Chrysler - Towncountry :: 1999 - At Start Up Kills Immediately?
I have a 99 Town & Country that occasionally has a starting problem that has stumped my otherwise excellent mechanic. Every once in awhile when I start my van it kills right away. Even if I rev the engine with the gas pedal it kills immediately. It will do that 3-5 times, then when I turn the key nothing will happen, no click no dash lights, nothing. Often if I let it sit at that point for a few hours it will start and run fine.
The alternator was changed two years ago in an attempt to fix this problem and the starter was just replaced a few months ago.
Chrysler - Towncountry :: Failure Of Dash Indicators Intermittently
The dashboard display on my 1998 Chrysler Town and Country fails intermittently. There are no readings for Fuel, Oil Temperature, speed or odometer. This condition comes and goes. My mechanic has tried every thing he knows and now says he has to replace the entire system?
View 4 RepliesChrysler - Towncountry :: 2012 - Heat Blows Cold From One Side Hot From Other Intermittently?
Bought new oct.2012. Fiirst time used heat blows cold from one side hot from other. not consistent, will vary from left cold, then hot from right or the opposite. been fighting with chrysler from then till now. engineers know problem exists and are working on a fix. haven't found it yet. contacted chrysler numerous times, just get passed from one to another.
View 2 RepliesChrysler - Towncountry :: 2008 - Won't Start Sporadically
My 2008 Chrysler Town & Country has, since it was 2 mos. old, had a "no-start" problem. This is not a stalling problem. It happens when the car is off and I try to turn it on. The problem is very sporadic (sometimes several times a day - I do lots of short drives - sometimes several times over the course of a few weeks, then no problems for months). When I turn the key in the ignition, all electrical components come on (dashboard lights, air, radio, etc.) but nothing happens with the engine (it does not make a sound). The dealer has replaced a computer component, the battery, the starter, the electronic keys but the problem always happens again (within a few days of it the "repair"). I usually have to turn the key 3-12 times (sometimes I take it out of the ignition, sometimes I pray!) and eventually the engine starts. Because the problem is sporadic, the dealer has not been able to replicate the problem (though they have, at times, had it for a week or more and even driven it as if it were their own, home at night, to work, to run errands). Although the car eventually starts, it is very problematic when I have to be somewhere and it takes 10 minutes (not to mention a lot of worrying) to get it started.
View 3 RepliesChrysler - Towncountry :: 1991 Sporadically Fail To Start
My 1991 Town & Country will sporadically fail to start. e.g. I start and drive the vehicle,( this may be a short distance or a longer distance) I stop somewhere, I go to start the vehicle and nothing. No amount of tinkering will cause it to once again start. I wait for maybe 10 to 20 minutes and it starts. (Sometimes this can actually take many hours.) Seems to be worse when the weather is very hot. (What I know: There is fuel at the fuel rail. I have used a gauge and the pressure is correct at the fuel rail. There is no power whatsoever at the coil packs yet the Automatic Shutdown Relay is working correctly.) I have replaced the PCM and still the same problem. One time I started the vehicle, drove 200 feet and it stalled out completely. That just happened the one time. Finally, It seems to have gotten more frequent in its stalling behavior.
View 3 RepliesChrysler - Towncountry :: Starter Does Not Activate Occasionally Will Not Start
Used 2000 Town & Country is a great ride EXCEPT it occasionally will not start. All the electrical systems work except the starter does not activate. No connection to temp. Happens when cold or when hot. Sometimes cuts off when running and will not start. With the ignition in run position prior to starting, the check engine light does not light up and starter doesn't work. When in run and the check engine light comes on the starter will work and starts easily.
Sometimes in run position the check engine light is flashing and starter will activate for split second before light and starter quit. It's gone for months without happening and I fantasize that it has miraculously healed itself then it will happen once, or perhaps daily for a week. Sometimes wait +/- 1/2 hour and it cranks right up. Sometimes it won't crank for a day. Have replaced computer twice, various sensors (cam shaft sensor?...I'm not a mechanic) Our very competent mechanic won't let us bring it near his shop.
Chrysler - Towncountry :: Oil Pressure Light Is On At The Cold Start
The oil light on my 2005 Chrysler Town & Country comes on when started when it is cold outside. It stays on until I turn the key off and restart, then it goes out and does not come back on. My mechanic cannot find anything wrong. This only happens in cold weather, not in the summer.
