Ford - Explorer :: 2000 - Upper Or Lower Intake Gaskets
Our 2000 explorer xls 4x4 with 4.0 ohv just pop the code for the intake gasket leaking. My question is, would there be any way to tell if it is the upper or lower that is leaking? It has 188k on it but still runs good. I think I can feel a miss in it at idle but it is not a steady miss.
View 1 RepliesLexus GS 2013+ :: Changing 18 Inch Wheels On Luxury Edition GS350 To 20 Inch?
I'm interested in changing my wife's 18 inch wheels on her luxury edition Gs 350 to 20 inch wheels. what comfort level from the 18 ' s to the 20's I would loose. I know there will be a comfort lost , but is it major..
View 7 RepliesLexus IS 2014+ :: Difference Between 17 Inch And 18 Inch Wheels On IS250?
I have driven two Lexus IS 250's with the standard 17" wheels. I am considering trading up to the 2014 model, which appears to often come with 18" wheels on the AWD model (which is what I am looking for).
What differences can I expect on the 18" wheels vs. what the 17" gives now?
Ford - Explorer :: 2001 - Backfiring Through Intake
I have a vehicle that came in on the hook its an 01 exploder4.0 sohc no start.. when cranking it will back fire through intake. no dtc's however its also showing all monitors not set?? dead battery erasing keep alive memory I don't know. Here's what i do know apparently it had gotten partial tune up all left side plugs and wires changed. All right side plugs and number 3 wire factory. I have plenty of fuel pressure. It appears that all cylinders have 150 psi for compression.
I changed all plugs and spark tester is showing there is spark at the plug, (yes at all) just cranks and cranks and then back fires. I also have removed front ho2s to rule out blocked cats, wires are not crossed. I have an rpm signal which should have been evident when I had spark and injector pulse. have not changed the wires nor the coil which is a 6 pack coil. (Boss refuses to get them for me since i have spark )even though I told him there was some arcing.
Grand Prix :: 2000 - Soft Brake Pedal Goes To An Inch Off The Floor
I have a 2000 Grand Prix 3.8 with 65,000 miles. Bought the car new for the wife to drive. The front brake lines rusted out. My wife has a friend who is a backyard mechanic. She had him replace the front brake lines, from the abs block to each front wheel. Well she finally told me that the brake pedal is not right. I went out and sure enough with pressure on the pedal it goes to an inch off the floor. I bled all for lines at each caliper, no change in pedal. I bled almost a full bottle of fluid. You can pump the pedal for 10 minutes and no change in the pedal. I don't think it is air in the line. I changed the pads and rotors on all four corners last fall. The brake pedal was normal then.
View 5 RepliesExplorer :: 1999 Ford 4.0L - Removing Upper Intake
I went thru a 100 posts on "Intake gasket" search but I couldn't find any repair information on the 4.0L intake gasket replacement. I'm having difficulty pulling the upper intake off. All nuts and connections have been removed except for the egr tube that's connected to the upper intake.
According to another site, u should be able to just pull straight up, clear the intake studs, turn the intake to the left and then up due to the fact the egr tube is curves inside the intake towards the front of the upper intake. No luck. egr tube won't separate from the intake. This is a little long but everything has been disassembled to this point. BTW this is a 4.0L OHV engine
Golf IV R32 :: Loud Whooshing Sound / Vibration After Intake Mod
Couple days ago I took out the factory air box and cut the bottom out. I also cleaned my K&N filter at the same time. I cut the whole bottom edge to edge up to about 2" from the flapper on the motor side of the box. Re-installed and everything is tight. I drove the car and noticed a LOUD or what I consider loud noise from about 3,000rpm to redline. I am thinking it could be just the additional air being sucked from the air box. However its much louder then I would expect from a CAI. Does a CAI make a loud difference? I noticed a increase in performance so I know its working. Also, it could be described a a light, smooth sounding exhaust leak. But I am susceptible since this problem was not their prior to the intake mod.
View 6 RepliesFord - Explorer :: 1998 - Vacuum Line Missing On The Top Of Intake
I have a vacuum line missing on the top of intake its a 98 explorer 4.0 sohc. I don't know where it goes...
View 2 RepliesFord - Explorer :: Changing Upper And Lower Intake Gaskets
I'm in the process of changing my upper and lower intake gaskets. my question is, the upper intake along with the tubing on the fuel rail are caked with oil/carbon, along with the back side of throttle body. What would be the best way to clean them?
View 2 RepliesFord F-150 - 1997-2003 :: Loud Humming Coming From Air Intake
First of my truck is an 03, xlt 4.6 5-speed with 82,000 miles. Almost always when i come to a stop i can hear a faint humming that is coming from the engine compartment. There is no pattern or set way that this humming happens, it just comes and goes when at idle. As soon as you put load on the motor it will go away. I got under the hood today and fired it up, nothing, gave it just a little throttle and sure enough here is this odd humming. It is coming from in the air intake. Also while i was under there i noticed that the cable that is right next to the throttle cable is very loose, i am not sure what this cable goes to or if this could be part of my problem
View 14 RepliesFord - Explorer :: 1997 - Found Oil In Manifold And In Cold Air Intake System?
