Ford F-150 - 1997-2003 :: Blower Motor Resistor Location
I'm looking for information and possible photo location for the blower motor resistor. My truck has climate control. I've looked under the dash on the passenger side and behind the glove box door and I've been unable to spot the location. Do I have to remove the plastic panel behind the glove box?
View 6 RepliesFord A/C :: 2006 F350 - Location Of Blower Motor Speed Resistor?
I have google it looked all over was told it was under the hood next to the fan even shown a photo when I went under the hood right were the resistor was in the photo there was a long black box about 4 inches long and 2 inches wide. looked nothing like the photo.
So I went back on line and read that its above the passengers feet you take a few screws off after you take the glove box off and it should be there. Well after taking 8 screws off I find nothing but a coil behind there. Nothing that looked like a resistor.
2006 f350 diesel?
Tiguan :: Blower Motor Resistor Location
Where blower resistor is located?
View 6 RepliesFord Escape / Hybrid :: 2010 - HVAC Blower Motor Only Seems To Be Working On 3 And 4 Position?
Blower motor only seems to be working on the 3 & 4 position? Resistor bad? What is the location?
View 1 RepliesFord Escape / Hybrid :: 2006 - Fuse 26 Keeps Blowing / HVAC Blower Motor Turned Off
I have a 06 Mercury Mariner and this past week fuse #26 keeps blowing turning the HVAC blower motor off. I replaced the blower motor since i had one already in the garage and same thing is happening. The AC will run for awhile and in about 10/15 mins the fuse will blow. Fuse #26 is the Climate control system mode switch, are these known to go bad? Is this the part I should replace or look for other problems IE compressor?
View 2 RepliesFord Escape / Hybrid :: 2005 - No Heat From Blower Below 30 MPH
I have a 2005 Escape Hybrid. Last summer, the A/C went out, so when in the fall I finally got around to having the cooling system flushed. Did the trick, and A/C works fine. Now that winter's come along, I've noticed an issue with the heat. All fan speeds work correctly, and the dash controls for heat and cold work properly. But what's odd is that I get plenty of heat when the vehicle is at speed, above about 30 mph. As soon as I slow down below that, or hit a red light, there's no heat. The blower just blows cold air until I am back up at speed again.
View 9 RepliesFord - Escape :: 2010 - Location Of Fan Speed Resistor?
2010 Ford Escape Fan Speed Resistor Location? I've seen videos for 2001-2004 and 2008. They do not apply to 2010. The resistor board location has moved since 2008.
It used to be just inboard of the cabin fan motor. They were so close that If you wanted to pull the motor, you needed to unplug the wire harness from the resistor board as well as the motor.
Where is the cabin fan resistor card located for the '10 Escape, pray tell?
Ford Escape / Hybrid :: 2005 V6 - Checking Lubricant - Transfer Case Location?
I have an 05 Escape XLT 4WD worth 3.0L V6. My HAYNES says the transfer case lubricant should be checked every 15k - I bought it with 75k and it has 107k now and I have never checked it. I am wondering if it is common practice to do this every 15k? The transfer case is then one next to the oil pan? The book has one photo.
View 1 RepliesFord F-150 (2009-2014) :: Blower Motor Resistor Overheating
Have a 2009 platinum, 5.4, supercrew with dualzone heating and air. The blower motor resistor block is overheating and melting the connector block. fooled with it way too much, and then put a new resistor and pigtail in it. The new resistor would kick out in about 30 seconds, so used the old resistor on the new pigtail, got hot, melted the new pigtail. What is causing the resistor block to get so hot, and what do I do about it?
View 7 RepliesFord A/C :: After Changing Resistor Blower Motor Started Smoking?
I parked my 2003 f150 about 8wks ago, and at that time the blower had been running only on high then not at all, then only on high again.
As I need it to pull the boat up north next week, I purchased and changed the resistor. When I started it up the blower motor wouldn't run and eventually it started to smoke, so I pulled the wire connector to the motor.