View 15 RepliesChrysler - Towncountry :: 2008 - Windshield Wipers Would Start Flapping
I have a 2008 Chrysler Town & Country with all the bells and whistles. About a year ago started with a strange problem. When you started the car these things happened: The windshield wipers would start flapping, the windows would be locked, fan on the heating system would go to full blast while the temperature would reset to 72 degrees and the automatic doors would not work. The problem is intermittent and seems to be worse on hot days. My mechanic was lost on this and sent us to the dealer. The dealer said it was the radio/DVD system? That didn’t sound right so I had them just disconnect the system to see first if it corrected the problem. Hooked the system back up. Now the DVD doesn’t work and still have the problem. We have tried turning off the car and unhooking the battery. this stops it sometimes. Then we found that just resetting the the temperature would straighten it out (sometimes and temporarily). The car has been doing great for the past 6 months (fall and winter) and now started doing it again.
View 19 RepliesChrysler - Towncountry :: 1996 Won't Start / Turns Over And Fires For About 1 To 2 Seconds
My 96 Town and Country won't start. It turns over and fires for about 1-2 seconds max. After that it only turns over, no fire. The key sign/symptom is that the odometer and PRNL do not light up. This is very sporadic. Sometimes months and months apart. I unhook the battery in an effort to reset the computer. Sometimes it works in 1/2 hr. Sometimes several hours. So I don't think it resets but I still do it anyway. I have replaced the computer but no luck. Could it somehow be the dash cluster?
View 8 RepliesChrysler - Towncountry :: 2005 - Won't Start - Bad Relay / Short Circuit?
i have a 2005 Town & Country that now won't turn over. When I just turn the key to the on position (not even to start) the gauges flip around, the odo flashes intermittently as if there's some kind of short, and i can hear a regular, repetitive clicking from an area behind the battery that sounds like an electrical relay of some sort trying to engage but failing. Short history that may be related: I recently replaced the blower motor resistor since the AC blower would stop after about 10 min of driving. (Btw, replacing the resistor worked for a while, then failed again, so something else is going on).
I had disconnected the battery when I replaced the resistor and then 5 days later the car wouldn't start. It's 2 year old battery, so I assumed there was corrosion on the terminal and I had not reconnected it tightly enough. At that time, a quick jumpstart got it going again. A couple days later, it wouldn't start again, would only "click" when turning the key (e.g. starter solenoid). Now, it won't even do that, just this repetitive relay sound and the "short-circuit" appearance on the gauges/readouts. At least it's in my garage!
Chrysler - Towncountry :: 1999 - Stutters A Bit When Accelerating At 40 - 55 Mph
I have a 1999 Town and Country van, 3.8L engine. It has 220K miles on it. Lately, when I am accelerating, it seems to do fine until I get to 40-55 mph. In that range, it stutters a bit. After that it runs fine, even at higher speeds. I usually don't get this stuttering at the lower speeds as I am, for example, accelerating to get on a highway. A mechanic friend of mine says that it may be a vac leak. Does this sound right, or are there other possibilities.
View 3 RepliesChrysler - Towncountry :: Squeal Coming From The Engine Compartment / Hard To Start
I am the 2nd owner of a 2001 Chrysler Town and Country Minivan Limited. The vehicle is in very good shape and I service it every three months and have the tires rotated every six months.
Just recently I have been having a problem with it not wanting to start. I have had a bit of a squeal coming from the engine compartment and know it is the serpentine belt that needs to be changed out before it gets bad (I have only heard the squeal probably three times since December 2012.)
I would rather buy my parts and have the mechanic put them on instead of him buying them and charging me double.
My question is...do you think it is only my belt or should I think in the direction of the Starter or something else. After about threee or four tries it will finally start.
Chrysler - Towncountry :: 1999 - Hovers Around 2000 RPM When Let Off The Accelerator
I am having problems with the acceleration. when I let off the accelerator it hovers around 2000 rpm and then it takes awhile to come down. I checked the throttle cable and it seems free and the springs are on the throttle body.
