Ford Excursion :: Power Seat Won't Move Back
I've had an intermittent problem with the driver side power seat not moving back. Can't figure out if its a switch or drive gear.
View 14 RepliesFord Excursion :: Install Snaps On 2nd Row Back Seat?
How to install snaps on the 2nd row back seat fold down board? My just wont stay up anymore with the velcro.
View 14 RepliesFord Excursion :: No Reading At Oil Gauge And Temp Light Is On When Very Cold
I have a 2001 Excursion Limited V10. 146000 miles 2 wheel drive. I have had it about a year and this is my first winter to really have experience with her.
When the outside temperature is very cold and the engine is cold from sitting all night, at start up, the oil pressure gauge reads nothing and the oil pressure/temp idiot light is on. Only does this during the first very cold start up or after sitting and engine getting very cold again.
I can drive just a short distance (2 blocks) and both gauge and light go to normal and stay there for the rest of my drive. I am using a quality 5/20 oil and filter and the level is good. Warmer days it has never happened. Truck runs fine, smooth idle, no "limp mode". She has not had any recent work done. All the other dash gauges read fine.
There is something about really cold temperatures that have to be causing the issue , I think. ??
Ford Excursion :: Oil Pressure Gauge Not Reading Intermittently / Battery Light Coming On
I have been having an intermittent (2 times in the past 2000 miles) oil pressure gauge not reading. As I own a 6.0L I understand that this is just a pressure switch in reality and if the engine was starved of oil the HPOP system would kill the engine. The first time the oil gauge went out it was raining out. The second time was after going through a carwash and getting the underbody wash. At this time my battery light also came on for a few seconds.
Both problems seemed to go away after an engine restart. Today it is snowing lightly and my battery light came on again. I happened to be monitoring the battery voltage and FICM voltage via OBD II using Torque app. At no time while the battery light was on today did the battery voltage drop below 13.5V. The FICM was also stable at 48.5+/-.5V.
As the battery voltage read by the PCM is not actually dropping and the previous oil pressure gauge and the fact that my left blinker indicator is out I am thinking I may have electrical issues with the gauge cluster. I have never had these issues while driving in dry weather. Where do I start troubleshooting this? Also I am going out of town for the next two weeks and my girlfriend was going to use the vehicle. Is it OK for her to drive?
Chrysler - 300m :: Gauge Will Randomly Drop Down To Empty / Low Fuel Light Turn On Then Go Back To Correct Reading
MY 2000 300M has a problem with the fuel gauge. When over 1/2 a tank and just under the full mark the gauge will randomly drop down to empty and turn on the low fuel light then go back to the correct reading and will do this over and over again. my mechanic has looked at the car believes it's the sending unit. Just wanted a second opinion before I spent the money for a fuel pump module for the car.
View 7 RepliesFord Excursion :: Burnt Clutch Smell - Rear Calipers Locking Up
Driving home today I started smelling a burnt clutch smell!
Well since I have an automatic, I wasn't to worried until my 6 yr old gets out when we get home and says "DAD something stinks really bad out here!"
Get out and wow!! I have never had a caliper lock up on any vehicle I have ever owned! It stunk like I burnt a clutch out of a standard tranny!
So I start poking around and the left rear caliper is locked up, rotor is blue and you can hear it popping like a valve spring cooling down.
So my question is is there anything to look for other than the normal? I will be getting the brake system power bleed after I replace the caliper. I already checked the brake lines and there are no obvious issues. It is possible the rubber inner lining is toast.
Ford Excursion :: Reading Oil Dipstick / Cannot See A Definitive Line
How come I cannot read this thing worth a crap? I just had the oil changed and I can't see a definitive line on the dipstick. This thing burns oil when I am towing so I need to keep an eye on it.
View 5 RepliesFord Excursion :: Exterior Temp Reading Gone Blank?
My outside temperature reading on my '05 (6.0 PSD EB) Ex has recently gone black..no reading. I haven't noticed any other issues, just no outside temp readings... Do these sensors go bad or ? Is it a big deal to change them out?
I was told it should be located just to the side of left hand (drivers side) headlight behind the grill, a small black cube (approx. 1 inch square) with three wires coming out of it. However, I'm not finding it there.
Where is the temp sensor located? Is there a fuse covering this sensor?
Toyota - Avalon :: Interior Light Fixture For Back Seat Buzzes Intermittently
The interior light fixture for the back seat buzzes intermittently. It only happens when the radio is on. Is this something that can be repaired easily?
View 1 RepliesSanta Fe (CM - 2007-12) :: Headrest Of Back Seat Won't Go To Up Position After Fold Down Seat
The headrest of back seat will bend over when fold down the seat. But one of the headrests can't go back to original up position. The dealer has adjusted the cable but this just temporarily fixed the problem. The problem is back again. I will go back to dealer but can they really fix it? Should I ask for a replacement of the whole seat?
View 1 RepliesFord Excursion :: A/C Gauge Reading - Leak In Low And High Pressure Valve?
