Elantra MD (2010-15) :: Change Oil Warning System
Past cars have always had a change oil warning system. Usually there's a button under the hood or a certain sequence of pressing the brake to "reset" the oil life monitor. Does the Elantra have any such thing. I didn't see anything about it in the manual.
View 22 RepliesElantra MD (2010-15) :: Can Change Keyless Entry Transmitters?
So, my wife's laptop bag got stolen out of a coworkers car... It JUST SO HAPPENED to have our new Elantra key fob (no keys, JUST the transmitter). Any way to go get a new transmitter and program it to THAT one; rather than risk the thief coming back and opening our doors?
View 25 RepliesPassat (B7) :: Strong Vibration Leads To Flashing CEL
I leased my 2012 Passat SE 2.5 Manual in March and I have been happy with it overall; however, the car has some strange behavior. Sometimes, under hard acceleration while the clutch is partially engaged a strong vibration comes from the engine bay accompanied by a flashing check engine light that turns solid after about 10 seconds. The vibration feels similar to but not exactly like ABS brakes. I took it to the dealer, took a technician on a test drive, reproduced the event for him, and left it in their hands for a day or two. The check engine light code was for an engine misfire. They told me to contact them if it happened again. It has happened a few times ( I need to take it back). I would like to know if I have a defect or if there is a design flaw in one of the systems.
View 24 RepliesPrius (Gen 2) :: Key Left In Slot Warning Leads To Drain Battery
One day, I drove my Prius with my key fob in pocket. Parked the car. Turned off the power. Opened the driver side door to get off. Heard the continuous beep of "key fob in the slot" warning. I had never heard of it so I did not what it was. Tried closing / opening the door several times. The warning kept coming when I opened it. Tried getting off the car, pushed the lock button. It locked with lock beep normally.
After a few hours, I found the battery was dead. Had it jump started and the problem had not come back for a few weeks.
Prius (2004-09) :: Engine Overheating High As 250 F Leads To Red Triangle
My 2009 Prius is overheating at times. I have a Scan Gauge connected and it normally shows an engine temp of 181-182 f. Rarely approaches 200. At times, it will go as high as 250 which brings on the red triangle and gong sound. If I start out cold (don't shut off the car during the trip), it will run perfectly for the entire time. Doesn't matter what the outside temp or whether running AC.
If I stop for a couple mins and turn off the engine, then restart, it will misbehave and run all over the temp spectrum. I took it on a 1000 mi drive to Seattle in July. On the way there, I didn't notice any problems but it was rainy, cool and didn't run the AC much.
Coming back was a different story. If I let it sit (powered off) for 15-20 mins or so, it will hold the correct temp. It's just when it sits (powered off) for brief periods (less than 10 mins) that it will act up. Another clue is that it cools going up hill and gets hotter going down. That seems contrary to the usual and only does that when acting up.
Prius (Gen 2) :: Leaving Hazard Lights On For 3 Hours Leads To Dead Battery
I left my hazard lights on for 3 hours. Outdoor temp is 25 F
Car will not power up, no dash controls illuminate when fob is inserted and start button pressed.
Can I rectify this problem by jumping the accessory battery with a 12V power pack make to just art ordinary cars.
Can it be main battery that is the problem. It is the original 12 V battery.
Golf IV R32 :: FX850 - Clutch Sticking / Rapid Jerks Which Leads To Stalling
So I've been dealing with this for a little while now and it's starting to really irritate me. With my 850, when cold, it drives awesome- perfect engagement, pressure, etc. When hot, I'm noticing that even with the pedal to the floor while in gear, I might get a few 'jerks' until it frees up. Also engaging while hot (in traffic) can sometimes cause rapid 'jerks' which leads to stalling, the pedal engagement is all over the place and you really have to know how to drive the car, just to get it right.
Now I've bled the line about 4 times now in the last three years and it seems to improve slightly (maybe placebo effect), but I'm not looking into it maybe being the grease on the input shaft? I know we greased the throwout bearing and input shaft, but it was a very light coating since I was nervous about getting grease on a $2400 clutch.
Gen 2 Prius (Audio/Electronics) :: Accidently Put Penny Into CD Player Leads To Dead Radio
My wonderful three year old put a penny into the CD player. First it played, then it stopped and we got weird loud popping noises, even with the volume off. Now the radio/CD player is off and can't be turned on.
It seems like a good time to upgrade, but what should I be looking for as far as no power to the audio?
Fuse?
I know nothing about this stuff.
Ford 7.3L Power Stroke (1999-2003) :: Fuel Line Leads To Head Under Turbo Leaking?
The fuel line on the passenger side under the turbo that leads to the head is leaking looks like from rubbing on the pedestal, anyone ever just cut it and throw in some fuel line and hose clamps?
View 14 RepliesHyundai - Elantra :: Alarm Keeps Going Off Randomly After Oil Change
I got my oil changed and tires balanced Saturday at the local shop around the corner. Now my alarm goes off randomly and when I use the clicker thing to lock the car, the horn doesn't make the beep sound it used to on the the second click. It never did this prior to having the oil changed, but how could that have anything to do with the alarm? I need to figure out how to make it stop, it's waking me (and my neighbors) up at night, and I have to keep leaving where ever I am to go out and see if the dang thing is going off again, which it is about half the time.
