Jeep - Cherokee :: 2004 - Transmission Started To Make A Clicking Sound
I have a 2004 Jeep Grand Cherokee with about 105,000 miles. The transmission (or transfer case) recently started to make a clicking sound. It usually happens in 2 wheel drive mode and gets louder as the car warms up. the clicking sound occurs in all gears except park. It also gets faster with car speed. If the car is put into 4 wheel (full time) mode the sound seems to go away or is not as audible. When you shift back in 2 wheel drive mode the clicking sound comes back.
View 1 RepliesJeep - Steering - Cherokee - Fluids :: 1995 - Started Groaning When Make Full Turns
My '95 Grand Cherokee (104K miles) just started groaning when I make full turns. After first 1 or two turns, right or left, can hear the steering column groan and feel some resistance. Have I lost power steering fluid? or worse?
View 2 RepliesJeep - Cherokee :: 1999 - Hesitates After Start And AC Stops Blowing After Hour Driving
My jeep is having two issues. First, almost every time I start the vehicle it idles fine, but then when I start to accelerate it bogs down for 1 to 2 seconds. I will accelerate through it and after that it runs fine and doesn't do it again until the next time I start the vehicle. My second issue is that after driving for a couple of hours with the AC on, the flow of air out of the vents drops. The air is still cold to the touch just barely blowing. Once I cut the motor off for about 30 minutes it works fine again for a couple more hours. Also, when the intensity of the air coming out of the vents dies down the blower motor sounds like it is working harder to put out the little bit of air pressure.
View 3 RepliesJeep - Cherokee :: 2001 - Starting After Crank For 20 To 30 Seconds And Idling Rough
Pretty soon this thing's gonna have ALL new parts and STILL running rough! The Jeep has about 40K on a Jasper motor, 175K on everything else. I was experiencing starting issues (crank for 20-30 seconds), and noticed a P0171 code on my odometer (O2 sensor?) so off to my mechanic. He replaced two O2 sensors, no change. New code read MAP sensor, replaced, no change.
Finally, changed Fuel Pump in tank (Fuel filter was changed 2 months ago), still no change. I tried starting it tonight by turning the key 5-10 sec. to prime gas, started but still rough at idle. Runs strong above idle 1500-2000RPM. Mechanic can't check fuel pressure at rails? for some reason. My next thoughts were spark plugs and vacuum lines...
Cherokee :: 1996 Jeep Won't Start
I have had no problems out of my jeep except my check engine light came on and it was a bad 02 Sensor and I was told I didn't need to replace it. Well I was driving down the highway and all of a sudden my jeep died. The radio cut off my air and I put it in neutral and I tried to start it and it would not crank. I coasted in a drive way and it cranked and them died. Now it acts like it wants to start but it wont. Replaced the fuel filter. I am getting fuel to the fuel rail. It will not start with starter fluid. I took the crank sensor off and it replaced it and it still wouldn't crank. My fuel pump makes a whinning sound. My lights come on..My windshield wipers won't. My radio doesn't work and the inside lights well I couldn't get them to go off before I before my vehicle died on me, about 3 weeks before I just took the bulbs out. Would the 02 sensor make it not start?
View 14 RepliesCherokee :: 97 Jeep Running Fine Then Out Now Won't Start
I currently have a 1997 jeep grand cherokee that I seems to die on me. I will charge the battery to 100 percent and its actually a good battery. The vehicle will run fine and then out of nowhere it wont start. I throw the battery jump box on it and it starts. I was thinking that something has been obviously drawing power from the battery. What it could be?
View 1 RepliesJeep - Cherokee :: 1998 - Hard To Start / Need To Rev It Up
My 98 cherokee sport(xj) 190k has always been reliable but now its hard to start. I must press on the gas pedal and rev it up so it doesn't die. Never has done this, after a few revs it seems find. Is my fuel pump bad.?
View 2 RepliesJeep - Cherokee :: 2000 Would Not Start / Turn Over Then Die
This past week when I went to leave work my jeep would not start. It would turn over once, and then die....but if I kept my foot on the gas and kept the RPM's up it stayed running. So, I drove it home with one foot on the gas and one on the brake so it wouldn't stall out on the road. The next 2 days the same thing happened when I went to leave work. It starts fine the rest of the time, even first thing in the morning when it's cold..
View 1 RepliesCherokee :: 1991 Jeep Laredo 4.0L Inline 6 Won't Start?
Got done driving it one day, parked it, sat approx. 2-3 days, tried to start and it wouldn't start. When the engine was turning sounded like it was getting fire every couple secs but wouldn't fully start. Replaced the fuel filter, tps, distributor cap & rotor, still no luck. Took a look at what color the spark was and it was quite yellow, does it need to be blue?
View 12 RepliesCherokee :: 2001 Jeep Taking Several Attempts To Start
There was one message that I found like my problem, but a little different. When I turn the key it won't start, just sounds like it is going to start. I turn the key the second time it will usually start. sometimes it takes 3 times.
