Ford Excursion :: Truck Shaking Pretty Bad / Also Pulls Hard To The Right
So my 01 has been parked in the garage for about 2 months. Normally on battery tender but it accidentally got unplugged and I didn't realize til yesterday when I went to start it. So I got the battery charged up and put air in my rear drivers tire since every time it sits it goes flat. Well I did all this I so I could take it to get tires today.
Driving to work and its shaking pretty bad at highway speed. Don't recall it doing this yesterday. Never really did this before either. The truck also pulls hard to the right. Its done this for a while so I'm not sure if it's just the tires or needs alignment or something else. Or all of the above.
I'm mainly concerned with why it was shaking. The front tires don't look low however I will check the pressure on my lunch hour today.
Ford 6.0L Power Stroke Diesel :: Truck Pulls Really Hard To The Right If Going Over 40 MPH
If I am going over 40 mph and I have to brake hard my truck pulls really hard to the right. I mean so hard it will take me off the road. My truck is a 2004 f250 with 147,000 miles.
In the last six months I have replaced both hubs, rotors and brakes. I really drive like an old man so I don't know how long I have had this issue. Just someone pulled in front of me on the freeway and I had to brake hard and I found this out.
I have checked both front capilers and brake lines and those are fine. I have brand new tires on it. I really have no clue what is going on. I have pulled the brakes off three times and checked everything out and it looks good. If slowly push the brakes everything is great, it is only when I have to really slam on them.
Ford Excursion :: Door Handle Pulls Hard - Way To Adjust?
My passenger rear door handle opens at almost end of the pull if that makes sense. This is different than the others. Is there a way to adjust it?
View 2 RepliesFord Brakes/Suspension :: Truck Badly Pulls Left When Braking Hard
Just replaced break pads and rotors. Inner pad on left side was gone leading me to believe slides were not working properly. Pulled apart, cleaned and greased everything, and replaced pads and rotors. Calipers seem to be working fine. Now when I break hard, the truck pulls badly to the left. When I break softly, it seeks normal. My front end is a bit out of whack and veers just a bit to the left. Do you think this is my issue with the breaking ? I'm getting new tires and an alignment soon but was just curious.
View 3 RepliesFord Super Duty (1999-2016) :: 2003 F250 - Truck Pulls To Right When Driving And Pulls To Left On Braking
My 2003 F250 6.0 pulls to the right when driving at any speed. In order to keep it going straight the steering wheel must be slightly tilted to the left, not much but a little. When the brakes are applied hard it will go to the left slightly if you are not holding the wheel good. Neither of these are terrible, just a nuisance. I'm worried about uneven tire wear too. One front wheel bearing was replaced a few weeks ago. It had this problem before that and still does after. Does this sound like an alignment or maybe something more?
View 13 RepliesFord Excursion :: 2001 - Acceleration Pulls Left / Deceleration Pulls Right
2001 Ex 7.3 4x4 with 4" lift (6" with 37" Pro Comp tires)
All new front end steering components.
All new Shocks (bilstein)
All tires properly inflated to same PSI
All new brake rotors, calipers, caliper mounts, and pads.
When under hard acceleration the vehicle pulls to the left and I have to compensate by steering to the right. Under deceleration the vehicle pulls to the right and I have to compensate by steering to the left.
I am about to change all four brake lines to Braided Stainless Steel lines, replace all leaf spring bushings with polyurethane, and install a rear anti-sway bar. I'm going through this methodically enough or am I just building a brand new truck one part at a time?
Ford Excursion :: Hard Hit When Truck Goes Through Dip Or Bump
I had a 7" icon installed with reservoir shocks installed. Rides pretty good driving unless I hit a dip or bump. When either of those are steep down or up I have a very hard hit. Could the shocks not have enough travel? I am at a loss to explain except it is a pretty hard contact. It looks like the shocks have about 3-4" of shaft exposed on the shock. Unfortunately I do not think I can post pictures yet.
View 7 RepliesFord Excursion :: Truck Died On A Hard Right Turn?
So making a hard turn this AM truck died. It started right up and didn't see anything else unusual. May be I should start by looking at I.A.C?
View 13 RepliesFord Excursion :: Transmission Slip / Hard Vibration That Shakes Whole Truck
My 2002 excursion 7.3 is acting weird when in drive. I have to get to around 2k rpm to get moving and hard shifts. But if I put it in 1st it has no problem but in 2nd i have hard vibration that shakes whole truck.
View 5 RepliesDodge - Journey :: 2011 - Pulls Hard To The Right On Hard Acceleration?
My 2011 Dodge Journey, V-6, auto, awd, pulls hard to the right on hard acceleration. It always pulls just as the transmission shifts. My dealer's service manager said its due to the front drive shafts being different lengths and torgueing differently.
