Elantra HD (2006-10) :: Hard To Start When Weather Is Warm
This has been going on for 3 or 4 months can someone tell me where the ETC sensor is located on 4 cylinder 2008 Elantra ?
View 5 RepliesElantra HD (2006-10) :: Intermittent Hard Shifts When Moving From A Cold Start
I bought a 2010 Elantra touring last September (it now has 166000 km). I love the car except for the hard shifts. It happens every morning when moving from a cold start. They vary from slight to pretty noticeable. I had the transmission flushed shortly I got the car. I just had the transmission reset about 2 weeks ago. It was smooth as glass for about a day or so after. Then back to square one. Yesterday it hesitated shifting between 4th and 5th going back and fourth a couple of times.
View 2 RepliesElantra HD (2006-10) :: 2008 - Hard To Start / Code P2626 For O2 Sensor
I recently replaced the timing belt, water pump, tensioner, all accessory belts. Made sure timing marks were spot on, did the 2 revolutions of the engine by hand, tensioner pointer was still in window per instructions. I noticed right after the car seemed not as responsive, or zippy, but did start and run fine for 340 miles. Than out of nowhere, it became hard to start, acting like it was out of time, so I removed top timing cover, doubled checked, everything, I even went as far as advancing the timing belt 1 tooth, than rotating engine by hand, than trying to start the vehicle. It still acted the same way, so I tried retarding it 1 tooth back from the original position, still the same issue. So I reinstalled it back to the correct position with, white crank mark @ TDC, and cam pulley hole lined up with the red painted groove in the cylinder head. Installed tensioner per Gates instructions, attempted to start, after 3 or 4 10 second cranks car will start and purr like nothing is wrong, take it for a test drive approximately 1 mile, car starts bucking, came back home. Pulled codes, tells me P2626 for o2 sensor.
View 4 RepliesElantra HD (2006-10) :: At Start Up Hard Shifting - Rebuild Transmissions Synchronizes?
I've read a lot on here that people have issues with their elentra when shifting gears, I have been having this issue for a while now and have been trying to trouble shoot the issue. (some make the mistake of using GL5 instead of GL4 or the master, slave cylinder are bad.
I've checked all of those symptoms and all is still well oh and my car is an 07 with 141k miles on it with the clutch replaced at 75k miles on it.) I went to a thicker gear oil from 75/85 to 75/90 which isn't much of a difference. It did work for a short time with the rough shifting gears but it's doing it again.
From 1st to 2nd (especially from initial start then after it warms up it's not as rough but still grinds and 3rd gear is on its way to grinding) I've started with all the small things and i'm considering rebuilding the transmissions synchronizes in the the input and output shafts for the gears.
Elantra HD (2006-10) :: 2007 - Engine Stalls When Attempt To Start / Place The Car Into Gear (auto)
I have a 07 Elantra with 68,000 miles. I am having a cold start issue. When the car sits overnight and I attempt to start/place the car into gear (auto), the car will stall. This occurs whether the car is placed in forward/reverse and with the a/c on/off. The vehicle will start fine the rest of the day with no issues.
View 8 RepliesElantra HD (2006-10) :: AC Is Blowing Cold Air But Not Hard Enough At Max Settings
My 2008 Elantra blows cold air, but just not as hard as it used to. At max setting, it's not blowing hard enough.
Also, my steering wheel starts to shake pretty bad going 70+ mph. What could be the problem for this?
I don't know the first thing about cars!
Elantra HD (2006-10) :: 2007 - Hard To Shift Into 1st / 2nd Gear
I got a new clutch & shift cables & fluid professionally done one year ago. I have only put 5k miles on it since. In the last two months the... gate/slot for 1st & 2nd have been getting worse n worse. All gears show sporadic rough shifting (read rough as a clunk or one tooth grind), but 1st/2nd are consistently rough & the gate seems to be getting narrower...
Environmental & operating temp, do not noticeably affect these symptoms.
Elantra HD (2006-10) :: Rumble Strip Noise While Hard Braking
I have a weird problem with my 2008 Elantra GLS 86K Miles on it. I did a couple of searches on this problem but didn't find any threads. About a month ago I noticed that when I braked hard at highway speeds 65 to 70 Mph I would get a noise that sounded like I was driving over the rumble strips on the side of the road. The rumble was the same frequency no matter what speed you are going, it doesn't get faster or slower. The problem slowly got worse to the point that it would happen at 25 to 30 Mph. The noise sounds like it is coming from the front but I can't tell which side. I figured that it was probably rotors and time for a brake overhaul so I replaced the rotors, pads and hardware on the front and the back. I used synthetic brake grease on the slides and guides. I also replaced the brake fluid with synthetic DOT 3.
When I did the back brakes I found that the wheel bearing on the passenger side was leaking lots of grease so I replaced it with a Timken bearing. (I live over an hour away from the nearest dealer so I did the repairs myself.) While I was working on the bearing I pushed the rear shock up and out of the way and it stayed in the up position for quite a while, aren't the shocks under pressure and usually push right back down? (Just an off subject thought) Well after replacing the bearing the rumble strip noise went back to just happening at speeds from 45 Mph and up. I was also thinking of pulling the fuse on the ABS and seeing if the problem goes away but will pulling the fuse hurt the car in any way or trip a code? I know what the ABS sounds like and this is not the same noise you get when sliding on ice.
