Ford Super Duty (1999-2016) :: Slight Wobble After Hitting A Bump In The Road
I purchased the truck from a used car lot about 3 months ago and after driving for a few thousand miles I am feeling a slight wobble after hitting a bump in the road. Here is my truck set up:
- 2011 Ford Lariat F250 4X4 FX4 6.7 ltr
- 67400 miles
- Tires stock and great tread
- Rancho steering stabilizer kit
- Rancho Shocks
- Rear air bags
It does appear one of the rancho stabilizer dampers is leaking slightly. Why would the previous owner install a rancho stabilizer kit? Is it because of the rear air bags?
Ford Aerostar :: Cabin Hatch Removal
Is there something else hold the cabin hatch (doghouse) in place? I've unsnapped 3 latches but it still refuses to come loose.
View 2 RepliesFord Super Duty (1999-2016) :: F350 4x4 Death Wobble Felling Even Around Slight Bends In The Road
I put new ball joints on a few months ago and now the truck is starting the death wobbles felling even around slight bends in the road.I jacked it up and the passenger side tire will move 1" side to side scarey.Not sure what I need to replace.
View 9 RepliesPhaeton :: Slight Wheel Wobble At High Speed
Ive had my new Phaeton just over three weeks and have ha to take it back to the dealer with a slight wheel wobble at high speed, I gather the geometry on these is quite complex and the alignment is usually done on all four wheels. Interestingly however the dealer diagnosis is for four new tyres, obviously this is under warranty, but it seems strange to have to fit four new tyres on a brand new car!
View 6 RepliesFord Aerostar :: 1992 - AC Hoses Block Radiator Removal
On my 92 Aero 4.0L with A/C, I need to replace the radiator but I am not sure how to move the A/C hoses out of the way to extract the shroud and the radiator.
I have viewed a video where a guy said to remove the serpentine belt and then unbolt the A/C compressor and move the compressor and hoses out of the way. Hope this means that I don't have to discharge or disconnect AC hoses. Not good for me.....
Well, the video instruction seems simple enough......but there doesn't appear to be enough "play" in the AC hoses to move them far enough to extract the radiator, and not being an AC guy (and the potential danger of releasing freon), I am at a loss.
How to move the AC hoses out of the way (without disconnecting the hoses or discharging the system) ....
Not to mention it would be great to find out what the torque specification is for tightening the AC compressor bolts for proper reassembly. And being the backyard mechanic I am, any drawings, details or diagrams that you can provide would be very useful.
BTW, I have looked in the forum for radiator removal information and none of the threads I read addressed moving the AC hoses (which of course run right over the top of the dang radiator).
If I get past these "hoses" I will also take advantage of the radiator removal to replace the fan and fan clutch and thermostat while I am there, but first things first, if you know what I mean.
Celica :: 1995 Toyota GT - Crankshaft Pulley Have A Slight Wobble
I have a 95 Toyota Celica GT which started making a noise today. It does not seem to increase when the engine is revved. The crankshaft pulley seems to have a slight wobble, belt feels tight, does not appear worn. Does not matter if AC is on or off. No performance issues. I'm thinking harmonic balancer replacement.
View 1 RepliesFord Aerostar :: Gas Fumes Smell When AC Running
AC recharge seemed to be when problem started. But... If I do NOT run the AC unit and drive it with VENT open there seems to be no smell. When I run the AC the smell appears. Since the AC system is supposed to be(I think) a closed under pressure system why would I get a gas smell ONLY when the AC is running? Starting /stopping it gets a bit worse. Baffled here but that's nothing new...
View 2 RepliesFord Aerostar :: 1989 - After New Radiator Running Hot?
Aero, 3.0 Shorty 1989
put a new radiator in my truck, as the original one finally had a small crack.. (I've kept it, since it is brass or copper!)
I put a new 192 T-stat in there too, (OEM temp)
but, now it seems that the van is running hotter than it did before!
when I had the original rad in there, it would never get above the R in the Normal word... now it runs at about M (high middle)
Also, when I tryed to burp it, I'd top it off, but then it would put the extra in the overflow tank, and only stays full up to the very bottom of the filler neck.
this is a plastic radiator... is that what the difference is?
I used to be able to top off the old tank, and it would be right at the top whenever I opened the cap... not so with this one>?
wondering if I should go down to like a 180 degree t-stat? gauge still stays normal - but if it's correct, it's about 50 degress difference.
Ford Aerostar :: 1988 - Clutch Feel Grabby / Some Sludge Accumulation Between Trans And Engine
I've got an oddball '88 SWB with the M5OD transmission. Since I've had it (about a year now), its always required a lot of gas to get it rolling without it stalling after sitting overnight or during the day at work, especially putting it in reverse for the first time. The shifts have always been a little choppy/jerky/grabby/whatever you want to call it, too. Mostly going into first from a stop, but you can feel it other gears too, especially if you're not flooring it.
