Ford Transmission :: RPMs Drop And Truck Dies As Soon As Put It In Drive Or Reverse
Just finished putting a fresh 460 backed by a (1977) c6 in my '68 ranger and now I'm having (what I believe is) transmission problems. The truck will idle and rev properly in gear but as soon as I put it in drive or reverse the RPM's drop and it dies. I jacked the back end up and put it in both drive and reverse and the tire's spin, but if I try and apply the brake to stop them the truck will die. My suspicion is that the torque converter is locked up all the time. I have managed to get it in gear and give it gas and it'll drive and shift fine, until I come to a stop. My question, what would cause the converter to do this? It's the same transmission and converter that I pulled out a month ago and I never had any issues before...
View 4 RepliesFord F-150 - 1997-2003 :: Transmission Drop Out Of Gear With Selector In Drive
I have a 1997 F-150, 2 wheel drive, 4.6L truck. Recently the transmission got to where it didn't shift properly. Then it got to where, after driving it about 10 to 15 miles the transmission would drop out of gear with the transmission selector in drive.
I have replaced the transmission sensor, the rear end sensor and it still does the same thing. Drive about 10 to 15 miles and, with the transmission selector in drive the truck will not pull. The motor can be rev'ed but the truck won't move just like it was in neutral.
What is wrong. The transmission shifts fine, the truck runs fine, but after 10 to 15 miles the transmission quits working.
Lexus RX 2010-15 :: When Put Transmission In Drive Or Reverse / RX350 Going Into Gear Twice
I have a 2015 Lexus rx 350 it is not all wheel drive. When I put the transmission in drive or reverse I have what I would call a double engagement. It feels like it is going into gear twice. It does not slip it shifts smooth.
View 1 RepliesLexus ES 2007-12 :: Clicking Sound In Transmission When Car Is In Gear Either Reverse Or Drive
I always thought the clicking sound I was hearing in the morning was coming from the engine. Then I realized the sound doesn't start until the car is in gear, either reverse or drive. After a few minutes it will go away but until it does, it is a noticeable sound. I still have a warranty. I am wondering what this could be.
View 3 RepliesElantra MD (2010-15) :: 2012 GL Jerking Whenever Switch The Gear From Park To Drive Or Reverse / Neutral
I have an Elantra 2012 sedan GL and last year i tried installing HID's. It worked for a whole but then it stopped after. I learned that it wasn't getting enough power so then yesterday I bought a wiring kit to be able to wire my HID to tap to the battery to get more power. Everything was fine till I got to work but when I had to leave work., there was an issue. Whenever i switch the gear from park to drive or reverse or neutral. My car seems to jerk. And when I'm driving and it changes gears, it also jerks. Kind of the same thing how if your driving a manual car and you change gears wrong. This happens when my lights are off. But when i turn them on it then stops. And when i turn it back of it doesn't do it anymore.
View 5 RepliesSonata NF (2006-10) :: Transmission Whine Only When Pressing On Gas In Drive Or Reverse
So I have a 2006 2.4 sonata with a transmission whine only when pressing on the gas in drive or reverse. I just flushed and replaced the fluid and it is at the correct level. What I want to know is since the transmission has in internal filter, is it possible for me to clean it out to get rid of the whining sound?
View 8 RepliesFord Transmission :: 2006 F250 5R110W - No Reverse Drive In Park And Neutral?
I've got a 2006 F250 6.0 5R110W 4wd 220,000 miles It started getting a slight delay going into reverse and tow light flashing last week. all else functioning perfect Got a pending code P0700 and P0741 I stopped at NAPA when I was leaving no reverse checked every thing all was normal no leaks and fluid good color drove perfect in drive I got back to the shop [10 miles] put truck in park it was like its still in drive same with neutral, in reverse it wants to creep forward.
View 1 RepliesFord Transmission :: 1989 F350 - Harder To Shift / Grinding Noise Like It Doesn't Want To Go In Gear
I have a 1989 F-350 7.3 IDI with a ZF-5 trans. Lately, I noticed that it was a little harder to shift my truck through gears while driving than it normally is, and when I'm stopped and try shifting into first gear or something it like vibrates and makes like a grinding noise like it doesn't want to go in gear. For a while, I've also had to push on the clutch very hard in order for it to I guess hit the linkage and start, but I never had problems shifting until lately.
Today though, I went to start my truck, I pushed on the clutch as hard as I could, and the switch would not engage so I couldn't start it. So, I guess the switch was farther to link than the pedal could possibly go. I went under the dashboard and engaged it by hand then it started. I drove home and the shifting was still iffy. How can I make the switch engage normally again so its closer I guess and so I don't have to push so damn hard on the clutch to get it to start? And could the switch linkage have anything to do with the shifting being funky lately, or could that only be the clutch itself?
Elantra HD (2006-10) :: Auto Transmission In Default Mode / Stuck In 3rd Gear
My auto transmission in my 2007 Elantra with 125,000 miles went into default mode, stuck in 3rd gear. No codes went off. I drove it home this way, but after sitting for 90 minutes, now it works fine. I've heard about the input and output sensors. What should I replace? I went to HMA service to get info on both sensors, but it wasn't detailed enough.
