Ford Escape / Hybrid :: 2008 - How To Disable Low Tire Pressure Light
With winter on its way I have installed winter tires and steel rims w/o pressure sensors on my 08 Escape. Is there a way to disable the dash warning light for low tire air pressure?
View 14 RepliesFord Escape / Hybrid :: Oil Pressure Light Was Blinking / Now Constant
I'm having an issue with my ford again. Escape, V6, 123k miles. Recent work done: Replaced all spark plugs, coils, and intake manifold gaskets. Replaced all four O2 sensors. Oil change switching from the 5w-20 to 5w-30 due to it getting cold, (probably a month ago?).
Now for my current problem. Two days ago on a 20* morning, after it sat outside all night, I drove about 3 miles and then noticed the oil pressure light was blinking intermittently. When I came to a complete stop, it stayed lit. I pulled into a parking lot and starting shutting stuff down. I noticed when I turned the heater blower off, the light went out. Turning it on to High, I noticed the RPMS on the tach dropped to around the 500 mark, and the oil pressure light came back on. I turned it off and let it sit for about 45 minutes. Oil is showing good on the dipstick. I then drove it the last two days without the light coming on.
Now this morning, driving it again in 20* weather, after it sat outside, the light came on again, in almost the exact same place away from home. Both times the motor had reached operating temp, with the temp gauge being in the middle between "C" and "H". This time, even with turning the blower off, it came on every time it was at idle. I let it sit another 45 minutes, but this time when I drove it, the light was more intermittent and then was constant.
Again, the oil level is good on the dipstick, and the motor seems to be running smooth. I'm wondering if this could have anything to do with changing over to a different oil and with it being so cold in the mornings?
I have it written down at home, but I can't remember when I did the actual oil change, but its probably been a little over a month. I went from 5w-20 Pennzoil, to 5w-30; wix filter. I'm planning on doing another oil change tomorrow when I get home and go back to the original 5w-20. Also, I'm ordering a new oil pressure sensor, and I'll try that also. I've also looked into an oil pressure tester....
Ford Escape / Hybrid :: 2012 - Reset Low Tire Pressure Light?
I just put on new winter tires and rims on my 2012 Escape and after driving about 6 miles, the low tire pressure light came on. Is there is a procedure to learn the vehicle to the new tires?
View 6 RepliesFord Escape / Hybrid :: 2006 - Low Pressure Warning Light Flashing On
My friends 2006 Escape has the ( low pressure warning light) flashing on for about 10 seconds after starting the engine. All tires are at correct pressure. What is causing this?
View 5 RepliesFord Escape / Hybrid :: 2008 V6 - ABS And Traction Light
I recently purchased a 2008 ford escape, v6, 2wd. When I bought it, I noticed the ABS light was on, and I got an appointment scheduled to get it fixed, but they couldn't get it looked at for 2 weeks out. Needing a vehicle to drive to and from work, I agreed to schedule the appointment, as I test drove it with the light on with no issues.
Well, after putting about 200 miles on it over the weekend, there are now noticeable issues. First off, the parking brake light decided to come on intermittently, and now it comes on and off spiradicly. Secondly, when I drive the car now, I can hear a clunking noise, followed by the traction control light blinking (It was on constant before), and loss of power. I ended up pinpointing that to being the brakes engaging while the car was driving (I noticed when I stopped, the rotors were really hot. I threw a tiny bit of snow on them and they smoked really bad.
I removed the tires in the front, and checked the tone rings, they both appear to have been replaced recently as they are still shiny as if they were brand new. I also took the ABS sensors out, and wiped them down, they also appear to be new (Although the bolts that hold them on clearly aren't new). I don't have access to a high-level scan tool to get it looked at, and I refuse to drive it anymore to take it to a shop just to have it looked at, what else could be causing the issues? It's highly possible that one of the ABS sensors is bad, but how do I go about checking it without just replacing it? Can I use a voltmeter or something to check it to see if it's getting the correct voltage?
I am not sure how the abs system works, but I know that the traction control light is on because the abs light is on, as they both have the same systems they use, but would that also cause the parking brake light to come on, too ? It originally wasn't on, but just started doing it recently. I checked the fluid level, and it's more than within range. This is my daily driver, and obviously I can't go two weeks without a vehicle, and that's the soonest I can get it into a shop...
