Ford Aerostar :: 1992 - Transmission Slipping After Few Minutes Of Driving?

I have a 92' Areostar XL 3.0 2WD. When I first start it and put it in drive it takes a few minutes before it kicks in. After a few minutes of driving it doesn't have a really bad problem (only a few times has it slipped in lower gears.) I was told it could be a clogged transmission filter, old transmission fluid that is glummed up, or pull belts need to be tightened. I have the van up on jacks now and was getting ready to change the filter and fluid but I decided to get some advise first before I screw things up or do any unnecessary work.

View 14 Replies

Ford Aerostar :: 1992 - Transmission Goes Out Of Gear When Accelerate To Downshift In OD

I searched a lot but did not find these symptoms on my 1992 Aerostar 3.0 2WD with A4LD transmission.

In overdrive, accelerate to down shift, and the transmission goes out of gear. Engine revs as if it was taken out of gear. Manually shift to Drive, and it works fine.

Overdrive works fine if at speed, and works to shift up, but if going slow enough to drop to lower gear, transmission goes out of gear. Manually in drive, works fine.

I may have other symptoms, but this was on the way home from work, and I just parked it. I checked fluid level, and it was fine, still in the cross-hatch area of the stick, light colored oil, no smell.

I will replace the modulator and replace the filter, and see what that will do. If the overdrive works at overdrive speed, I do not see how that could be an overdrive housing failure that I have seen in many posts. I am aware of keeping track of the pin for the modulator.

I also have read that band adjustment is not a good idea. If they are worn that bad, they should be replaced. I don't think it is a band or clutch problem. I think it is a shift control problem. We will start with the modulator and filter and take it from there.

View 4 Replies

Ford Escape / Hybrid :: 1st Gear Hesitating - CD4E Transmission?

I have had my truck in the local ford shop because the fluid was a little bit burnt smelling, I had a flush done to it and then afterwards I noticed first gear started hesistating and then would go to second, when it warm it doesn't have any issues, shifts normal, but when cold or starting off even with running in the morning before going to work its still does that, I would like to find out before it starts becoming a serious problem....

View 6 Replies

Ford Aerostar :: 1998 - Transmission Won't Shift / Stay In 1st Gear

It's a 1988 with a 3.0 engine and an automatic transmission. It doesn't want to shift. I can make it shift manually, but if I leave it in OD, it wants to stay in 1st gear . If you fiddle with the accelerator, you can get it to shift. Then it wants to stay in 2nd, and so on.

Like I said, if I use the gear selector to manually shift, it will go to all four gears just fine.

My thoughts are a vacuum leak (a big one) or a faulty vacuum modulator at the transmission. No, the vacuum line to it doesn't have tranny fluid in it, but I replaced it, and I wonder if it's bad. Yes, I made sure to put the little metal pin/link back in it.

View 1 Replies

Ford Aerostar :: 1997 AWD Transmission Cooler - Bumps In And Out Of Gear

My 97 AWD Aerostar bumps in and out of gear on very hot days. I've had the transmission fluid and filter changed. That repair worked, but it still shifts hard when very hot. I tow a boat. I always push the shifter button in to deactivate the OD when towing. I talked to friends who recommended an auxiliary transmission cooler. I looked on the van where one might be installed. I have a factory transmission cooler (oem factory installed).

The cooler is in front of the radiator. I don't see any room to add an additional cooler. The van has 145,000 miles. The van runs and shifts fine most of the time. The problem has happened only on very hot days. What I can do to prevent transmission problems. I've read that the AWD 1997s use a five speed transmission. 1997 was the first and last year the five speed automatic was installed in the AWD Aerostar.

View 10 Replies

Ford - Escort :: 1992 - Cannot Get Transmission Out Of Park / Car Won't Go Into Gear

I have a 1992 Ford Escort. It's a junker (literally - it has a recovered title, the car having been totaled at some time in the past), but it gets me around. Or, it did.

The battery went dead a while back, and I'd been using the wife's car. She had to be out of town, so I got a new battery. Car started right up, but I couldn't get the transmission out of Park. I think there are switches to make sure that the brake is on, etc., that have to be made before the car can be put into gear. Is there anything I can do? Where are these switches? Obviously, I can't drive the car to a shop, and I'd prefer not to have it towed unless there's no alternative.

