Corolla / Matrix 2009-13 :: Disturbing Vibration With Sound On Brake Pedal
This vibration with sound on my brake pedal started after i change my stock intake to takeda. Well, Not all the time this thing happen, only when im in this kind of situation:
Pressing and hold my brake pedal at full stop and the gear is set to Drive, then, when the RPM goes down to below 900, the vibration with sound started, and it only disappear when i release my brake or when the RPM goes up automatically.
But, this only happened with this kind of situation when my car already heated up (like driving it more than 10 mins) and the temperature is at stable level.
While my car is just started driving, or its not already heated up, no vibration is happening.
Corolla / Matrix 2009-13 :: Brake Pedal Working On Low Position
On my 2010 s ,my pedal brake begin to work on low position, I have 35000km it is normal? my wife hate this car because this.
View 4 RepliesCorolla / Matrix 2009-13 :: 2011 LE Engine Vibration Right Between 2000 - 3000 RPM
I am getting a engine vibration on a new 2011 corolla LE. The vibration is right between 2000-3000 RPM. Also the muffler kinda sounds louder at that RPM. I have only 300 miles on this car ...
View 14 RepliesCorolla / Matrix 2009-13 :: Brake Pedal Seems To Go Half Way To Floor Before Grabbing
I did a search and found nothing. When I press on the brake pedal, it seems to go half way to the floor before grabbing. The other 2010 I tested did the same thing. Is this common or is this something that I need to take to the dealer?
View 5 RepliesCorolla / Matrix 2009-13 :: Brake Pedal Takes A Bit Of Travel To Engage / Air Sound
Is this normal? You can hear the air coming out.
The reason I ask if it's normal is because it seems like I have to press my brake pedal halfway down before it engages. At least an inch or two. However I can still lock up the beaks. But it seems like they are not as sensitive. Takes a bit of travel to engage.
I've already bled the brakes too.
Corolla / Matrix 2009-13 :: Brake Pedal Spongy And Making Hissing Sound
2009 XRS ABS brakes .... I changed all four brake pads and flushed out most of the old brake fluid. Bled all four sides. But now while I am in idle (like waiting for a light to turn) my brake pedal is spongy and is making a hissing sound. All was good before I did this job.
View 3 RepliesCorolla / Matrix 2009-13 :: When Release Gas Pedal RPM Goes Down Then Back Up
When I am driving holding the gas pedal and the rpm at about 1500-2000 rpm but when I release the gas pedal the rpm goes down maybe 500-750 rpm then back up.
View 4 RepliesCorolla / Matrix 2009-13 :: Throttle Or Gas Pedal Adjustment?
Is there anyway we can adjust our throttle or gas pedal? Cause when I press down on gas, it doesn't open until about an inch down the pedal. Pretty much, I just want the throttle to be more responsive.
View 7 RepliesCorolla / Matrix 2009-13 :: Front End Rumbling / Vibration Around 20 - 25 Mph
Recently purchased my first Toyota, a 2012 Corolla S with 76,000 miles on the ODO. I have a concern about a front end rumbling.
First, the problem...
This "rumble" (the best way I can describe it) starts becoming noticeable around 20-25 mph, depending on the condition of the road I'm on (it could be lower, but I'm in Michigan, all the roads are bad here). This rumble isn't a noise, but more of a low frequency sensation that can be felt in the car and through the steering wheel, and vibrates the rear view mirror. The rumble comes and goes, it isn't constant. Sort of like driving over a rumble strips put on roads before stop signs/intersections, it seems to have an oscillation to it. The rumble intensifies very little with speed. It doesn't seem to oscillate any faster or rumble much harder, it's just there.
Things I've ruled out...
Brakes. When I bought the car, the first thing I noticed was that the front brake rotors were slightly warped, so I installed new rotors and good pads. That didn't get rid of the problem, though I didn't really expect it to.
Tires. The previous owner had seriously over-inflated these tires. Once taken down to their proper pressure, they were noticeably cupped down the middle. These tires were also horribly noisy would not balance, so brand new tires went on (Michelins). The new tires greatly improved the ride, reduced noise, and got rid of a lot of other shakes and vibrations, but the "rumble" remains.
Wheel Bearings. I'm not 100% on this one, but as far as I can tell, it's not the wheel bearings. I've taken the car out on twisty roads and there is no change in the rumble through hard turns, nor any additional vibrations of any kind. Usually bad wheel bearings will exhibit some noise or vibration when being loaded in a turn, but not in this case, so I've ruled them out.
Things I'm not sure about...
CV Joints. I've never had a CV joint go bad or fail on me, so I am unfamiliar with the common signs and symptoms. I have inspected the boots, and they appear to be in good condition and crack free, though that doesn't mean a joint isn't failing. There's no clicking during slow sharp turns, but I think that would only present itself if an outer joint was failing. I'm going to get the car in the air this weekend to do a drain and fill on the tranny (the fluid is getting pretty dark, so I want to get some new in there).
I drove a Ford Focus for the past 10 years and a Ford Contour for 10 years before that, putting over 200,000 miles on both, and never experienced any sort of problem like this.
Corolla / Matrix 2009-13 :: Clutch Pedal Was Sticking For A Second Or Two Between Shifts During Drive
It was about 7 degrees Fahrenheit and I started my car and it took a few seconds longer to start then normal but I kind of expected that as it was pretty cold.
