C/K :: 1995 - All New Plugs And Wires But No Spark
Had issues with TBI, rebuilt. Had some starting problems after truck sat for 1 day or more, but would start after a few tries. At one point when it was particularly stubborn, starter lead vibrated off. Once reconnected, truck started, ran fine, but had some electrical humming & radio interference. The starting issue continued with some low rpm stumbling, when driving check engine light would come on at cruising speeds and go off 7-8 seconds after letting off gas.
Had 1 day lest week when I drove a bit more then normal (150+) but ran fine other then engine light. Next day started, but ran horribly rough with violent back fires. At one point stalled and would not restart. It looked and acted like it was flooding itself out and poor spark. Less then a year I replaced cap, rotor and coil. Now I have done all new plugs and wires. Now it appears I have no spark. I had been in the dash messing with the blower motor relay 2 days prior to the stalling and not starting.
Does the ECM control spark? Cant it go bad slowly? And if I had to do alot of cranking of the engine to get it to start, would that have any thing to do with it going bad?
Passat (B5) :: Oil In The Ignition Wires And Spark Plugs
Today I ran into a problem while i was changing my spark plugs ...two of the plugs were completely covered in oil. I mean oil was literally dripping off those plugs. I have a Passat 1999 2.8L V6. What could be wrong.
View 3 RepliesEscort :: 1996 Ford - Spark Plug Removal
I want to remove the spark plugs but unable to loosen them. How I can easily loosen them up without breaking them?
View 2 RepliesFord F-150 (2004-2008) :: 2006 - When To Change Spark Plugs Normally?
I am a newbie here, and also a new owner of a 2006 F150 XLT 4X4 with the 5.4 engine. It has 68K miles on it and looks to have been well cared for. I have a couple questions. First the truck is runnig great, no problems. I have read the threads regarding the spark plug issues and was looking for an opinion about changing them. Should I wait until I have problems, or due to the age of the truck, should I go ahead and attempt it soon? Also, I would like to find a used cap for the bed. I have the 6.5 bed, and wondered what range of years would work with my truck.
View 3 RepliesFord Super Duty (1999-2016) :: 2015 - Change Spark Plugs With Cab On?
Got a 2015 6.2. No where near time to change plugs, with alot accessories i have installed it would suck if the cab has to come off. Can the plugs be changed with the cab on?
View 12 RepliesPhaeton :: How To Change Spark Plugs
I would like to have a look at the condition of the ignition plugs in my V8 Phaeton.
According to the service plan, it's already time to change them and it also seems that the car has lost some power when accelerating.
Is it even possible to change them with the 'usual' knowledge (knows how to change a tire and so on) or should I better go to a professional.
Tiguan :: 2010 - How To Change Spark Plugs
I need to change spark plugs in my daughter's 2010 Tiguan but I have never worked on a VW before. How do I get to the spark plugs and what brand is recommended?
View 6 RepliesLexus GS 2006-11 :: 08 GS350 With 57k / Change The Spark Plugs?
I'm wondering when I should get the spark plugs change.
I have 08 GS350 with 57k.
Phaeton :: How To Access And Change Spark Plugs On V8 Engine
I would like to have a look at the condition of the ignition plugs in my V8 Phaeton. According to the service plan, it's already time to change them and it also seems that the car has lost some power when accelerating.
Is it even possible to change them with the 'usual' knowledge (knows how to change a tire and so on) or should I better go to a professional.
Toyota - Camry :: 1996 Frequently Keeps Losing Power To The Spark Plugs
My old 1996 Camry with 2200 cc 4 cylinder engine, frequently keeps losing power to the spark plugs. I have changed the fuel filter and the ignition coil. That did not work. I also noticed that the car was starting when I unplug and replug the primary wire plug to the ignition coil. So I have replaced the primary power plug with a six inch pigtail and a used plug purchased from a salvage yard. This is not working either. The Toyota dealer near my house want to replace the igniter and the Engine Control Module just to be sure that these are not the sources of problem. The dealer did not test these parts. So I refused to replace the parts without a proper test. I would like to test these parts. Is there a test available for the igniter and ECM that could be performed. I have access to a lot of tools. I need a schematic and/or test to test these components.
View 18 RepliesToyota - Corolla :: 2002 - Tighten Spark Plugs To Same Torque Specifications As Regular Plugs
I am changing my own spark plugs for the first time. I have a spark plug wrench, dielectric grease, anti-seize compound etc.
I have a Haynes manual for my 2002 Toyota Corolla. The book was written before Irridium plugs were used. Should I tighten the spark plugs to the same torque specifications as regular plugs? The book says 158 inch pounds. How do I know I have tightened them to the right amount?
How do I avoid cross threading the spark plugs? What happens if you cross thread the spark plugs (assuming the car seems to be running fine)? Would I need a new engine or expensive repair when it is time to replace the spark plugs again?
Ford Ranger / B-Series :: 2001 - Turns Over Great But Will Not Start After New Plugs And Wires
2001 Ford Ranger 4.0 - 250k miles had the original plugs and wires ....
First things first - I changed them one at a time and confirmed the truck started and ran after each one was changed. I changed all the plugs on the drivers side with no issue. 4,5,6 ... Then I changed plug 3, rear passenger side plug closet to the firewall.
