Elantra HD (2006-10) :: 2007 - How To Remove The Crank Pulley
Preparing for a timing belt replacement on a 2007 elantra. well aware of how to remove the crank pulley and do the job. My question is this : once you have the nut off, does the crank pulley come off by hand or is a puller required? came off nicely wiggling it by hand on any accent i've done, but never done this particular job with the elantra.
View 4 RepliesElantra HD (2006-10) :: Engine Diesels When Turn Ignition Off
I have an Elantra (gas) with 23'000 miles and occasionally when I turn the ignition off it will diesel . I use 87 octane in the car . Changed the spark plugs 3 weeks ago , although it did it prior to that .
View 1 RepliesAccent MC (2006-11) :: 2007 - Engine Will Crank But Won't Start At All
I have a Hyundai accent 2007, I guess the brain box is faulty, the engine will crank fan roll etc but won't start at all, can dis reset work for it at all ...
View 14 RepliesFord :: 1982 - Engine Tries To Crank With No Key In The Ignition
My 1982 Ford Granada cranked slowly and failed to start. Before getting a new battery (it's already 6 years old), I cleaned the battery terminals and cable clamps from corrosion and re-connected them. The car started with no problem. The second time I turned the key, the car cranked slowly and again it failed to start. This time, I noticed the battery was being drained with the ignition off (the voltage was way too low). I frantically removed the negative battery terminal to prevent a fire and drained battery. When I re-connected the battery terminal, the engine tries to crank with no key in the ignition. Is there a relay or solenoid that froze in a closed position? Or, could it be a faulty ignition switch?
View 15 RepliesIgnition - Buick - Lesabre :: 1997 - CEL Flashing / Engine Does Not Crank At All Or Turn Over
Pulling into work this morning I noticed my check engine light was flashing. The car (1997 Buick LeSabre, aka The Rolling Couch) was still running and everything seemed normal. I turned off the car and then went back out 3 hours later and tried to start it. It would not start, and the symptom is not one I've had any luck Googling. When I turn the key, it makes a sound, but it's not a click. It's the normal sound when ignition starts, but the engine does not crank at all or turn over. It just makes a single ignition sound and then nothing. Could this be a belt? The starter? I have not taken it anywhere or pulled the error code yet.
View 13 RepliesElantra HD (2006-10) :: 2007 - Engine Stalls When Attempt To Start / Place The Car Into Gear (auto)
I have a 07 Elantra with 68,000 miles. I am having a cold start issue. When the car sits overnight and I attempt to start/place the car into gear (auto), the car will stall. This occurs whether the car is placed in forward/reverse and with the a/c on/off. The vehicle will start fine the rest of the day with no issues.
View 8 RepliesElantra HD (2006-10) :: 2009 - No Crank / Start
I have a 2009 Entrant, lately I've started experiencing no crank starts, I try a couple of times and then it starts normally. The car has new battery and terminals so am thinking it might the starter. I've looked online on a how to change starter for a 2009 starter video but no dice. I've found every other Hyundai but not the 2007 to 2010.
View 2 RepliesElantra MD (2010-15) :: Engine Keeps Knocking After Turning Off Ignition
My engine keeps knocking for a minute or so after I come to a stop and turn off ignition. Should I be concerned?
View 14 RepliesAccent MC (2006-11) :: 2007 - Ignition Key Will Not Turn To Start
Drove the car yesterday all was fine. Came home and shut it off. Went to start it about an hour later and the ignition key will not turn. Tried a second key and still no luck. Disconnected the battery and waited for about 10 mins. Reconnected battery still no luck. Wiggled steering wheel and shifter (automatic) still no luck.
View 16 RepliesElantra MD (2010-15) :: 2013 GLS - Push Start Ignition / Locking Car With Engine Running
I have a 2013 Elantra GLS, with Push Start ignition.
Whenever I get out of my car for a few minutes, I keep the engine running, so what I do is, I keep the Smart Key inside the car, and remove the physical key trying to lock the doors from outside (I do this to keep the car cool from inside because the heat in my country is scorching!)...what I found recently is that as I do this, only the driver door gets locked, and all the other doors are still unlocked...I don't know if this is a fault or standard....
Sonata NF (2006-10) :: 2007 / 2.4L - No Crank When Turn The Start Key
I Have a sonata 2007 2.4L automatic and I just had a start problem today. I turned the start key and nothing no crank, all the light in the dashboard are ok, i can hear the fuel pump and my batery is fine. I tried 5 time to start it and nothing I wait 10 minutes and the car started ..
View 10 RepliesHyundai - Sonata :: 2007 - Ignition Would Not Turn The Engine
On sporadic occasions when I turn the key to start the car, I get nothing. No buzzers, bells, lights or ignition. If I open and close the door, all is well.
View 3 RepliesSonata NF (2006-10) :: Engine Crank But Won't Start
I've Sonata 2006 and it's just fine no problems at all, until this problem comes. When I start the car the engine crank but not start, RMPs is jumping to 4 then into 0.. I checked fuel pump, battery and sparks all are good.
