Corolla / Matrix 2009-13 :: 2011 - Idling At 1000 RPMs - Too High?
Noticed this morning I was idling at 1000 rpms and was wondering if that's normal or a little high?
View 5 RepliesCorolla / Matrix 2009-13 :: Toyota Making A Loud Grinding Metallic Noise On Front Left Side
I have a 2009 Toyota Corolla and it's making a loud grinding metallic noise on the front left side. It does it while I drive the faster I go the louder it gets. When I turn to the left it makes it louder, when I turn right the noise decreases. PG&E have been breaking the roads by where I live and there's a lot of little rocks I drive thru. I'm wondering if that's the problem?? What do I do?
View 4 RepliesCorolla / Matrix 2009-13 :: Chain Grinding Sound On Cold Start Ups
We got a 15 F150 yay for her but I got stuck with her 113k.
So the engine makes a chain grinding sound on cold start ups and the tranny is slipping pretty hard.
Can I swap a 2.4 with a 5spd without doing a bunch of wiring?
Corolla / Matrix 2009-13 :: Loud Humming Sound At The Rear When Reaches At 40 Mph
I bought a used 2010 corolla and notice a loud humming sound at the rear when it reaches 40 mph. I figured it was the rear hub bearing assembly. I already bought a pair of Beck/Arnley 051-6262 hub assembly. I found two threads here about the removal/installation but did not say the torque of the 4 bolts behind the hub assembly. I read on the Toyota Manual that it is 74 ft-lbs. Do you think that this is too tight for a 10 mm back plate. The wheel/rims bolt torque is 76 ft-lbs but the nut is about an inch length. It is almost the same torque for an inch nut compared to 10 mm back plate. Is 74 ft-lbs right especially for an aftermarket beck/arnley brand? On the Toyota Manual, the 2003-2008 Corolla 4 bolt torque is 45 ft-lbs. The 2010 is 74 ft-lbs???
View 1 RepliesCorolla / Matrix 2009-13 :: Unusual Rumble Or Grinding Sound Coming From Driver Side Front Wheel Well
I noticed while driving my car there was a unusual rumble or grinding sound coming from my drivers side front wheel well. I get out and look I see a bunch of Fluid all over my wheel well. I look around turn my wheel around and see this fluids all on my rotors and suspension. Ive noticed couple weeks back the boots on the struts were ripped in two pieces from deteriorating or dry rotting (this was on both sides) and ive also been hearing some odd squeaking sound for over 15k miles every once in a while going over big bumps or train tracks. Struts go out at only 80k miles on their corolla? Yeah struts do usually lose their life around 60-80k miles but I've never seen them leak around that many miles. Is this a common issue?
View 5 RepliesCorolla / Matrix 2009-13 :: On Cold Startup Car Makes Loud Hissing Sound Then Runs Normally
It has happened three times now on cold startup my car makes this loud hissing sound then the car runs normally. Once a few months ago. Again a few weeks ago and this morning it was pretty cold maybe low 50's. I normally turn the key in the ignition to the "acc" position let it "ding" once then start the car. What could this loud hissing be that only happens on cold startup then the car runs like nothing happened? I called my local mechanic and he said he wouldn't know if he can't recreate the sound. Which you really can't because it happens once every blue moon but I wanna make sure I'm not ignoring a problem that could get worse.
View 9 RepliesCorolla / Matrix 2009-13 :: 2010 Toyota S - ABS Engaging And Loud Pulsing / Creaking Sound
I own a 2010 Toyota Corolla S that I purchased with about 30k miles, I have put about 65k on it since purchasing it. When applying the brakes in dry conditions I am receiving what feels like the abs engaging and a loud pulsing sound/creaking sound. The brakes will pulsate as if I am stopping on snow or ice but no traction control or abs lights will not illuminate. This has been happening for a good while(ever since I purchased the car). I have replaced the front rotors and pads and the problem purists.
The road conditions in this video are completely dry with an outside temperature in the high 70's.... YouTube .....
Corolla / Matrix 2009-13 :: RPMs Drop When Car Is Idling?
When your car is idling the rpms drop below 600rpm and you can feel like its going to stall but then goes normal. How do i fix this? Clean throttle body???
Also how hard is it to change the transmission fluid? Possible to do it at home?
