Elantra XD (2001-06) :: Transmission Is Shifting Into Higher Gear Without Releasing The Lower Gear
My 2006 Elantra (54,000 miles) shifts really, really hard when it's not cold and passes through the 35 mph range -- hard enough to make you glad you've got your seatbelt on. I've taken it to my regular mechanic and now it's in an automatic transmission shop.
My mechanic changed the fluid (twice), and took it through a "learning sequence". The fluid didn't look that bad and he reported that there were no codes to work with. He thinks I'm going to have to get a new transmission.
The AT shop has confirmed that there are no codes to work with and that the problem begins at 143 degrees. They tell me that the transmission is shifting into a higher gear without releasing the lower gear. They tried replacing a couple of solenoids, but that yielded no change in behavior. Now, they're telling me they "think" I need a new computer. I'm just afraid the trial & error approach is going to cost me a boat-load.
Elantra XD (2001-06) :: Stuck In Second Gear
I have a Hyundai elantra 2002 that is stuck in second gear. I was driving it, I came to a stop sign so I put it in neutral and when I shifted into first i heard a pop. I started driving and when I shifted into second I noticed the shifter was really loose, when I tried shifting into third I couldn't.. it is like there is a brick wall. I can shift from 1st to 2nd but the shifter just moves up and down. Also if I let the clutch up it stalls the car. I was told that my car is stuck in second gear.
View 1 RepliesElantra XD (2001-06) :: Grinding In Second Gear
I have a 2005 5 speed manual elantra that I let my wife drive it home when I drove another vehicle and the next day when I went to drive it it started grinding going into second gear. What can be causing this? The clutch works great on the other gears.
View 1 RepliesElantra XD (2001-06) :: Will Not Shift Out Of 2nd Gear?
My 98 elantra will not shift out of 2nd gear?...
View 4 RepliesElantra XD (2001-06) :: Car Would Slam Into 2nd / CEL Come On And It Get Stuck In 3rd Gear
I recently started getting transmission problems with my 2001 elantra.. the car would slam into second gear and the check engine light would come on and it get stuck in 3rd gear.. The codes I am getting are P0720, P0715, P1529. I searched and i found that most people that had this problem replaced the input and the output speed sensor and the problem is fixed.. so i went and i got two new sensors and replaced them i am still have the same exact problem... the car drives good for the first 5mins and then it would slam hard into gear, check engine light comes on the it get stuck in third gear...
View 6 RepliesElantra XD (2001-06) :: Slams Shifting From 2nd To 3rd Gear
I bought my 2005 automatic 4 speed Elantra knowing of this problem and feeling good about being able to track it down. how ever This did not stand to be the case. Start up cold shifts through every gear smooth as silk with know slippage or harsh shifts. roughly 10 to 15 mins after the car reaches operating temp on the gauge it begins to slam into 3rd gear only. Most of the time it is a double slam. Like bam bam real fast but indeed does shift into the 3rd gear then into over drive smoothly. I can duplicate it any time i desire to by merely pulling it back into 2nd gear and manually pushing the shifter back up to 3rd. it will slam every time with out fail. The man i bought it from told me he had this trouble and changed the transmission out with a 500.00 used one and did the exact same thing...
So I felt must be electrical wiring or TCM bad but upon examination i found no codes present to date. he threw parts at it and replaced both input and output sensors based off some thing he read on the net. also he said he replaced the TPS with a TPS from a wrecked car, still same harsh shift. he however could not remember how the fluid looked upon changing it and the filter as he also did that, nor can he remember what fluid type he used. I know shot in the dark right??? What is the actually fix such a hard slam when shifting into 3rd.
Elantra XD (2001-06) :: Noise When Engage A Gear
Just wondering to diagnose the noise my manual 2002 is making when I engage a gear.
Generally, it'll clank every single time I put the gear in gear. I.e. clutch down (quiet), shift into gear (clank), lift clutch up (clank).
Very annoying; has been happening basically since I bought the car (but obviously not when I test drove it!)
I do not think it's a motor mount, especially since I wouldn't think that moving the gear into gear (before lifting clutch back up) would cause the motor to shift enough to make the mount clank. If at all...
