Ford Ranger / B-Series :: 1991 - No Power To Fuel Pump?
I can't get power to the fuel pump on my 91 ranger 3.0 5 speed. I just bought the truck and replaced all the relays checked all the fuses under the dash and under the hood. If I jump the relay it comes on and wont go off.
View 14 RepliesFord 6.0L Power Stroke Diesel :: Fuel Pressure - Engine Did Not Start When Turned The Switch Key On
2004 6.0. 160K miles.
I'm about to replace an injector and wanted baseline info on fuel pressure before doing the work. Using a gauge tapped into the top of an aluminum alloy fuel filter cap (from bulletproof diesel), I turned the switch key on but did not start the engine.
Static pressure jumped to 60psi, but as soon as the pump cut off the pressure dropped off to zero. Again, engine not started. I cycled the key off and back on and the pressure hit 60psi and held that until the pump cycled off, then dropped back to zero.
I'd like to get a few confirmations that fuel pressure should or should not fall off when the pump kicks off.
Side note, during the crank process the pressure jumps and holds at 60psi and stays at 60psi while idling. I have not conducted a dynamic road test yet. Didn't have the adapter to connect my long hose...
Ford Fuel System :: 1991 F250 XLT - Fuel Pump Will Not Stop Running
I just bought another 1991 Ford. This one is a 1/2 ton XLT Lariet with the 302 and for the first time I own a short bed. I also have a 1991 F-250 XLT with a 460 and a 8' bed.
Here is the problem, ( I think) it will not run or at least not for long. The fuel pump, which I am guessing is in the rear tank will not stop running. On the F-250 the pump stops running after a few seconds after I turn on the key.
Where should I start to find out my problem with the fuel system?
Ford - Explorer :: Loss Of Power To Fuel Pump / Crank But No Start
I have an 04 Ford Explorer XLT 4.0 Flex Fuel. There has been loss of power to fuel pump. Relay and fuse both good, replaced the inertia switch...still nothing. Could a FPDM (fuel pump driver module) have anything to do with this issue? Or what should I check next? I am definitely at a loss as to what the issue could be! I know it is fuel related because I used starting fluid and it started right up and run for just a few seconds, so that should rule out ignition I think.
View 3 RepliesCamry :: 2003 - No Power To Fuel Pump When Key Is Turned To On Position
I have a 2003 camry v6 that doesn't start. There is no power to the fuel pump when the key is turned to the on position. Where is the relay for the fuel pump?
View 2 RepliesFord F-150 (2004-2008) :: Buzzing Noise Coming From Fuel Pump But Not Enough Power To Turn Over
I have a 2005 F-150 supercrew 4.6L with appx 127,000 miles on it. Back in December i took the family to a drive in movie and left the ignition turned to the on position. I jumped the battery and drove a few miles home. The next morning when i tried to start the truck it would not turn over. There was a buzzing noise coming from the fuel pump but not enough juice to turn the truck over. This has happened a few times in the last couple of months but will jump and run fine for weeks at a time. I've taken a 2500 mile round trip to Texas with no issues. I took a 200 mile trip this past weekend and now it will not start. I'm thinking it could be the fuel pump relay? I went to the parts store and bought a relay but it's not the same size as the one in my Haynes Manual. The part from the store is the same size as the bigger relays in the kick panel fuse box but does not match any of the plugs. According to my manual the fuel pump relay should be a smaller relay.
View 4 RepliesCelica :: 1991 - Intermittent Start As If The Fuel Pump Is Not Pumping
It acts like it is fuel poor, As if the fuel pump is not pumping. It spins fast on start. Then another try and it starts! No relationship to hot or cold. Fuel OK. Battery strong. I find no corrosion on fuel pump leads.
View 8 RepliesFord Fuel System :: Oil Coming From Side Of Fuel Pump?
I was letting my truck idle to work on a cooling issue when I noticed oil coming from my fuel pump! What would cause this? It wasn't coming from were the pump bolts to the timing cover it was coming out of the side of the pump it looked like? I'm going to get a new one.
