Ford Brakes/Suspension :: 2008 F250 - Steering Stabilizer Replacement?

Looking to replace the steering stabilizer on my 2008 F-250. It has a 6" lift and 37" tires.

Also, does "dual" mean better?

View 3 Replies

Ford Brakes/Suspension :: 1997 F250 - Power Steering Jerks To Left Or Right

My 97F250, 7.3 diesel, 4WD has an intermittent steering issue. When I come out of a turn, it doesn't want to come out of the turn all the way. It will keep pulling one way, and I have to jerk the steering wheel in opposite direction, and sometimes the truck then over corrects quickly the other direction. Mechanic said front end looks good, so he replace the power steering pump. That didn't work...

View 4 Replies

Ford Brakes/Suspension :: 1991 F250 - Hard Turning Steering Wheel To Right

I have a 1991 F250 Lariat, 4x4, 460 engine, auto trans. I am having trouble with my steering. The power stering turns good to the left but when I turn to the right it is like there is no power and is very tough to turn.

View 1 Replies

Ford Brakes/Suspension :: 2010 F250 - Steering Wheel Gradually Works Itself Off-Center

I have a 2010 F250 King Ranch FX4. I have an odd problem that I am trying to get to the bottom of. We went on a 2,500 mile road trip last year and I noticed on the way home my steering wheel had worked it's way off center counter-clockwise at a perfect diagonal. I had gotten an alignment right before we left and it was perfect center at that point.

I took it back in when I got home and had a tire rotation and another alignment. Within a week the wheel was off again to the same degree, counter-clockwise at a perfect diagonal.

Two weeks ago... tired and annoyed of driving like this, I crawled under the truck and adjusted the steering wheel to center via the drag link adjustment. I tightened everything down tight and this lasted all of three days.

Wat would cause this? Tires are wearing normally, alignment checks out and it tracks straight. I do see some grease like leakage where the pitman arm meets the top of the drag link and again have some small grease where the drag link connect to the passenger side tire. I lifted the front end and tried to move/wiggle the tires and I have no movement... everything is solid. The truck never wanders when on the road... steering wheel is just off.

Truck only has 90k on it of highway miles and an easy life thus far. I am not hard on the truck.

View 1 Replies

Ford Brakes/Suspension :: 2000 F250 - When Brake Applied Rear End Starts Jumping And Bucking?

I have a 2000 F250 PSD. When applying the brakes, the rear end starts jumping and bucking. The effect is exaggerated when pulling a trailer and applying the truck brakes to stop. The problem does not occur when manually applying the trailer brakes. It was suggested to me that this problem is caused by a hydro boost leak.

View 3 Replies

Corolla / Matrix 2009-13 :: Steering Feels Extremely Loose

The steering in my '12 feels extremely loose, at highway speeds just a minor twitch on the steering wheel sends me right or left.

View 4 Replies

Ford Brakes/Suspension :: 1994 F250 - Blown Brake Line / No Brakes At All?

I have a 1994 F-250 4x4 w/manual transmission. I was driving a few days ago when the brake pedal suddenly went to the floor. I had almost no brakes (less than 10% at most), but luckily was able to get off the road safely. It was immediately apparent that the line connecting the T-fitting and the passenger side drum had broken.

I have never blown a brake line before, but I always assumed that you would have either front or rear brakes, depending on which line blew. Unfortunately I was wrong! The master cylinder reservoir was about 3/4 full when I initially checked it, but after I moved (slowly) the truck to a safer spot in the parking lot, I checked again and it was nearly empty.

Is my brake system behaving normally (no brakes front or rear, blown line completely empties the reservoir), or should there be some safety factor built in? If the system is operating correctly, is there any way to convert to a system that doesn't give out fully when a line is blown?

View 14 Replies

Ford Brakes/Suspension :: 1995 F250 Truck Does Not Stop Fast Enough When Hit The Brakes

My truck sat for 4 years. 1995 F-250. We needed to replace the brake lines. when you hit the brakes the truck does stop but not fast enough and it will not pass inspection this way. So far I've replaced

1. All the brake lines
2. Calipers
3. Brakes all around
4.RABS module
5. Master cylinder
6. Wheel cylinders

Pretty much everything but the brake booster. Lines were bled several times. The brakes still go to the floor. Anything else that I haven't tried? I want my truck back!

View 4 Replies

Ford Brakes/Suspension :: 2005 F250 Front Brakes Calipers Are Locking Up

I have a 2005 F250 & both front calipers are locking up. I have replaced the front pads, no change, my mechanic installed a new master cylinder. No lockup for about two weeks until today. Front calibers are locking up again.

View 1 Replies

Ford Brakes/Suspension :: 1997 F250 - Hard Pedal / No Brakes Intermittently

I have a 97 F250 that is having reoccurring brake issues, It has an intermittent hard pedal with little to no brakes when it occurs. It will stop but you are standing on the pedal with both feet. I have replaced the booster, master cylinder, and the vacuum pump in the past trying to isolate the issue and still had the problem. On this year model the abs ids only on the rear correct???? if it is shouldn't it only be affecting the rear brakes? Since this truck has a dual reservoir MC the front should still work?

View 4 Replies

Ford Brakes/Suspension :: 2003 F250 - Brakes Pedal Pulsed A Bit

If this was my car or older truck I would know what the deal was. First hill I came down in my recently bought 2003 F250 the pedal pulsed a bit as I tried to slow down...is this the way ABS brakes behave? Never had them on a truck before...she stopped ok but don't know if they are warped or normal ...I'll pull wheels later (not a daily driver)...