Anyway, here is a link to a YouTube video I've uploaded. Every time you hear a clank, I'm simply lifting the clutch to engage the gear. I do this quite a few times going forward and backward. [URL] .....
Elantra XD (2001-06) :: Car Stuck Into 2nd Or 3rd Gear While Driving
2001 Hyundai Elantra 183 miles.
codes- p0720 output speed sensor circuit malfunction, p0500 veh speed sensor a malfunction.
Recent fixes on my 2001 Hyundai Elantra.
A few months ago i had my speed sensor cleaned, and a power steering leak. No problem after that was fixed and cleaned the sensor. Soon after that my water pump went bad and i had that replaced along with 3 new belts. Just last week i had my front driver side replaced with a new wheel bearing and axle.
My Problem then and now.
My problem months ago, my car would be shifting into different gears as it pleased; while driving or sitting at a light i would feel it jump and it felt as if it was stuck into 2nd or 3rd gear as i was driving. My engine light would soon come on after this. To accelerate i feel as if i had to floor my pedal when the shifting or engine light came on. I looked up my codes and they are the same as they are now. I read about same problem and fixed it by just cleaning the speed sensor off. My friend and i did the same thing and it fixed those issues. My problem now is that i just had my axle and wheel bearing fixed (my car moves smoother and quiet) my engine light came on again, it had not been on since, i read the codes and they are my speed sensor same as before but my car has not been shifting as it was in the past. Would this be because the sensor needs to be cleaned again or replaced, or because of my new replacements on my wheel.
Elantra XD (2001-06) :: Engine Missing When Put It In Gear
Our Hyundai Elantra starts up and idols like a dream, but when you put it in gear the engine misses so bad it doesn't want to go. What could be the problem that is causing it to do this?
View 5 RepliesElantra XD (2001-06) :: Pulsating Vibration Only In 5th Gear At 40 - 45 Mph
In my 2005 elantra GT 5 speed, I get a weird pulsating vibration in 5th gear at 45-50mph. It's noticeable enough to have a friend ask me about it. But it's very slight. I have 124k miles, and a new clutch. I've only had the car for a couple weeks so it's still new to me. My first inclination is axles or a wheel bearing. Maybe a motor mount. But then again, only in 5th?
View 3 RepliesElantra XD (2001-06) :: Car Jerks Sometime While Changing Gear
I've hyundai elantra 2013 while changing gear by car jerk and sometime it doesn't jerk. What is issue causing car to jerk when changing gear. It happens not every time, sometime it don't jerk while changing gear.
View 1 RepliesGolf V R32 :: Thuds When Transmission Shifts Down?
When I come to a stop in S mode there's sometimes a noticeable thud as the transmission shifts down. Is this something I should be concerned about or want to try to fix?
View 9 RepliesElantra XD (2001-06) :: Each Gear Catches On Something And Stalls After MTX Replaced
I replaced the MTX transmission, and while cleaning off the rotors of oil, I let the one side spin while in first gear. I put the wheels back on and started to back out of the driveway. It seemed as if I was rolling into something as it wanted to stop moving backwards. I then put the front of the car back on jackstands and tried to move through the gears. While in 1st or reverse, the car begins to engage and then acts as if it is grabbing gears and will stall. The car does not want to move. I then went outside with the car off and tried to spin the wheels in neutral. One wheel spins one way, the other spins another. I tried to put the car in reverse and it starts to move the tires, then catches on something and stalls. Then, the shifter is stuck in reverse and I have to work to get it out.
View 4 RepliesElantra XD (2001-06) :: Hyundai Won't Shift Into Gear While Driving?
The strangest thing happened to me on the way home yesterday from work. I was driving about 110 all the way home on a highway and took an exit to my local area when i noticed as i approached the ramp i wasn't able to shift into any gears. It just felt like there was something blocking me, like a wall of rubber or something. I stopped the car on the side of the road, unsure what was going on. While the car was on and my foot on the clutch, i am able to move into all gears perfectly fine but its when i start moving i cannot go into the others. Strange. I was able to force it into second gear from first but it sounded like two plates or discs sort of sliding around on each other..maybe that was my imagination but i stopped and didn't proceed further.
While i was sitting waiting for the tow truck, i remember that the last few months it has been getting harder and harder to get into gears while driving. I would be driving and would have some resistance to get into the pocket. This progressively got worse and i guess lead to this point where i am unable to get anywhere.