Corolla / Matrix 2009-13 :: Fire Up / Run For A Couple Of Seconds And Cut Off
I have a 2009 corolla with about 125,00. I bought it used about two years ago and it has been trouble free. This morning when I went to start it, about 29F with heavy frost on the windows, it would fire up run for a couple of seconds and cut off. I id this probably 20 times and gave up. I called a neighbor to take me to my bus and thought I would try it one more time. fired right up and stayed running. Also started right up when I tried it later when I got back from work.
View 2 RepliesCorolla / Matrix 2009-13 :: Running Rough When Idling In Drive
My 09 corolla is running rough when idling in drive. It doesn't happen in park or neutral.
View 5 RepliesCorolla / Matrix 2009-13 :: Average Readout Drops To Around 22 Mpg While Car Idling
I have a 2013 Corolla S. I notice when I let the car idle for like 5-10 minutes the Average mpg readout drops to around 22 mpg(in city while driving it is usually at 25). Why is this?
View 5 RepliesCorolla / Matrix 2009-13 :: Transmission Failure - No Power For Up To 30 Seconds
we bought a Toyota Levin 2013 in December New Zealand. We loved the car and for the first three months it went well. Then the transmission? started playing up. First thing on a clear crisp cold morning ( or that seems to be one trigger) we would move off from stationary and it would start to accelerate and then it loses power and almost comes to a stop ( approx 30 secs) then it would engage and move off. This has happened 5-7 times and is dangerous. It will also do this when hot and going up a hill. Toyota is trying to say this is a characteristic and there is nothing wrong. To me it is dangerous.. I haven't noticed the engine light go on.
View 2 RepliesCorolla / Matrix 2009-13 :: CE ABS Starting Coming On A Lot More
I've got a 2009 Corolla CE, 5 speed. I've only had the car since september and had no issues until now. Now that there's snow on the roads, my car's ABS has starting coming on a lot more. Whenever it comes on, there's a noise that sounds very similar to grinding gears in a transmission coming from the front of the car. It's the first car I've ever had with ABS, and I've never heard this noise in any of my friend's cars with ABS, so I don't know if this is normal or not.
View 8 RepliesCorolla / Matrix 2009-13 :: Ticking Noise Under 1000 RPMs When Car Is Idling
I have a 2009 Corolla and anytime the car is idling and it drops below 1000 RPMS there is an extremely annoying ticking sound, it goes away when I put it in Neutral or the AC is on because it idles higher.
View 7 RepliesCorolla / Matrix 2009-13 :: Grinding Noise When Accelerate
So ever since I bought my car in April, I hear this noise when I accelerate. It only happens when I first start the car. Its a grinding light noise but you can definitely hear it when you are in the car. I only hear it when after I start the car, go reverse, and right after I step on the gas on drive. Today I took it in for my 10k service and told the Assistant Service Manager about it. We went and took my car for a test drive and now we also hear the noise right after we he start the car then reverse.
View 11 RepliesCorolla / Matrix 2009-13 :: TSB - Grinding Noise On Start Up
I have a 2009 Corolla with 67k on the odometer so it is outside of warranty. I recently found about the TSB for the grinding noise on start up and took the car to my mechanic to have it looked at. He said he wasn't able to do the job because he would have to do some sort of computer update (ECU reflash?) and he doesn't have the means.
My car is currently at the dealership, and they want around 1800 dollars, 1400 for the VVTI gear, and another 400 for a tensioner. I have a friend who used to be a Toyota mechanic, and he says he can do the work as stated in the TSB, but he's unsure if the ECU would need updating, and it does not mention anything in the TSB. So what I am wondering is if :
1. Does changing the VVTI gear actually fix the grinding noise? I was reading an old thread where members said it was still there after having the TSB done.
2. Does there need to be anything done to the ECU after doing the TSB?
Corolla / Matrix 2009-13 :: 2011 - Grinding In Third Gear And Sometimes 4th
So the grind in 3rd gear is getting pretty bad. I have to put it into third slowly and 4th sometimes grinds a bit. Could it be the slave or master cylinder?
View 8 RepliesCorolla / Matrix 2009-13 :: Grinding Noise Whenever Start Up
I have a 2009 corolla S. no warranty. 59k miles. my car gets a grinding noise whenever i start it. this is the example of the sound.
YouTube ....
Corolla / Matrix 2009-13 :: 2010 - Disable Traction Control For More Than Just A Few Seconds?
Here is the deal I have an autocross event coming up this weekend, and a 2010 corolla with traction control. How can I disable the traction control for more than just a few seconds? It is strange that when I hit the button after about 15 seconds the traction control comes back on.
View 12 Replies