Where I can find a procedure for motor testing, and removal as I think this is probably where I'm headed with this. There seems to be utube videos on everything else but not this. I may just have to go out and purchase a Hains or Chilton manual but I'm Scottish and always look for the free route first.
Ford Ranger / B-Series :: 1997 - Heater Blower Motor Resistor Rusted
I am not great with electrical but can manage. Here's the deal, Ihave a 1997 ford ranger 2wd 2.3L 5spd with a/c 233,000 miles i just replaced the heater blower motor resistor as the old one was rusted bad as was the pig tail going to it bad that one of the terminals broke off and was rusted in the harness so i replaced the plug as well problem is i still have no fan if i jump it it works but have no power at the plug for resistor or motor and no power at the switch inside the truck I do have power to one terminal where the relay plugs in, where to look next?
View 14 RepliesFord Ranger / B-Series :: New Heater Core / Blower Motor And Resistor Still No Heat?
with a new heater core, new blower motor, and new resistor and no heat, what would be the problem? gonna check the thermostat tomorrow.
View 2 RepliesFord Super Duty (1999-2016) :: 2009 F250 - Dual Climate Blower Resistor Location?
My blower works half of the time...from what I have researched it is more than likely the resistor. The thing is I can't find it..all the videos and pictures looks like they are the **** control control. Where this is located for the dual climate control?
View 3 RepliesAlero :: 2000 - Blower Motor Resistor Replaced
2000 Alero. Wife reported to me she had no blower motor. I pulled the motor and it tested good. Next I replaced the resistor with one from auto zone. Now I have blower in all but the 5th and highest position. I suspect a bad new resistor but I left it for now because it's a pain to remove.
Could I have got a bad resistor? In my experience a bad resistor will give you high and nothing else.
Ford F-150 (2009-2014) :: Blower Motor Resistor Replaced - Fan Completely Shuts Down On High Speed
I replaced the blower motor resistor on a 2010 F150 with dual climate control where the blower was stuck on high.
After replacing the resistor, now the lower speeds work fine, but when placed on high speed, the fan completely shuts down. Replace with the old resistor, and it only runs on high.
How to proceed, or what else might be the problem?
Yaris/Scion & Vitz :: Low Fan Speeds Do Not Work / Blower Resistor Location
Where the blower resistor is? I ordered one with the advice of the parts department but I do not know where it is located. I'm going to check under the glove compartment because I couldn't find it in the compartment in front of the gear shift and under the radio.
Symptom on 2000 Toyota Echo: Low fan speeds do not work. Only high speed works.
Grand Prix :: Are Resistor And Blower Motor Close Enough To Cause Leakage?
I have a 2004 pontiac grand prix gt. I read some where that some of these have the resistor and blower motor close together and that the molding or rubber that runs at the bottom of the windshield after time will leak water into the blower motor and resistor and cause a short. I believe this has been the cause of a lot of my issues with car shorting out. the other day had to have it towed for the first time in its 11 years and found out it was one of the j fuses arcing causing the car not to start.
It's already 267,000 miles.
Engines - Astro - Chevrolet - Heating :: Blower Motor - Two Resistor Plug Wires (orange And Black) Burnt
I replaced the blower motor and the resistor. I just replaced the resistor again only after only a couple weeks. I noticed that two resistor plug wires (orange and black) were burnt. what can be done to fit this problem.
View 1 RepliesFord Aerostar :: 1997 - Location Of Blower Fan Motor Relay?
I'm having some trouble with the front blower fan on my 97 Aerostar 3.0, it will only intermittently work, one time we had it running, lifted up the hood on the van, checked the connection to the motor, looked good, dropped the hood and the fan immediately started working again, I'm wonder if the relay might be starting to go bad, the fan in the back works, so I'm not sure. Where the relay is for the blower motor, or what might be wrong?
View 6 Replies