Then after letting the engine warm up a little bit I went to leave and the clutch pedal was sticking for a second or two between shifts and I still kind of ignored it and drove home, well after a 45 minute drive by my house it was still doing it.
The next day I drove it to the store and after sitting in my garage for a while it was fine. A few days later, (well last night) I went on a break to get some food and it did the same thing when I left to do that but after it was warmed up to normal operating temperatures it was fine again. When I first started it, the temp was 13 degrees.
I am trying to figure out if there is something wrong with my car or if all of them do that. I am going to stop by the local dealership on my way home today but if it is normal I don't want to waste my time. I just don't like the fact that I live in Minnesota and the temperature is going to get colder then that. I mean what is it going to do then?
Corolla / Matrix 2009-13 :: Low Idle And Vibration While Stopped At A Light
My wife's 2009 Corolla S has 107,000 miles. Early on it developed a low idle and vibration while stopped at a light. It was idling about 600 rpm after it warmed up. It never stalled but occasionally vibrated. After doing some research I found some were having success cleaning the throttle body and throttle plate. I did that along with changing the spark plugs. At that time I disconnected the battery to reset the computer. She has put about 2,000 miles on it since then and it never idles below 800 rpm. The vibration hasn't been back either.
I believe it was the throttle body/ plate cleaning and disconnecting the battery that resets the computer that fixed it. The plugs still looked good at 105 K miles, but I had new ones so I put them in. I bought a can of Berryman b12 choke & carb cleaner and sprayed a little on the throttle body and plate and then sprayed some on a rag and wiped down the body and plate. It was quite dirty.
Corolla / Matrix 2009-13 :: Toyota LE - Vibration / Rough Idle Low RPM
Basically when the car is in D and when i am stopped with the brakes pressed on at a stop sign or a red light, the car starts vibrating and i can see the the rpm going down and then receiving back up and going down again something when the car is in R. its a 2009 toyota corolla le 90k miles. when the headlights are on, the rpm stays high so the car does not vibrate or anything. other than this the car runs perfectly fine.
View 1 RepliesCorolla / Matrix 2009-13 :: Vibration And Shaking During Slow Moving?
Recently, my 09 corolla S starts shaking during slow moving . As I accelerate more, it start vibrating at high frequency. And I can hear the sound "kin kin kni.." I checked the tires, they all look fine. It has 60k miles on.
View 2 RepliesCorolla / Matrix 2009-13 :: 2011 LE - Where Is The Air Filter
Where is the Air Filter? How do you access it? 2011 LE
View 4 RepliesCorolla / Matrix 2009-13 :: 2011 LE Bad Gas Millage (27 MPG)?
I just got a 2011 corolla le with 45k miles and the gas millage is terrible. I have a 2005 acura rsx and I drive about 20 miles a day and I can go a whole month without refilling. I Put in half a tank in our corolla and only got 115 miles out of it. I drive the same way I do in my acura which Is pretty fuel efficient. My car tells me I am getting 27 mpg. But if I calculated correctly (115miles /7 gallons= about 1 8 mpg, my acura will get nearly twice that millage. What do you think I need to do. I've only put 500-1000 miles on it and not sure when the last tune up was. Should I take it to Toyota?
View 7 RepliesCorolla / Matrix 2009-13 :: Throw-out Bearing - Noise Comes And Goes As Clutch Pedal Is Released
Title should say Throw-out bearing aka Release bearing.
I have a 2010 5 speed Corolla CE. Having problems with their Throw-out bearings. At around 8000 miles the sqeaking/chirping noise of the bearing was too much so I brought in it to the dealer to fix. They agreed and made the repair.
Now it is only at 10000 miles (22000km) and I can hear it starting again. Just wondering if it is a common problem?
Noise comes and goes as the clutch pedal is released. If you push it in it will go away. It also will happen in all gears but easiest to hear in neutral.
Corolla / Matrix 2009-13 :: Noise From Engine Department While Driving And Depressing Gas Pedal
I have Corolla 1.6 dual VVTi (year - 2009.), manual transmission, 1ZR engine, for about a year, ~50000miles on clock. About a month ago from a engine part it began to produce sound that can be heard on the accompanying recordings.
For these sounds is characteristic that:
- can be heard only while driving and depressing a gas pedal, its not heard when Im changing rmps while the car is stationary..
-only when engine is warm
-from about 1900rpm to 3000rpm.
-Toyota service is not useful, they fail to locate the source of the sound.
I submit sound recordings that I made by placing a microphone in the motor department.
[URL] ......
Corolla / Matrix 2009-13 :: 2010 - Metallic Pads Cause Premature Pedal Shudder?
I bought my 2010 Corolla 5 years ago with 17,000 miles on it. Since then I've put on about another 46,000. With 63,000 miles it needs it's 4th set of rotors due to brake pulse and shudder. We live in the prairie and I'm not hard on brakes. The brakes have never felt like my 05 Corolla.
Can this be caused by too aggressive of brake pads?
Corolla / Matrix 2009-13 :: Shaking While Braking When Car Slows Down To A Stop
I have an '09. Experience a shakiness/shaking when the car slows down to a stop? Like, you slow down to a stop, then the car starts to shake for a few seconds.
I feel like it doesn't happen to me in neutral, which makes me think it is the transmission. Sometimes I get a rough/shaky start as well....