Caravan/Voyager :: Steering Wheel Shakes And Pulsates When Put On Brakes
When i put on the brakes the steering wheel shakes and pulsates. Iam getting mixed info. One person I know said it is the brakes (front), another person said i need the alignment checked. yet another said Rotors, and still another said back brakes.... When i touch the brakes the whole van pulsates and the steering wheel shakes.
View 3 RepliesCaravan/Voyager :: 1996 - Front End Shakes Like The Wheels Are Coming Off
My daughter has a 1996 Grand Voyager that she would like to sell. However, right now when you drive it the front end shakes horribly like the wheels are coming off. I mean the whole dash is shaking. Scary! In addition, I swear I've seen the front wheels appear to wobble when she's driving it. Ive changed the wheel bearing on the passenger side and was astonished to find that it made no difference. I was wondering about the half shafts and CV joints and such. How can I tell if these are bad? I've grabbed them and tried to move them and they don't move.
View 2 RepliesFord F-150 (2004-2008) :: Violent Shudder On Braking At Highway Speeds / Warped Rotors?
So my 07 with 125k miles has had new rotors for about 50k miles or so, but for a while now when the brakes get hot it gets a violent shudder on braking at highway speeds....the odd part to me is nothing at lower speeds, and not always at higher speeds....do I just have warped rotors again? The rest of the front end I good and tight....
View 9 RepliesCaravan/Voyager :: Motor Cut Off While Driving Down Highway Or When Stopped
96 plymouth voyger se 3.3 6cly motor cut off while driving down highway or when stopped no check engine light...
View 1 RepliesCaravan/Voyager :: 1999 GC - Engine Cutting Out While Braking Or Get To Low Speed
I have a 99' GC and just changed out the EGR valve. Now the engine cuts out when you brake or get to a low speed. Idles a little rough also.
View 7 RepliesCaravan/Voyager :: 2000 Van Jerks Hard And Speed Drops At Highway
My van just started to have this issue today with jerking real hard like its dropping a couple of gears while going between 50-60mph. It is a 2000 with the flex fuel 3.3L 4 speed auto.When this happens the spedo will go from 55mph to 40 instantly while keeping a steady speed and it feels like the tranny is going to rip right out. This will happen every 5 to 10 min but go back to normal driving after 3 sec and has not popped any codes. It runs like a top and all fluids are at the correct levels. I have to commute 50 miles a day to work so i really need to figure this out!!!
View 1 RepliesCaravan/Voyager :: 2009 - Front End Grinding Noise Only When Braking To A Complete Stop
Back in June I replaced all 4 brakes and rotors. Now all of sudden I hear a loud grinding noise in the front end only when I'm braking to a complete stop.
I took all 4 tires off and then took off the pads. The pads and rotors are all still brand new and have very minor normal wear. Also the calipers still look good.
I then put everything back together and went for a test drive. The grinding noise is still there. It's very loud and only when I come to a complete stop.
Sonata NF (2006-10) :: Wheel Shakes When Braking At Speeds Of 80 Plus
My 06 sonata's steering wheel recently started shaking when I am braking from speeds of 80+ also a little when going down really steep hills. This happened once before when I got new front tires because the tire shop didn't balance the tires correctly. I know it could also mean warped rotors but in my experience rotors only become warped when you drive them with really low pads. Btw the car has 46k miles on it, and it is a 3.3 liter v6 gls.
View 9 RepliesNissan - Pathfinder :: 1996 - Shakes At Highway Speeds Around 60 MPH
Our Pathfinder shakes side to side around 60mph and quits after 65 or 70 (We live in New Mexico and commute through Texas where speeds are much higher than back East). We have changed shocks, struts & mounts, tires, and alignments. Most of these have been changed multiple times over the years, especially tires.
We have been driving this way since May of 2005 (129,916 miles). We have TRIED to get it fixed. We have had it in shops all across the country (we travel a bit). We talk it up to people we meet who know cars. We have taken it to Nissan, with no results. NO ONE has solved the problem and we are out lots of money.
We are now at 205,000 miles. I would really like to get this fixed! We cannot afford to just buy a new car. Mechanics across the country have not solved this issue!
Accent LC (2000-05) :: Steering Wheel Shakes Quite A Bit At Highway Speeds 70 MPH
My accent just crossed 180K mark. From last year the steering wheel shakes quite a bit at highway speeds ,say 70MPH. It's especially bad when I accelerates . Took the car to a shop, they told me two things, the CV axle of passenger side needs replacement, and the wheel hub bearings are bad(both front wheels). They quoted me $200 for replacing the cv axle, and $400 for replacing both front wheel bearings. Since I don't even think the car worth $600 right now(given high mileage), I told them I'll just do the axle(I know how to do it myself but don't have the time, plus it won't be that much cheaper DIY anyway). They said fine, but if you don't replace the bearings you may have the wheel fly off one day and that's dangerous.
