Ford 7.3L Power Stroke (1999-2003) :: A/C Won't Work At Idle?
I have a 99 f350 and my a/c does not work at idle at highway rpm it blows cold. but once i let it sit and idle even on 1300rpm high idle it will now blow cold. it blows hot untill i rev it up aroung 2000rpm or drive down the road. I have charged the a/c system it has the proper about of refidgerant in it compressor gap is correct. Is it supposed to be like this? If not what are some things to check?
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: Waste Gate Supposed To Work At High RPMs / Boost?
I understand how the waste gate is supposed to work at high rpms / boost.
I believe that as long as I keep the max boost down, that I can run with the waste gate plugged in order to goose the power a little in the 2000-28000 RPM range. Since the truck is stock and there's no intention of running higher RPMs, it seems like plugging the waste gate is a good idea. I just want to make sure that I'm not missing something.
It appears that the wast gate also opens when at idle and possibly when you let off the throttle. Are these important functions of the waste gate as well?
Here's a chart showing waste gate operation...
Ford 7.3L Power Stroke (1999-2003) :: Heavy Smoke At Start - High Idle?
Here's the deal. 99 Powerstroke out new injectors and orings. Did orings twice to make sure i didn't damage it. New turbo, new utvc gasket, new ipr, new fuel pump, I new complete engine wire harness. I pulled the injectors and ran in another truck no problem. New injector cups compression was all in the 300-375 range. Any cold start smokes like hell. Goes away when driving after the first time of hitting boost. Spits and shudders for a few seconds until boosting. Every time I stop it starts smoking again at idle. No power loss not using oil. Can't get a grasp on this smoking issue. When cold start I kill millions of mosquitos in a one-mile radius.
View 3 RepliesFord 7.3L Power Stroke (1999-2003) :: High Idle After It Sits About A Minute Warming Up
I have noticed thru the cold months after I start my 2001 F250 7.3L 4X4 after it sits about a minute "warming up" that it goes into a high idle. The high idle will stop once I press the brakes. Is this normal?
I think this is a unrelated issue, but just started over the weekend. Was riding home, and pressed my brakes and the pedal moved almost to the floor. Not normal conditions for my truck. Usually the pedal is very stiff. I have noticed that my power steering pump has had a hum for months. I changed the fluid (ATF Mercon) within the last 6k miles and that calmed it down a bit.
After the pedal went to the floor, the hum seemed to quieten down even more. The power steering still works and the reservoir has adequate fluid and so does the brake fluid reservoir. I haven't noticed any leaks around the truck. I'm going to bleed the brake in an hour or so. The brakes pedal seems stiff when I press it after the high idle, but then it gets soft after a pump or two.
Ford 7.3L Power Stroke (1999-2003) :: 2002 - High Idle While In Gear / Stay At 800 RPM
So finally got my truck running due to a fuel issue. Anyways been driving it for a week or two now, and I have a strange problem idk if it has been covered here or not.
Driving around tow etc if you come to a light or whatever and stop the rpms stay at 800rpm. Now if you shift it out of gear and back into drive the rpms settle back down around 650. Where is should be.
My guess is the torque converter is not disengaged all the way when it stuck at high rpm (800-900) for this situation. No cel, slippage, or crazy noises
2002 7.3 power stroke all stock right now @160k black crewcab
Previous owner had a tunner on it but not anymore. Could it have smoke the trans???
Ford 7.3L Power Stroke (1999-2003) :: 2002 - High Idle In Cold Weather
Does the 2002 7.3 have an automatic high idle in cold weather?When you start it after it runs for a few moments it goes into high idle until you hit the accelerator. I had a 96 powerstroke before this one,it didn't do this. Just wondering?
View 4 RepliesFord 7.3L Power Stroke (1999-2003) :: Shuddering In OD - High Idle - Missing On Deceleration
My truck was shuddering in od. So as I last effort thinking it might be injectors I pulled all of them and replaced all of the orings and valve cover harnesses. After all of this was done seemed to do nothing at all. Now a new problem has surfaced. It's having idle problems. It will now idle at 780-850 instead of 650-700rmps. Also on deceleration it will miss pretty bad. Checked all of my injectors again all connections are good and all of the injectors are tight. Not burning any oil. So I unplugged the icp and bam runs like a top perfect running engine. So I bought a new one and plugged it in and itake doing the same thing. So what is going on! Also it was throwing a random check engine light but wouldn't bring a code up I'm completely lost....