View 7 Replies

Ford Brakes/Suspension :: 2003 F250 - Brakes Are Spongy Or Go To Floor

Brake issues 2003 f250 super duty 6.0. Changed master cylinder, drivers side rear brake hose, new pads all around. Pedal is good at times for a few seconds. I've bled them all numerous times truck running or not flushed power steering pump new fluid. Brakes are spongy or go to floor. Do I need a scanner?

View 2 Replies

Ford Brakes/Suspension :: 1999 F250 V10 - Transmission Not Shifting Correctly / Brakes Locking Up

I have a 1999 f250 super duty, that was wrecked a few months ago. I have put the truck back together with the mechanic. The front drivers side was wrecked. The power steering fluid tank was cracked and had to be replaced. Also had problems with a box behind the drivers headlight? I did hard wire it together and it fixed the problems i was having the the speedometer and the transmission not shifting correctly.

Everything is put back together now but I drove it today and the brakes locked down after driving it a few miles? Had to push the truck hard to get it back to my house, a mile or so. If i let off the gas it would come to a quick stop. It is ALL four brakes locking up. If it sits for awhile they unlock but will lock up again after driving. The truck is lifted and the ABS light has come on.

It was not on before but i am pretty sure the ABS is disabled on the truck. the wires are hanging down by each tire. This is how they truck was when i bought it. Not sure what is causing the brakes to lock up.

View 1 Replies

Ford Brakes/Suspension :: 2003 - Lost All Power Brakes / Steering?

Yesterday while driving, i lost all power steering and power brakes (you would automatically think Booster). I pulled over, popped the hood and fluid was spewing from behind the power steering pump somewhere. I limped the truck home about 20 miles. I checked brake fluid and it was full. checked power steering fluid and it appeared to be empty. Yet when i added fluid it took less than a half quart. I started the vehicle to pressurize the pump and find the leak. Yet the pump never pumped any fluid. (one would thing pump was out) I am baffled as to if the pump went out, why fluid loss? If the booster was out, why do i still have brakes just without power assist? Andif a hose is blown, why such small fluid loss? I dont want to just start replacing parts till it get the right one

View 1 Replies

Ford Brakes/Suspension :: 2006 F250 - Rattling After Doing Brakes / Emergency Brake And Rear Wheel Bearings

Before I get started... My truck is a 2006 F-250 Super Duty XLT 6-speed 4x4 with a Limited Slip.

I just got finished with a big job on my truck. New pads all the way around, turned rotors, new emergency brake shoes, hardware, and backing plate as well as replaced the rear wheel bearings both inner and outer as well as the axle o-ring and inner seal. Also, took off the rear pumpkin cover painted it and put fresh fluid in, went with Mobil 1 75W140 LS.

Took it for a drive and the brakes work great. Followed the directions for breaking in the emergency brake which worked fine.

Now the problem is I'm getting rattling from possibly all of the wheels. Definitely from the front driver and at least one of the rear wheels. It was so dark I didn't get a chance to look at it I just pulled it back in driveway.

I'll start looking at things tomorrow but, any common mistakes or things I should check first?

View 1 Replies

Ford Super Duty (1999-2016) :: Play In Steering Wheel / Loose Front End Suspension Parts

I have a '99 F250 w/ PSD with 165k miles.

When I drive, I move the steering wheel and nothing happens for the first few degrees of turn and then I encounter resistence and it turns. It's the same either way. The vehicle seems to track nicely, doesn't pull to either side, just a lot of slop in the steering wheel.

Is there a way to determine if this is really steering related or is it just loose/worn front end suspension parts making themselves known? My guess is suspension items, but the fact the front end behaves itself when the truck is moving has me doubting that just a bit.

View 5 Replies

Tiguan :: 2016 - Loose Steering / Braking And Suspension

2016 tiguan sel. To make a long story short I drove a '14 r line and was told the '16 SEL would drive the same because they changed the trim lineup. The Sel has a noticeably more loose steering, braking, and suspension. It also doesn't hold revs the same. My sales person was an idiot and I couldn't drive model I bought because they had lost the keys and it was the only one they had.

View 2 Replies

Ford Super Duty (1999-2016) :: 2000 - Extremely Hard Ride - Steering Wheel Jerky Over Bump?

I'm completely aware a lifted truck will not ride factory and most likely ride harder. But this is ridiculous.

So I bought a 8" super lift for my F250 7.3 2000, although the price is very cheap at that shipped to my door debating if I have messed up either with the brand or somewhere because I feel like I went from a casual ride in my lovely 7.3 to feeling like a horse carriage of a few century's ago.

Lift is setup with lift leaf springs in the front, one add a leaf in the rear with a block, and 4 new shocks and all the other hardware included to do the lift.

I'm wondering if it's possible the springs are installed wrong, or the shocks are just that bad or if there a weird issue I've over looked.

Tire pressure is set to 35-40 psi all around on toyo open country mts, (which I was running before the lift so that hasn't changed) but I mean this is so stiff that when I hit a bump my steering wheel jerks and I feel like my suspension has absolutely no flex in it. Debating on returning to stock or not at this point...

View 13 Replies

Ford Brakes/Suspension :: Tightening Steering Box

I am trying to adjust the steering box since it is so sloppy. I know there is a set screw with a torque head on top of it but I can't get the nut to loosen. Is there any way to do this. I've drenched it with a product we use called Rusty which is a rust penitrant and a solvent. Works real well to get the rusted screws to loosen but this thing isn't budging!

View 7 Replies