Prius V :: Taking Longer To Engage EV Mode
Just recently I"ve noticed my Pri-v is taking longer, and not as often switching to EV. All these observations are after the car has been fully warmed up and driven for several miles with a sufficient battery charge. Previously it would always switch to EV at 43mph when letting off the accelerator.......and I could keep it going usually till about 45.... A quick let of the accelerator would almost always accomplish this. Recently it has not been consistent...a few times not even shutting off when the car is stopped. The car has about 88,000 on the odometer. I've always noticed when it does go from ICE to EV, the transition is not a smooth too. That I"m guessing is the transmission fluid?
View 9 RepliesGolf/GTI VI :: 2010 - Clutch Starting To Slip
I have a 2010 gti with stage 2 tune, and mk6 clutch starting to slip? i have 30,000 miles, i am starting to do my research on the clutches. I am also looking in to just replacing the clutch disk, and i am wondering it just the clutch disk will hold up?
View 24 RepliesGolf/GTI VI :: Clutch Starting To Slip / Cannot Handle It
I have a 2012 GTi. I just got the stage 2 unitronic flash on my car and now my clutch slips bad. I know i will need to replace my clutch. It was starting to slip before the tune and now it just cant handle it. The shop I went to recommended a South Bend Stage 2 Clutch kit (single mass). Its a daily driver and want something that will last and hold up to 325ftlbs of torque. I do think i want to go with the single mass clutch though.
View 13 RepliesGTI 337/20th Anniversary :: Clutch Is Starting To Slip
Noticed recently that my clutch is starting to slip. It only seems to happen when I'm cruising in 6th and floor it. When the boost spikes, the revs will shoot up ~750 rpm and then settle back down before the car starts to pull. It is chipped Unitronic Stage 2 with some other bolt-ons.
What I'm wondering is, should I just drive it like this until it really starts to go, or should I replace it now? And what are my options for a new clutch? I don't want to big turbo this car, so the most it could get is a few more bolt-ons. I'd like a stock feeling clutch.
Elantra GD (2013+) :: Auto Trans Clutch Slip?
I have a 13' GT with an automatic trans and 15,000 miles.
While getting onto the highway yesterday I was in D (not + -) and I was probably in 4th gear and hit the gas pedal maybe 60-70% down and my rpms shot straight to 6-7k but I didn't get any acceleration. I let the rpms drop and it drove fine after. Pretty sure I was smelling burnt clutch too (kind of unfamiliar with that scent, I've never slipped a clutch before).
I should probably take it to the dealer for them to look at it, but am worried it will be a 1-2 week thing and I'm not sure if I'd get a loaner.
Ford 7.3L Power Stroke (1999-2003) :: 2001 F250 Taking Longer To Start
Ok I've got an 01 F250 sd 7.3 with 257k on it it just started talking longer to start than it should it will do it cold or hot even if I shut it off at the drive thru takes it like 10 sec or more to fire. My question is I thought about purchasing a autoenginuity to find the problem but not sure the best place to get and what model I should get.
View 7 RepliesFord A/C :: Taking Longer And Longer To Start Cooling?
02 Ranger 2.3 4cyl 5 spd 115K.... My A/C seems to take longer and longer to start cooling/ When it does start cooling it seems that is is actually colder than it has ever been (original owner) and the control is more sensitive to the touch when moved. Being a 4 cyl it's easy to detect when the compressor kicks in and it seems each time it is taking longer to do so. If I stop the motor, it goes thru the same cycle of time or longer before cooling (compressor kicking in) again. No codes, No unusual noises.
View 5 RepliesElantra MD (2010-15) :: Engine Cranking Longer Before Starting
I've only had the car a month, and it's happened maybe three times now. I turn the key, and it takes twice as long as usual to start, about 5 full seconds of the engine cranking before it ignites. I think each time was after I had driven the car an hour or two before (when I'm heading home after an outing). Most of the time, the car starts fine. What's going on?
View 11 RepliesEscort :: 2001 - Clutch Pedal Don't Engage
I have a 2001 Ford ZX2 with 170,000 miles on it. The clutch pedal doesn't engage the clutch until it is almost touching the floorboard. I thought it had a hydraulic clutch being a 2001 but I can't find a reservoir for the fluid so now I must assume now that it is a mechanical clutch.
1. Does they hide the reservoir on these ZX2's?
2. What could cause the clutch issue?
Elantra XD (2001-06) :: Misfire - CEL Flashing When Give A Lot Of Gas Like Taking Off From A Stop Light
I have a 2003 Hyundai Elantra standard model, Manual drive.
It started out with the CEL flashing sometimes if I give it a lot of gas like taking off from a stop light. Then the car would just lose power when I was driving randomly and cut off like I was running out of gas. Then I restart it a few minutes later and it would drive fine. Then it now got to the point that when you try to drive it, it just shakes a whole lot and it has like 20% power, you can hit the gas as much as you want and it pretty much doesn't move.
The first time I had it towed home I replaced the Ignition Coil, and Spark Plug Wires which did nothing.
The first shop I took it to said it was a bad injector and bad spark plug wires (even though they were new)
So they changed the injector and wires and the car ran fine for 2 weeks at most and started doing the same thing. When I took it back he said another injector went bad and that they were all going to go bad in sequence. So I had him replace that one and it drove perfect again for a week and had the same problem.
Then I took it to another shop which said my spark plug cables were arcing inside where it plugs in so I took the cables back and got replacements and he said they were still arcing and were garbage to get cables from the dealer so I did that and it ran fine for an hour after taking it home and just started like it was running out of gas. I would have to floor it and basically coast, and try to restart it and when I would give it gas it would hardly go and I just had to keep restarting it and finally it wouldn't start so I towed it home, and sure enough after cooling down it started again and now when you drive it, it feels like you've only got 20% of power.
