Ford Aerostar :: Water Temp Reading Too High
The water temperature in my 97 3 liter Aerostar seems to be higher than I would expect when climbing a mountain road with the aircon on full. It was only about 75 degrees F and the elevation went from 300 feet up to 2,400 and the gauge was at 3/4 to the red zone.
I don't use aircon much here in the south Bay Area but as I recall the gauge on both my 96 and 97 Aeros was straight up during such climbs. The 96 is out of coolent so I can't compare it now.
The reason I'm rather concerned is we are about to leave on a 2,500 mile road trip with 4 people and lots of gear through Nevada and Utah and we'll climb a lot of passes in 90 degree heat or higher.
The mileage is about 135k and the water pump was replaced about 2 years ago. The radiator was replaced at about 100k.
Ford F-150 - 1997-2003 :: 2000 V8 - Location Of Coolant Temp Sensor?
Where exactly is the coolant temp sensor located on a 2000 F-150 4.6 V-8.
View 5 RepliesFord Super Duty (1999-2016) :: 2011 - Temp Sensor Location?
I need a replacement driver side door, towing mirror for a 2011 Ford F250 SuperDuty with turn signal, heated, electrically adjustable manual-extend and manual fold options. The truck VIN number is 1FT7X2B67BEC96261. The truck also has an Outside-Air-Temperature indication which is what I'm not sure about. It is my understanding that the Outside-Air-Temperature sensor may be in the side mirror. Looking for any info on the temperature sensor located on this truck? I found an aftermarket mirror while I can not afford Ford. However, the aftermarket mirror ad says it does not have Outside-Air-Temperature and I would like to keep that working.
View 1 RepliesPhaeton :: Outside Air Temp Sensor Location?
Where is the ambiant outside air temp sensor located on the Phaeton? I know it is located under the outside left or right mirror (based on model year) on a Volvo but not sure where it is on the Phaeton. No problems, just curious.
View 6 RepliesPassat (B6) :: Outside Air Temp Sensor Location
Where it is?? Body shop didn't connect it after repairing my bumper and I would rather not have to take it off again..
View 3 RepliesPassat (B5) :: Location Of Coolant Temp Sensor?
Where is the coolant temp sensor on a 1.8t passat 04? I did a search but cant find any diagram
View 1 RepliesGolf IV / Jetta IV :: Location Of Air Temp Sensor?
I dont see anything attached to the manifold....
View 10 RepliesFord Super Duty (1999-2016) :: 2002 F250 - Trans Temp Sensor Location
I have noticed my trans temp gauge needle is dead center of the gauge even on a cold start. I thought my sensor was under the pan so I pulled it and did not see any sensor at all. Is there a external sensor?
View 5 RepliesCamry 2012+ :: Transmission Temp Sensor Location?
Where the transmission temperature sensor is on a 2014 Camry 4 cylinder. I am contemplating unplugging it to improve shift points. I know it may affect gas mileage but the current shift points suck.
View 2 RepliesGTI 337/20th Anniversary :: Location Of Outdoor Temp Sensor
Where it's located i heard passenger side behind front bumper. i just looked for about 30 min can't locate it. Reason being is when i check the outdoor temp i get ---F so either it fell off or it's bad lol if someone can post a quick pic ....
View 8 RepliesGolf IV / Jetta IV :: 2002 - Ambient Temp Sensor Location?
Where the ambient temp sensor is located on my 02 Golf 2.0.
View 5 RepliesAccent MC (2006-11) :: 2008 - Coolant Temp Sensor Location?
Where the ECT sensor is located? I would really like to have a diagram of the engine. Where I can find an engine diagram for a 2008 accent gls?
View 3 RepliesFord Ranger / B-Series :: Water Temp Sensor Leaking / Missing Vacuum Hose
Was fixing leaking water temp sensor today and noticed the nipple under oil fill cap didn't have hose on it. After further investigation I found open spot on air intake hose with nothing in it. Both places seem to have vacuum, what goes here. BTW it is a 1999 Ranger ext cab with 3.0 flex engine and auto trans. Will try to get picture n post also...