Ford Escape / Hybrid :: 2008 - Traction Control Light Came On
I just bought a 2008 Mercury Mariner about a month ago. A couple of times the Traction Control light came on from when I started it, until I turned it off (5-30 minutes.) Then it didn't come on for days. What the problem could be??
View 1 RepliesFord Escape / Hybrid :: 2008 XLT - Anti-Theft System Warning Light Flashes Every 3 Seconds
On my new/used 2008 Escape XLT 2.3L 2WD. It flashes every two seconds, like the manual says. Lower left corner of instrument cluster.
But I don't recall the warning light flashing when I test drove it. But I did push the buttons on the keyfob and various places on the dash/instrument cluster to see what they did...
Is the anti-theft system an on/off affair? If so, how do I turn it off?
Ford Escape / Hybrid :: 2003 V6 - No Key On Prime / Zero Line Pressure
No key on prime. Inertia switch OK. Zero line pressure when filter removed & changed. Tries to start with ether. Front 3 coils are for sure firing. Swapped the pump relay with fan relay, no change, no prime.
I'm working with an 03 factory hard copy manual & I'm just not seeing a testing procedure, but I'm bat blind sometimes. What I'm missing? The patient had run fine all day, stopped for an hour. Got back in, started badly, shook somewhat, died, no start since.
Ford Escape / Hybrid :: 2009 - Tire Pressure Sensor Malfunction Fault
The facts: 2009 4x4 V6 Escape with Valve stem mounted TPMS
I am getting a tire pressure sensor malfunction fault. The warning light is on and the error message is displayed on the little screen in the gauge cluster.
What I have tried: First I should say I have replace to defective sensor twice now...
1) I put the escape in tpms train mode by hitting the hazard switch off/on about 6 times.
2) I used the train tool to train all the tires but there is one that is giving me trouble and will not train.
3) I tried deflating the problem tire and inflating it to the specified pressure given on the be pillar of the escape (30 psig)... after inflating it I tried to retain it with no luck.
4) I tried rotating the tires and as I mentioned earlier I have replaces the problem sensor twice. Still can't can't get the problem tire to train.
My thoughts:
1) I don't think this is a module error because I can train the other tires and since I rotated them I know their position is not a factor.
2) its possible that I have got two defective tpms sensors but I think that is unlikely.
3) I have read of another procedure to put the escape in tpms train mode that requires you to turn the ignition on/off, step on the break pedal, tap your head and rub your belly, etc... but I have not tried this method. Is there a difference from this train mode verse hitting the hazard switch on/off about 6 times?
4) Does the train tool only work on previously trained sensors? do I need to register the new TPMS sensor with the TPMS module? I have an OBDII tool that connects to scanXL software on my laptop which included the ford proprietary protocol. I looked for a way to program a tpms sensor (similar to how I did it with my toyota) but couldn't find the option.
Ford Escape / Hybrid :: Replacing Power Steering Pump Pressure Line
I need to replace my pressure line on my 02 Escape 3.0L. Looking for a DIY for doing this same job?
View 1 RepliesFord Escape / Hybrid :: 2002 - Overdrive Deselect Button Stopped Working
2002 Escape. The over drive deselect button stopped working on my wife's escape. Is their a fuse other than the box under the hood? Transmission was rebuilt not too long aga and has been running fine till the other day.
View 2 RepliesFord Escape / Hybrid :: Keyless Entry Fail And Tire Pressure Sensor Fault
Over the weekend my 2008 Escape Hybrid manifest 2 problems the same day.
1. The remote keyless entry button stopped working (thought it was dead battery in key)
2. Got a error message 'Tire Pressure Sensor Fault'
So after suffering with having to actually unlock my car with a key (heehee/see sarcastic grin) and getting irritated by the error message. I asked the internet about my symptoms. Got the standard answers of "bad tire pressure sensor/reprogram" and change the battery in the key. But ONE and only one person (namely Enviroguy ) said what I thought was going on - that these two problems were related. (afterall it is 2 wireless devices in the car.)