View 2 Replies

Toyota - Camry :: Transmission Takes A Half Second To Go Into Gear

Auto tranny takes a half second to go into gear. It doesn't slip just slight hesitation going into gear. This rig has 173000 miles on it and I don't know its maintenance history and don't want to stick much money in it.

View 3 Replies

4Runner/GX470 :: 1995 - Transmission Takes A While To Up-shift As Get To Last Gear

My transmission up shifts fine for the first couple of gears, but as I get to the last gear (I think it is the last gear), my transmission takes a while to up-shift. I am at 3000 RPM before it up-shifts then goes down to 2000 RPM on the next gear. Is there any fix that will not require a new tranny?

View 4 Replies

Lexus RX 2004-09 :: Transmission Response Takes Forever To Realize First Gear

I have a 98 GS4 and a 04 RX330 and one major issue I have with the RX, is the poor downshift response when slowing down, to say 5-10 mph and give it gas, the transmission takes FOREVER to realize I want first gear. If I am giving it 50% throttle at 5-10 mph after slowing and needing to get a move on, the throttle seems like it is there, but the transmission takes an eternity to realize "oh, you want first? hang on while I think about it", then it grabs first and LURCHES forward, giving everyone a very uncomfortable jerk.

My GS however, when down to those speeds is always spot on the right gear. Yeah, I know its comparing a GS to a RX, but wouldn't you think that Lexus would figure that one out?

Is the 04 worse than 05 or 06? Can I use an 05 or 06 trans controller and get some improved transmission response?

You can tell by the lurch, the throttle is responding to the driver's throttle pedal input, but the transmission isn't figuring it out till way too late. I don't get the lurch like at slower speeds and higher throttle input, but it sure makes for a poorly driving car.

I see the same problem when taking slower corners, get it down to 10-20 mph for a corner and the transmission won't downshift till AFTER the apex of the corner, despite what throttle pedal is pressed.

View 3 Replies

Ford Aerostar :: 1992 Won't Start / No Spark

I have a 1992 Aerostar with a 3.0L engine. For the past few weeks she intermittently didn't want to start but eventually always did. I replaced the fuel pump relay because she always have had problems with that. The relays are loose and get wet. Anyway, I thought i fixed it because I didn't have any problems for about 2 weeks. But one day didn't want to start again. She finally started and took her home.

Now, no matter what she wont start. I did some tests and there is gas been pumped but I don't have a spark. I put a new ignition coil and a new ignition module and still no spark. If im right, i only have 2 things left that could be the culprit, the profile ignition pickup, and/or the computer. Is there any other reason that could be the problem? I read online that in order to replace the PIP i have to take apart the distributor. Is this true?

View 10 Replies

Ford Aerostar :: 1992 2WD Keeps Cutting Out Like It Is Not Getting Fuel

My 1992 AeroStar 3.0L 2WD keeps cutting out like it's not getting fuel BUT...only after around 55 mph and after it warms up.

I first thought it was the fuel pump so I changed it. I didn't get a whole sending unit along with pump, I just dropped the tank and changed the pump...that didn't do the trick. Then I checked the fuel filter along the bottom rail and it's very clear flowing. Then I thought it might be the fuel pressure regulator. Ok, how many of you have changed the fuel pressure regulator? Man it was tough! I had to grind down an allen wrench to get room to turn those three allen bolts AND I replaced it while I was stranded on the side of the road!

Well, replacing that regulator didn't work either. I don't know where to go from here. It totally cuts out at higher speeds when it's warmed up. Could it be the oxygen sensor? It can't be the plugs. I don't think it can be the sending unit in the tank even though I changed its pump. Is there another fuel filter somewhere? I'm moving to another town and I have to get the van there.

View 13 Replies

Ford Aerostar :: 1992 - No Start - ECM Died?

Picked up another 92 extended! Seller's mechanic thought ECM died. When you connect the battery, the fuel pump runs, steady. 167K, same as my DD van! Plans are to pull the trans and swap tires first, and eventually pull the motor and freshen the seals and gaskets, and a timing chain. I would like to have it run first though. I'll take pics after it's hauled home.