View 7 RepliesFord - Ranger :: 1995 - Pulls Hard To The Right
I've got a 1995 Ford Ranger that pulls hard to the right. It has always pulled to the right a little, but recently it has been worse. About a year and a half ago I replaced all four shocks, the two front tires, and had all four wheels aligned, but this did not stop the slight pull to the right. I get it back from the mechanic yesterday, and he tells me that there is a little bit of wire showing on the inside or the front drivers side tire.Is there some kind of joint or something in the steering that may be worn out that needs to be replaced? If so, how much does something like this cost to replace?I've been slowly replacing everything on my truck that needs to be replaced as I get the money, but it seems that lately it's just got way more expensive. I know that it's not a cheap fix for something like this, but I just wish it wouldn't happen all at once
View 2 RepliesFord - F150 :: 2008 - Truck Pulls Right After Alignment
It's an 08 Ford F-150. 4x4... Truck was pulling hard to the right. Took it in and got the alignment done, they told me front right was worn and would still pull slight right. When I drove it, still pulled just as hard. Took it back and had tires rotated, they test drove it multiple times and made small adjustments then told me it was good to go. Drove to work today and still pulling. Not quite as bad but definitely more than a slight pull. What's my next step? What else could cause this?
View 19 RepliesFord Excursion :: Pulls To The Right While Braking
Just as the title says I'm getting a good pull to the right when braking. Little background, truck has 155k, rotors and pads replaced 10 days ago, new tires today. Now with the new tires the pull is more pronounced than with the old tires but has been there, which I thought was just worn out rubber, apparently not.
All caliper pins are greased and moving freely, and for kicks I replaced left pins to see if some how they were fouling up, they weren't, still pulling. So my question after searching is maybe the last two culprits are bad caliper or bad hose? I just wanted to bounce this off the board and see if I am on the right track to fix this issue.
Ford - F350 :: When Braking Truck Pulls To The Right Momentarily Then Straightens Out
I have a 2002 F350 4x4 diesel. When I brake it pulls to the right momentarily then straightens out almost immediately. I've heard that this can be caused by bad ball joints, but I just had all four replaced less than a 15,000 miles ago, and I keep them greased regularly(every oil change). The rotors are a bit warped, but would that cause only a momentary pull? Other than that the brakes are good. I'm sure that the shocks are due for replacement. Tire wear/pressure is good. I had an alignment when the ball joints were replaced.
View 5 RepliesFord - F150 :: Truck Pulls To The Left While Applying The Brakes
02-F150-4.2L-102k. Truck was rolling down the road at approx. 35 to 40 mph. A speed bump/table appeared out of nowhere and was hit before beeing seen. Immediately since this event, the truck pulls to the left while applying the brakes. It pulls very hard and is fine while rolling down the road. Is there some damaged steering component or did one of the calipers go out from the jolt?
View 4 RepliesFord Excursion :: 2000 XLT Pulls To The Left
I have a 2000 XLT, V10, Auto, 4" suspension lift on 315/75R16. It recently started pulling to the left and has been getting worse. At <5mph the steering wheel will pulse to the left almost a quarter turn if you let it go and hold there. At actual driving speeds it feels like a constant pressure. The tire appears to have a wobble to it when driving, I know this because my wife drove followed me in it so I could observe.
It also turned easier to the left than to the right when I jacked up the front end and both wheels spun with ease. I have checked the tire rod, drag link, ball joints, and wheel bearings. They all checked out. The last things I can think to do would be to check the steering stabilizers, I have the dual inline set up, or swap the front tires and see if the problem moves from left to right.
Ford 6.0L Power Stroke Diesel :: Truck Pulls Left When Under Braking
So I've been noticing the truck pulls left when under braking. So, I replaced the front calipers. Now, it still pulls left. When I got home I felt the discs on all corners and found three about the same, barely touchable, and the front left a little warmer. So, it seems its braking more, but its brand new. So, what should I do? They are also pulsing a little.
View 14 RepliesFord Ranger / B-Series :: 2000 - Pulls To Left Real Hard?
My 2000 ranger in 4x4 high never did this. And in 2wd it doesn't pull at all...
When in 4x4 high it pulls hard to the left ?????? is left not working? It has automatic hubs ...
Ford 6.0L Power Stroke Diesel :: Truck Pulls Left Badly When Braking
Truck pulls to the left while braking, pretty bad. So, pulled the front right wheel off thinking the pins are stuck again as last year. Bottom pin was fine, top pin pretty gummed up but not froze so I cleaned it up good, used thin layer of the good stuff, put back together and test drove........same thing. Pulls left upon braking just as bad as before. Caliper pistons seemed fine, didn't take much to compress them either. Would a right rear cause this?
View 14 Replies