Dodge - Dakota :: 1997 - Intermittent High Idle
vehicle 1997 dakota engine 3.9L w/autotrans.
The vehicle exhibits an intermittent high idle. I have replaced the usual IAC stepper motor and checked the tps for proper function, also completely cleaned, inspected and relubed the throttle body and linkage.
According to my Inova 3140, there are no codes and the temperature sensors and tps percentage are reading correctly. Also the battery and charging system are functioning correctly.
I do not have bi directional capability or the ability to monitor any of the pid'sOne other thing is that she also has a slight rough idle, but that could be the 200,000 miles.
Dodge - Dakota :: 2005 - Steering Wheel Will Shake Randomly When Driving
I have a 2005 dodge Dakota when I'm driving the steering wheel will shake randomly.This isn't happening constantly when driving and it will stop after I make a turn. In addition it will happen randomly regardless of what speed I'm driving. What's going on?
View 1 RepliesDodge - Dakota :: 1997 Starts And Vehicle Will Move Then Engine Dies
'97 dodge dakota engine starts and vehicle will move and then engine dies. Just bought it and it ran fine. Coil was replaced by previous owner four months ago. At times it will run fine but is not reliable and wife will not drive in it. Had it towed to dodge dealer and they said it needed a new coil which they installed and still have the same problem and now think it might be the ecm which is mine even if it does not cure problem. Truck has 145k miles and otherwise is in good shape. When it does run, engine is strong, automatic shifts good and all accessories work. But, it won't keep running.
View 14 RepliesDodge - Dakota :: 1995 - Grinding At Sharp Turns Only Once Warmed Up After Freeway Driving
I have a 1995 Dodge Dakota. After a bit of freeway diving and everything is all warmed up the truck makes a rubbing/grinding/groaning noise, but only during sharp turns. Once I straighten the wheels back out the nose goes away. The noise doesn't exist when it's cold though.
View 11 RepliesDodge - Dakota :: 2004 - Hard Time Starting And After About 10 Minutes Just Dies While Driving
The truck had a hard time starting, turn the key over hear that it wants to, but won't. Once getting it started, truck would drive fine, but after about 10 minutes just dies while driving. It then took 6-7 tries to get it started again, drove back like no issue. What it could be? I have come up with, potential battery, fuel pump/filter, spark plugs, EEC relay, PCM, or AIS motor, O2 sensor....
View 2 RepliesStalling - Dodge - Dakota :: 1997 V8 Stalls While Idling In Drive, But Not Neutral Or Park
I have a 1997 Dodge Dakota V8 (automatic) with about 140k and live in Vermont. Recently, my truck will konk out while I am sitting at a red light. As I'm sitting there, the RPM's keep going down below 700, until finally stalling out completely. When I shift into Park/Neutral then turn ignition, it will start right back up again. To get around this, I have been shifting into Neutral while I wait at the light, then back into Drive when it turns green. I have recently installed a new battery and exhaust system. I am wondering if this is occurring because of worn plugs, a dirty air filter, cracked vacuum hose, or bad alternator?
View 2 RepliesDodge - Electrical-wiring - Gauges - Dakota :: Battery Cable Pops Off While Driving / Car Keeps Running
While driving home after replacing a dead battery, clearly I didn't tighten the negative cable enough as it popped off while I was driving (I only found this out after I got home though). But even after popping off, the truck kept going, albeit with the battery gauge maxed out and the dashboard/headlights flickering. I turned off what I could (it was night, so I needed headlights!), but it still accelerated well, and there were no noticeable performance issues at all. When I got home, I tightened the cable, started it up again just fine, ran it for a minute, then turned it off and restarted it fine again with no problems.
My concern is: am I looking at serious electrical issues long term, or should I be ok? I'm just trying to make sure that driving without a negative cable for less than a mile doesn't fry certain parts of the car, and end up causing big issues down the road. (Truck is a 2000 dodge dakota slt)
Dodge - Dakota :: Humming Like Noise When Transmission Is Engaged
I noticed a humming like noise when my transmission is engaged. I looked under the truck and saw a wet spot on the transmission(leaking)It is a manual transmission 5 speed Dodge Dakota 2001.
View 2 RepliesDodge - Dakota :: 1987 - Chirping Noise From The Rear At Acceleration
I have an 87 Dakota with a two-piece driveshaft, bought it new. A couple months ago at 140,000 miles there came a chirping noise from the rear at acceleration from a stop. I changed the u-joints with new Moogs and had a new center support bearing pressed on at a driveline shop. Reinstall driveshaft same as it came out. The u-joint at the diff was shot, the other two not far behind. The chirping vanished as expected, but was replaced with a slight vibration felt in the seat starting at 50-55 mph. I dropped the truck off at the driveline shop to get the driveshaft balanced. They put it on the balancer and called to say they couldn't balance it, the indicator kept jumping around and wouldn't stabilize. I asked them to reinstall it and came to pick get the truck. The guy who worked on it said that this was usually a u-joint problem. I asked what brand they used and pulled he out a Neapco u-joint box and said they use them exclusively and have never had any problems. I ordered Neapcos from RockAuto. Will replace the Moogs and see what happens. After they reinstalled the shaft I drove in the freeway and it acted exactly the same.
I was very careful when pressing out the old joints not to stress any of the yokes, applying pressure to the u-joint members at right angles to the cap being pressed out and not to the cap 180 degrees opposite. When installing the new joints, after inserting the clips (interior) I pressed all clips snug against the yoke. The joints all moved freely in all directions. Again, the shaft was replaced exactly as it came out.