Truck will not start, turns over great, but will not start. I have confirmed I am getting spark. No clue what could have changed, I just pulled out the old plug and wire put in a new one and it wouldn't start.
My father-in-law said if you have spark check fuel. I recall seeing a post about someone breaking a cable for the coil pack but i have checked and i see nothing broken.
Ford - Escort :: 1999 - No Start After Cranking / Plugs Wet With Fuel
99 escort 2.0 will not start. Has spark, fuel pressure, and 100 psi compression in each cylinder. After cranking for awhile , pull the plugs out and the plugs are wet with fuel. There is no answers anywhere on the net, but apparently there are others like this out there. No codes also.
View 1 RepliesCamry 2012+ :: Unused Door Plugs / Wires?
While I was installing my side mirror turn signals I noticed there were two plugs tucked away in plastic not connected to anything. One is towards the outside of the door. As if it was to be connected to the door handle sensor that comes with the push button start package. The other one was towards the inside of the door, as if it is used with the lane assist or even side mirror turn signals. I never really messed with them as I was following the DYI. I should've checked to see if they were wired to the turn signals so I wouldn't have had to run the wires all the way to the fuse block. Below are the pictures of what I'm talking about.
Front/Inside of door
Rear/Outside of door
Buick - Lesabre :: 2001 - New Plugs / Wires But Still Misfires
I just bought a 2001 Buick Lesabre and it was driving fine until this morning when it misfired on the highway. I was going about 40 mph and I felt a little jerk in my engine and my CEL started to flash. I pulled it over and got it towed to my house and my code reader says a p0300...which is a random misfire code. So I figured i just need a tune up so I went and bought new plugs and wires and replaced the old ones. And to my surprise...still a noisy shakey rough erratic start and idle. Before this there were no problems the car shifted properly to all gears and picked up and accelerated like a champ there were no obvious issues. Now I cant get it out of my driveway. I was wondering if any other problems could cause this misfire, and how to eliminate problems without buying parts?
View 19 RepliesGolf IV / Jetta IV :: 2001 - Misfiring After Installing Brand New Coil Pack, Wires And Plugs
2001 MK4 GTI VR6 put brand new coil pack, wires and plugs in the car because it was misfiring. Was fine for about a week than I got a clogged cat code and could feel the affects. I now have no cat, no resonator, and no muffler. The car is finally driving good and then the check engine light came back. It says only a misfire in Cylinder #3 and when accelerate hard to speed up my check engine light starts to blink until I stop accelerating hard. So my guess is the clogged cat caused that cylinder to misfire but I do not know the actual solution to this. My EVAP hose is semi-pinched and when u squeeze it you can almost kill the engine. The weirdest thing of all is this: driving normal I shift in between 2000 and 3000 RPM and once i get into 4th gear about 2000 RPM......my car starts shaking badly and i feel like my engine is going to fall out. I have searched and the only thing i can think of is a bad injector...
View 3 RepliesFord Aerostar :: Diagram For Driver Side Spark Plug Wires At Coil Pack?
I removed all the spark plug wires for testing/cleaning and install new spark plugs, but stupidly forgot to mark the wires where they came off at the Coil Pack. yes, Now I cannot find a diagram for the Driver's Side wire positions at the Coil Pack.
(The Passenger side wires are 1-2-3, starting from the front of the engine, simple enough); The Coil pack itself has numbers stamped on it, so I have the Passenger side done correctly.
But the Driver's Side wires are not in a Sequence of 4-5-6, instead they are 4-6-5 (or something like that), and I can't remember their positions at the Coil Pack. Looking for a drawing showing the Driver's side Wires as they connect to the Coil pack?
Example:
Front Driver's side plug wire connects to which coil pack position? (Front, Center, or Rear?)
Center Driver's side plug wire connects to which coil pack position? (F, C, or R?)
Rear Driver's side plug wire connects to which coil pack position? (F, C, or R?)
Ford - Escort :: 1999 - Weak Spark On Cylinders 2 And 4
My problem started five months ago and was very intermittent until now. The engine would run rough at start up either cold of hot and then run fine after about two or three miles. Now it runs rough all the time. I have installed a new ignition coil, new spark plug wires and new spark plugs. The engine starts ok but it runs rough and when I pull the spark plug wires one at a time,while it is running, the spark is very weak on cylinders 2 and 4. The spark on the other two cylinders looks good. I have checked the connector on the powertrain control module, which is a EEC-V, and there doesn't seem to be any bad connections there.
View 6 RepliesFord - Ranger :: Cylinder Misfire - Spark Plugs Keep Going Bad
I purchased a 2000 Ford Ranger last year. Within the first two months of ownership, the vehicle was having a cylinder 4 misfire. To fix it, I replaced the fuel filter, plugs, wires and cap - replacing the wires, plugs and cap fixed the issue. The issue went away for four months when cylinder 4 misfired again. I brought it to a repair shop and they again replaced the wires and plugs. The vehicle now has a cylinder 6 misfire.
There has to be something causing these plugs to continually go bad. Rather than just replacing the plugs again, I'd like to attempt to be proactive and fix the root of the issue. I've googled the issue and some of the forums seem to indicate a bad EGR valve.