View 7 RepliesFord Fuel System :: No Fuel Coming From Pump Nozzle?
Working on my cousin's 84 F150 351w HO with a Holley 4180 4bbl and auto trans.
I rebuilt the carb because of sticking floats (that and it was filthy and sitting). It fired up and I drove it to my uncle's shop a ways down the road before even adjusting anything. At the shop, it fires right up, idles great and floats and idle mixture screws are now adjusted.
It has a dead spot right off of idle that's been driving me crazy, and stalls in gear if I'm not careful with the pedal.
After reading around here, I looked down the carb to make sure the fuel was squirting as soon as the throttle moved, and noticed there was NO FUEL squirting from the nozzles. So that explains the dead spot...
There was just the needle, then the nozzles, then the screw that went in, same as they came out (only cleaner). Wondering where to go from here to get these working again. Going to pull the nozzles off and see if there's anything obvious going on in there.
Ford Ranger / B-Series :: 2000 - Just Turned Over But Would Not Start - No Fuel Pump Noise
My daughter's boyfriend just bought a 2000 ranger with a 2.5. We just put a flexplate in it and it wouldn't start. Just turned over. Listened for the fuel pump and no noise. After a few minutes, it worked. He drove it home last night and said that it didn't want to work first try but worked with the second try. He drove it to church, 40 miles, and it sit for around two hours and wouldn't start, no matter how many tries.
We tried changing the relays around with no luck. We went and eat lunch and back to the truck with a rubber hammer. Then it starts on the second try without using the hammer. We got under it and cleaned the connections up and put some bulb grease on them. I couldn't get the one apart right on top of the pump itself, I was afraid of breaking it. It's been doing fine since we left the church before we cleaned the connections.
Ford - Explorer :: 2003 - No Fuel Pressure / Pump Will Not Run
I have a 03 explorer sport trac that has no fuel pressure the pump will not run. It is a bew pump just replaced it amd drove 4 miles cut it off filled up with gas now it wont run I replaced the pump again thinking I might have got a bad pump but it still wont run. I've checked the relay and inertia switch I have the 5 pin connector on the fuel pump module. 1 wire has good power to it but the pump won't run...
View 6 RepliesFord - Explorer :: 2000 - Fuel Pump Won't Run / Burnt Up?
My friends 2000(I think) explorer With the 4.0 86k has burnt up two pumps in two weeks. This last one only lasted a day. There was over half a tank of fuel in it when installed and only drove it to work and back, about 50 miles. Next morning he went to leave, nothing. Pump won't run. Checked fuses and relays they were okay. Why would this be happening?
View 2 RepliesFord - Explorer :: 2002 - Fuel Pump Not Turning On
I have a 2002 ford explore 4.0 sport 4wd. I have a problem with my car, one day I tried starting the car and it didn't want to start. So i replaced the fuel filter and the car started. then after starting it a few times it didn't want to start anymore, so i took of the fuel tank (thinking bad gas, and there was stuff in the gas) so i take out the old gas out and put new gas, and bought a new fuel pump and filter, and when i put the gas tank back on the car, it still didnt want to start, so i take the fuel pump and find a random battery and connected it to the fuel pump and the pump spins so it works. I connected the pump to the car by itself not it the fuel tank (from underneath the car) and i was under the car to see if the pump turns on and someone tuned the car on, and the pump doesn't turn on (doesn't spin or anything). Long Story short, what i should do? Also I was looking for the fuel pump fuse and couldn't find it (thinking it might be the fuse) what is the fuse number or where its located.. i know where the fuel pump relay is, but just not the fuse. Why the pump wouldn't turned on??? The pic is how my fuse box looks like(there are many different version of the fuse box just wanted to show you how mine looks)...
View 11 RepliesFord - Explorer :: 2003 - Fuel Pump Won't Running?