View 2 RepliesChrysler - Towncountry :: 1999 - Van Seems To Move Forward With Brakes Applied At Red Light
While driving idle seemed to increase. Noticed at red lite where van seemed to want to move forward with brakes applied. Went to parking lot put van in park engine RPM rose to around 2500 RPM on it's own. Opened hood and fiddled around with a wire???/hose thing near the throttle control line (wire that connects foot piece to engine). A bunch of black powder (carbon?) fell out. Turned the van off then back on a couple of times. On the third time idle returned to normal and has operated normal since. What caused this? What do I tell my mechanic? What was the wire/tube thing (it entered what I assume is the air intake at a right angle) right in front of where the wire from the foot control hooks up.
View 1 RepliesChrysler - Towncountry :: 1999 - While Turning Left Makes Creaks / Groans Sounds
1999 Town&Country minivan with 165k
There is a creaking or groaning from the driver's side front when turning left at very low speed, like in a parking lot. When parked, turning the steering wheel in place intermittently causes the same thing but only when the wheel is turning to the left. No noise when coming back to center or going to the right.
Noise is definitely not a clunk or pop or squeal. No difference in handling at normal driving speeds.
Jacked up front driver's side tire and tried push/pull at 3, 6, 9, and 12 o'clock positions. Nothing strange, even with enough force to be concerned with jack support only. Pulled the tire and checked out tie rod end and tie rod. Pushing and pulling saw no movement. Grabbed swaybar link and push/pull, all solid. No leaks or worn boots on any of them. Checked PS fluid--fine.
Should I suspect lower control arm ball joint? Is noise consistent? Maybe it needs grease? Unfortunately, car is far from home, so the biggest question is whether it is safe to drive hundreds of miles before sorting it out.
Sebring - Chrysler :: 2008 - Won't Start Intermittently
I have a 2008 Sebring convertible that has starting issues. Sometimes when I turn the key to start, it does nothing (no noises, maybe a small click very rarely). If I take the key out and put it back in, it may start. Usually, I have to turn the power on, move the gears, and try again. Sometimes, it will start immediately, or I may have to do this procedure several times. It has been taken into the Chrysler dealer twice. They said it was not the switch or alternator and replaced the battery that wouldn't keep a charge. It was a 5-yr battery with 3 years of use. I was told to drive more! I shouldn't have to charge the battery every day. Several diagnostic tests were performed with no results. It still did this twice after the battery was replaced. Could it be cables?
View 3 RepliesChrysler - Towncountry :: 2007 - Shudders Between 40 - 42 MPH
My Town & Country 07 shudders (best word I can use to describe the sensation) between 40-42 MPH. First repair place convinced me I need tie rods, did not resolve problem. Next place said I need struts and new tires but the problem is not solved. Why the van would do this shudder, rumble, whatever - but only at 40? If I rapidly accelerate, like getting on the highway, it doesn't happen.
View 3 RepliesChrysler - Towncountry :: Car Stalled And Won't Immediately Restart
When I had 67 miles on my 2013 Chrysler T&C Van it stalled and would not immediately restart. The Electronic Vehicle Information Center revealed both the coolant and engine oil temp was in excess of 300 degrees. After 15 minutes the temps were between 280 and 285. The engine started and I drove slowly the3 miles to my house and had it towed to the dealership the next day. Mechanic found the quick connect coolant line to 3rd seat heater was improperly installed at factory allowing 1 gallon plus of coolant to escape.
A mechanical engineer and a Chrysler mech ( not one from the dealership) advises it is just a matter of time until I have internal engine damage. Chrysler Owner Assistance Dept assigned a case mgr. She reported the van was repaired and operating properly because the coolant line was repaired. Their first offer was 1 months loan payment, which I refused.
Chrysler - Towncountry :: 2001 - Calibrating The Speedometer?
I have a 2001 Chrysler Town and Country w/ 3.8L engine and 196,000 miles. Several years ago the transmission was rebuilt. Since then the speedometer was off 1-2 mph at 65 mph. I recently bought new tires and now the speedometer is off 2-3 mph at 65 mph. My question is: How do you calibrate the speedometer? I know all about the reset for a bouncing/stuck needle. That does not calibrate the scale. I've read about gear replacement and found the Hyper-Tech calibration programmer (which is not available for the 2001 T&C).
View 5 Replies