Ford 6.0L Power Stroke Diesel :: Scan Gauge Just Went Blank
My ScanGauge just went blank, which was nuisance because I like to monitor it in the mountain climbs. It felt like a 'naked' dash without it. My separate pyrometer was the only additional info I had. The ScanGauge only has a few thousand miles on it. Wondering how reliable these things are before considering getting another, or inquiring about a fix I know I will first have to double check that the OBII port is still OK, but I expect it is.
View 11 RepliesFord 6.0L Power Stroke Diesel :: PID To Monitor MAF With Scan Gauge II?
I have googled for this and searched the typical sites but cannot find the PID to monitor the MAF with my scan gauge II. Am I blind or does it even exist?
View 1 RepliesFord 6.0L Power Stroke Diesel :: Engine Off Scan Gauge Shows 14.4lbs
2005 f350 6.0, parked in my shop and the batteries were dead after 2 weeks on vacation, (I left a few items plugged into 12vdc ports charging) charged it up and started right up. Next day cruising down the road about 75 the wrench icon showed up, strange. I reviewed my scan gauge and only thing not correct was my boost, it was 20lbs plus, idles at 14lbs. dash gauge appears normal.
Next morning I turned on the key, turned on my scan gauge engine is not running and the reading show 14.4lbs on my scan gauge. so..... adding the 14.4 to the scan gauge reading thru the drive cycle. so my computer thinks it is seeing 20-30 boost during acceleration. A bad sensor......... but don't know which one.
Ford 6.0L Power Stroke Diesel :: 2005 - 2007 - Setting Up Scan Gauge?
I'm looking to buy a used 2005-2007 6.0L and bought a ScanGauge to take with me when I look at the next truck I'll be considering. I dont have a truck now and I see that the ScanGauge derives power from OBD port of the truck. Is there any other way to set it up in advance?
View 9 RepliesFord 6.0L Power Stroke Diesel :: Oil And Coolant Temps Never Go Above 190
I have a new(and flushed) oil cooler and new thermostat and my coolant and oil temps never go above 190. They are always within 3 degrees at most but is this actually losing fuel mileage? I thought these were good numbers, could be wrong though.
View 1 RepliesFord 6.0L Power Stroke Diesel :: Hot Temps - No Coolant
I am looking for some insight on an issue before I lose sleep over head gaskets. Headed out today in the truck, and no heat whatsoever. Im thinking maybe a vacuum issue, but 4wd (esof) and all vents move just fine. About 10 miles in I over heated at 236 ect. After cracking the coolant cap there was no coolant. I havent actively monitored it but last i checked was fine.
The exhaust does not smell sweet and I see no puddles or any evidence of coolant splatter before today when i refilled it today. There was some tonight but im thinking that's from me spilling some today. Egr is also blocked off. I need the truck soon for plowing so need this resolved asap.
Ford 6.0L Power Stroke Diesel :: High Coolant And Oil Temps?
New 6.0 owner having some issues. I have read just about everything I can find on the ECT/EOT problem.
208K on it, its been studded, running a full banks system. Factory size tires. Since buying it I have drained and flushed with distilled 4 times before new ELC coolant (system looks very clean, no debris found at all), T6 oil change and cleaned the air filter.
I am having a large delta on ECT and EOT. Here's some data from today's run. There is a lot of it. Readings from every minute.
Ambient Temp 118 today, took it for a run up the highway cruised north at 65 mph and back south at 75mph. I was driving on Saturday at 75mph and got the wrench light for excessive delta with 232 degree EOT.
45mph on the way to the Freeway- ECT 195.8, EOT 213.5
65mph after accelerating lightly- ECT 197.6, EOT 216.4
10 miles later, flat 65mph cruise set, it maintained a reasonable temp hold and reached max of ECT 199.4, EOT 218.7
After 2 minutes of coasting down off-ramp and sitting at a light- ECT 195.8, EOT 213.5
after reaching 75MPH moderately- ECT 201.2, EOT 216.5
1 mile later, holding 75mph- ECT 204.8, EOT 220.2
2 miles at 75mph- ECT 204.8, EOT 224.6
3 miles at 75mph- ECT 204.8, EOT 225.2
4 miles at 75mph- ECT 204.8, EOT 226.4
5 miles at 75mph- ECT 204.8, EOT 227.3
6 miles at 75mph- ECT 204.8, EOT 228.2
7 miles at 75mph- ECT 206.6, EOT 228.5
8 miles at 75mph - ECT 208.4, EOT 231.0
At this point I dropped cruised and coasted to the next exit, a mile down.
