Ford Excursion :: 2003 - Wiring Diagrams For Lightning System?
I have a 03 Eddie Bauer PSD and I'm looking for wiring diagrams online. Specifically for the lighting systems. I bought a set of OEM telescoping, heated mirrors with turn signal and running lights and the running lights do not work. Appears that 03 may not have supported this but I see other rigs with the same mirrors and the running lights working.
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: Adapt 7 Connector Plug To Aux Power?
On the back of my truck I have two plugs to operate trailer lights/brakes etc but I only use one. The one I'm not using (pictured) I'd like to adapt for aux power in the trailer to operate some IP cameras. I need to know about the pin outs of this connector and what gauge wire to use between the trailer and truck. I plan on running the 12V and ground conductors from this plug through an adapter into the trailer.
In the trailer I'll have a 1000W inverter --> UPS --> TL-WR810N Router --> TL-SG1008P POE switch --> and 4 small ip cams.
Ford 7.3L Power Stroke (1999-2003) :: Diagram Of OBD2 Connector
Looking for the wiring diagram with colors for which port should be what wire for the obd2 connector for my early 99 f-250. I actually think it is obd 1 on our trucks but you get the idea. My truck doesn't have power to the plug I guess. I have a guy plug in a scanner to take a look at everything but he said the plug wouldn't power up his scanner. Just trying to get this fixed. Another question, if I buy a AE does that require the truck to power up the software or does it get powered my the laptop?
View 11 RepliesFord 7.3L Power Stroke (1999-2003) :: Stripped Wire Harness Connector Bolt?
As part of my ongoing P1393 troubleshooting, I’ve found that I can’t get the main engine wire harness separated. The big connector by the driver’s side valve cover.
I’ve cranked and cranked in the correct direction, but the plug never separates. I tried a cordless impact wrench and it still doesn’t move. (Edit -- the bolt moves very freely, but it doesn't push out one side (e.g. like removing the PCM) I can't figure out how to separate the two sides.)
Any tips on how to get it separated? Can I cut off the bolt head to get it separated?
Ford Super Duty (1999-2016) :: 2008 - Mirror Wiring Diagrams?
I have an early 99 F250 that I'm putting 08+ mirrors on. I'm not real sure what year they are, but no wiring diagrams I can find match up. See, my mirrors have 12 wires. All diagrams I find have 10. The colors don't match either. I wanna wire these up but I can't decipher the wiring.
View 2 RepliesFord Super Duty (1999-2016) :: Mirrors / Locks / Windows Wiring Diagrams?
I have a mostly complete 1999 F250 XLT I'd like to salvage the power mirrors, locks, and windows from to install on my 2001 XL. I know the door harness and therefore the dash harnesses will be somewhat different. I'd like to see if there is a difference in the other ends where they connect to under the dash.
Looking for the wiring diagrams for those components so I can see what else I need to change?
Ford 7.3L Power Stroke (1999-2003) :: Wiring Diagram For The UVCH Pigtail?
I can't find a wiring diagram for the UVCH pigtail anywhere. The one that came with the harness assumes the old one was still connected. My wires were burned through and I need to know what colors to wire in from the truck to the new harness so everything matches up.
View 9 RepliesFord 7.3L Power Stroke (1999-2003) :: Wiring Diagram For Small LEDs?
I am looking at putting a couple small LEDs in the pinch weld area under the doors on the cab. I want to have them come on when I open up a door. Where is the best place to grab power from the door switch circuit for that? The passenger side I was thinking of grabbing it where it goes into the sleeve between the cab and the door, but on the drivers side there are a lot of things in the way to get to that point. Can I pick it up down in the door jamb area? Is there a wire going to the dome light there?
View 8 RepliesFord 7.3L Power Stroke (1999-2003) :: Adding LEDs - Wiring Harness?
I am going to add some led's to illuminate the steps getting into my truck at night. I plan on putting them directly under the door over the steps. Is there a wire under the door threshold I can tap into at each door? If so what color? If not, where to get the power from. I want them to turn on and off with the interior lights when doors are opened.
View 1 RepliesFord 7.3L Power Stroke (1999-2003) :: 2001 F350 - Fog Light Wiring Harness
Where I can get the head light to fog light wiring harness..it is almost as hard as finding the holly grail..... 2001 f350 7.3 .......
View 9 RepliesFord 7.3L Power Stroke (1999-2003) :: 2000 - Ignition Harness Wiring Colors?