View 4 RepliesLexus GS 2006-11 :: Check 4WD Message When Turn Ignition ON Engine OFF?
I've noticed that the car has started to give me all the dummy messages, particlarly "CHECK 4WD" when I turn the ignition on without the engine running. If I then hold the brake pedal and start the engine, the message remains. If I turn the ignition off, and then start normally with the brake pedal depressed and start the engine it goes all normally and "CHECK OK" and I never get any errors when driving. I also noticed when this happens the AFS light is flashing as well - well, basically every warning on the dash is lit.
So, what's up with that ... I know it's normal for all the dash lights to light when the ignition is on and engine is off but I never noticed CHECK 4WD in this state previously. I haven't really noticed if it happens every time but it seems to happen quite a bit when I just turn the ignition back on to do something like close the moonroof if I forgot it. It's also odd that it doesn't clear when starting the car without first turning ignition off after that.
I assume that nothing is actually broken because it all behaves normally when starting the car regularly and the car does not complain at all when driving around.
Jeep - Grandcherokee :: 2007 - No Engine Crank And Transmission Over Temp Message
2007 Grand Cherokee - no previous problem - no work done in last year.No engine crank - brief dash msg of "transmission over temp" - then msg disappears and vehicle is silent when key turned.Has happened 4xs in the past 2 weeks. Sometimes will start after a few minutes other times will not start until 24 hours later.Tuesday drove 20 miles no problem. Stopped car for 2 hours went out to restart and nothing but silence. Brief dash msg of transmission over temp.Had vehicle towed to dealer. Tow truck driver had never heard of this problem and it did the same thing for him. Dealer had jeep for two days and can find no problem. Started right up for dealer. No fault codes.
View 4 RepliesSonata NF (2006-10) :: 2008 GLS Won't Start / Ignition Try But Fail To Engage The Engine
I'm in a bit of a bind. I was very low on gas drove my car on fumes (mistake, yes) back to my place. Today, it will not start. I dumped 3/4 of a gallon into the tank, and still no start.
The ignition will try, fail to engage the engine, and then emit rapid clicks as the interior light flashes. The battery works, as all the cabin lights turn on.
I really don't want to the fuel pump to be broken, so I'm trying to eliminate possibilities before that. Is there something wrong with the ignition, perhaps? What is the clicking after the attempted "heaves" of the ignition switch?
Accent MC (2006-11) :: Engine Struggle And Stumble - Stuck Ignition Coil
My wife has an 09 Accent and a couple of days ago we were exiting the highway. As I stepped on the accelerator I noticed the engine struggle and stumble followed by the flashing MEL. I pulled into a parking lot and shut the car off and plugged the reader in to get the code but the computer already erased the code and the MEL light was extinguished and it ran fine the rest of the day. The following day my wife was driving it on the highway when the MEL light came back on but there was no associated engine roughness. I had her plug in the reader to get the code for me and it came up with P302 - misfire detected in the #2 cylinder. She didn't notice any engine roughness so I told her to drive to work but stay off the highway. She went out at lunch and the MEL light was off.
I did some research on here and the web and found the accent is known for going through ignition coils as well as a possible design flaw with the ignition wire harness that could cause it to rub and become frayed. I ordered the wire harness from our local Hyundai dealer and got an ignition coil from autozone. I also figured that I might as well get 4 spark plugs and replace them while I was at it. I got the plastic cover off and removed the 10mm bolt from the #2 ignition coil but it was wedged in there and would not budge. The coils from 1, 3, and 4 popped out with no issues. I ended up using almost a half a can of PB Blaster and 2 hours before the coil finally came out. The problem that I'm now looking at is some of the plastic from the coil remained stuck to the metal in the holder. Is there anything that I can use to clean out that metal cylinder?
After examining the spark plug from the #2 cylinder I could tell it was fouled and needed replacing but my concern is now that that new coil will get stuck in much the same manner. I'm pretty sure that the coils were WELL past due for replacement as I'm not sure when they, with the spark plugs, were replaced last. I'm pretty sure it was before my wife and I got together so that's more than the recommended 60k replacement intervals. I've ordered 3 more ignition coils to replace all of them and reset the 60k replacement interval. Since I replaced the one coil and 4 spark plugs the problem seems to have been corrected and the car is running great.
Passat (B6) :: Front Engine Mount Broken - 2007 2.0T Sedan Crank But Won't Start
I have a 2007 Passat 2.0t Sedan. My wife broke the front engine mount this morning and now it will crank, but will not start. Put my code reader on it and it is throwing camshaft position sensor, misfire cyl. 4, fuel rail pressure low, and Mass Air Flow sensor codes. It looks like the insert of the mount is wedged against the belt. Would the engine mount being broken cause any of these codes for some reason? and would the mount against the belt cause it to not start?
View 6 RepliesFord F-150 (2004-2008) :: 2006 - Engine Won't Crank - No Start?
I was working on trailer lights and now no trailer lights and relays click but eng no crank. Batt has 12volts.
View 1 Replies