Ford Excursion :: Fuse 27 Keeps Blowing As Soon As Shift Into Reverse
Fuse #27 keeps blowing as soon as I shift into reverse.
Prior to shifting, everything works as it should - I've unplugged the rear sensors, back up lights, trailer plug, and each time, fuse #27 keeps blowing.....
Where I should look? Also - looking for a 2003 excursion wiring diagram that shows what all fuse#27 controls?
Ford Excursion :: 2000 V10 - Fuse 19 Keep Blowing - All Gauges And Speedometer Die?
I have a 2000 Excursion V10, I keep blowing the #19 10A miniature fuse while I am going down the road. All gauges and speedometer all of sudden die but the vehicle keeps running until I turn it off. When I try to restart she won't fire until I put a new fuse in.
View 14 RepliesFord Excursion :: Keeps Blowing Fuse 45 - Headlights Off - Engine Sputter And Die?
My Excursion keeps blowing fuse #45, a/k/a "Ignition switch Run/ Start feed"
Going to have to go in shop. Seems to be a short in the steering column.
Then the dash lights go dim, headlights die, engine sputters and dies. I am guessing alternator most likely.
These two things might be related? Maybe there's not a short in the steering column, I dunno.
Ford Excursion :: Fuse 3 Keeps Blowing - Camera Pointing Straight Down?
Ok I keep blowing fuse #3 in the interior compartment. Let me preface this by saying I have my always-on power for my rear view mirror which is the display for my back up camera, pulled from a wire that is fed by this fuse. The camera is on reverse power only and it pulled from the reverse lights in the rear of the truck, but the always-on power is pulled from this location for the display. Doesn't matter if I have always-on power to camera if the display fuse it has blown and I am guessing the mirror power is the source of my problem.
The fuse controls the OBD and the cigarette lighter and it seems to blow every time I plug anything into that power port that is more serious than say a phone charge. When this fuse goes then my mirror display is down, and back up camera is mainly used for hitching up a trailer solo. My camera is pointed straight down at my hitch ball and it makes hitching up by myself very easy.
I have a volt meter but not sure where I need to test, and well what a bad number is when I do test it? The mirror instructions say to pull always on power under the dash and the right wires are attached, and the fuse rating matches, so don't think it's a too much being pulled issue. Maybe a bad connection or maybe a relay issue? I had this fuse blow several times before I had the power mirror but it's certainly gotten worse.
Ford Excursion :: 2000 - Starter Motor Fuse Keep Blowing After Radio Install
So i bought an excursion 3 or 4 days ago and yesterday I went to install a double din dvd receiver. As I was installing something shorted out and I blew the radio fuse. No big deal or so I thought. Got the radio in and replaced the fuse but then the X wouldn't start. Went through everything and found a 5 amp fuse and a 15 amp fuse blown as well. Turns out the 15 amp fuse is for starter motor or something. Well I replaced the fuses and they kept blowing. Unhooked the radio completely and still keep blowing and the X is still obviously not starting. Pulled every relay I could in hopes something would reset and nothing. Any clue what it could be at this point?
View 14 RepliesFord Excursion :: Gauges Fuse Keep Blowing When Move Gear Shifter To Drive
My 2000 ford excursion gauges fuse keeps popping. It started earlier this year and I couldn't pin point when it would pop. Now I'm sure after 30.00 worth of fuses that it happens when I change the gear shifter from park or rev to drive.
View 5 RepliesFord Excursion :: 2001 - Tranny Fuse Blowing - Electrical Malfunction - Wiring Diagram?
I posted earlier about the tranny in my 01 Ex v10 having a transmission problem. The show looked at it and found the O2 sensor had shorted out and in some way sending the truck in to limp home causing the tranny fuse to blow????
Any way they fixed it or so they said and I drove it for a few hours and it did fine. The next morning I drove it and it blew the fuse. (under hood box I belive #19) I took it back to the shop and they beat and banged on it....got it wet etc. and can not get it to do it again. I know whe have an electrical issue but what all runs off of the fuse that controlls the tranny?
Is there any online wiring diagrams of excursions or superduty drive trains? Where all to look for the problem?
Ford F-150 - 1997-2003 :: PCM 30 Amp Fuse Blowing
Why the 30amp PCM fuse located in the under dash panel would blow. Problem started while truck was running and a simple replace of the fuse would it it back alive again. Now fuse is blowing at ignition on. Truck is 1997 F250 LD.
View 7 RepliesFord F-150 - 1997-2003 :: FX4 - Fuse 23 Keeps Blowing
I am having trouble with fuse 23 under the hood blowing while driving. I have read several threads on this issue but still no luck. I have removed all 4 02 sensors and ac relay and still about 1/4 mile down the road the fuse blows, and is giving the shift solenoid A shift solenoid B and the torque converter clutch solenoid electrical circuit. I have checked both plugs on the trans, I even dropped the pan and ohmed the solenoids out. I dont know what else to do?