View 14 RepliesJeep - Cherokee :: 1997 - Click When Turn The Key But Won't Start Up
I recently had some wires fixed under the hood of my 1997 Jeep Grand Cherokee, because it wouldn't start. The mechanic told me that it looked like a squirrel had been making a nest under the hood and had chewed on some wires. I suspect that it may have happened over a long period of time, but I'm not positive of that.
Since then, a couple of times it has not started. I get in, turn the key, and all I hear is a click (not a repeated clicking).I've been able to get it to start by putting it in neutral, pushing it forward a foot or two, and then putting it back in park and turning the key again. When I do that, it starts right up. if you happen to know what part of the starter system is most likely at fault.
Jeep - Cherokee :: 1991 - Suddenly Stalls At Start Up
1991 Jeep Cherokee Laredo ran smooth until suddenly stalled; would restart for only a few seconds. Visually diagnosed and installed fuel pump; then ran for 2 minutes & rough before stalling. Now we have a new crankshaft sensor; now runs for 5 seconds. We rebuilt one part at a time? Diagnostic equipment not available.
View 10 RepliesJeep - Cherokee :: Missing Then Quit And Will Not Start But A Little Later Restart
I have a 1997 jeep gran cherokee 4.0 it takes spells that it will start missing and then quit and will not start but a little later it will start and the code is number 43. Also it will backfire and destroy the muffler. I have replaced the coil and the crank sensor and muffler of course two times. This is not something that happens with heat. It will do it when it is hot or when it is cold also replaced the engine control module or brain. It may do it often and it may run for months before it does it. Again always code 43 when it sets a code what is wrong ?
View 7 RepliesCherokee :: 1996 Jeep Won't Start Occasionally - Ignition Circuit?
I have a 1996 Jeep Cherokee (sport, six cylinder, 4WD) that won't start occasionally. 98% of the time, it starts up without problem. When it doesn't work the scenario is: put the key in, dash lights up, begin to turn the ignition switch, and suddenly the whole system looses power - no lights on he dash and of course, no cranking of the engine. If I try again immediately, I either get nothing or maybe power until I start to turn the key. If I wait ~5 minutes and try again, it fires right up. This has happened in various weather conditions.
Another problem that might be related is that about 40% of the time, it cranks but won't start in PARK. If I switch to NEUTRAL and try again, it fires right up.
Cherokee :: 1991 Jeep Won't Start If Distributor Bolt Tighten
My jeep wont start if I tighten the distributor bolt, it will start and run fine if i leave the distributor loose. Has been running that way for 2 years and i just was wondering what would cause that kind of problem... 1991 Jeep Cherokee Laredo inline 6 ....
View 3 RepliesJeep - Cherokee :: 1998 - Cranks But Doesn't Start Immediately?
I've got a 1998 Jeep Cherokee Sport 4x4, 4.0 L I6, automatic, 169k miles, that often cranks but doesn't start up. When I cut the power and try again, it starts up right away. I'm concerned this workaround will one day not work and I'll be left stranded, so I'd like to fix this if it's cheap and easy. The symptoms suggest either a lack of fuel or lack of spark due to an electrical problem, so I replaced the ASD (auto shutdown) and Fuel Pump relays, but they made no difference. The other two relays - Starter and Cooling Fan - seemed irrelevant. What this could be? Maybe the crank angle sensor? (I'm not even sure where that's located.)
View 4 RepliesJeep - Cherokee :: 1998 - No Response When Put The Keys In Ignition And Try To Start
My Jeep will not start. I can put the keys in the ignition and try to start it and nothing will happen. No sounds, clicking, nothing. The battery is fine, I replaced it with a new one, made sure it was charged and nothing happens when I try to crank it. The interior lights dont come on when I open the door but if i turn them on, they come on but they are very dim. Automatics locks dont work, horn doesnt work. I tried to jump start it with the new battery in with my other car. It tried to turn over but wont come on. It just sounds like the battery is dead when I try to turn it over. The vehicle in question is a 98 Jeep Grand Cherokee Laredo.
View 5 RepliesJeep - Cherokee :: 1999 - Backfire Every Now And Then
What would cause a 1999 jeep cherokee 4 liter inline 6 to backfire every now and then.
View 1 RepliesCherokee :: 94 Jeep - Howling Noise That Sounded Like A Bearing Going Out
Had a howling noise that sounded like a bearing going out. After searching, I see that the fan belt is actually sliding on the pulley. Looks like a vertical alignment problem. It could be the idler pulley, the fan pulley or possibly the lower Crank (?) pulley knocking it out. I can see the belt sliding approx 3/8 to 1/2 inch . At idle it sits closer to the engine, as rev it seems to line up. All this action certainly means the belt is shot. But could be idler too.
I went through a few things to check it out. I looked at the power steering unit, pulled off the belt and check if there was any obvious play in each of the pulleys. All seemed ok. The idler seemed rough running but no wobble of play in it. I will replace the idler anyway since I bought one. The belt has no damage to it. It was changed about a year ago. So it's just been wandering on the fan pulley. Went to the Crank pulley and the dampener .and it feels tight. There are some obvious small plastic cracks on the outside. friend suggest pulling on the pulley and look for separation between the inner, outer, and rubber ring in between. Felt and looked tight. After I change the idler anyways, I'll look again. But could the crank dampener still be bad?