View 2 RepliesElantra XD (2001-06) :: How To Change Flasher Relay
I want to convert my stock turn signals into LED, but i want to do without the hyperblink. I've done some research into this, and have ended up confusing myself. I don't know if I have to add resistors in order to stop the hyperblink that would occur, or if I can simply change the flasher relay and it be more straightforward.
2001 Hyundai Elantra GLS
Ford F-150 (2009-2014) :: Ticking Noise At 800 To 1000 RPMs / Rough Idle Leads To Engine Fail
2010 F150 ... So I have the tick noise at rpm's 800-1000 at drive through, stops, etc. So I did research on it a few months ago and saw that it might be VCT's but should be able to drive. so I drove it waiting to save money and have it go to a shop. well this past weekend while coming home from work my oil light came on the pressure dropped to zero, I was on the highway so I drove about another mile to get off highway and once I got off my truck died. I had it towed to my house and I thought I blew my motor. So I started doing research here and found that the VCT's AND cam Phaser could be bad. so I replaced my VCT on driver side put it all back together it started and loud knock was gone. then after 5 mins it was back very loud knock!
So I shut it down and took apart the passenger side once I got the valve cover off I found the problem.... The bolt that holds the cam phaser in place snapped off and was riding along the camshaft. So I took that out and extracted remaining part of bolt. inspected my camshaft and it was really messed up. so I bought new Phaser and Camshaft. the camshaft just came in today and I am trying to put it back in. but the hole for the pin in the phaser doesn't line up and I cant spin the shaft to make it line up. should I spin the cam phaser? I marked the chain and the phaser is where it should be on chain, but with that bolt snapping off could that have thrown the timing off so my mark is no good? when I lay the camshaft in place it sits perfect and if I just move the phase over 2-3 links it will all fit together. Should I do that?
Elantra HD (2006-10) :: Brake Noise Before And After Rotor / Pad Change
I recently changed the rear pads/rotors on a 07. the dealer said it needed new pads because I guess the heard a light grinding noise but I did not think they looked at it. I believe the pads/rotors still had 10K miles left on them. The car has 40K miles on it.
Anyhow, I noticed the old pads had some life to them, but uneven wear in some cases. Looked like the classic issue with brake pad/caliper design tolerance error.
I did grind down the pad holder a bit so they can slide on the caliper easily without getting stuck and resulting in uneven wear.
After the new pads/rotor, the rear right appears to be making the same light muffled grinding sound when you apply the brake.
Elantra XD (2001-06) :: Occasional Rough Change In Auto Transmission
I have a Hyundai Elantra XD 2004 FX hatch. About 3 weeks ago we noticed that there was an occasional rough change in the transmission. It happens mostly between gears 3 and 4, but can happen outside these gear also.
I have checked the fluid level and it always seems low. Over the last 3 weeks I purchased some transmission fluid (I used the Castrol brand for that specific car as looked up by the spare parts shop) and the problem hasn't got any better. On top of that despite adding a total of 800mL over the last couple of weeks it still doesn't appear to register between the cold and hot level on the dipstick.
I've looked around for leaks and can't seem to find any, there were a couple of drops underneath the car but I can't say for sure they are transmission fluid, I'll have to check this again soon (it's a bit difficult as it's not my car it's my wife's and when she gets home it's dark). Either way it's only a couple of drops at worst.
What this might be, and what the process I should follow to diagnose it is? If it's anything besides a leak in a hose then I'll definitely be taking it to a mechanic/transmission specialist.
Elantra XD (2001-06) :: Code P0016 Popped Out After Timing Belt Change
I just changed the timing belt on my sisters car and finished yesterday and drove it today. A check engine light came on so I went to check it out and P0016 popped up. I've done some research and people say that it might be that the timing belt is misaligned or loose. I tightened the belt not too tight but not too loose. Note: I also spilled coolant on the crankshaft pulley and a bit on the belt itself. The car idles rough when driving too. I will tomorrow take off the cover and check the tension of the belt.
View 9 RepliesHyundai - Elantra :: 2007 - After Oil Change Stuttering When Stopped / Wheezing When Gears Shifting?
I have a 2007 Manual drive Hyundai Elantra with 98,000 miles on it. Prior to going to Valvoline (who I know are not the best oil change places) if I was parked with foot on clutch and brake there was a tinny noise coming from the engine. I was going to have it checked out.
Fast forward I had my oil changed at Valvoline on Saturday (2 days ago) since then when parked with foot on clutch and brake the car begins to make a stuttering/shuttering noise and is shaking a bit (in time). In addition when I shift gears and go faster there is a wheezing noise.
I assume I need to bring this back to Valvoline? Is there anything that they could have done during the oil change that would cause this issue?I didn't get the air filter but it wasn't that horrible. They of course said I should get the radiator flush and the transmission flush.
Elantra HD (2006-10) :: Engine Stopping / Rumbling When Change Gears Occasionally And Sometimes At Stop Sign
My 2007 elantra has been rumbling when i change gears occasionally and sometimes when stopping at a stop sign the car just dies. The car starts right up though as if nothing happened. It only happens like twice a week but i really want it fixed. I already changed the motor mount next to the engine block on the left. Could it be the motor mount connecting to the transmission?
View 1 RepliesMalibu :: 2010 - How To Change Headlight
How do you change the headlight on a 2010 Malibu...
View 14 RepliesLexus RX 2010-15 :: Transmission Oil And Filter Change
In the 2nd gen forum , there are great instruction son how to change the tranny oil and filter. Are there any DIY threads with pics on how to change the tranny filter/fluid?
View 11 Replies