Ford 6.7L Power Stroke Diesel :: Electric Door Locks No Longer Function - Hot Smell / Burned Out
Driving today I noticed a hot smell, it went away shortly after. When I got home I noticed the electric door locks no longer function. I guess this will be a test of my 3rd party warranty!
View 10 RepliesFord Super Duty (1999-2016) :: 2008 - Power Door Locks Doesn't Function
I am switching over to 08 door panels so in my attempt to rewire the door locks I crossed a bunch of wire that I shouldn't have because I had the wrong pin out and I shorted out the circuit. I rebuilt my 08 switches with the 04 parts so now I can reuse my old wiring connectors. I just soldered the old connectors back on and replaced the 30 amp fuse for the power locks. for some reason only the lock function on the passenger side works and it locks both doors but I have no unlock function on the passenger side or anything on the drivers side. Are there any other fuses that I could have missed? I don't have long to do anything invasive but as far as fuses I have all day to replace them. Basically I shorted stuff then I put everything back to the way it was stock and now my locks no worky
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: Lose Accelerator Function After Hitting A Bump - CEL On
What would cause me to lose accelerator pedal function after hitting a bump? The engine remains on, the CEL comes on and after a few seconds or shifting into neutral and back into drive I regain the accelerator again and the CEL goes out
The truck shows no codes. It is if some connection makes/breaks intermittently when I hit a rough pavement. Also, she sometimes won't shift in reverse. Could it be related?
Ford 7.3L Power Stroke (1999-2003) :: Glow Plug Control Module Function?
OK, what does a glow plug control module do? The short bus I got has one on it. It looks like it fits right into the circuit without much, if any, modification. I got one with my short bus and am curious if it would be something worth adding to my pickup. So...what does it do and could I/should I install it?
View 4 RepliesFord 7.3L Power Stroke (1999-2003) :: Door Locks Actuate But Fob Won't Program
on my 2002 lariat.. Crew Cab dually. 7.3.. it will go into programming mode after 8 cycles.. Door locks actuate, but fob wont program. I checked the fobs and they are sending signals. What could be problem?
View 8 RepliesTouareg :: Radio Turns On Whenever Any Function On Nav Is Activated
I've just acquired a 2008 Cranberry T'reg V8 with the Techno and Lux packages. Whenever any function on the Nav/Radio unit is activated, the radio turns on. For example, when shifting into reverse, this activates the reverse camera screen -- and the radio also turns on. Likewise, if I turn on the navigation screen, the radio turns on. This is kind of annoying if I don't want the radio on, but want other functions activated. Is there a setting that I'm missing? The only thing I can figure is to keep the volume setting at zero.
View 2 RepliesFord 6.0L Power Stroke Diesel :: 2003 - Truck Locks Up At 45 - 50 Mph
I have a 2003 6.0l f250 disel and when I am driving and get up to around 45 mph it will shift and start to shake the whole truck and even if you mash the throttle RPMs won't move and will not gain speed until you let off the throttle and then re engage but it will continue to do this and I cannot seem to figure out what is wrong.
View 13 RepliesFord Super Duty (1999-2016) :: 2003 F250 - Power Door Locks Are Operating Backwards
2003 F250 extended cab .. I've only had the truck a couple of weeks... While I was check out some lighting issues I noticed that the power door locks are operating backwards (unlock is locked and locked is unlocked) is the a simple explanation or has someone wired them reversed???? If you wired the driver's door backward would that effect the passenger door??
View 5 RepliesFord 6.0L Power Stroke Diesel :: Turbo Pedestal Sensor Function?
What's the purpose of the pedestal sensor
View 1 RepliesFord 7.3L Power Stroke (1999-2003) :: Power Stroke Malfunction - In Reverse / With Lights On Engine Shut Off
Last November I forgot to plug my truck in and it got down to 0, my girlfriend tried unsuccessfully to jump start it. When I got home I jumped it and got it running. I took it down to a heated shop to troubleshoot the glow plug circuit. I discovered it was not getting 12v to the glow plug relay. Also I started it and tried to back it up in the shop, when put in reverse it killed the engine, not lugged it down it was like you shut the switch off.
Also I discovered if you turn the lights on it kills the engine immediately. It will not crank with the lights on either. So far I have replaced the computer,ignition switch,batteries, and cam positioning sensor. Now comes the weird part!! I decided to get it running and pull the bulbs out of the back up lights I pulled the drivers bulb first then the passengers side bulb. When I pulled the passengers side bulb it killed the engine.
It is not my daily driver so it still sits in my shop. I have a hunch it's a ground issue but I've checked and cleaned up all the grounds I can find and it still has the problem.
Ford 7.3L Power Stroke (1999-2003) :: E350 - Sudden Power Loss / Zero Power
I am still failing to appropriately diagnose the problem(s) with my '03 Ford E-350 7.3L Powerstroke. This van has only 69,000 miles on it. A week or two back (just a few days back in work time) it suddenly went from running perfectly smooth, clean and wonderful to this:
- Zero power. Putting the van in gear and flooring the engine causes lots more smoke not nearly any rev of the engine and just a crawl forward.
- Lots of smoke out the back exhaust, whitish. I cannot discern wether it smells like diesel or oil (because I'm ignorant here), but the smell is very strong.
- After warming up and idling ~ 15 min I check under the coolant cap and see no signs of bubbling or disruption (from opening the cap in the coolant tank).
