Ford 7.3L Power Stroke (1999-2003) :: Power Stroke Malfunction - In Reverse / With Lights On Engine Shut Off
Last November I forgot to plug my truck in and it got down to 0, my girlfriend tried unsuccessfully to jump start it. When I got home I jumped it and got it running. I took it down to a heated shop to troubleshoot the glow plug circuit. I discovered it was not getting 12v to the glow plug relay. Also I started it and tried to back it up in the shop, when put in reverse it killed the engine, not lugged it down it was like you shut the switch off.
Also I discovered if you turn the lights on it kills the engine immediately. It will not crank with the lights on either. So far I have replaced the computer,ignition switch,batteries, and cam positioning sensor. Now comes the weird part!! I decided to get it running and pull the bulbs out of the back up lights I pulled the drivers bulb first then the passengers side bulb. When I pulled the passengers side bulb it killed the engine.
It is not my daily driver so it still sits in my shop. I have a hunch it's a ground issue but I've checked and cleaned up all the grounds I can find and it still has the problem.
Ford 7.3L Power Stroke (1999-2003) :: Hold Gear Selector Towards Park To Get Reverse Lights To Come On
I have noticed that I have to hold my gear selector towards park to get the reverse lights to come on. Also some times I have to hold it towards park to get it to start. I changed my tranny in Dec 2009 and occasionally it would do this while starting, just noticed the reverse lights about a week ago. Tried moving the cable where it attaches to the tranny a couple of serrations each direction. No luck. Is there another place I can make an adjustment?
View 14 RepliesFord Ranger / B-Series :: 2003 - Power Source Backup Lights?
I lost my backup lights. The owners manual does not list a power source (fuse) for the 4.0. I do not see a bad fuse, however I suspect that the backup lights are fused somehow somewhere on a 4.0. I do not have a manual for the 2003 Ranger.
View 9 RepliesFord 7.3L Power Stroke (1999-2003) :: Truck Turns Over Just Fine But Won't Start
I bought a 99F350 with a 7.3, it was not running when I bought it. Batteries good, new starter, turns over just fine, fuel pump works, but now I don't know what to look for.
Was testing ohms for my injectors and at the plug on top of the driver side valve cover, couldn't get a reading at all, tested the ohms at the pass. Side valve cover plug and got good ohm readings.
Ford 7.3L Power Stroke (1999-2003) :: Engine Died Suddenly / Turns Over But Won't Fire
I have a 99 F450 bucket truck. I was up in the bucket when the engine died suddenly. It turns over but won't fire. I have no dash warning lights now either but everything else seems to be working. Lights, radio, annoying beeping sound from the key left in the ignition, etc. There are roughly 5 or 6 fuses in the panel to the lower left of the steering column that don't have power to them. Are they all supposed to have power when the ignition is on? I checked the fuse panel under the hood and all of the fuses that have 12V to them are good. There are a few small ones that don't have power to them but I don't think they do all the time.
View 9 RepliesFord 7.3L Power Stroke (1999-2003) :: 2002 F250 - No Power To Reverse Light Sockets
I have a 2002 f250 CC 4wd 7.3 and I have no power to my reverse light sockets. I am stumped, all my fuses are good, I don't think there's a relay so i haven't checked that. My neutral safety switch is good, I'm getting power to both the blue/pink and black/pink wire. What it could be, at first it was constantly blowing fuse 27 every time I put it in reverse but then it stopped blowing it obviously because they won't come on.
View 8 RepliesFord 7.3L Power Stroke (1999-2003) :: Little Squeak Only Happens In Reverse
So this started yesterday when I pulled in to my drive way and it only happens in reverse. When I back up it sounds like a mouse is under the truck I think it is the rubber part of the seal on the front of the rear deferential. Can I just replace the seal and be good or is this something that could be a bigger problem? My deferential fluid level is full. I also have slop in the rear end if I go from drive to reverse you can here the thud/clunk is there any way to tighten that up or am I just looking at having to rebuild the whole thing.
View 8 RepliesFord 7.3L Power Stroke (1999-2003) :: Truck Stalling When Going Into Reverse
This just started happening last week. When I put the truck into reverse, the engine lugs down and dies. It' as if the AT is fully engaging reverse gear with no clutching action. If give the truck a bit of pedal, I can put her in reverse and back up without issue. Going forward into Drive has no issues.
View 8 RepliesFord 7.3L Power Stroke (1999-2003) :: 4r100 - Reverse Started To Go Away
Installed rebuilt transmission 1 month ago. Have noticed reverse has started to go away. Feels like it is slipping or tires are losing traction with a lot of vibration in the steering wheel.(tires are not slipping that's just the way it feels).. Does it worse when trans is up to temp. I suspect feed bolts but want opinions.(Mark K.) All forward gears seem fine with no issues. I have never been under the pan deep enough to access the feed bolts.
