Dodge - Grandcaravan :: 2002 - Transmission Not Changing Gears?
My 2002 Dodge Grand Caravan transmission suddenly does not changing in gear This happened when I was driving. The engine light came one and transmission seems to stuck in a gear. Acceleration is fine but the van slows down quickly if I let go the gas pedal. Seems like it stuck in a gear. How to I troubleshoot and is there anything I can do at home?
View 19 RepliesGolf IV / Jetta IV :: 2002 1.8T - Shifting Out Of Time / Revs When Changing Gears
Got a 02 Jetta 1.8T 5spd auto tiptronic with 100k miles. Having issues with shifting. Trying to determine if its electronic or mechanical. Had a short in solenoid 10 N283 which melted the TCM. Put in a used N283 to see if the trans is still ok mechanically. Plan is if its ok to put new fluids and solenoid pack. What do the experts think does is need a full rebuild or will new electronics do the job?
After putting the used N283 solenoid the trans works but not correct. The problem is in the shifting only. Feels like its out of time. When you start moving from a stopped position from 1st to 2nd the car takes off good but when changing gears it reves and feels like its slipping then it hits hard into 2nd. Then 2nd-3rd is a fast shift and not hard. 3rd-4th slips and revs a little then changes gears 4th-5th is fine. all down shifts are fine. Does not mater if the car is hot or cold its the same.
If I disconnect the MAF 1st to 2nd shifts fine with no problems. 2nd-3rd little rough but not bad. Problem with disconnected MAF when going in Drive at 30-40mph all of a sudden it jumped into 1st gear and felt like I was slamming on the brakes.
With the MAF connected and I shift manually in tiptronic mode each gear runs real good with no slipping at all. But same problem happens when switching gears. I can drive it smooth if i accelerate to 3000 rpm and then left off the gas a little and it shifts fine.. Same with the other gears.
I got a used TCM to rule that out and the problem is close to the same. It tries to shift at lower rpm but still does about the same problem. I did recently had a MAF go out. Put in a new bosch and no change. Did my VCDS scan and only codes I get is "17840 secondary air". I can get operational data on some solenoids but not sure what parameters to look for.
Dodge - Dakota :: 2002 - Sloppy Shifting / Heavy Thump Changing Gears When Slowing
Last year, July, replaced Trans.modulator..All went well. Now..sloppy shifting, occasion heavy thump changing gears when slowing. Trans. people say All good according to their programs.....but they also feel the same problems. Its an internal problem, they say, too expensive to tear down.Drive it until it dies. ( 161 K on the odometer.....otherwise is perfect. I want to do a flush, then drop the pan, change the screens, tighten the bands and replace Trans. fluid.
View 1 RepliesLexus IS 2014+ :: Changing Rims Effect On Tire Pressure Monitoring System
If changing the rims on my '14 IS will affect the TPMS function? If so, am I able to transfer this on to my new set of rims? Also, is there a TPMS reset switch in the car?
View 3 RepliesPrius (2010-12) Fuel :: Changing Tire Size Effect On MPG / Handling / Traction?
My original Yokohama avid s33 is about ready to be changed. It now have over 42k on them. I think I can still stretch it before the winter starts. My OEM size are 195/65/15 and I'm thinking of getting the 205/65/15. According to Tire Dimensions Made Simple - Discount Tire my tire rotation will decrease by over 16 revs per mile. I know the side wall is going to be about a quarter an inch higher about an inch and a half bigger in circumference And the car is going to sit half an inch higher and a wider Width.
Looking for observation/s pertaining to performance, mpg, handling, traction, etc.
Ford - Mustang - Transmissions :: Shifter In Console Sticks When Changing Gears
My Mustang is an automatic. The shifter in the console sticks when changing gears. At times, I have to keep it half way into another gear or else I hear grinding or the car won't go into gear. Is it my transmission or my console?
View 2 RepliesFord F-150 - 1997-2003 :: Loud Squeal Until Changing Gears When Accelerate
When I accelerate i get a loud squeal until my truck changes a few gears. Its only when I accelerate and only if my trucks warm and has been running or a few minutes. Cold start it wont happen right away. What it is or could be. Changed my serpentine belt that didn't work...
