Elantra XD (2001-06) :: Rear Drum Brake Replacement
This is my first time working on drum breaks, all the repair manuals and videos don't make it look too bad. I did have a question about the parts required to replace the rear breaks.
Assuming these breaks are very worn. What parts would need to be replaced in a typical break job.
The pics below are what I'm planning on buying:
Shoes
Rotors
Drum
Hardware Kit
Is there anything that I'm missing?
Ford Excursion :: Rotted Brake Lines / Replacement?
Is it a do it yourself job to replace brake lines. Never done it before or even seen it done. Special tools required? Will the auto parts store know exactly what I need? Are these questions answering my question?(don't do it) ...
View 14 RepliesElantra XD (2001-06) :: 2004 - Rear Brake Sticks / Parking Brake Is Broken
I have a 2004 Elantra GLS. My left rear brake was hanging (wheel was very hot to the touch after driving, while other wheels were not), so I had a friend check the brake pads. We decided to replace the pads and rotors. While doing so, the parking brake seemed stuck in the on position, so I opted to have him disconnect it completely until I could afford to replace it. I had used it for the first time about 2 weeks before I noticed the hot brake problem, so we figured that must have been why the brake was hanging.
My friend replaced the rotors and pads, put some penetrant/lubricant on the piston of the caliper and reassembled the brakes. He did use the special tool to spin the caliper in when putting the pads on, however he didn't know that was necessary and tried to force them in with a C-clamp first.
Now, I seem to have two problems:
1. The left rear brake still hangs sometimes. I will drive the car and when I park it I can feel the heat coming off of the left rear wheel. It is extremely hot, so I know the brake is hanging (even with the parking brake disconnected). What is the problem here? Is the caliper bad? Would replacing the caliper solve the problem? Does the parking brake have to be connected to stop the caliper from hanging up?
2. My second problem is the pulsating of the brakes. I am afraid the rotor is warped because of the heat, or maybe he didn't clean everything well enough before he put the new rotor on. How can I figure out what the problem is? Is there a way to check a rotor to see if it is warped? Could there be another reason I feel the pulsating brakes? By the way, the brake fluid is full.
If the caliper needs to be replaced and I can leave the parking brake disconnected, are there any special instructions my friend should know about before working on this? He does work on a lot of cars and rebuilds cars to sell, so he is pretty knowledgeable. I think the only thing he didn't know about was rotating the piston. I would like to provide him with detailed instructions if necessary.
Prius (2001-03) :: Brake Fluid Dripping Down On The Brake Lines
seem to be losing brake fluid from the area of the ABS system and it dripping down on the brake lines underneath. Noticed this when draining excess oil from the engine (dealers!!!!). I'm thinking this has been leaking a long time. I have the worst luck finding a reputable mechanic anymore and if I can't trust a dealer...
View 9 RepliesCamry :: 2003 - Rear Brake Replacement
2003 LE Camry i want to replace Rear brakes. Is there a DIY for it. I know it is challenging...
View 10 RepliesElantra XD (2001-06) :: Rear Left Brake Light Won't Turn On
I have a 2003 hyundai elantra gt. All the lights and bulbs work, except for the rear left brake light. I've replaced it twice now, and used a bulb I know was good, so the problem is not a bulb. I checked the fuse, and the fuse is ok as well. When I measure at the bulb socket with an ammeter I get around 20 mA which I assume is too small and I assume there is a loose wire somewhere.
View 2 RepliesElantra XD (2001-06) :: Rear Brake Sound When Stopping In Reverse
I am having an interesting sound coming from my rear brakes when I stop from reversing, for example, when I'm pulling out the drive way or a parking space. It kind of sounds like a loud "hum" that lasts a spit second, until the car actually stops. I changed the rear brakes and rotors about 1500 miles ago.
2006 Elantra Limited, 88,XXX miles.
Elantra XD (2001-06) :: Rear Parking Brake Cable Hanging
I noticed the rear parking cable's one end hanging. Not sure how to connect it. Appears a part is missing.
View 7 RepliesElantra XD (2001-06) :: Brake Fluid Leaking From Rear Tires
Topped off my brake fluid 6 months ago. Last week my brake light came on. I checked and I only had half the fluid left so I topped it off again. Today I went out and there was some kind of oil near my rear tires and my light came on again, needs more brake fluid.
View 6 RepliesFord Ranger / B-Series :: 1988 - Rusted Rear Brake Lines
I am going to fail State safety inspection due to a problem with my brakes. Months ago when I was trying to get it through emissions testing the mechanics looked under the truck to see where the brakes were leaking. All they told me was the rear lines are rusted through and need replacing.
From my reading I believe the lines are 3/16" line and I think they go around the back of the fuel tank and up the frame rail. Correct?
My questions are, what length line do I need (I am not a hard-line expert, but I will try). I want to order some ss line so it won't rust through again. Is the system made of small sections threaded together? Or is it one long section? And what else would I need/want to replace along the way?
Ford F-150 - 1997-2003 :: Brake Lines Leaking?