View 2 RepliesFord 6.7L Power Stroke Diesel :: High Idle Mod Does Not Work With Remote Start
I recently did the high idle mod but as many of you know it does not work with remote start. I found the below link on how to make it work with rewiring how the aux switches receive power. Are the aux switches hot all the time even with the key off?
[URL] ....
Ford 7.3L Power Stroke (1999-2003) :: 2000 F350 - High Idle / Over Drive Light Started Blinking
OK, truck is 2000 F350. I am heading on a 2000 mile roadtrip to Yellowstone for my wife's 40th birthday in two days. What was our rock of a vehicle is now causing me severe anxiety.
Over the last few days the truck has been difficult to start - almost stops turning over as if the batteries were low. So I ignored it because if I plug it in, it starts fine and if I drive it and it gets hot - it starts fine.
Tonight while driving - I noticed a high idle and then it went to normal - I thought it was weird and a few miles later at a stop sign it struggled at idle, sort of loping but not romping very high and the over drive light started blinking. When I got home when I went from drive to neutral it goes to high idle and then the overdrive light blinks. The first time it blinked it went off when I pressed the OD button - but now it continues to blink.
Would low batteries be the root cause of this? I will continue my search for blinking OD light but I thought I would get this in the queue in case this is bigger than I can handle. I have 48 hours to resolve this issue - leaving Wednesday early morning.
Ford 7.3L Power Stroke (1999-2003) :: 2000 F350 - Missing After Start Up - High Idle - Got Codes P1316 / P1211?
Well, long story is that I starting have problems with my 2000 F350 Dually 7.3 PSD about 6 months ago ( ~10K miles ago ). I have sunk almost 5K$ in mechanics and the problem is still present.
By troubleshoot, I do not mean try this, try this, as that has been what is happening. I mean making test measurements and diagnostics. I am fairly mechanically inclined, but I am no mechanic. Looking for primers on how the 7.3 PSD works.
Symptoms: After the truck sits 12 to 14 hours, it starts and idles fine ( ~ 700 RPM on the 'Dash Tach' ) just as it has always done. During the first 5 miles of driving it, the SES light comes on and it sputters, stalls, and vibrates as if a couple of the injectors are not firing. It then clears up and the SES light goes out, except that it idles at about 1200 RPM ( 'Dash Tach' ).
It runs fine like this the rest of the day, If I shut it down it will start right up and run fine, but it has the high idles. Only if it is shut down longer than 12 to 16 hours do the symptoms, other than the high idle, reappear. The high idle is constant. Also mpg have fallen ( 13 opposed to 16 ).
It does not seem to be related to ambient temperature, or the amount of warm-up idle. I have idled it for three hours on startup and it is fine, until I drive the first 5 miles or so.
Now, I have had three mechanics work on it and they have replaced: the ICP sensor ( 3 times ), the Fuel filter ( twice ), drained, flushed and refilled the HPOP, replaced both sides of the valve cover wiring harness, put in a new IDM, fuel heater, CPS sensor ( 3 times ), fuel pump in fuel tank, EBPV ( not sure what this is ), and the last straw was saying the injectors needed to be replaced ( or at least the O-rings, but while we are in there you might as well ... ).
I bought a cheap code reader and it says: P1316 & P1211. I believe these are the same codes since day 1.
Ford 6.0L Power Stroke Diesel :: 2003 F350 - High Idle And Stuck On Third Gear
Was driving my truck normal, got to a stop and the truck staring to idle high and like stuck on third gear and also the tow light (over drive) started to flashing Is like the truck put it self on safe mod. Drove it back home but couldn't do more than 55 miles n hour so I didn't hurt the trans.
View 1 RepliesFord 6.0L Power Stroke Diesel :: 2003 - Turbo Whistling Very Loud At Idle / High RPMs?
