Suburban :: Excessive Dust On Rear Brakes - Light Squeaking Noise When Tires Rotate
So my saga continues with my rear brakes on my 99 Suburban - had a glazing problem that was eventually discovered, glaze knocked off old pads and then glaze came back again. So we replaced the rear drums and pads. A month and a half later I get an irritating squeaking noise.
Noise - when the tires are rotating they make a light squeaking noise, a rotating/pulsing squeak; when the brakes are applied they make a lower pitch squeak and if I apply just the right pressure on the brakes I can get the noise to go away (while also giving it gas to keep moving).
Last night I inspected the rear brakes and found an excessive amount of dust/grime on the pads. The drums we fairly clean. The pads had a heavy layer of rust/grime on them. When I ran my finger over them it left no mark on the pad because it was so heavy, but my finger had this sooty grime on it. The rust covered about a 1/3 to 1/2 of the pads (each pad had a different amount of coverage).
Everything is brand new and I'm not sure what is causing all the dust coverage.
Toyota - Corolla :: 2000 - Possible To Rotate The Front Tires?
Car is a 2000 Corolla CE with 4-spd auto. Is it possible to rotate one side of the front tire while the car is jacked up? How about if it is in neutral with the parking brake on?
View 5 RepliesSonata NF (2006-10) :: Front End Knocks And Clunks Going Over Bumps And When Stepping On Brakes?
Have all kinds of front end knocks and clunks going over bumps and when stepping on the brakes when backing up. Looking to make a parts list to replace everything at once. I see the upper control arm has 2 bushings and a ball joint, the lower control arm has a bunch of bushings and a ball joint. What else should I replace?
View 8 RepliesFord Brakes/Suspension :: Front Brakes Locks Up / Tires Screeching
On braking my front brakes locks up and there's a screeching of tires. Once I release the pedal all seems fine...or is it?
I dissassembled the front brake calipers and cleaned out the cylinder bores and blew out any contaminants from the line. Reassembled and bled the system only to find the pads doesn't move as freely from the rotors as they should. C-clamped the cylinder as far back in the caliper as it will go, pumped the brakes and still the rotor doesn't move freely from the pads, when the pedal is released...which accounts for the radical "loss of power", as the front brakes are holding on.
Bare in mind the vehicle hasn't seen the long road for almost 5 years and has been under the grinder/ welder/ primer/ sanding for most of that period and only moves out in the driveway when it's a good day to work outside.
New flex hoses? Flush the brake fluid from the whole system and start fresh? New caliper rubber seals? Blow the lines out with compressed air to rid of goop? New proportioning valve?
Camry :: How To Rotate Tires
So i need to rotate my tires and i want to know if there a special way to rotate them and if i need to reset the TPM system so the computer know where each tire is? Usually I just switch back to front or, move the driver rear to the front, driver front to passenger rear, passenger rear to front and pass. front to driver rear.
View 14 RepliesLexus GX 2010+ :: Proper Way To Rotate Tires?
What is the proper way to rotate the tires on the GX and how frequent should be done?
View 14 RepliesPassat (B6) :: Proper Sequence To Rotate Stock Wheels / Tires?
What is the proper sequence to rotate the stock wheels/tires? Is it front to back only on the same side or does it need to be crossed front to back?
View 6 RepliesGrand Prix :: 2004 GTP - Wheel Noise After New Tires / Rotate And Balance
I have a new car now, 2004 Grand Prix GTP Comp G, got it at 88k and it now has 167k. Nearly no problems other than routine maintenance, but here I am with an issue I can't seem to figure out.
A few weeks ago, I blew a tire on the highway, ended up getting 2 new tires put on the front and moved the fronts to the back. Tires were then rebalanced and the alignment straightened out.
The guys at the shop said the front tie end rod needed replaced, but I'm pretty sure they were trying to make extra money off a new customer because my bill was going from tires/alignment to tires/alignment, bearings, tie end rods, and speed sensors.
Now, on to my issue. When I'm driving on the interstate, I notice a humming sound that seems to come from the front passenger wheel between 68-80mph. Soon as I go over 80 or under 68, it's gone. I noticed that the noise lessened when I veered to the right, so I assumed it was the bearing.
Took the car to my usual shop, had the bearings checked, got the front driver bearing replaced under warranty. Mechanic said the passenger bearing seemed fine. Got it on the highway again today, noise is still there.