Elantra XD (2001-06) :: Rough Ignition / Hard Start
When I try to start my wife's '06, it takes a little bit longer to start than in the past (used to take only 2 turns or so, now it takes 3 or 4). When it does finally ignite, it's a rough ignition and then it goes to normal. Why this is happening?
View 3 RepliesElantra HD (2006-10) :: 2008 - Clutch Pedal Went Hard And Moving Was About Impossible
I was driving and the clutch started acting strange. Before I could get home, the pedal went hard and moving was about impossible. My husband replaced the clutch, throwout bearing, and also the slave cylinder. He got everything put together and the clutch was not disengaging. We have bled the system from the master and also from the slave multiple times, about 10 over the past few months. Still we are not able to get the car moving. The pedal has pressure behind it but nothing. We have checked for leaks and have not found any.
View 5 RepliesElantra XD (2001-06) :: 2003 - Hard To Start / Smell Of Gas While Driving
2003 elentra. yesterday my friend went to start her car and it wouldn't start. she said it sounded like a baseball card in bike spokes. later that night they tried it again and gave it gas while starting it. it started right up. the car runs fine after they get it started. the check engine light isn't on. and there is increase scent of gas while driving it.
View 3 RepliesElantra HD (2006-10) :: 2009 - Steering Hard / Squealing Or Scratching Metal Noises
I heard some noise when the steering is hard. The noise sounds like squealing or scratching metals. What will be the problem? Is it the EPS system or just the serpentine belt slipping on the alternator?
BTW, the mileage is about 137700.
Elantra XD (2001-06) :: 2003 - Hard Start Up And Making Cranking Noise
So I recently bought a Hyundai Elantra Gt 2003 that I totally love. But ever since I bought it, it struggles to turn on. It makes a cranking noise before it turns on, and it takes about 2 to 3 times for it to fully turn on. I changed the crank shaft sensor and the fuel pump. What can it be?
View 1 RepliesElantra XD (2001-06) :: 2002 - Hard Start / Bad Gas Mileage And Early Fill Up Click Off
I am trying to fix the pesky hard start that I have. My car doesn't start right up anymore unless it is frozen cold. Other than that it takes 2-3 cranks sometimes 4 to turn over. That's annoying and embarrassing and I am trying to remedy it ASAP.
I have a check valve and Purge valve on hand right now. In my research it seems this is where I need to focus. I do have an engine code it was P0456 this time. I also have a gas cap.
I have a check valve because of the all too familiar cutting off early at fuel pump problem. I wanted to start there first since I am sure something needs repairing down by the fuel tank and since the problem is common. And hopefully the valve will work with the fill up and MAYBE with the start, if not that is where the purge valve comes in.
I got as far as get the 2 12mm bolts off and then couldn't make it any further.
Elantra MD (2010-15) :: Transmission Slips From Cold Start / Shifting Hard From 1st To 2nd Gears
I've had 2 Elantra 2012 models 1 a gls the second a limited. As far as transmission issues both Elantra's from a cold start after allowing RPM's to idle down before taking off they both have started shifting hard going from 1st to second gear 1st car was around 8-9 k miles now 2nd started at 3 k miles. Since owning 2 cars same make same year same transmission and many times to dealer 1st car ended with Transmission replaced 2nd has now started doing the same thing they reset adaptive and next day did it again its now back at dealer waiting for them to diagnose again.
View 13 RepliesHyundai - Elantra :: Stiff Drive - Hard To Reach 40 Mph Without Engine Feeling Heavily Over Worked
When I drive my car, is fine for the first twenty minutes. After which time, the car drives like the E brake is on. Further, when I'm in city streets, the rpms go really high just to hit 25 mph. When I take my foot off the gas, the car gradually slows to the point where the car stops while in drive. Even if i press the gas, I have to press hard before the car moves. And when it does move, is like the E brake is on because it acts like it doesn't want to move. While traveling, is hard to reach 40 mph without the engine feeling heavily over worked.
View 12 RepliesAccent MC (2006-11) :: Hard To Start When Have Low Fuel
My car has a bit of trouble starting every now and again. I have noticed it is when I have low fuel. When I try to start it it will just keep winding over. I'll switch my car off completely and try again. It usually starts the second or third time. What could be the problem? Its a 05/06 Hyundai Accent
View 4 RepliesFord - Explorer :: 2006 - Hard To Start?
It is a 2006 Explorer with the 4.0 and around 89,000 on the odometer. Around a couple weeks or so ago the wife said the explorer was hard to start one evening and it has been like that ever since. It cranks for about 5 seconds and then fires. So far it has started every time since this issue began. This is really the first issue we have ever had other than the radiator replacement a few years ago.
View 3 RepliesAccent MC (2006-11) :: Hard To Start After Filling Gas Tank
My wife's 2007 Accent started having starting problems right after filling the tank. Is this an EVAP canister problem?
View 8 Replies