After coasting to exit and sitting for a minute- ECT 201.2, EOT 221.0
After a mile at 45mph- ECT 203.0, EOT 221.6
2 miles at 45mph, lightly on throttle- ECT 204.8, EOT 221.0
After idling stopped for a few minutes- ECT 195.8, EOT 213.8
Driving again lightly at 45mph- ECT 203.0, EOT 211.5
Am I just ignoring the obvious oil cooler issue or is this a water pump, etc? I changed out the thermostat again for another motorcraft unit after Saturdays hot run. I swear it did not run this hot when I got it... but I question if they were running nearly 100% water in the system. What EGR cooler there is, if there is a way to tell without disassembly?
Ford 6.0L Power Stroke Diesel :: Coolant Temps Seem High
It's been pretty smooth sailing since I installed my BPD oil cooler a couple months ago, oil temps are great now. However, in the last month or so, since the outside temps have gotten hot, I'm noticing that my coolant temps seem to be a little higher than they should. I put a new Ford thermostat in it back in the fall when I flushed the coolant system and refilled with EC1 coolant. The temps I'm seeing range from 206 up to 222 and I have seen as high as 230 when I was going up a long grade on a hot day. This is not towing.
The fan does kick on like it should, or at least I think its working properly. When the temp gets to 210-212 I can hear the fan a little, when the temp gets to 219 I can really hear the fan. It usually cools it back down pretty quick unless I'm headed up a long grade. Am I wrong in thinking these temps are too high for a 192 degree stat? My worst fear of course is head gaskets even though I don't have any other HG symptoms. No coolant loss, no puking. What other things should I check first? A new thermostat would be easy enough but I don't know if that would be the issue or not.
Ford 6.0L Power Stroke Diesel :: 2007 F250 - Max Oil And Coolant Temps?
I have a 2007 F250 with the 6.0. Towing up a long hill my truck went into limp mode. I didn't have gauges at the time so I didn't know what my temps were. I now have gauges. I know that the coolant and Oil temps should not be more than 10-15* apart, but what is the max temp that oil should EVER get towing up a steep and long hill? Also, what is the max temp that coolant should EVER get towing up a steep and long hill?
View 14 RepliesFord 6.0L Power Stroke Diesel :: Higher Than Normal Coolant Temps
Took a trip today that was 3 hours there and 3 hours back. Truck ran normal on the way there (eot about 202 and ect about 196-198), but on the way back truck ran a little hotter than normal (ect as high as 214 eot stayed within 2-3* plus or minus ect). Fan did kick on every time I hit ect of 212 and would drop it down to 196-198 and oil temp would drop at the same rate.
Truck is stock 190k miles with a bulletproof egr cooler and coolant filter. Oil cooler probably has about 20k on it. (4th one on this truck- since I like changing them out as much as the rest of us). I checked coolant level when I got home and I might've added a pint to get to bottom of sticker. I'm not sure it wasn't a pint low when I did last flush and cooler replacement.
No puking and I can't find any leaks. I pulled egr valve and no moisture in manifold just a worm out o ring that'll I'll replace. I can't find any leaks. Where to check that I haven't? I don't feel like I'm losing coolant because I wasn't really low. My fan never failed to kick on when I hit 212 or stopped at a red light. No moisture in manifold so I'm not thinking losing coolant due to head gasket. Maybe radiator looks ok but tomorrow I will blow out any bugs to make sure.
Ford 6.0L Power Stroke Diesel :: 2005 F250 - Message Center In Gauge Cluster Only Show Mileage And Engine Hours
2005 6.0L F250 Lariat. I picked up a couple weeks ago. The message center in the gauge cluster will only show my mileage (kilometres) and engine hours but nothing else.
Also the three buttons/controls to the right of the steering column don't do anything. I checked the wiring behind the dash and it's all plugged in... The other problem is the SRS light will flash on and off while driving.
Ford 6.0L Power Stroke Diesel :: Coolant Pressure Gauge Installation?