View 3 RepliesFord 7.3L Power Stroke (1999-2003) :: Engine Turns Over Just A Couple Of Times Then Sounds Like Starter Disengages
Yesterday my truck began to give me some problems starting. The engine turns over just a couple of times then it sounds like the starter disengages and winds up. it took multiple attempts but it finally fired up. Does this sound like the starter or could it possibly be the starter relay?
2002 F350 CCLB Lariat 7.3
Ford 7.3L Power Stroke (1999-2003) :: 2000 - No Lights With Open Door - Dome Lights On When Switch On?
I have had the PSD about 2 months. It's a 2000 Ext cab LXT.
If you open the door, no lights. If the key is in the ignition and you open the door it buzzes. If you have the light on, the light around the door locks and window controls stay on after you turn off the truck until you open the door. The dome light never comes on unless you use the switch on the light. What's up with the darkness! This truck is like a cave! No under dash lights, no door lights no dome light! As for those red lenses on the door, no wiring, no lights no nada! Do the lights com on when you open the door? Any light?
Ford 7.3L Power Stroke (1999-2003) :: Reverse Light Wire Location
I'm getting ready to put in my new double din and it said to hook the wire for the camera up to the reverse light wire. Which one this is on the harness coming out of the column?
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: 2000 F550 Turns Over / Black Smoke From Tail Pipe But No Start
Ok I'm working on a 2000 7.3 on a F550 truck was running but had no power so we changed out all the injectors and glow plugs and rebuilt the turbo now there is no start it turns over and were getting black smoke from the tail pipe. What is going on with it?
View 2 RepliesFord 7.3L Power Stroke (1999-2003) :: 2001 F250 Will Not Move / Won't Go In Forward Or Reverse
Just bought an 01 F250 7.3 but it will not move I think it has something to do with the fuses because it won't go in forward or reverse but I can't find an accurate diagram For fuse box I'm missing probably 8 fuses underneath the dash and I think one of them has to control the transmission module. What it could be if someone doesn't think the fuses...
View 9 RepliesFord 7.3L Power Stroke (1999-2003) :: 2001 F350 - 4r100 Transmission - No Reverse
my parents have a f350 which now has no reverse. it has a reman sticker on it, 230k on the truck but no idea on mileage on the tranny. shifts 1st through 4th fine, no slip. Tc lockup works just fine. No codes found with my solus scanner. When shifted in reverse it will move back about 2 ft if revved above 2k and then nothing. Am I looking a trans rebuild or is there something I can check and repair with in it the truck?
View 4 RepliesFord 7.3L Power Stroke (1999-2003) :: Popping And Thumping Noise When Make Hard Left Turns Driving Around Town
Back in January I had my right front wheel bearing and u-joint go out, so I replaced them both. At the time I didn't realize my outer stub axle shaft was wore so I just put it back in. After a little driving the right side started to "thump" and "pop" when I would make hard left turns driving around town.
I replaced the outer front stub axle shaft and seal again because the old one was worn down. This eliminated any play in the u-joint. After a bit of driving the thumping and popping noise came back.
I decided to dig into it today so I pulled it all apart. When everything is apart it turns easily, no issue at all. When I assembled the wheel bearing, torqued it to 55 ft/lbs and installed and "locked" the hub I noticed something peculiar. I can barely turn the whole assembly by hand. I have to put a good amount of force to get the whole assembly to turn at all. When I walk to the driver side with all the same parts there i can turn the wheel bearing and locked axle shaft with one finger on the studs.
I have been in this thing 5 times and can not figure out what the heck is wrong. I can't figure out why this stupid axle shaft and wheel bearing are so hard to turn, together or separately, and I can't figure out how to get my front end to stop that thumping and popping.
Ford 7.3L Power Stroke (1999-2003) :: 2001 - Slight Whine / Grinding Noise Only In First And Reverse
I have a 2001 f 350 7.3 diesel r 400 tranny 320000 miles. . Im having transmission issues. It makes a slight whine/ grinding noise only in first And reverse. And it surges. Sometimes its fine though to. Check engine light came on. Only codes i get are #4 glow plug out and a low boost pressure. Checked boost before fixin Running fine at the normal about 20 psi. ive read a bad or dirty map or iat sensor can cause transmission issues along with the low boost error code. But in my experience and some reading it sounds like a stall converter.
View 9 RepliesFord 7.3L Power Stroke (1999-2003) :: Truck Takes 30 Seconds Or So To Start Moving Especially In Reverse When Started
When I start my truck it takes 30 seconds or so for the truck to start moving... especially when in reverse. If I give it some gas it doesn't take quite as long. I am not a transmission guy. I assume it has something to do with building pressure but I don't know what would be the cause. The fluid is full and looks good.
View 8 RepliesFord 6.7L Power Stroke Diesel :: Source For Switched Power Under The Dash
I am looking for a source for switched power under the dash. I am going to wire up power to my TST507 TPMS but I would like to have switched power. I have a bundle of wires all capped off under there but no idea if any are switched power. I thought I would ask before trying to probe each and every one.
View 7 Replies