View 7 RepliesFord - Escape :: Engine Knocking At Stop / Shuddering When Changing Gears At High Speeds
2002 Ford Escape. My car was sitting for a week in cold weather. I started it yesterday with no problem, but only waited for a minute or two before driving. I was driving at city speeds, and heard a knock. I was accelerating up a hill and it hesitated/ jerked once or twice. The check engine light came on, and now it knocks every few seconds when I am stopped at a light. It also doesn't seem to catch the highest gear (5?) when it shifts, making a constant knocking sound and vibrating. Letting go of the gas or accelerating so it shifts back down makes the noise go away. In other gears it seems fine, with an occasional jump... It is an Automatic V6. I am taking the car in Monday, but I would like to know possible causes.
This morning I let my car warm up for 40 minutes (15 minutes in park and 25 idling at the bus stop). The problem was no better. By knock I meant it feels like someone bumped the engine. My foot vibrates on the brake for a second. And when it changes into the highest gear, it shudders ( until I release or further press the gas pedal. The revs don't change while it is shuddering or knocking.
Ford 7.3L Power Stroke (1999-2003) :: Installed New Intake Now Loud Shutter When Changing Gears?
Put in my new S&B intake today and when I stomp on the gas I am getting a loud shuddering noise from the intake when I change gears. Also sounds like a squealing sound sometimes. Doesn't sound like other trucks that I have heard. What that could be?
View 14 RepliesFord Super Duty (1999-2016) :: 2012 F250 - Grunt When Changing Gears / Mushy Brakes
On the surface, the F-250/350 seems to have great brakes: big rotors, vented front and rear, and dual-piston calipers front and rear. But, I have two problems:
One is the annoying 'grunt' the brakes make every time you change from Park to Drive, or Park to Reverse, or Drive to Reverse. Its as if under normal brake pressure, the brakes cannot hold the truck from moving against the torque convertor engaging. It's not just my truck, I've heard older SD's with the 5.4L or diesel do this too. If you push the pedal really hard, it won't grunt.
The second problem I think is the root of the first: mushy brakes. Maybe I'm just used to driving european cars with firm brakes, but every time I apply my truck's brakes, it feels like I need to bleed the system! The truck does slow pretty well, and I realize it's heavy, but how can the pedal feel be improved? Maybe replacing the rubber sections with braided stainless?
Lastly, the truck has a 'hill-hold' feature which is retarded in an automatic transmission. My problem with it, is that sometimes it sticks on...engage drive, the truck won't move...a second later its like something gets unstuck and the truck kind of lurches forward.
Touareg :: Slipping When Changing Gears From 5th To 4th
I have an early model year 2004 Touareg which has lately developed what appears to be a slipping problem when changing gears from 5th to 4th when decelerating or the same when accelerating strongly and downshifting. When switching over to tiptronic mode, its not clear if that apparent slipping goes away or changes. It definitely isn't as severe but that could be due to perception or the RPMs where the shifting is occurring.
The only real interesting characteristic of this clunk and lurch that is experienced is that it only happens when the car is warm -- I've been watching the transmission oil temperature, and it appears to start happening as it passes through 200 degrees. When it starts, the lurch/clunk is small and not too bad. As the car reaches temperature, it reaches if full lurch/clunk potential.
I have taken it to the dealer once and they have "upgraded software" that was supposed to clear up the problem, but did not.
Passat (B6) :: Changing Gears Too Soon On Automatic Mode
About twice a year I am noting a too soon change of gears on automatic mode. This may be the fourth time it happens is just coming and going by itself.
I notice that when driving on constant traffic and going about 40mph I'm doing 5th gear so when traffic clears up I have to really step on the gas so car downgrades to catch up with traffic. What may be happening?
Corolla / Matrix 2009-13 :: Squeak When Changing Gears Especially From 1st To 2nd
I have a squeak when I change gears, especially from 1st to 2nd. I have a twm short shifter with bronze cable bushings. My first thought was that the bronze bushings were causing the squeak, but I eventually narrowed it down to the shaft that comes out of the back of the transmission with the weight bolted on it (not sure what it's called). I took out the intake filter box so I could get at it and confirm that it was where the squeaking was coming from. That's definitely where it was coming from so I pulled back the boot seal and greased the shaft with some white lithium grease. That has worked a bit, but the squeak is still there.