First thing i thought was the transmission, but i am able to go forward in first and reverse okay and the clutch pedal was not to the floor. The clutch was recently changed, approx 20k ago.
Could it be something easy to fix? Perhaps the clutch cable has stretched out and it is not pulling me far enough into the gears making it impossible to shift. Maybe the master or slave clutch cylinder have failed? I am not sure at all!
Elantra XD (2001-06) :: Spongy Gear / Idles At 900 Rpms
I have a 05 Hyundai Elantra 2.0L engine(Manual) thats been acting funny. There's a couple issues im having with it.
1. Not matter how far the gas pedal pushed down RPMs wont go over 2,500
2. Car surges and jumps back and fourth sometimes.
3. Idles around 900rpm
4. Sometimes when I take off I'm able to get around 40 mph, and thats where it tops out at.
5. Shifting into 1st gear feels a little spongy
6. Also it can go all the way into 4th gear without dying and the top speed will only be at 10mph
Things I've done so far.
1. Compression test cylinders all came back fine
2. Replaced TPS
3. Checked to make sure exhaust wasn't obstructed
4. I got a stethoscope and listened for the ticking for the fuel injectors and also got some fuel injector cleaner.
Elantra XD (2001-06) :: Gear Shift Lurched To The Left
I have an '01 Elantra 5 speed. Been great for 3 years. Replaced the clutch at 169000 km and it's been going really well.
It now has 186000 and just recently the gear shift lurched to the left (I did not notice exactly when it happened) but when I tried to shift down to 2nd it was noticeably more difficult to select. Selecting 1st or 2nd has become more difficult ever since.
It is certainly visible that the shift has moved because when 3rd is selected it looks like 1st is selected. I'm guessing a mounting bolt for the shift may have broken or dislodged.
Elantra XD (2001-06) :: While Driving Car Randomly Drops Into Third Gear
I have a 2001 elantra gls automatic. I have am suffering what seems to be a common problem with these. while driving my car randomly drops into third gear, also sometimes it sticks in like second first (like 5000 rpm just to go 30). my brother put a computer on it and error codes popped up: p0500 vehicle speed sensor; p0501 speed sensor range performance; and p0720 output speed sensor. I checked all the wiring and none of it is damaged, so I'm thinking bad sensor. What i really need to know is, could one of these sensors be tripping the others and if so which one? or should i replace all 3?
View 5 RepliesElantra XD (2001-06) :: GLS Clutch Engaged And In Gear But Car Will Not Move
Here's the scoop: 2 year old clutch & flywheel with 21,000 miles on them. Clutch master cyl. is full & not leaking. The clutch slave cyl. moves when the clutch is pressed & is also not leaking. The shifter linkage has been checked at the shifter and moves freely as it should.
I started the car, put it in gear, let the clutch out and there is no movement from the car regardless of the engine revs. The engine runs freely and does not die with the clutch engaged and the transaxle in gear. Putting it in ANY gear (including reverse) has no effect. The car will not move.
After turning the engine off I left the car in gear, left the e-brake disengaged, released the foot brake and the car stayed put. I then put the shifter into neutral, let the foot brake off and the car began to roll. I stopped, put the shifter back into 1st, let the foot brake off and the car was again stationary and did not roll. This tells me that the shifter linkage indeed works and that the car WILL go into gear. So, why won't the car move under power?
Elantra XD (2001-06) :: Slow Speed Shifting From 2nd To 3rd Gear With CEL On
I have a 2001 Elantra gls which I bought a year ago. It had shifting problems from 2nd to 3rd gear with CEL on. I replaced the input and output speed sensors and connectors and fixed the problem to a point. It was still shifting a little hard even after a fluid change with SP111. I added 2 bottles of Lubeguard red and it has worked immensely almost to the point of no problems....except. At slow speed shifting like going into a store parking lot or on a freeway with stop and go traffic, it will shift hard from 2nd to 3rd (I think) maybe 1st to 2nd not sure. If accelerating at normal speed shifts fine. No cel and the tranny fluid is on the full mark, not overfilled. Would a wheel speed senso cause this or damaged clutch pacs maybe?.
View 4 Replies