- After warming up there are no warning lights visible on the dash, and I don't have a computer to read codes (if there are any to read).
- I replaced the turbo up-pipes which had a visible leak previously. This did not hurt the symptoms, though no more visual leaks under the dog house.
- I thought maybe I put gasoline instead of diesel in the truck, not so.
- To do the above test I had to use the fuel pump to get gas out the tank to test. I hijacked the fuel pump output and turned the car on a few times to get gas out to a tank. The pump seemed to work just fine.
This was all very sudden which is perplexing, and, in use, the van was previously an ambulette and in my few miles with it (maybe 200-300 only) use was extremely light for such an engine/van, just driving around doing errands. I am not sure if this is relevant (no one has suggested so, yet) but before all this happened I uninstalled the rear HVAC that came with the van when I bought it. The AC lines were sealed under the hood. The coolant line was returned at the doghouse (you can see this at the beginning of the video).
At the moment the van has no power to go anywhere. I have not yet checked the CPS or IPC sensors, and understand this might be the next route in standard troubleshooting?
2003 Ford E 350 7.3L Trouble - YouTube....
Ford 6.7L Power Stroke Diesel :: Truck Would Not Open Door Locks For Like Ten Minutes
My truck would not open door locks for like ten minutes or do anything. then all off sudden it worked again its this twice...
View 9 RepliesFord 6.7L Power Stroke Diesel :: 2015 F250 - How To Disable Auto Locks
I tried the methods that I could find on youtube but with no luck.... I do not have the option to change the settings in the message center either...
View 14 RepliesFord Super Duty (1999-2016) :: 2004 F250 - Loss Of Power Door Locks And Power Windows
I have a 2004 F250 Super duty that had a battery die (I left the keys in the ignition switched on overnight) and after jumping the battery off the vehicle started up but now I have no power door lock or window functions. Any reason a dead battery issue might affect the power locks and windows?
View 10 RepliesFord F-150 - 1997-2003 :: 4wd Not Engaging / 2wd Solenoid Always Activated
Found out the hard way that the 4wd does not work on this new stupid truck. I've been troubleshooting the solenoids and confirmed that the 2wd solenoid gets grounded and will read ~12V when switched to 4wd; however, the 2wd solenoid always remains grounded and will always read 12V across the plug no matter if it's in 2wd,4hi,4lo. What would cause this? It seems that I would have vacuum going to the front differential from both the 2wd and 4wd solenoids at the same time, thus not allowing it to go into 4wd. BTW, this is on a '98, 4.6, turn dial 4wd
View 14 RepliesFord 6.0L Power Stroke Diesel :: Dash / Windows / Locks / Radio All Quit Working
We just replaced an injector in my truck. Everything was fine, ran great, etc.
On the freeway home, the dash, windows, locks, radio all quit working. at first they'd stop and come back, stop and come back, etc. then finally they stopped. As I was getting off the nearest exit, the truck started dying on me. Once I got pulled over out of the way, it acted like the battery was completely dead.
After a few minutes of scratching my head and staring under the hood, I happened to look at the passenger side batter, and the crossover cable from the drivers side was broken off right at the terminal!! We must have broke it off while doing the injector. as I look closer at it, it had been broken before. Some idiot before me had actually taken a broken crimp style terminal, shoved it and crimped it into a new one and called it good.
I was able to redneck it back together so i could finish the last couple miles home. I fixed it properly with a new crimp terminal, heat shrink, etc. Why did the engine die with the crossover connection broken? was it because the series was not complete, and all the electronics were running off the battery(s) and not the alternator? I'm really confused. I've heard of people only running one battery before.
Ford 7.3L Power Stroke (1999-2003) :: Will Cluster From 2003 6.0L Work In 2002 Model?
I have a 2002 7.3L Screw 4x4. Will a 03/04 6.0L instrument cluster work in this truck? The 2 clusters appear identical. I put the 6.0 cluster in and the trans temp, and coolant temp gauge will not work. All the gauges sweep when it is powered on, but the coolant and trans temp lay flat, and the check gauge light is on. All other gauges and functions work. When I put my other cluster in, all gauges work fine. Is there a difference in the VSM, PCM, or the SCP communication?
View 6 RepliesFord 7.3L Power Stroke (1999-2003) :: 2003 F350 - Oil Leak When Parked After Running
I have a 03 F-350, 7.3L. There is a slow oil leak that only leaks after I've run the truck. In other words, it doesn't just sit and leak overnight. I'll park it after running, and the next morning I'll notice a small pool of oil, approximately 2" in diameter. The leak appears to be coming from the oil pan area. I degreased the entire oil pan area to get a better visual of where the leak is coming from. I can see oil trailing down the front of the oil pan and the rear of the oil pan. Does this sound like the gasket? Or, what else could it be? I'm praying its not as bad as I think and need to replace the gasket.
View 3 RepliesFord 7.3L Power Stroke (1999-2003) :: 2003 - Running Rough / 2 Cylinders Not Working Correctly
I have a 2003 F250 7.3L. I put new injectors in my truck four months ago and all of a sudden, I have 2 cylinders not working correctly, making the truck to run really badly. I sent the 2 injectors from the bad cylinders back for warranty and they replaced both of the injectors but nothing was wrong. I put them in and the truck still runs badly. I have a new fuel filter, new ICP, new CPS and glow plug relay. I cannot drive the truck, it smokes white at idle. I can unplug each injector at a time and cyclinder 5 does not change how the truck runs
View 14 Replies