These are my gauge readings at 70 degrees Fahrenheit. According to an AC conversion for gauges calibrated in Pascals, 35-40F converts to 241-276 KPa, 140-160F converts to 1000-1103Kpa. The gauges are in Mpa which by conversion is 3 decimal points to the left so .241-.276 and 1-1.103 Mpa. Here are my gauge readings at 68 degrees ambient temp. Rear air is same as an ambient temp on max ac and the front is pictured. There seem to be virtually no pressure differences which I would interpret as a novice that there is ) freon flow.
There is freon in the system with the high pressure being approx correct but the low side is too high if I understand correctly. Basically when at highway speeds at 75 degrees yesterday the front AC was cold and the rear was outside vent temp only. There are slight leaks in the low and high-pressure valves. I have a Mastercool replacement tool but they did not send a fitting for the high-pressure valve. What these readings mean as far as what may be wrong?
Ford Excursion :: 2001 V10 - No Tach Or Fuel Reading At Startup For A Minute Or So
Occasionally when i start my Ex, there will be NO tach reading (0 RPM) and NO fuel gauge reading (E). The Temp and Oil gauges will work fine though.
After a min or so, they come to life and move normally. This happens intermittently.
2001 V10 4x4 Limited.
Touareg :: Back Seat Won't Go Back Up
I collapsed the rear seats this morning, loaded the Treg up with stuff (nothing too heavy) and drove 200 miles. Got home, unloaded stuff and then tried to put the seats back up. The center seat belt is integrated into the passenger side 60% folding seat. But for some reason it's now "locked" as the belts do when the car is in an accident.
Since the belt is tight as it is in the lowered position, it will not allow me to lift up the back portion of the seat. After looking at it in the somewhat narrow view I have from between the floor and the lowered back rest, I can see that when I try to lift the back rest, the belt needs to slack some to allow the seat back to go all the way up. But since it catches, it only allow the seat back to raise about 6" before it's too tight to raise the seat back anymore.
I looked at the mounting bolts for the bottom portion of the belt in the space I can see and I see a 12 point star pattern bolt (not sure of proper name). With my Passat, I was able to find a suitable allen wrench that fits in the 12 point star pattern bolt that controls the back door catch for adjustment purposes. But with this one, I tried both metric and SAE and neither has a close enough match.
The belt locking mechanism allows for about 1" of belt travel before it locks. I've jiggled with the belt trying to get the mechanism to unlock so I don't have to remove the belt anchor point on the floor of the car (which I don't have the right wrench for). Anything I can do with the belt? Or do I just go after getting the right wrench and undoing the anchor to allow more belt slack to reset the belt?
Ford - Explorer :: Back Seat Window Motor Regulators Going Out
My daughter has a 94 explorer xlt 4 dr. The window motor regulators are going out. I replaced one of the front ones and decided I'd just make the parts needed next time. All that was really wrong with the front was the little plastic slugs were crushed. They are easy enough to make.
Tonight I tried to remove one of the rear motors, so I could open it up and get the measurements I needed. I found 2 screws that secure the motor, but that's not all that holds it. It seems to be mounted with a spot welded stud as well. There is a small dimple in the door panel in the approximate area.
Before I start drilling things that might not need drilled, I thought maybe I better check here first. How is this supposed to be removed ? The Haynes manual for it tells nothing as to the removal and replacement of any of the window motors. Is the reg inside the gear head anything like the front door motors ?
Ford F-150 (2009-2014) :: Rattles Coming From Back Seat
I have a 2010 Ford Raptor and lately I have been hearing some rattles coming from the back seat. I am about 99% sure it's from the rear window... Not positive, but when I listen for the sound that's where it comes from. It's very faint on normal road and rattles after every bump or pothole I hit. I am still under warranty but I don't want to take it to ford unless I have to. I have spent hours on end looking for solutions online but I can't find anything that's my exact problem.
View 4 RepliesFord F-150 - 1997-2003 :: Seat Belt Won't Retract Back Up
Driver side seatbelt wont retract back up i have to push it in and sometimes it will suck it up but most of the time it wont is there a way to take it apart and clean it maybe?
View 9 RepliesFord F-150 - 1997-2003 :: Seat Back Won't Stay In Up Position 1
I have a 2000 Regular Cab Work Truck with non power split bench seat. The passenger side back will not hook in the up position.
Before diving into it. Is the mechanism broken or is it something I can fix if I tear it apart? There is nothing stuck under or behind that I can tell.
Ford - Explorer :: Front A/C Stopped Blowing, But Back Seat Still Blow
My a/c stopped blowing from the front seats but the back seats still blow. My gut is saying that the blower motor has went out, because all my fuses that I've checked aren't blown. It's too hot for the blower to go out.
View 4 RepliesFord F-150 (2004-2008) :: 2005 - Rear Seat Back Removal
My uncle has an 05 F150 extended cab. When he bought it he put his license plate in the rear window until he could get some bolts for it. When it was there it fell between the back of the rear seat and the back of the cab. Currently he has one plate on the rear, but is worried he will get stopped for not having a front plate installed. So he knew I am an FTE member and I could find out how to remove the seat back. I have not tried to remove it nor seen if I could reach it.
View 4 Replies