Changing the key fob battery had no effect & Both keys were unresponsive. Seeing what Enviroguy said about certain chargers or wireless devices can cause interference in the tire sensor and keyless systems. .... Then I remember that I had been using a new no-name charger for my cell phone when this problem started.
I unplugged that charger.....(it was a cheap generic power point to USB adapter). The Keyless system is working... ! The tire pressure error has vanished.... !
I did not go to the car appointment.... Now let's hope this was in fact the problem! May my 2008 Ford Escape Hybrid "Be Healed!"
Ford Escape / Hybrid :: 2008 - Loose Brakes - ABS Mod Or MC?
OK so this issue first started in July on way back from Florida the brakes started going to the floor. You did have normal braking power, but you had to about stand on them. Took it to mechanic who cleaned and adjusted brakes, after that they seemed to work fine. Fast forward to a month later, I was going over some train tracks with a somewhat heavy load, I braked when going over them, right after that it seemed the brakes went about half way before braking. I took it back to same mechanic who said it's now either the Master Cylinder, or ABS module. I have found so many conflicting posts on this I'm not sure which way to go. I'd really hate to spend $400 on MC, and then it turns out to be ABS. There is also a swooshing noise when you depress brake.
View 11 RepliesFord Escape / Hybrid :: 2008 V6 - Location Of PCV Valve
My wife drives a 2008 V6, where is the PCV Valve? Pics ????
View 7 RepliesFord Escape / Hybrid :: 2008 - Sputters And Dies
My 08 escape (3.0) wouldn't go over 45-50mph Sunday on my way home. The next morning I made it about 2 blocks and the battery light came on and it died. I am replacing the battery tomorrow because it tested bad but believe there is also an exhaust problem. Last week it began making a noise I could hear inside the car only when accelerating. Almost sounded like a small,air plane. The car will start and run now but cuts out and sometimes will Rev up when I press accelerator and sometimes won't. The exhaust pipe gets hot really fast and it and the motor both vibrate we the car is started (more than normal) any clue on where to start??
View 1 RepliesFord Escape / Hybrid :: 2008 4WD 2.3L - Rattling / Exhaust Leak?
Wife is operating a 08 Escape with about 31K miles on her. She loves the vehicle but since we bought it with 24K miles on it it has had a rattle under it. I assumed that it was the heat shield and i would get around to securing it but haven't yet. Here's the question. I noticed recently that about mid way back under the pass side there is a black spot developing on the concrete where she parks every day. The vehicle does not sit and idle there. Its started and is moving in about 20 every time. I have not got under there yet but was looking for possible answers as to what and where to look? Flex pipe? Bad seal on exhaust? If this is the case should a 31K mile vehicle have this issue? The vehicle is louder than a 2.3L should be but from reading that seems normal. If it is the flex is this something that a novice wrench can do?
View 6 RepliesFord Escape / Hybrid :: 2008 - Tailgate Does Not Work Correctly
My ford escape tailgate switch stopped working, the glass worked fine and opened with the switch. I ruled out the fuse as both I believe work off the same fuse. I removed the back panel to access the mechanism and found that, I could get the tailgate to work if I disconnected the wire from the glass tailgate switch and as the wire connector (shown In picture) was reinserted it would energize the tailgate switch and I am able to open the tailgate. What the actual problem is. I initially thought that it could be the tailgate switch itself but having seen what is happening I really am at a loss to what is the problem....
View 1 RepliesFord Escape / Hybrid :: 2008 - Flat Spots On Tire
So I have a 2008 escape 4wd.... I am getting a few flat spots on the inside passenger rear tire... So I figured it was the shocks so I unbolted both and cycled them and they both felt the same... There was dampening you can feel the oil going through the valves or whatever... I have felt completely bad shocks before and it was just a smooth motion when cycling the shocks... Can it still feel like there good but there not? The thing has 85k on it and I'm not sure if they have ever been replaced before..
View 6 RepliesFord Escape / Hybrid :: 2008 - A/C Blows Air Only From Primary Vents?
I have a 2008 Ford Escape XLS (4 cylinder) that currently is having an issue with the AC system. It blows the air at the correct temp but it only comes out of the primary vents. If i select defroster or floor vents, it doesn't switch over to those. What specifically should I be looking at to fix it.
View 8 Replies