Dodge - Dakota :: Fast And Loud Clunking Noise From A Pulley
My tensioner pulley is already shaking but when the ac clutch is engaged the tensioner starts to shake even more and it starts to make a clunking noise extremely loud and fast. I also noticed that the crank pulley is shaking quite a bit too so I don't know if that has anything to do with it.
View 4 RepliesDodge - Dakota :: Whistling Noise (sounds Like Air At High Pitch)
I have this whistling noise coming from the front area of my truck (97 dodge dakota) 4X4. The noise sounds like air at high pitch (just my opinion and friends), happens around 30 to 40 mph when you hear the whistling noise. I've taped all holes and gaps that might be causing the sound but no avail. I've had a friend look at it, that's a fire truck mechanic and no luck and he said it didn't sound like wheel bearing problem.
View 1 RepliesDodge - Dakota :: Chirping Noise Upon Acceleration From Stop Coming From Under Truck Bed
I have an 87 longbed Dakota that I bought new. It's my work truck. Lately it has developed a chirping noise that I hear best with the rear slider window open. I think it is safe to say that it is not coming from under the hood. When I accelerate from a stop the chirping noise increases in pitch and frequency. The frequency does not change when the auto trans up shifts. There has been no noticeable out-of-the-ordinary vibrations, even at freeway speeds.
I have stopped driving on the freeway since the chirping became impossible to ignore. The chirping becomes less and less audible the faster I go as the pitch and frequency increases. When just starting from a dead stop, it sounds like a metallic scraping noise. Whenever I take my foot off the gas the chirping stops, even when still coasting, so it only occurs under load. It does not occur when the truck is stopped and the engine is revved.
Dodge - Dakota :: 2004 - Clunking Noise When Going Forward While Turning Either Direction
My 04 Dakota 4x4 makes a clunking noise when
1) in 4-wheel drive going forward while turning either direction (but not while going straight) and
2) in 4-wheel drive in reverse (straight or turning). It does not do it in 2-wheel drive under any circumstances.
I suspect the front drive shaft U-joints since it only happens in 4-wheel drive. Rear drive shaft U-joints or front CV joints would be a possibility but I would think they would cause a noise in both 2 and 4-wheel drive and in either direction equally.
Sonata NF (2006-10) :: Grinding And Banging Noise When Driving At Low Speeds
A few days ago, my Sonata 2006 LX started making weird noises when driving at low speeds. The noise comes from the front driver's side area, they are not affected by steering or going over bumps. Usually get less intense when I accelerate or brake. At speeds around 5 mph, the noise is grinding and pretty loud. At higher speeds, it's more like banging and it's frequency increases with the speed. There was no effect other than the noise, but the last day at higher speeds, I can feel with the steering wheel a little vibration sometimes from the banging.
I've been having tough times renting a car during the weekend and I still drive on short distances, but I'm afraid it could be a safety issue or that I can be making things much worse to repair. The noises got worse since the beginning, but I don't think they are getting any worse anymore.
Dodge - Dakota :: 2006 - Racket Noise Coming From Front End When Hit A Rough Place On Road
My 06 Dodge Dakota, has a terrible racket coming from the front end when you hit a rough place in the roads especially the left side, seems worse when the wheels are cut, nothing is obviously loose ,it has 88K miles on it.
View 6 RepliesDodge - Dakota :: 1999 Won't Turn Over - Glove Boxes Making Clicking Noise When Door Opened
I have a 99 dakota. The truck wont turn over, headlights/doom lights nothing in side works. But when i open the door the glove boxes starts making a clicking noise ? it happened once before and once i pushed it down a little drive way everything turned back on ? What could cause this problem ?
View 3 RepliesFord - Explorer :: 1998 - Loud Banging Noise When Driving Coming From The Rear
My 1998 Explorer is making a terrible banging noise when driving. It appears to come from the rear. It only occurs when i step on the gas, gives a bang and the car shudders lightly. The bang can be gone for 10 - 30 seconds, and all of a sudden appear again. If I step hard on the gas, it will make a bang! bang! bang! noise.. If let my foot off the gas, it rolls quitely without any noise.
I have greased the slip yoke, inspected the U-joints, checked the rear calipers, opened the rear axle/differential plate - no metal parts or excessive wear were observed.. The transmission runs smoothly, there are no other noises apart from the bang. It is as if someone is hitting the car with a hammer from underneath...
Prius (Gen 3) Fuel :: Power Mode MPG For Aggressive Driving
My friend is an aggressive driver. After she drives there is a drop in the calculated mpg's by at least 2 mpg sometimes as much as 5. Would it be better for her to drive in POWER MODE not only for the mpg's,?
View 3 RepliesGolf/GTI VII :: After Installation Of Lowering Spring Hearing Popping / Banging Over Large Bumps?
I installed H&R lowering springs this weekend and now the suspension is making quite a bit of noise. I've double and triple checked the installation, and this isn't my first rodeo, so I don't think anything is improperly installed.
I'm hearing popping/banging over large bumps. I do believe that the noise is most noticeable when my tires drop off into a pothole and the suspension is unloaded. I think the noise is caused by the suspension being uncompressed and then the coils of the springs either hitting themselves or hitting the top hat.
Experienced excessive noise with the H&R springs? I think my next course of action is to get some spring isolators and see if that stops the noise.