My 2000 f350 has wires that dont match anything I've seen. I need to mate this to an 08 harness so I need to be accurate. I have
(2) yellow. I know this is 12v constant
(2) green/purple I know this is 12v constant
(1) red/black
(2) solid red
(1) solid black
(1) gray/light blue
Ford 7.3L Power Stroke (1999-2003) :: 2007 - Parking Brake Wiring Diagram?
Got a 2002 7.3 f550 and the other morning it wouldn't go into high idle. Noticed my parking brake light was off. Messed with the switch and eventually jumped straight from the connector to ground... still no light. The light does illuminate with key on. I have tested the fuses. Where do I go from here? Looking for a wiring diagram....
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: Starter Relay On Fender - Wiring Diagram
Any pic or wiring diagram of the starter relay that is mounted to the fender. I'm trying to start the truck finally but it's just cranking and I think I might have mixed up the wiring. Is there supposed to be a constant hot at the glow plug relay when the ignition is off?
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: F250 - Starting System Wiring Diagram?
I have a new to me 1999 F250 with the 7.3 engine. The previous owner installed a push button start to get around the ignition actuator being broke. Over the weekend I pulled the column and replaced the actuator but the truck will still not start with the key; with the push button it starts just fine. I'm not getting any power on the starter relay signal wire, so I suspect something in between the key and starter relay. I searched around a bit, but could not find a wiring diagram for a 1999 diesel super duty.
View 3 RepliesFord Ranger / B-Series :: 1986 - Fuel System Wiring Diagrams?
Looking for the wiring diagrams for 86 ranger fuel system. I replaced the fuel pump relay after testing and finding that it was bad, still not getting fuel. I want to test any fusible links or anything else that could have gone wrong before I throw another part at it.
View 1 RepliesFord 7.3L Power Stroke (1999-2003) :: 2000 - Got Code P1316 - Injector Wiring Harness?
I have a 2000 Ford F550 7.3. I bought a Superchips programmer to read the codes on my truck and up pops this P1316, so I did some research and found out that the most common problem is the injector wiring harness. I bought new valve cover gaskets and the injector wiring as well because the truck is old and I figured new wires wouldn't hurt.
So after installing the new wiring harness and gaskets I'm still getting this Code! The truck idles rough and serge's sometimes, also there is a lack of power and some shaking between 40 and 50 miles per hour, however form 50 to 60 MPH seem's to be just fine. I don't trust the "Mechanic Shops" around here and will only take the truck in as a last resort.
Ford 7.3L Power Stroke (1999-2003) :: E350 - Instrument Cluster Not Working After Electrical Wiring Mistake
I am currently converting a 1999 E350 7.3 diesel bus into a camper to live in. The bus has already had a lot of weird custom work. Done by someone else and a lot of the interior torn out and extra insulation put in. There is an exposed electrical panel behind the drivers seat. It was a cheap buy, previously fleet maintained with only 120k.
I was hooking up a battery for accessories to a terminal labeled "Battery" that does run indeed directly to the + terminal of the battery in the engine compartment.
Unfortunately I mistakenly connected the accessory battery to a terminal labeled "ignition" that runs to behind the dash. When I tried starting the vehicle off the auxiliary battery for a test everything went out for 2 seconds, I heard a click from the engine compartment, and everything than came back on. This is when I realized my mistake.
It used to be the speedo only didn't work (which I assumed was the step motor), now after this mistake all the gauges, the odometer and the buzzers don't work. Lights like the battery and airbag warning indicator still function.
Checked fuse 2 (15 amp) for the instrument cluster and it is intact. Actually checked every fuse in the vehicle in both fuse panels and all are intact. The radio works though and the vehicle is not equipped with power windows.
Going to go get a radio removal tool to take apart the dash and get back there. What this could be? Did I fry a relay? Did I fry the cluster circuit board.
Ford F-150 - 1997-2003 :: Vacuum Diagrams For 4 Wheel Drive?
Looking for the vacuum diagrams for the four wheel drive, where I can find them?
View 10 RepliesFord 6.0L Power Stroke Diesel :: Charging Line In 7 Pin Connector For Trailer Batteries
I have both a hydraulic dump trailer with two 12v batteries and an RV trailer with two 6v batteries to supply 12v. Both trailer's batteries are wired to be charged from the tow vehicle if the TV is equipped with a charge line.
Does the OEM 7 pin connector on a 2005 Ford 6.0 F250 CC 4X4 have a charging line on it? If so which terminal / pin is it?
What gauge of wire is it and how much amperage will it deliver to the connector? For testing, when is it hot? When the truck is running only? When the key is on? Is it hot all of the time?