Adding a coolant pressure gauge to truck? There are some expensive kits but considering I already have a gauge that would work, could I just buy a 5v sending unit for fuel pressure or oil pressure and have it work?
View 14 RepliesFord 6.0L Power Stroke Diesel :: 2004 - Engine Coolant Temp Gauge Does Not Work
Bought this truck, and the engine coolant temp gauge does not work, so I replaced the sender, still don't work.
View 8 RepliesFord 6.0L Power Stroke Diesel :: Max Oil Temps While Towing
Last year while towing my fifth wheel to the North Rim of the Grand Canyon my oil temp went to 260 degrees several times. The outside temps were 95 degrees at the start and it is a long steep climb with a heavy load. Each time I pulled over for a bit, as I couldn't remember at what temp that plastic thing inside the oil filter melted. Each time it cooled off fairly quickly but it really stressed me out. So how hot can the oil get. I am using Rotella T-6 and my temp different is only 12-15 unloaded. Could I allow 280 for 15 minutes or so?
View 11 RepliesFord 6.7L Power Stroke Diesel :: Truck Temps While Towing In Hot Weather
I was towing the 5er (about 15000#), across Southern Mn and SD today going right into a 20-25 mph wind in upper 90 temps, saw 228 on the oil temp and 199 on the tranny temp. When tow need to see for warmest temps and at what point you start to get concerned...
View 10 RepliesFord 6.0L Power Stroke Diesel :: No Crank Mainly During Colder Temps - Code P0341
I've got a no crank issue this morning. This truck has done this randomly off and on, mainly during colder temps, but normally if I hold the key in the start position for a few seconds it will crank. This morning, no such luck. Batteries are good, everything has power, I can hear the starter relay clicking when I turn the key to start but it won't turn over. It never does this during warm weather. It got down in the low 40s last night and it's rearing it's ugly head this morning. The only code is the P0341, camshaft position sensor, but I don't know if that would be the cause of this or not. It's a starter issue or the CPS?
View 4 RepliesFord 6.0L Power Stroke Diesel :: Blown Upper Radiator Hose And EOT Temps
This weekend while towing a light load I noticed my FWT and EOT starting to climb rapidly, EOT reached 260 FWT I think about 240. I exited the interstate to find I had a busted radiator hose. I replaced the hose and filled the system with distilled water, but didn't add antifreeze at this time. The system wasn't completely empty.
I noticed once back on the road my EOT seemed to be higher than normal but FWT seemed to be normal. Could the lack of antifreeze cause a greater delta between FWT and EOT? I have seen articles which state do not use Ford Premium Gold Coolant, but to use CAT EL-1 coolant instead. Which should I use?
Ford 6.0L Power Stroke Diesel :: 2005 F350 - Extremely High Oil Temps When Towing
On my 2005 F350 Super duty 6.0 Power Stroke Diesel I have extremely high oil temps when towing and also have a warm start problem. I need to tackle both these problems at the same time but I am struggling to find the correct (and still affordable) parts for this. My local parts store and Ford dealer are way over priced.
First, I need an oil cooler (truck has an EGR delete so no EGR cooler).
Second, I want to replace all the seals in the high pressure oil system and replace the HPOP elbow.(Already replaced IPR)
Third, I would like to do the Blue Spring update as well while I am in there.
Looking for part numbers or kits numbers. I usually do all my own research but right now I am way too swamped at work and home to find these parts.
Ford 6.0L Power Stroke Diesel :: Sudden Overheating / Temps Spiked While Driving On The Freeway
2004 F250 6.0 L. New head gaskets, ARP studs, new oil cooler, new water pump, all new hoses, new thermostat, 4" exhaust, EGR delete, new coolant bottle, radiator and cooling system flush, new injector seals and oil rail plugs all done at 98,000 miles. The truck is at 119,000 now and has been doing great since all the work. I have been frequently hauling very heavy loads and pulling cars on trailers and no problems. EOT has been staying about 7 degrees above ECT except on hill climbs. No coolant loss at all. Today suddenly while driving on the freeway (unloaded) the temps spiked. I pulled over when the ECT hit 240. Once cooled down I checked coolant level, hoses etc and since all was fine I took off again. Overheated again after about 5 miles. My understanding was that the Ford thermostat fails open if it fails. Do I have that wrong? Do I have a stuck thermostat? Some other problem?
View 14 Replies