Anyway, it seems to have gotten worse and I'm getting to the point where I'm looking at a cause. One thought I had was oil contamination on the clutch discs, I know this will make a clutch feel "grabby". There is some sludge accumulation between the trans and engine, and it appears I may have a very slow leak there.
I have to change the trans fluid this weekend and am wondering if there's anything I should inspect while I'm at it -- I don't know a whole lot about the clutch system on this van and there's next to no information on it. Frankly, I don't even know if its hydraulic or cable.
Ford Aerostar :: 1991 - Running Rough / Very Low Vacuum
1991 aerostar 4.0 ... My van was running well til last week.it allegedly has 77000 miles on it. It started running really rough within a 50 mile period. I've quit driving it til I am sure. I am not harming it. I put a vacuum gauge on it. It wildly fluctuates between 3 and 7 pounds at idle. I've tried plugging the four vacuum lines one at a time to eliminate the accessories as the problem.the check engine light is off and my scan tool shows no codes.i unhooked the exhaust at the manifolds to make sure the cats aren't clogged.it doesn't have egr. There's no water in the oil or bubbles in the radiator.i have a compression tester but id like to avoid trying to get to the plugs unless necessary.
View 5 RepliesFord Aerostar :: Running With AWD Unplugged Increase Fuel Mileage?
Winter is over and summer is here. Will running with the AWD module unplugged increase fuel mileage? Will it do any harm to the drivetrain? (Assume matched tires, good alignment and suspension).
Signed, Looking to squeeze a buck anyway I can.
Ford 7.3L Power Stroke (1999-2003) :: Doing Clutch - Slave Cylinder Removal
I'm getting ready to swap my clutch and got to looking at the slave cylinder. I read somewhere that you have to rotate and twist it to get it out? Or something else? Also after reinstalling how do you get the slave plastic piece cut that holds the rod in? Or do you just push the clutch?
View 4 RepliesFord Aerostar :: 1990 4.0 Liter - Running Rough / Exhaust Smells Like Gas And Has A Misfire
1990 Ford Aerostar. When I start runs really rough and has excessive fuel consumption and the exhaust smells like gas and has a misfire my friend says its the coil pack going bad im not sure. I love my ford aerostar dont wanna get rid of it.
View 5 RepliesFord Aerostar :: 1995 - Engine Running Without Coolant / Head Gaskets Are Blown
I have a 1995 aero with 4 wheel drive and a 4 liter. Lent it out and the engine was run without coolant. Pretty sure the head gaskets are blown. I found a replacement 4 liter from a 92 explorer and wondered if it would swap in. Will the bolt pattern match, computer, mounts,etc?
View 5 RepliesFord Transmission :: 1997 F150 4x4 V8 Skidding / Clutch Is Not Holding At Times When Shifting Up Or Down While On Cruise And Slight Hills
This is an Auto/4z4/4.6 V-8. It's Skidding or a Clutch is not holding at times when shifting up or down while on Cruise and slight hills.
someone suggested changing oil and filter about two years ago. I did that and it didn't change a thing. $145 that time.
I'd like to know if its the clutch in the torque converter, or the Transmission? If I have to change something out, should I get both?
Tiguan :: Slight Slippage From The Clutch
Just installed APR stage 1 software around 1000 miles ago. The power increase is great, though the last couple days i noticed a slight like slippage from the clutch. I dont do any burnouts. Just open it up,( full thottle) here and there. Always let the car reach operating temp before i start driving. I am afraid that the stock clutch is going to go on me. By the way the car only has 2600 miles on the odo...
View 3 RepliesFord A/C :: Clutch Does Not Engage And Compressor Is Not Running
So clutch doesn't engage and compressor is not running. I have 12-13v at the low pressure switch and the same at the high. When I jump the low pressure I don't get any voltage at all at the plug that controls the relay for the clutch.
Where I'm confused is:
Is this a low pressure problem - gauge is reading 60psi on the accumulator
Or
Is this electrical somewhere?
Ford 6.7L Power Stroke Diesel :: Slight Hissing Noise From Dash When Running A/C
I already have my suspicions, since my wife's GMC did the same exact thing a few months ago. I hear a slight hissing noise from my dash, when running my A/C. I took the system off AUTO, to see if it was caused by the automated venting system, but it kept doing it. I have noticed it the past week, and its becoming a little more pronounced. System still blows cold. It does seem that it takes the truck longer to get cool in the afternoons lately, but it might be due to it being so hot lately.
My wife's car did the same thing and blew cold air for a while....until the hissing became constant and very loud. Turned out, she had a leak from one of the hoses. Dealer replaced it, and find ever since. I'm thinking my system has likely developed a leak and has reduced system refrigerant pressure. Any other possibilities?
Ford Transmission :: No Clutch / Truck Will Not Engage A Gear While Running
I have a 2001 m5r2 ford f-150 standard transmission. i have replaced the slave cyl., the entire clutch assy., the master cyl. pilot bearing. the trans. will engage all five gears plus reverse while truck is off but will not engage a gear while running. i have bled and bled and bled and still will not engage.
View 1 Replies