The only preexisting condition the car had was a clogged charcoal canister because when I get gas it always keeps clicking and I have to put 30 cents of gas in at a time or the nozzle shuts off or if I keep doing it too fast the gas comes out and runs down the side of the car.
I changed the spark plugs I think about 2 weeks before this stuff started happening. So far it has new:
Ignition coil
Spark plugs
Spark Plug wires (x2)
Fuel Injectors (x2)
Hollowed out Cat Converter because the mechanic said it was clogged
Ford Super Duty (1999-2016) :: 2001 F250 - Rear End Slip / Bump When Initially Starting From A Dead Stop
I am experiencing what feels like a "bump in the rear" when initially starting from a dead stop. It feels like a car behind me tapped the bumper or that the truck "hunkers down" first, then moves. Tranny seems fine also. Once moving, there is no problem whatsoever. There atre no noises, leaks, or other symptoms. Also, when coming to a stop, it feels the same way just before the truck completely stops. If I drift forward a little, then apply the accelerator, it does not "slip" or hunker down.
Took it to the dealer and they claim that they can't find anything wrong and may just be the suspension releasing? The truck does this whether loaded or not?
2001 F250 CC Lariat SB 7.3
Elantra XD (2001-06) :: Engine Light While Driving And 2nd Gear Taking Time Shifting - Thump On Transmission
O.K. first of all I had an issue with the Odometer pointer being jumpy. Sometimes it wouldn't move. Now I replaced the input sensor at first and did not fix the problem. I replaced the output sensor and fixed it. "BUT", Now, I have a problem with the transmission shifting. I get an engine light while driving and the 2nd gear seems to take its time shifting and when it does it make the left side drive shaft kick in hard and spends my wheel to a screeching effect. Plus a thump on the transmission. I rechecked the sensor for connection and reinstalled. Drove the car still have the same issue?
View 2 RepliesElantra XD (2001-06) :: Passenger Side Headlight Low Beam No Longer Works
I have a 2006 elantra. I just got it back from having a new clutch put in. My passenger side headlight, low beam, no longer works. I tried two different new bulbs and it still doesn't work. All the other lights on the car are working, including the high beam and running light on the passenger side. Is there something that would have been disconnected when they replaced the clutch? Is there something I should check?
View 1 RepliesPrius V :: 2012 - Key Fob Taking Longer To Open Doors
Taking longer and longer for key fob to open doors, etc. Assume the battery needs to be changed. Have no problem with other fob. How do you change the battery in the key fob for this year model.
View 13 RepliesElantra XD (2001-06) :: Noise When Engage A Gear
Just wondering to diagnose the noise my manual 2002 is making when I engage a gear.
Generally, it'll clank every single time I put the gear in gear. I.e. clutch down (quiet), shift into gear (clank), lift clutch up (clank).
Very annoying; has been happening basically since I bought the car (but obviously not when I test drove it!)
I do not think it's a motor mount, especially since I wouldn't think that moving the gear into gear (before lifting clutch back up) would cause the motor to shift enough to make the mount clank. If at all...
Anyway, here is a link to a YouTube video I've uploaded. Every time you hear a clank, I'm simply lifting the clutch to engage the gear. I do this quite a few times going forward and backward. [URL] .....
Accent LC (2000-05) :: 2003 Taking Longer Than Usual To Start
2003 accent. I had an intermittent starting issue, nothing serious. Then one day dead in the water. Had it in my garage so i changed all belts, Crank position sensor, starter and solenoid. It seemed to start different, a little longer than usual to start, but started. Drove it for about a week and dead again. Dont know if it was chance or not but as weather got colder, seemed to take a little longer to start. Cranks but does not fire. I can hear fuel pump priming. I took the spark plug wire and held it next to frame and did not see a spark. To double check i tried ether and still would not turn over. Assuming fuel is not an issue at this point. How ever i did get an evap code p0441 but it went away. I am stumped at this point. I am not very good at electrical on vehicles. I want to check coils, and work my way back but not sure if I am doing it correctly. Most vehicle videos don't have the same parts.
View 13 RepliesElantra XD (2001-06) :: 2002 - Cruise Control Would Not Engage
My cruise control wouldn't engage this afternoon and once I got home I noticed that the brake lights including the third light are on. Headlight switch is rotated to off position, checked brake fluid and its normal, backed car up and hit pedal thinking something might have been locked up but to no avail.
View 4 RepliesAccent MC (2006-11) :: 2009 - Cranking Slow / Taking Longer To Start
On my 09 accent, it's been cranking slow/taking longer to start. Occasionally it won't even have the guts to spin the starter (clicking solenoid noise).
I checked the battery (<1 year old), and it has a resting voltage of 16.2 (?!) When running, it jumps to 17.4. Is this a bad alternator?
Golf/GTI VI :: 2012 - Spongy Brakes / Pedal Taking Longer To Depress Before Stopping
I've got a '12 GTI (bought 10/1/12) with just over 20k miles on it. Everything on the car is stock and original - pads, rotors, calipers - and the brake fluid hasn't been flushed yet. The last few months I've noticed an increasing sponginess to the brakes, the pedal taking longer to depress before I feel significant stopping.
Pads and rotors still look good. Fluid level's normal. At best it feels like maybe some air pockets might've worked into the fluid lines. At worst it feels like maybe a leaky master cylinder. I'm wondering if it's a common problem.