View 8 RepliesCamry :: 2008 SE Heating - Replaced The Water Pump And The Temp Sensor
I have a 2008 Camry SE with about 118K miles
I have replaced the Water pump and the temp sensor recently.
The problem is when you turn the thermostat control to hot on the HVAC dial only warm air blows and it is only warm when the engine is revved or going down the road.
My question is: Is the door on these electronically controlled or vacuum controlled? it is like the blend door gets stuck and is not closing fully or something.
Ford Aerostar :: 1992 Won't Start / No Spark
I have a 1992 Aerostar with a 3.0L engine. For the past few weeks she intermittently didn't want to start but eventually always did. I replaced the fuel pump relay because she always have had problems with that. The relays are loose and get wet. Anyway, I thought i fixed it because I didn't have any problems for about 2 weeks. But one day didn't want to start again. She finally started and took her home.
Now, no matter what she wont start. I did some tests and there is gas been pumped but I don't have a spark. I put a new ignition coil and a new ignition module and still no spark. If im right, i only have 2 things left that could be the culprit, the profile ignition pickup, and/or the computer. Is there any other reason that could be the problem? I read online that in order to replace the PIP i have to take apart the distributor. Is this true?
Ford Aerostar :: 1992 2WD Keeps Cutting Out Like It Is Not Getting Fuel
My 1992 AeroStar 3.0L 2WD keeps cutting out like it's not getting fuel BUT...only after around 55 mph and after it warms up.
I first thought it was the fuel pump so I changed it. I didn't get a whole sending unit along with pump, I just dropped the tank and changed the pump...that didn't do the trick. Then I checked the fuel filter along the bottom rail and it's very clear flowing. Then I thought it might be the fuel pressure regulator. Ok, how many of you have changed the fuel pressure regulator? Man it was tough! I had to grind down an allen wrench to get room to turn those three allen bolts AND I replaced it while I was stranded on the side of the road!
Well, replacing that regulator didn't work either. I don't know where to go from here. It totally cuts out at higher speeds when it's warmed up. Could it be the oxygen sensor? It can't be the plugs. I don't think it can be the sending unit in the tank even though I changed its pump. Is there another fuel filter somewhere? I'm moving to another town and I have to get the van there.
Ford Aerostar :: 1992 - No Start - ECM Died?
Picked up another 92 extended! Seller's mechanic thought ECM died. When you connect the battery, the fuel pump runs, steady. 167K, same as my DD van! Plans are to pull the trans and swap tires first, and eventually pull the motor and freshen the seals and gaskets, and a timing chain. I would like to have it run first though. I'll take pics after it's hauled home.
View 3 RepliesFord Aerostar :: 1992 - Serpentine Belt Shredded
I was driving the other day (cold weather- approx 15 F), and my serpentine belt shredded. Managed to drive a mile or so to my driveway. The belt was shredded on the fan side (and had come completely off), but it wasn't torn in two. Got a new belt and installed it, but upon test-cranking, found that it was riding up one ridge on the crank. All the other ribbed pulleys were fine (PS, AC). The smooth pulleys had the belt move a little, however.
Thinking I didn't set it right, I reinstalled the belt on the crank and tried again. Same result (belt rides up one groove, towards the fan). I perused the archives, and one comment was that someone simply trimmed one groove off the belt and everything was happy. The belt found it's "groove", and didn't act up anymore. Doesn't fix the underlying problem, but
1) is this a good fix
2) any clue what is going on?
3) Do I need to get the crank fixed?
BTW, I am sure that I threaded the belt on correctly!
1992 Aerostar, 4.0L, AWD. AC+P/S....
Ford Aerostar :: 1992 - Model Of Transfer Case?
So long story short I have a 92 Aerostar AWD which I'm pretty sure had the transfer case recall done (97V204000 1992 FORD AEROSTAR Recalls) it has the aluminum driveshaft but a couple of years ago the transfer case cracked and I replaced it with a "New OEM" transfer case off eBay. Fast forward to the present and my van has a strong vibration at 60+ my transmission guy says it all looks good so the vibration has to be from one of the driveshafts. My thought is that I may have got a transfer case without the recall done on it and its warped my driveshaft. I don't really know thats possible or what I could do about it if that was the case.
View 8 Replies