I have a 77 bronco with a 5.0 efi engine from a 97 Ford Explorer. I noticed there is oil in the cold air intake area and upper intake manifold. I was checking on things and noticed oil around the PCV valve and on the outside of the cold air intake system. Should I be concerned about this? I have done some research. I checked the PCV valve and intake manifold gasket which appear to look fine.
The PCV valve rattles and the gasket is intact. Granted there isn't a lot of oil when I looked inside the upper intake manifold but thought I should write and ask if this is a problem or not. Should I just replace them pcv valve any ways and recheck it after driving it for a few miles? The explorer did have 110K on it but when we took it apart we thought the engine looked great for how many miles it had on it. We did change out the cam and timing chain but as far as the other parts, we did not replace.
I am also getting a unusual reading to not reading with my oil gauge. When driving for a about 30 minutes or so, My oil gauge goes down to zero when I'm stopped but when I'm drive off then the pressure comes back up. When I have it in park the gauge reads fine.
Ford - Explorer :: 2002 - Missing At 90k Miles - Noise From Intake Area?
The other day my 2002 Sport Trac with 4.0 started to miss badly. It has only about 90,000 miles on it. It started to do this suddenly from one turn of the key to the next. It also makes a weird noice that sounds as if its coming from the intake area that can be described as a "chuffing" sound thats in time with the engine. The intake also gets very warm to the touch. We have since stopped driving it. I sprayed carb cleaner all around where the intake meets the head with no change in rpm. I also checked the plastic hose that goes behind the engine to the pcv valve and its ok.
View 10 RepliesFord - Explorer :: 2003 - Vacuum Leak And CEL On - Air Intake Gasket Replacement
I have a 2003 Explorer with the 4.0 K motor. It has a vacuum leak and the check engine light will come on from time to time. My work buddy has a high end computer and it showed that the driver side bank was running lean. The computer showed the O2 sensors to be working fine, and I replaced the PCV valve. All other vacuum line appear to be in good condition and I tried the spray test with the break cleaner with the motor running. This is leading me to believe the air intake gaskets where due for replacement. Here is my problem, I can not get the last bolt out of the plenum. The one on the driver side up against the fire wall. I tried to remove the cowl in order to get a straight shot at it but I can not get the seem seal to break free.
View 4 RepliesFord Super Duty (1999-2016) :: 2000 F250 V10 - Doing 2 Inch Level - Drop Pitman Arm?
I'm planning on doing a 2" level. Will I need a drop pitman arm, or can I stick with the stock pitman arm? Will I need anything else? I plan on doing the level when I replace my coil springs and shocks. (I have another thread on that). I'm driving a 2000 F250 V10 2WD CC SB (twin I-beam front axle) if that info is pertinent to this question.
View 2 RepliesGolf/GTI VI :: Loud Growl Coming From The Intake That Lasts About 20 Seconds On Start Up
So I installed my intake....again this weekend and have been monitoring it to make sure it doesn't pop off again. When you first start up, there is a very loud growl coming from the intake that lasts about 20 seconds. I also noticed that the breather filter kicks in during this time as well. Is this normal? I would yes but want to understand exactly why...
View 12 RepliesFord Aerostar :: Intake Ducts Making Loud Moan When Slowing Down To A Stop Or At Low Speeds
Lately, when slowing down to a stop, or very slow speeds, the intake ducts make a very loud moan. It sounds like a muted horn really. Sometimes, I can put it in park, and it'll be making the noise. Open the hood, and it feels like it is coming from the plastic intake tube. When it does this, the motor likely stalls out, and needs to be restarted.
Another issue, we cruise with it at roughly 100 kph. It works good, that 4.0 has gobs of power, but when cruising, sometimes it will very randomly work bad, just have a misfire hissy fit! It doesn't affect the cruising, but it just works funny.
Its a 1997 Ford Aerostar with the 4.0 OHV, and the E- 4wd with the Dana TC28 transfer case.
Ford Ranger / B-Series :: 1996 4.0 - Loud Whistle Intermittently From Intake Manifold Area
Just bought this truck and no check engine light was on, went to get it smogged so I could register it and it had the following fault codes: P1443, P0401, P1131, and P1132. The truck seems to run great in my opinion and even gets really good gas mileage. There is a whistle intermittently from the intake manifold area though that is at times pretty loud.
Smog tech told me these trucks are "notorious" for the check engine light going bad and that usually the entire instrument cluster has to be replaced in order to fix it. I'm a very experienced motorcycle /small engine tech but do not have much experience with car/truck engines and especially not with emissions control systems.
Again it is a 1996 Ford Ranger 4.0 V6, 4 wheel drive STX with 185,000 miles on it. Where to start or what might be the source(s) of these error codes?
Ford 7.3L Power Stroke (1999-2003) :: Installed New Intake Now Loud Shutter When Changing Gears?
Put in my new S&B intake today and when I stomp on the gas I am getting a loud shuddering noise from the intake when I change gears. Also sounds like a squealing sound sometimes. Doesn't sound like other trucks that I have heard. What that could be?
View 14 RepliesLS / MKZ :: Torque Sequence On Lower Intake 2000 V6
Looking for the torque sequence on the lower intake for a 2000 ls v6 ?
View 7 Replies