Just did a complete engine rebuild on 2003 Explorer. All back together....have new battery, starter working, spark at plugs lol crank but no start. Next check is fuel. Fuel pump WAS working fine when timing chain guides went about a year ago...(had to rehab 2 parents and finish bath remodel before pulling engine) So... 1 year later I can't seem to get the fuel pump to work. I checked all fuses and relay. The fuel gauge is working - full tank.
View 14 RepliesFord - Explorer :: 2000 4.0 Sometimes Will Not Start - Fuel Pump Going Out?
I have a 2000 4.0 Explorer that sometimes will not start. It has happened on cool mornings as well as hot days after I shut it off, for example, shutting it off to fuel up. I always turn the key to the on position and wait a second or two before cranking, and when I do that, I can usually hear the fuel pump. It's when I don't hear the fuel pump that I know it won't start, and sure enough, crank and no start. My question is, is the fuel pump going out? Or another thought I had was maybe the inertia switch starting to fail? It runs great when it starts, just has a problem starting sometimes.
View 8 RepliesFord - Explorer :: 1995 - Can't Hear The Fuel Pump?
I'm working on one of our fleet vehicles here, a 1995 Explorer. about 2 months back, it stalled out. Got it back to the shop and turned the key on .... I couldn't hear the fuel pump. I replaced the fuel pump and the fuel pump relay. Vehicle started right up and seemed to run O.K. About 2 weeks ago, it stalled out again, same symptoms, acts like it runs out of gas and can't hear fuel pump.So, I have been playing with it and find that it starts up great in the cool mornings. In the afternoon when the temps are hotter, it won't start (can't hear fuel pump). The following morning when temps are cool, it will start right up and can hear the fuel pump. I almost wrote this one off as a defective fuel pump, but I'm not sure on this one.
View 7 RepliesFord - Focus :: Sporadic No Start / Turned Ignition Key Heard Fuel Pump Hum But Does Not Fire
2009 Ford Focus. Six months ago got in car returning from 60 mile trip. Turned ignition key heard fuel pump hum but no juice to ignition. (Not anti-theft lockout--security light behaved normally.) Would not take jump. Ford Roadside assistance tried everything else possible. Nothing. Towed to nearest Ford dealer. On arrival, car started immediately. Took to local Ford dealer who found absolutely no problems but ran TSB 10-21-8 reprogram PCM--test OK. Had no further problems with car until a week-and-a-half ago--same thing happened. Car towed to dealer again. Started immediately at dealer! Picked up from dealer, that night same thing happened. Did not phone roadside assistance--after 45 minutes car inexplicably started. That was a week ago. No problems since then. Feeling a little panicky w/car that may fail at any time--winter coming.
View 5 RepliesFord Ranger / B-Series :: 1985 - Fuel Pump Wires Heating Up Intermittently At Inertia Switch
1985 2.3L... New fuel pump And fuel pump relay, problem was happening before new parts. the wires at inertia switch continue to get hot switch has been removed. The heat continues to under the hood where there is some so rt of connecting link and heat stops.what the is this link for, it doesn't look like A fusible link?? Saw a similar post here about a fuel pump shutting down and wires getting hot. Same problem.
View 9 RepliesFord - Explorer :: 2003 - Fuel Pump Pressure Drops?
I have an 03 Explorer that had a starting issue. Long story short, it had no fuel pressure. So after testing the relay, I switched out the pump with an Airtex unit . All seemed fine...for a while.
Became hard to start again, checked Schrader valve with the key on, and not running, no pressure. Strange though, it would run.
So got the fuel pressure gauge on it. Turn the key and pressure will go to about 5-10psi and then drop to zero. Turn key off and on again, up to 5-10psi, then drop to zero. Turn the key to start and pressure goes up to 10psi, then starts, then goes to 30 while running and you can drive it around. Shut off motor and pressure goes down to zero.how the sending unit is supposed to hold fuel pressure and not release it? Is there some kind of check valve in the sending unit assembly that can be cleaned or does it need a whole sending unit with another pump? I already spent the $100 for the pump, and it is working if you can drive it!