So I just purchased my first diesel a couple weeks ago (2003 f250 Lariat). I love it! However, I'm having concerns about my turbo whistle on it. At idle and while in higher RPMs is sounds ridiculously loud (even at 0 PSI in the boost). I've been doing my research on it and I know the 03's have the loudest sounding turbos because they have less vanes than the later models. I know without a video it's going to be hard to diagnose, but I am wondering if a loose boot would cause a turbo whining sound through the exhaust? I have yet to hear ANY other diesel in person that has a turbo whine as loud as mine.
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: Will Cluster From 2003 6.0L Work In 2002 Model?
I have a 2002 7.3L Screw 4x4. Will a 03/04 6.0L instrument cluster work in this truck? The 2 clusters appear identical. I put the 6.0 cluster in and the trans temp, and coolant temp gauge will not work. All the gauges sweep when it is powered on, but the coolant and trans temp lay flat, and the check gauge light is on. All other gauges and functions work. When I put my other cluster in, all gauges work fine. Is there a difference in the VSM, PCM, or the SCP communication?
View 6 RepliesFord 7.3L Power Stroke (1999-2003) :: 2002 - 305-75-20 Tires Work On 4x4?
I want to put 305-75-20 on my stock f250 4x4 will they work?
View 1 RepliesFord 7.3L Power Stroke (1999-2003) :: High Pressure Power Steering Hose
My high pressure power steering hose just blew at the "B" nut at the pump. Meaning, the fitting is still in the pump but the line is out. Do I need to replace the whole line or is there a retainer I can swap out?
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: 4WD Does Not Work / No Vacuum Leak Signs
In the past, I've had the common issues of vacuum leaks causing issues as evident from the defrost/ac and then finding busted vacuum lines. Changed out and everything fine for a few years. Now, i dont have 4wd but i dont have the tell tale vacuum leak signs. Also, even if i manually engage the hubs, still no 4wd.
I try to listen for the transfer case to engage when i switch from 2wd to 4wd, I think I hear it engaging, but to be honest the 7.3 makes so much racket Im not positive that Im hearing it, or at least not hearing it the way I "think" that i heard it in the past. I seem to recall a distinctive clunk when engaging, now its barely audible if at all. Now when I switch to 4-Low, there is the distinctive sound, and it does goes into low drive, just that its only 2wd-low, still no front wheel action.
I have never had any issues before other than the vacuum leaks, have never had reason to dig into the transfer case for any reason. The only time it has ever been touched was last summer when i had the BTS installed and all they did was remove and replace.
Do I finally need to either rebuild or replace my hubs? Is it possible not to have 4wd even with hubs manually engaged? Or is there an issue with the t-case? Or is there something else going on? I have access to a lift to attempt "driving" while all wheels off the ground, its just not mine and its a tight fit and a pain to get my truck on it.
Ford 7.3L Power Stroke (1999-2003) :: High Pressure Power Steering Line Blown?
I just replaced my 3rd HP power steering line last night( 3rd in 300K, always blows the same point....fitting comes apart where it attaches to the pump.
I'll start, mine have gone about 100K plus or minus 10K, almost thinking about making it a 100K maintenance item.
Ford 7.3L Power Stroke (1999-2003) :: Low On Power High On EGT
Pulled our 5th Wheel up to a campsite we like in the Eastern Sierra, have pulled this trailer there several times before. This trip it felt way down on power and the EGT's were getting up there, I saw 1320 and it would have gone higher if I hadn't backed out of it. It had good boost 24psi averaged 17 to 20 on the steep long pulls. We came home today without the trailer and it ran just fine except once when I really nailed it the emission system light came on and stayed on solid till I turned the key off and on. What is the Emission System light telling me? It ran just fine when the light was on and all indications on the Scangage were good as well a on the Boost, Egt and fuel pressure gauge.
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: 2002 - Electric Malfunction - Dimmer Won't Work?
I just got a 02 f250 lariat 4x4. 7.3. the dimmer on the dash will not work. The light switch was falling apart any way so I replaced it with motor raft switch. Didn't fix it I checked the fuses for the dash and lights. Can't find anything. It does have an aftermarket CD player and those light work with switch. Also it has the mirrors with turn signals and run lights. Neither works power mirrors work fine but no lights. On either side.
View 9 Replies