Ford F-150 - 1997-2003 :: Vacuum Diagrams For 4 Wheel Drive?
Looking for the vacuum diagrams for the four wheel drive, where I can find them?
View 10 RepliesFord 6.7L Power Stroke Diesel :: 2013 - Four Wheel Drive Vacuum Pump And Solenoid Location
I have a 2013 6.7 and i cant seem to get my 4wd to work in auto position on hubs i think i have it narrowed down to the solonoid for it but cant seem to find location on it.
View 3 RepliesFord Super Duty (1999-2016) :: F250 V10 - 4 Wheel Drive Hubs Are Not Working With The Vacuum
I recently picked up a '99 F250 Super Duty with the 6.8L V10 for a song.
The 4 wheel drive hubs are not working with the vacuum. If I use the manual lock on the hubs all is well. I ordered the Innova 31703 CarScan OBD2 + OBD1/ABS/SRS Scan Tool. It says it does Trans codes. I am hoping it will cover the 4 wheel drive too.
Maybe related, the heat is always on. Meaning I feel heat at my feet when the temp dial is cold and fan is off. I can't find the heater control valve to check the vacuum line.
Ford Excursion :: Small Puddle Under Passenger Side Tire / Wheel Area - Front Seal Leaking
So this morning is just getting better and better. Was coming back in from getting the mail and noticed a small puddle under the passenger side tire/wheel area.
I never ever have a puddle of any sort in my drive way so...I start crawling around the truck and this is what I find. I can free spin the dust seal, but its all the fluid that has be worried. With less then 4 days till I have to haul everyone to the airport this is not what I need.
IF (man I feel stupid for asking) IF I leave it in 2 wheel drive how big of an issue would it be to drive it?
None of the parts will be in before I have to drive everyone out to the airport, this is the only reason I'm even considering this..
Plus would this explain a sudden lost of MPG?
Ford Excursion :: 4 Wheel Drive Will Not Come On
Four wheel drive will not come on, no light on dash or engaging.Some times light on dash will flash. Why?
View 7 RepliesFord Excursion :: 2000 XLT - 4x4 Light Comes On But No Four Wheel Drive
I bought a 2000 Excursion XLT, 4x4 with the 7.3 Powerstroke Diesel back in the fall. Here in Indiana the winter is getting bad, not exactly the best time to find out your 4x4 doesn't work! My 4x4 light comes on, but I can tell I'm not in four wheel drive. I've read that on the diesels that the fix could be a simple vacuum line.
View 14 RepliesFord Excursion :: 2001 - 4 Wheel Drive Squeaking When Locked In
2001 7.3 l 4X4. I have done a ton of work to get the suspension and steering right. Changed all the shocks, added hellwig sways to front and rear, replaced steering gear with redhead, ball joints and added warns hubs. My question is today was the first time engaging the four wheel drive. I locked the hubs and turned the switch to 4X4 low, it starting squeaking and squalling and felt like my wheels were coming off. I put everything back to 2WD. I switched it to four wheel with out locking the hubs. no problem. When I locked the hubs in it started again. Been doing some research and looking at needle bearings, wheel bearings and axle joints.
View 10 RepliesFord Excursion :: 2000 - 4X4 Low Works But No 4 Wheel Drive In 4X4 High
I have the ESOF in a 2000 Excursion. I went to use 4X4 high and it would not give me 4 wheel drive. light on dash said 4X4 but no 4 wheel drive. I was in snow and only rear wheels spun. When switch is placed in 4X4 low I get 4 wheel drive.
View 1 RepliesGolf IV R32 :: Vacuum Leak On The Driver Side Seal
I have a vacuum leak on the driver side seal on the changeover rod in the intake manifold. It was replaced recently at the dealer and now has another hole in it. I was told this is caused by oil in the lines and my pcv valve is bad.
View 1 RepliesDodge - Neon :: CEL Stays On - Vacuum Seal On Gas Tank?
My check engine lite stays on. I was told it MIGHT be the vacuum seal on the gas tank. How much should I expect to pay to get this fixed? and how long should this repair take?