3.8SuperPacer
2004 Grand Prix GTP Comp G with Ram Air
1998 Grand Prix GTP 40th Anniversary Daytona 500 Pace Car Edition
Ford Excursion :: PSI In Front And Rear Tires?
" Michelin LTX A/T 2 Load range E tires that are size 265/75/16"
I don't haul much and I don't tow.
How much in the front tires and how much in the rear?
Ford Excursion : Cupping Just On The Inside Of Both Front Tires
Just put new tires on my excursion 4x4 powerstroke and I'm getting cupping just on the inside of both front tires it already has new ball joints and steering box tire rods are tight and all joints in the front. what else could cause it?
View 1 RepliesFord Excursion :: 2000 - Level 2WD With 285/75 16 Tires - Front Springs?
I recently purchased a 2000 Ex Limited 2wd. It is stone stock except a slight lift. This lift gives it a pretty significant rake that I'm not a fan of. I'd like to get this thing leveled out without spending a fortune and I believe that would require the knowledge of the FTE.
The pictures below show the rake and existing suspension mods. With 285/75 16 Tires there is about 6" clearance from tire to fender on the front and 9.5" in the rear. It has a 2" spacer under what I imagine is the stock front coil spring and a 4" block below what do not appear to be stock leaf springs (guessing because the anti wrap spring is not present).
I'd like to get the front end to sit about 3" higher than it currently is to better match the rear. Lifts of any type are foreign to me. What front springs (and other components) do I need (and what brands would you recommend based on hard earned experience) to make this thing work?
Corolla / Matrix 2009-13 :: Clicking Noise At Shifter When Stepping On Brakes
My son just bought a 09 Corolla LE and he gets this clicking noise every time the brakes are applied. The clicking noise comes from the Shifter.
I know that about the Shift Lock Solenoid, but this clicking sound is loud. I have been told that this is normal. So, I thought if this is what 10th Gen owners here is experiencing the same.
Sonata NF (2006-10) :: Clicking Sound From Gear Box Frequently While Stepping On Brakes
I have this clicking sound from the gear of my car every time i step on the brakes, is it normal or do i have something to worry about...
View 1 RepliesFord Excursion :: Front Brakes Pulsing Slightly
The front brakes are pulsing (slightly, enough to spill my coffee when they line up together) with each rotation. I can't tell if they're warped, or if they have a rough patch on each disc.
View 9 RepliesFord Excursion :: Brakes Dust On Front Wheel?
Here's what I am running into. I have factory setup and it doesn't feel adequate. I get vibrations, lots of brake dust on front wheels, and just don't feel I have the stopping power if needed in emergency or towing. Especially with how heavy my 6.0 is already.
View 12 RepliesFord Excursion :: Squeaking / Odd Grinding Coming From Front Brakes
Replaced both rear calipers about 4 months ago, both were frozen. A few weeks ago I started getting some bad squeaking from the front brakes. The front calipers seemed fine when I did the rears.
Tonight I had even more fun with the beast. Drove to my sons baseball game and felt an odd "grinding" when braking. *Seems* to be coming from the front. On the way home, the grinding was worse and then the fun really started. Hit the brakes and the wheels started hopping enough to shake the whole friggin' truck. Leaving from a light, you could feel the brakes stick and then release, next stop was more shake n bake.
Not sure where to start on this one.
Lexus SC430 :: Tires Went Flat When Car Parked In Garage
Several months ago one of my 20" toyo tires was flat when I came out of work. Being a high school teacher, I thought that perhaps it was a students involved situation. That came as a surprise in that as a teacher of over 37 years, nothing has ever happened to any of my vehicles, while parked at school. Also I found it strange that they would let air out and put the chrome valve cap back on. Well, over the weekend, the same thing happened, with the car parked in my garage. So in both instances the tires went flat, I filled them back up and they held air. This happened months apart.
View 6 RepliesGolf IV R32 :: Wheel Is Hard To Rotate When Car Is On The Lift - Front Caliper Piston Size?
One of the caliper does not fully retract when I don't push the brake, the wheel is hard to rotate when the car is on the lift.
I pretty sure it is the square ring the problem.
I know that those square ring worth only a couple of bucks.
Ford Excursion :: Will Not Start When Truck Is Not Parked Leveled?
I just bought the truck and the previous owner said sometimes when the truck is parked in an angle, like in a drive way it will not start unless you use a screw driver and touch both posts on the solenoid. It happened to me today and I do not like it and need to find the cause? Why it would do this?
View 9 Replies