They replaced the axle, and the car drives a lot better now. There's still a little bit of shaking at high speed but 75% of that shake has gone away. My question is, does the worn out bearing causes car to tremble at high speed? I heard other people told me there should be a grinding or loud hawling sound if the bearings are bad, but I don't hear that. I searched the internet and some people say, to determine if the hub bearings are bad, just drive it for 10 minutes then feel the hub. If it's barely warm, the bearings are good. If it's warm to hot, then the bearings are bad. I felt it and it's warm, but not too hot to touch. I tried the rear wheels and those are barely warm indeed.
So from this method it seems the front wheel hub bearings are indeed bad. I wonder how long I can keep driving this without endanger myself. $400 is not cheap for this car and I don't have a machine to press in the bearings myself. I can disassemble the rotor and hub that's not a big deal, but I don't know how to get the old bearing out and the new bearing in. Is there a machine shop that just do the pressing? Or, is there any shop selling the hub assembly with bearing already in place? this way I just remove the old hub assembly and replace it with the new assembly, a lot easier. I searched the internet but can only find pre-assembled hub w/ bearing for the rear wheel of this car. I need the front ones.
Passat (B7) :: Steering Wheel Shakes Just Slightly At Highway Speeds
Noticed the steering wheel shakes just slightly at highway speeds. Happens to me when I'm at around 65-70mph and above. It's just very slight, so I really wasn't thinking its an alignment issue at all. I didn't know if this was a bit normal for these B7s or what. I've had alignment issues in cars before and this just doesn't feel that bad, but its enough to give me pause.
View 7 RepliesToyota - Camry :: 2009 Shakes And Vibrates When Braking At High Speeds
I just bought a 2009 Toyota Camry with 78K miles on it. Everything is great except at highway speeds it shakes and vibrates when braking. The higher the speed the worse it is. Steering wheel shakes as well. I pulled both front tires off and the rotors appear to be smoothe on both sides with no grooves, etc. However, I'm due for new front brake pads. There's some pad left but could that be why it shakes and vibrates when braking? How do you tell if rotors are warped? Rotors are smooth but could they still be warped?
View 16 RepliesCaravan/Voyager :: Change Transmission Filter On 2008 GC SXT
Since there is not dipstick for a 2008 GC with six speed transmission, how much transmission fluid goes back?
View 2 RepliesCaravan/Voyager :: 2008 - Front End Clunking While Driving
I had to replace my swaybar links on my T&C due to it not passing state safety inspection. There was also some random noise that occasionally occurred on bumps. The tech said the "book" said to replace the strut and strut mounts but he could not see anything wrong. After replacing the swaybar links, there is now clunking while driving. I thought it was a lack of grease in the links but I greased them and while it got a little better...it still happens.
View 5 RepliesCamry :: 2009 4cyl - Steering Wheel Shakes After Braking At High Speed Going On Highway
I've been noticing my steering wheel shakes if i normally brake going on the highway at high speed. My friend said that it's probably your brakes and rotors. Get them replaced and resurface and that should fix the problem. Can i get some confirmation before i do this?
1. I just had my tires replace at 55k and bought this car new back in feb 09. it has 62k.
2. also i've been reading up on camries fail water pump. i'm thinking of doing this over the weekend or should i just wait until i notice some leaks?
3. lastly, any major thing i need to be aware of. i've done the normal engine oil and filter change, cabin and engine air filter change, that's about it. i hope these camries are bullet proof like the old school (92-95).
Ford 6.0L Power Stroke Diesel :: 2003 F350 Shakes At Highway Speeds
Have a 03 f350 with the 6.0 have been experiencing very harsh shaking problems. This only happens at highway speeds 55-60 any other speed is smooth as can be weather it's 25-95 mph. The weird part is that it only shakes when the truck shifts into overdrive and it shakes bad and if you lay into it like you were gonna pass someone it stops then shifts back into overdrive and shakes again.
View 6 RepliesCaravan/Voyager :: 2008 Dodge SXT - Rear Blower Won't Run With Controls
I have a 2008 Dodge Grand Caravan SXT with 58000 miles. The rear blower won't run with either the front controls or rear controls. I have checked the fuses and they looked ok.
View 14 RepliesCaravan/Voyager :: 2008 Brake Warning Light On Dash Is On
I'm working on a 2008 Grand Caravan SE 3.3L Brake warning light (!) on dash is on. Datastream on my OTC Genisys shows that the Brake fluid level switch is 'ON'.
The van does not have pad wear indicators; fluid is full; there are no leaks in the system; no brake pull, uneven braking or other performance issues.
Scantool says Park Brake is off and I disconnected it to be sure.
When checking connector at switch on the master, one wire has continuity to ground and the other has about 12.5V on the DMM but won't light my test light.
Caravan/Voyager :: 2008 GC - Pedal Goes To Floor After Changing Brakes And Rotors
I have a 2008 GC with the E-Brake calipers in the back. I changed the brakes and rotors all around and now the petal goes to the floor. I know it has something to do with the rear brakes, because I did the fronts first and after a few pumps I had good petal.
I've done these types of rear brakes before, you use a tool to turn the caliper in. Is there anything I missed? Did I turn it in too much? I don't think it is the master cylinder because it was fine before I started and fine after I did the fronts.
Also, the e-brake doesn't hold at all now, so that's another reason I think the problem is in the rear calipers. Maybe an Adjustment? There's nothing leaking, either.