View 6 RepliesSaturn :: 2004 - Front Wheel Drive Transmission Fit In Place Of All Wheel Drive?
Do a 2004 Saturn view front wheel drive transmission will fit in place of an all wheel drive...
View 1 RepliesFord Excursion :: Getting Door Seal Mod?
I am getting ready to do the door seal mod and have all the materials but can't find the post with the instructions.
View 5 RepliesFord Excursion :: A/C Shaft Seal Leaking?
Well, the ac in my truck has been less than exciting since I've owned it and its time to address it before another trip.
I crawled under last night to explore the Ac clutch air gap and found that the shaft seal is leaking and clutch is grooved pretty bad and covered in oil.
I'm thinking it's time for a compressor, clutch, orifice tube, expansion valve and reciever/dryer. Does that about sum it up? I haven't messed with AC systems much outside of my simple jeep system that was as easy as two seals and recharge in my garage to fix it.
Do I need to flush the lines out? Should I do that at all? Motor craft worth the cost over something like four seasons? Its almost twice the cost but in the end if something goes I'm further downstream after freon etc to charge it and the possible shop charge if I pay to have to done.
Ford Excursion :: Rubber Seal Near Axle Joint?
I unstuck my front axles yesterday and while under the car spinning the front axles freely and enjoying my easy fix, I noticed a rubber seal (a thick squared edge round rubber seal) sitting loose and spinning freely. Its next to the axle joint, right before it disappears into the housing.
I'm guessing this is a dust seal of some kind. There is no fluid leaking out...
I'm wondering if I can just press fit this thing back into place or do I have to take the whole front wheel assembly (hub, bearing, axle, etc) to get the seal back into place.
I'm wondering if it broke off from a larger seal or if this is the whole thing? You can see how the seal isn't sitting quite straight. It actually just spins around.
Ford Excursion :: Rear Pinion Seal Replacement?
I changed my rear axle grease a couple of weeks ago and now I see some fluid coming out of the pinion seal. Do you think I overfilled it or do I need a new seal?
How hard is it to replace the pinion seal, will I need a new crush washer and will it knock out the preload?
Ford Super Duty (1999-2016) :: Front Drive Shaft Spinning While In 2 Wheel Drive
I have a 1999 Ford F250 super duty 4wheel drive, lifted (really a leveling kit but had to lift rear to compensate), 5.4l. Im having a problem with my front shaft turning while in 2 wheel drive. Hubs aren't locked and its in 2 wheel not 4. I've taken hubs off and the bearing spins free soo I know its in auto. Why is the drive shaft still turning???????
View 5 RepliesFord Excursion :: 2000 V10 - Front Differential (Inner Seal) Leak
2000 Excursion, Limited, 4X4, 6.8L, V10. My right front inner differential seal is leaking. I have researched and found out that I have to remove the pumpkin gear assembly from the front differential to get at the seal.
Do I need any special tools to get the seals seated back into the differential? Any instructions or a list of parts needed?
I went to fordparts.com and entered my vin number but it makes no reference to the parts of the front differential only the rear.
Ford Excursion :: 2004 - Front Axle Inner Seal Replacement
I have an 04 Limited, 6.0 PSD, 4x4 which I need to replace the front inner axle seals, the right side is leaking out the shaft. I have watched a couple of YouTube videos on how it is done but would like to get some first hand knowledge and recommendations.
First, how important is it to check the backlash before beginning the removal of the gear assembly? Do I need to remove the pinion gear as well or just the gear assembly?
How difficult is it to get everything back on place once the seals are replaced? I have not done this type of repair before and am concerned I might miss something.
I am planning to replace all the ball joints at this time also, this was the primary reason for this maintenance in the first place.
Ford Excursion :: Stuck On Defrost Vacuum Leak
Ok, I have capped off the vacuum lines to the front hubs and replaced the vacuum solenoid on the passenger inner fender. Still stuck on defrost. I know there are several options from this point what would be the next step after what I have just recently done. Going away on a ski trip and would like to have it working properly before I go.
View 14 Replies