View 3 Replies

Ford Aerostar :: 1992 - Serpentine Belt Shredded

I was driving the other day (cold weather- approx 15 F), and my serpentine belt shredded. Managed to drive a mile or so to my driveway. The belt was shredded on the fan side (and had come completely off), but it wasn't torn in two. Got a new belt and installed it, but upon test-cranking, found that it was riding up one ridge on the crank. All the other ribbed pulleys were fine (PS, AC). The smooth pulleys had the belt move a little, however.

Thinking I didn't set it right, I reinstalled the belt on the crank and tried again. Same result (belt rides up one groove, towards the fan). I perused the archives, and one comment was that someone simply trimmed one groove off the belt and everything was happy. The belt found it's "groove", and didn't act up anymore. Doesn't fix the underlying problem, but

1) is this a good fix
2) any clue what is going on?
3) Do I need to get the crank fixed?

BTW, I am sure that I threaded the belt on correctly!

1992 Aerostar, 4.0L, AWD. AC+P/S....

View 9 Replies

Ford Aerostar :: 1992 - Model Of Transfer Case?

So long story short I have a 92 Aerostar AWD which I'm pretty sure had the transfer case recall done (97V204000 1992 FORD AEROSTAR Recalls) it has the aluminum driveshaft but a couple of years ago the transfer case cracked and I replaced it with a "New OEM" transfer case off eBay. Fast forward to the present and my van has a strong vibration at 60+ my transmission guy says it all looks good so the vibration has to be from one of the driveshafts. My thought is that I may have got a transfer case without the recall done on it and its warped my driveshaft. I don't really know thats possible or what I could do about it if that was the case.

View 8 Replies

Ford Aerostar :: 1992 - Road Noise From The Back

Finally got my title, plates, and inspection for my 92. Started driving it to work Monday, and things were going smoothly until this morning. I noticed this van had as much road noise from the back as my 95 did, I assumed it was the junkyard fresh Prime well tires. Well, the noise seemed especially loud today, and then it went quiet. I knew this wasn't a good thing! I turned onto the exit ramp, and instant smokescreen! I was planning on replacing the rear axle seals this weekend, but that apparently wasn't soon enough.

Let it cool for a bit, then limped over to the Lowe's parking lot. Conveniently, there's an Auto Zone there too! My wife picked me up, and I loaded the car with jack, stands, and tools, plus a quart of gear oil left over from when I changed a seat on the 95. Long story short, pulled the driver side axle, and the wheel bearing was completely disintegrated! Luckily, I was able to get my paycheck a day early, so I can pick up the new bearing in the morning, as well as 'rent' the bearing puller.

View 8 Replies

Ford Aerostar :: 1992 AWD 4.0L - Massive Oil Leak Suddenly

Oil leak started suddenly - losing large amounts - dripping off front differential. Very hard to determine source. Ahead of Sensor Assembly. Drivers side.

Leak is very bad. Quart drains out in 10 minutes - solid stream.

Could it be the timing cover gasket ? Or is that too far back.

Tempted to use bars...

View 4 Replies

Ford Aerostar :: 1992 - Rear Control Arm / Bushings Have Worn Out

I have a '92 Aerostar XLT with a rear control arm problem. The bushings have worn out and the rear end floats side to side as much as 1 1/2 inches. Ford says one bushing comes in the arm ( no longer avail ), one is a press in (no longer available), and the other is like a strut bushing and is available but without the other 2 there is no point in replacing the one. How to fix this enormous problem???

View 10 Replies

Ford Aerostar :: 1992 - First Crank Rough Idle On Startup

1992, shory 3.0 130K MILES

On start up runs very rough, will stall if not power braked or revd a little on start up/out of the driveway.

VOLT METER STARTS GOING NUTS!!

After a mile/warm up,,, runs great. But sometimes even when its hot, it will still try to do the rough idle briefly after just a few minutes restart. Give it a few revs at that point and its good. And once in a blue moon it will do it randomly at a stop light,, out of the blue. Very rare

View 12 Replies

Ford Aerostar :: 1992 - Stereo Upgrade - Remove Equalizer?

i have a 92 eddie bauer star with premium sound system with equalizer. i'm upgrading to an aftermarket system and was told there's a tray that replaces the equalizer and i'm wondering if it's a separate piece from the trim piece that covers the radio, vents etc. ?

View 6 Replies