View 3 RepliesFord 6.0L Power Stroke Diesel :: 2006 F350 - Clunking When Go From Drive To Reverse And Now With Drive Too
So I have a 06 350 and I'm getting clunking from drive to reverse and now with drive too, I know my rear diff is on it's last days but I am wondering if that could cause the clunking and now my truck around 90km shakes likes crazy and same thing wana know if that's the diff. And if I was to fix diff myself would it not just be easier for me to just swap axles if I wanted to be cheap??
View 12 RepliesElantra MD (2010-15) :: RPMs Drop / Car Bogging Down When Shift Into 4th Gear
I am not sure if it's my imagination or not, but my car seems to be running differently lately.
When the car shifts into 4th the Rpms seem to drop kind of and the car seems like it is bogging down. Not extreme, but I don't remember this when I first got it. It's like I really have to accelerate when it shifts into 4th or I cannot pick any speed up.
Is it because the motor is now broken in? It has right at 8,000 miles now. It's due for an oil change, but I wouldn't think that would have anything to do with it !
Elantra MD (2010-15) :: Acceleration Drop To 1000 / 1500 RPM Very Rapidly When Gear Shifts In 2nd
I have only done 18,000 Kms on my 2013 Elantra GLS. Whenever I am in traffic driving real slow, and whenever the gear shifts in 2nd, the acceleration begins to drop to 1000/1500 RPM very rapidly while pressing and releasing the pedal, and it becomes jerky...
I will try posting a video, but meanwhile, it gets really annoying at times and I need to maintain a very feather foot to make sure it doesn't jerk especially when there are passengers on board..
Ford Transmission :: 1987 E350 Does Not Drop To First Gear To Accelerate
I have a 1987 e350 conversion. Recently the vehicle has been acting up. Once warmed up, the transmission does not drop back into low/1st gear when stopped at a light, when we go to accelerate the vehicle has no power as it tries to accelerate in drive. I have to manually shift into first which the transmission immediately kicks down. When it comes to transmissions I like to have some knowledge before bringing to a shop.
View 2 RepliesPrius (2010-12) :: Gear Not Engaging In Drive Or Reverse
2010 Prius 52K miles... Not engaging in Drive or Reverse, Engine is not starting either. Got Message - Put in park , All the lights are ON , in the Dash .
View 11 RepliesElantra XD (2001-06) :: CEL / Codes P0705 And P1529 - Car Jerks Into Reverse And Drive
I have the following codes:
P0705
P1529
It looks like P1529 is caused by P0705. P0705 is the neutral range sensor. I purchased the sensor and replaced it. It is aligned correctly and I am still having the same CEL and codes.
What the car doing: The car jerks into reverse and drive. The dash does not indicate what gear I am in (PRNDL).
When it drives, acceleration is very slow. I believe the car is "stuck" in third gear. I've heard of fail safe mode?
What I did: This problem started when I changed my stereo. I did three bad things which may have caused this problem.
One, I had to put the car in "L" to get the dash off. I left it in "L" for a while then I tried starting the engine while it was still in "L".
Two, when I reinstalled the center console I swapped the wiring for the hazard lights and the rear windshield wiper (GT)
Three, I wired the dash illumination positive and negative together.
The cluster's backlight does not come on anymore and these codes came up. I checked all fuses and they are good. Where to look for a possible shorted wire that can be causing this?
Elantra MD (2010-15) :: 2012 GLS - Loud Clicking Noise When Going From Reverse To Drive
I just started hearing a loud click when I change from park to reverse and from reverse to drive. If I keep moving the knob between those three spots with my foot on the brake and hand brake off, I hear a loud click at each spot. Hard to describe... anyway, this only happens when I first start the car, by the time I get to work if I try doing that when I park there is no loud click sound. The thing is, I don't know if this was always happening and I just noticed it now, or if it just started.
View 14 RepliesChevrolet - Cavalier :: 2004 - Transmission Would Not Go In Reverse Or Drive
My future mother-in-law has a 2004 Chevy Cavalier. Last night night when she tried to put it in gear, the car would not go in reverse or drive. She recently had a tune-up on her car a month ago and everything seemed to be working fine. I think the transmission is dead. Does that sound right?
View 8 RepliesFord Transmission :: AOD Seems To Stay Locked Up In Either Drive Or Reverse
91 F-150 4x4 with AOD. OD,D,1st gear. The truck will idle fine, but when I put it into gear it seems like it is locked in in either drive or reverse. Its hard to stop at lights or stop signs and boggs the engine down and has no low end power. When in neutral it is fine. I have replaced the torque converter with a new one, no change. I replaced the valve body with a constant pressure body as well and still no change. Is there anything else that could keep the thing locked up? The smaller inside overdrive shaft looked good and slid in and out easily. Is there any kind of solenoid in the AOD that would cause this or if vacuum has any role in this problem...
View 1 RepliesFord Transmission :: Truck Stuck In Drive No Reverse
My truck does not go into reverse but thinks all positions of shifter are drive. I had some slippage and changed the filter and oil great for awhile then blame no reverse just forward I was told my torque converter was out I just don't know....
View 1 Replies