View 8 RepliesNissan - Sentra :: Changing Gears From Reverse To Drive
My wife always chastises me for not coming to a complete stop from backing up before I shift the car into drive. I do not shift when the car is still moving more than 1-2 MPH, in fact it is barely moving when I change gears. My wife insists that I come to a complete stop and wait 1-2 seconds before shifting from reverse to drive. She is convinced that I am doing damage to the transmission the way I shift. I insist that no damage is being done and point out that with over 100,000 miles there have been no transmission problems with the car. Am I damaging the transmission by shifting before I come to a complete stop in reverse?
View 9 RepliesPassat (B5) :: RPMs Go Crazy When Go Straight Before Changing Gears
I drive a 1998 B5 1.8T passat. This happens when i go up a hill, i mean i can go up the hill fine but then when I go straight my rpms go crazy before changing gears, idk if this is normal but I doubt it.
View 9 RepliesImpreza - Outback :: Jerking / Jumping When Changing Gears
I have a 2002 Impreza Outback Sport. Since moving to Tucson, AZ, from Flagstaff, AZ, the car jumps when changing gears (I have a manual) as if I was back in the day of learning how to drive a stick shift. This only happens in the summer, when temperatures get up to 110. Also, the idle is very rough and the car almost stalls when stopping quickly (this is infrequent). What's happening with my car?
View 2 RepliesChevrolet - Hhr :: Faulty Transmission - CEL On And Gears Are Sometimes Changing Harshly
Bought a 2009 Chevy HHR with 35,000 miles in July, 2010. In the summer of 2011 the ignition was replaced, as the key would not turn. (The engine was running at the time. It was necessary to disconnect the battery to turn off the engine.) At 55,000 miles the transmission suffered "catastrophic failure" and the entire transmission assembly was replaced. (The engine light never came on, although the transmission was slipping frequently.) After driving the car with the new transmission between 100 and 200 miles, the engine light came on. The error code indicated a faulty transmission fluid pressure switch. The transmission changed gears harshly at times and the automatic door locks stopped working properly. Sometimes they would lock when the car was taken out of "park" and sometimes not. Likewise, they would not always unlock when the transmission was put in "park." After replacing the switch, the technician said that for no reason the security light came on briefly as did the passenger airbag "on" indicator light. Once again, after having driven between 100 and 200 miles, the engine light is on again, and gears are sometimes changing harshly. No diagnosis yet. Do I need an exorcist?
View 7 RepliesGolf IV / Jetta IV :: 2000 - Not Changing Gears Automatically
I own a 2000 Jetta auto with 200k on it. I have the same problem. It wouldn't change gears till 4000 rpm i scanned it. And got the cods g38 and g68. So I changed both. It was working fine then again same thing it works then stop works. So scanned it again and got same codes changed them again worked fine then stopped working so I took it to vw and they told me same thing same sensors and the wire harness so I changed them again got the parts from VW this time. It was working then stopped. And when I turn on the car and drive my gear box display goes all black for at least 10 min driving then goes back to normal. But sill doesn't change gears. Now not even after 4000 rpm. Ps. When I do it manual 1st gear 2 and changes fine once I put it on drive doesn't not change gears.
View 7 RepliesGolf/GTI VII :: Faint Thump Noise When Changing Gears From 1st To 2nd And 2nd To 3rd
2015 GTI, 6sp, Coupe, 3000km.
When changing gears from 1st to 2nd and 2nd to 3rd, I get this faint THUMP thump noise coming from what seems to be the driver side foot well area, on the other side of the firewall.
Other ways to replicate is by simply clutching in as if changing gears, but not actually shifting. It can be prevented by shifting/accelerating very slowly (not practical).
Nothing can be felt in the clutch pedal OR the shifter. Can't be replicated in neutral, or by simply letting off the gas under boost. ONLY when the clutch is engaged about 2.5k RPM in 1st, and 2nd.
What it could be. Dogbone bushings? Engine mount? Gerbils? Also, went to dealer and they said it wasn't "enough" for them to start pulling stuff apart. Was told to wait until it gets worse.