View 14 RepliesFord Ranger / B-Series :: 2.3L - PCM Fuse Keeps Blowing
Description: It will crank over forever but not start. New timing belt water pump, etc, so it is not timing. tried different fuel pump relay. no luck. new fuse no luck. The radio fuse also shorts and blows when I change it. Headlight does not come on, but the cabin "ding ding ding" sound plays. Marker, turning, reverse, and brake lights work.
CHECK ENGINE LIGHT does not come on during key turn. I may know what caused it or it may not. Before all of this happened, my audio system fuse under the hood blow. It blew again after I installed a new fuse (immediately).
One day, the wires on a portable cigarette light pump snapped and the two wires had been touch. I noticed the truck stalled several times when letting off the gas and coming to a rolling stop. The fuel pump relay makes a click noise when I turn the key
Ford A/C :: 2008 - Clutch Fuse Keeps Blowing?
My A/C clutch fuse (#46) keeps blowing when the car is started but a/c is not on. Checked relay, it's ok. Unplugged compressor but the fuse still blows. Fan works, heat works, but no cold air.
View 1 RepliesFord - Focus :: 2007 Keep Blowing 10amp Fuse
My 2007 Focus wagon keep blowing (#30) 10amp fuse. It is connected to the tail lights (when the lights are on), the license plate light, and dashboard lights. I think it is related to moisture as it is worse (keeps blowing the fuse) after a rain. I've checked the taillights and there isn't any moisture there (although when I first found this, both taillight housings were pretty melted). Where to look for the short? Some other discussion groups listed different harnesses, but which one...I have the sinking feeling this is going to be impossible to find (or REALLY expensive)
View 1 RepliesFord - Suspension - F150 :: Fuse For The Speedometer Keeps Blowing
The fuse for the speedometer keeps blowing. I changed the fuse and the circit breaker in Dec. 6 weeks later the fuse blew again, I replaced it and it last another 2 weeks and blew again. What is causing and what might be the solution?
View 4 RepliesFord F-150 (2004-2008) :: Transmission Fuse Blowing?
2008 F150 Super crew 5.4 v8, bone stock. The truck was acting up with a rough idle and slight miss when in gear at a stop 2 weeks ago, loss of power going uphill. Changed fuel filter and filled up with premium and a can of sea foam. The truck straightened up after that, so I thought. Last Friday it dies in the road, cranks, but no fire.
Has to be the engine, had it towed to the local dealer and they get to look at it Monday afternoon, said the transmission fuse was blown and it keeps blowing new ones, it's in the transmission wiring. I am used to older trucks and was blown away transmission wiring will shut the truck down. I would think the wiring harness to the transmission would be simple enough to check out, can the wiring or solenoids in the tranny cause this?
Ford Ranger / B-Series :: 2000 - Fuse Keeps Blowing On
2000 Model, The fuse keeps blowing on this. I thought it was the cruise control fuse because the cruise kept not working and when I replaced fuse it would work. Only for a little though, then I looked at manual and it says the fuse is for the brake position switch. I am presuming this is just like the old days and that is the brake light switch under the dash. They use to have two wires now there is like five. Anyways I do not see any bare wires or anything that would blow a fuse, is it common for these switches to go out or what??
View 13 RepliesFord - Explorer :: 1998 - Getting No Fuel - Fuse Not Blowing?
my wifes explorer is getting no fuel. (there is a valve I depressed similaR to a tire valve, I pressed it once some fuel dribbled out, and thats it, turned the key several times and not a drop off fuel. I went as far as checking the fuse, the fuse is not blown. what are my next steps of trouble shooting.
View 8 RepliesFord Wiring/Electrical :: Overdrive Fuse Keeps Blowing
Overdrive fuse keeps blowing. Drive one and 2 shifts fine. 3 and overdrive don't work. Had transmission checked it is fine. Repair shop says it is electrical.
View 1 RepliesFord F-150 (2004-2008) :: Fuse 41 Sparks And Keeps Blowing
I own a 2004 F150 Screw Lariat and the fuse # 41 keep blowing. This fuse goes to the cigar lighter and the Diagnostic connector power. As soon as I put the fuse in, it sparks and blows. I have even tried different sizes.
View 2 RepliesFord Ranger / B-Series :: 1991 2WD - EEC Fuse Keeps Blowing
My dad's 1991 Ford ranger 3.0 2wd just died on him when he was driving home and I checked to see if the truck had a spark and it did not so I replaced the ignition control module, then ignition coil, then distributor and rotor cap(plug) and I put new plugs and wires on it a few months back too. I also checked to make sure that the timing chain was working as well (while I had the distributor cap off). Then I realized that the EEC maxi fuse was blown. I then found a fourm that said it might be the relay so I replaced the EEC and the fuel pump relays while I had them both out. Every time I put a new 30 amp fuse in the EEC slot and turn the key to start it the fuse blows and the truck won't start. What might be wrong?
View 1 Replies