i just keep doing oil changes until it looks clean?
View 3 RepliesFord F-150 - 1997-2003 :: 1998 - Truck Is Jumping From 1500 To About 2500 - 2600 RPMs
So my 98 f150 xlt 4.6 is having a issue where the truck is jumping from 1500 rpm to about 2500 - 2600 rpm. You know sitting there trying to get up to speed. then all the sudden i look down and its at 1500 rpm. but still not really going anywhere. So i give it a little more throttle or gas and it jumps from 1500 to about 2500. Its been like this for a month but i thought it was crap fuel. What is the cause or maybe a solution?
View 4 RepliesFord F-150 - 1997-2003 :: 1998 - Clunk Noise Coming From Right Front?
I have a 1998 F150 with a 4.6 engine and is a 4x4 now the other day when I was backing out of the garage I heard a clunk noise and it seems like it is coming from the right front, so I tried it going forward it made the same noise but not as bad. There is no road noise and all the u joints are good and tight, the noise was when I gave it a little gas. My question is the front cv u joint would this make the noise? And what about the hub? What is the proper why to check the CV joint and the hub? The noise was when I was in 2 wheel drive.
View 14 RepliesFord F-150 - 1997-2003 :: 1998 4X4 - Front Drive Shaft Won't Turn On
My t case will engage in 4 high and 4 low. so i know the switch and motor works because it go all the way to 4 low and i can feel the lower gears. BUT the front drive shaft is not turning because i know that the front diff is engaging just fine cus one I just fixed it and because when i put it in 4x4 the front drive shaft is locked in but when i take it out the drive shaft moves freely when i turn it by hand. But when I test it in gravel or mud the front wheels still ain't turning. So its gota be the t case. But what are the part that may be broken in the t case and if I can fix it wile its still on the truck.
View 4 RepliesFord F-150 - 1997-2003 :: 1998 F250 - Front Rotor Seized Thoroughly
1998 F250 ld 5.4 4X4 4wabs. The front rotor was seized on THOROUGHLY bearing split apart (outer bearing and bearing "core" still attached to rotor, outer race inner bearing and sleeve still in steering knuckle), the bearing was fine fine until i tried to remove the rotor, any chance it can be pressed back together and saved?
View 3 RepliesFord F-150 - 1997-2003 :: 1998 - New Front Calipers / Brakes Barely Functioning
I just bought a 1998 F150 2wd with the 4.6L(no ABS) to be my beater home depot truck. The brakes barely functioned, so I replaced the front bearings, rotors, pads, and calipers. I bled the brakes exactly like I normally do. When I tried to move the truck, the rear tires spun with the front completely locked(also discovered the right rear line had a hole and crimped the line for a moment, but it was the tire that was spinning).
I searched and many people said that bad rubber lines cause the calipers to lockup. I loosened the bleed valves and the fronts were still locked(jacked up the truck and used a breaker bar on lug nuts trying to rotate each tire). I am guessing that it has to be master cylinder or the steel lines. Any tests I could do to narrow down this issue further?
Ford F-150 - 1997-2003 :: Truck Sat Higher In Front End And Caster / Camber Way Out
ok, I have an 02 f-150 4x4 that I did the brakes, shocks, and inner and outer tie rod ends. When I was done, the truck sat higher in the front end and the caster/camber was way out. bottom of tire sits way in. Is this just and adjustment to the tie rods, or what. The old rod ends were pretty bad. Could this be the result of an alignment tech setting caster way out to account for the bad ball joints?
View 10 RepliesFord F-150 - 1997-2003 :: 1998 - When Parked On An Incline Surface With Front Uphill Won't Start?
I have a 1998 F-150 V8 4.6L. Currently has about 83000 miles. I have had this problem twice now. When I park on an incline with the front up hill the engine will not start. It will crank like it is trying to start, but it sounds like its not getting enough fuel. Both times my tank has been nearly full or 3/4 full. Just put on a new fuel filter and the old one was still clean. ( I could blow through it with ease). I think it is the fuel pump.
View 1 RepliesFord F-150 - 1997-2003 :: Strange Noise Coming From Front Passenger Side Of Truck
Have a 1998 F-150....heard a strange noise coming from the front passenger side of the truck. Parked and turned the wheel and heard something fall off. It appears to be a shield of some sort.
View 2 RepliesFord F-150 - 1997-2003 :: 1998 F250 - Front Axle Stuck Locked In And Drive-line Shaking
I have a 98 F250LD, its a Lariat, so everything electric/auto. Shift on the Fly 4x4, 5.4, 188K, Factory rear air suspension. Typical Minnesota rust. Anyway, I just noticed in the last 75 miles or so, a drive-line vibration. There is nothing until 39 MPH. Then from 39-41 MPH there is a decent vibration. Stops until 50, then from 50 MPH up it is a steady vibration. I have already changed the u-joints in the rear shaft. I have pulled/wiggled on everything else I can think of with no luck of finding of anything loose.
One thing I did notice, is that the front axle is locked in all the time. How long it has been like this: years for all I know... I can flip the switch from 2wd to 4H and 4L. It all seems to work fine, I hear clicking, the 4x4 engages, the proper lights come on/off. The front axle will pull when supposed to. The transfer case seems to be working fine, but the front axle won't disengage. I am hoping this can be fixed cheaply/easily (DIYer), and also hoping this explains my low fuel mileage.
Front axle? Where to look or what to try and fix for the vibration?
Honda - Cr-v - Noises :: 2004 - Jingling / Metallic Sound In Right Front End
When I turn left I hear a jingling, metallic sound in right front end. Only when I turn left not turning right. And when I hit a bump I hear that sound. When I drive into a drive way while turning left it clangs-jingles. I checked everything up front myself can't find anything lose. Whats the Problem?
View 3 RepliesFord F-150 - 1997-2003 :: 1998 - 4WD Won't Engaging?
I am having a problem with my 1998 F150 4x4. The 4WD is not engaging. It is a manual shift. I have checked the transfer case by turning the drive shaft in 2WD it is free. When I shift into 4WD it is does not spin freely. So I believe that is OK. I have checked the vaccum diaphram. It will move the piston when I attach a hose and pull vacuum on the inboard hose barb. So I believe the diaphram it self is OK. I am not sure if the hoses and selenoids are OK. They look fine. However there is a constant vacuum on the inboard hose line (red/pink color) wether I am in 4WD or not. Is this OK? How can I check the selenoids. If all this is OK, the next thing I believ it could be is the shift fork in the differential. Is that a difficult job? Do you need to pull the whole axle out to replace it?
View 14 Replies