Blew a hole in the 3/16 inch line to the rear on the left frame rail, behind the gas tank. Lost all brake function.
Got the truck home and inspected. The line was rusted bad about 6 ft long from the connection at the rear hose to the axle, up to the rear seat area ( crew cab). From the drivers seat forward, the line looks very good. The line across the rear axle from left to right looks very good. I bought two 50 inch standard lines 3/16 inch. Started at the rear hose connection 6 inches behind the gas tank and ran forward to the rear seat area.
Cut about 32 inches of the other 51 inch line and connected and ran forward to below the front seat area. There is a metric connector at this point. I cut an inch in front of it to eliminate it. NAPA sells a high psi compression fitting ( steel , 10,000#) that you can connect two 3/16 inch lines together. I did that under the drivers foot area. I have done two different 2002 F150s in the last year due to this failure. Something to look into. Not nice to loose brakes in traffic.
If your worried about the steel compression fitting, don't. I have used these on several cars and trucks over the last 15 years. Make sure you get the STEEL high pressure compression fitting. Total line replaced on CREW cab, 51 + 32 inches. Pops right back into the original plastic clamps.... I might mention, that is where the failure was, under the plastic clamp at the rear end of the gas tank area.......... crud must collect on the clamp.
Ford F-150 - 1997-2003 :: 1999 - Brake Lines Diagram?
I have a 1999 Ford F-150 4X4 w/4.6L V8 W code, I recently lost all brakes. The primary line from Master Cylinder to ABS Pump rusted out completely. Replaced them but the other lines from ABS Pump to wheels are looking real bad. So I need to replace them, however I have no idea what the routing system looks like. Looking for a 97-03 F-150 Brake Line Diagram? I live at the jersey shore... so yeah rust is extremely common.... unfortunately.Also, where to get line assemblies?
View 7 RepliesElantra XD (2001-06) :: 2003 - Grinding Noise From The Rear
2003 Elantra GT ... Yesterday I went out and heard a sort of grinding noise from the rear. I thought it was the brakes. This morning I took it to a mechanic and he said it was the brake pad rubbing on some rust on the rotor.
This evening my wife took the car out and, in addition to the sound, said she smelled burning rubber. So I took it out and after a while figured out it is the bottom of wheel coil (see photo) on the rear driver side rubbing against the tire! I assume the mechanic didn't spot it because it may move out of contact with the tire when the car is lifted up. What happened here?
Ford 7.3L Power Stroke (1999-2003) :: Air In Brake Lines / ABS Pump?
What happens if or when you get air in your brake lines and the air gets into your ABS pump/module? What are the symptoms? Anything other than a soft pedal? My ABS module keeps thinking one of my tires is sliding when i am driving and pulses my pedal and i am at a loss.
View 14 RepliesElantra XD (2001-06) :: 2003 - Brake Fluid Leak Coming From A Part Near Master Cylinder
I recently noticed that my brake fluid was leaking in my 2003 Hyundai Elantra and upon further inspection I found the leak was coming from a part near the master cylinder. I looked online and couldn't figure out if this part was part of the master cylinder or brake line or a part all on its own. I tried tightening it but It still leaks some. I read a similar post online and that it could just be that the washer needs replaced but I just wanted to check on here to see what the part is called and if I should just replace the whole thing. I included photos as well.
View 7 RepliesFord F-150 - 1997-2003 :: Winded Brake Lines From Master Cylinder To Front Splitter Block?
What kind of brake line is it and if is replicable with regular brake line? I'm just replacing long line between front and back splitter block and just would like to know what is it. What is purpose of that braiding (?) at front brake lines and why they wind down instead of going straight. Part of that long line is braided too, part that go across frame.
View 3 RepliesSanta FE SM (2001-06) :: 2003 - Rear Driver Side Brake Caliper Stuck Roughly
This is my second time posting for the same issue on a 2003 3.5L with 120,000+ miles. Rear driver side brake caliper is stuck again. I have replaced both rear calipers after the driver side stuck a few months back. So most likely the first time was caused by something else.
What else could be causing this? Brake line, master cylinder, or other? I did not replace any brake lines the last time this happened. Just calipers and pads.
Elantra XD (2001-06) :: 2003 - Left Tail Light Works But Brake Light Is Out
My daughter has a 2003 Elantra. The left tail light works but the brake light is out. I opened the trunk and removed the two screws for the cover and found the wire going through a rubber plug. Upon removing the plug, more wires and no bulb.
How do I get to the bulb? There appear to be three screws and bolts, one on each corner, holing the tail light in place. On the fourth corner is just a rubber-looking plug. Do I have to take the assembly out to change bulbs or am I missing something?
Hyundai - Elantra :: Rear Tires Worn Out - Replacement?
I drive a 2004 Hyundai Elantra with 72,000 miles on it. My rear tires are worn. Do I put the replacement tires on the rear or on the front (and rotate the front tires to the back?) I've asked several mechanics and got several different answers. Isn't there a definite answer to this question?
View 5 Replies