Camry 2012+ :: Removing Scratch From Black Plastic?
Any effective way to remove scratches from BLACK plastic? (Specifically, my inner door panel which is a matte textured black plastic).
View 13 RepliesLexus RC 2015+ :: Removing Back Black Plastic (aerodynamics) Comb Part?
I think the black comb looking things on the bumper look cheap.
View 14 RepliesPrius (Gen 3) :: One Side Of Bottom Black Plastic Cover Was Drooping
I just joined up after purchasing a CPO 2010 Prius IV. Love the car but after taking a closer look I noticed that one side of the bottom black plastic cover was drooping on one side. Upon closer inspection I noticed that there was a screw and plastic Grommet combination that was not locked into place. After unscrewing the screw, I tried to put the grommet back in place but noticed that it couldn't fit because (I believe) the white bumper portion where the grommet goes broke off. I compared it to the other side of the car and yes it does seem like part of the plastic top portion that is connected to the bumper broke off.
I inspected the bottom some more and it seems like there are a good number of screws missing and a large plastic piece that is the front tire well is also very loose.
Ford Ranger / B-Series :: 1994 2.3L - Coolant Leak Coming From Under Black Plastic Cover
I noticed green coolant leaking from bottom of black, what I think is called, timing belt cover. There is 188, 000 miles, and when I changed the timing belt, I did not change the water pump, although I did change out the thermostat. I have done a lot of work on this truck in the past. I checked the oil and no signs of water or coolant mixed in. The water pump is not weeping from the top well. I rely on this truck and the way I look at it is I may just keep driving it until it goes kaput (its real beat up). Should I go to an auto parts store and see if I can buy some sealant. I would guess it is either the water pump or maybe the timing cover gasket? I have inspected all hoses, and I see nothing. The leak must be coming from somewhere under that black, plastic cover. I am capable and willing to do just about anything other than perhaps a full engine pull, although I have the wherewithal to do that too if absolutely necessary.
View 9 RepliesCamry :: 2011 - Plastic Engine Cover Removal
How do I remove the plastic engine cover from a 2011 Camry ?
View 2 RepliesCamry :: 2007 V6 - Plastic Engine Cover Removal?
I have a 2007 Camry XLE V6 that needs new spark plugs and the first thing to remove is the plastic engine cover. I do not see any screws or bolts attaching it down and I would like to know the proper way to remove it without damaging it or the plugs holding it down. How to do this?
View 3 RepliesCamry :: Removing Passenger Side Air Vent Cover?
using a can of compressed air to clean the dust in the vents and the straw came loose and now its stuck inside the vent and whenever I make a turn I can hear the straw rolling around.
How do I actually remove the passenger side air vent cover? (nearest to the door) I tried to pry on it with a screwdriver but it doesn't seem like it wants to move. I actually asked the local dealer and they said I would have to remove the whole dash to access inside the vent. Do I really need to remove the whole dash or should I try to apply more pressure?
Camry :: 2009 XLE - Removing Back Deck Cover To Replace Speakers
I have a 2009 Camry XLE with the split reclining rear seats and the retractable (stupid) sunshade. I bought new 6x9's to replace speakers all around (Infinity 9632) with adapter plates. Got the door speakers replaced easily enough, but for the life of me I cannot figure out the rear deck. It is all one piece of plastic, no removable speaker grills. And of course the speakers are screwed in top down. Most of the posts I have found on the internet are either for previous gen Camry's or people who have the folding down rear seat.
So after a lot of manual labor I was able to remove the back seat completely and the center console. I can pop the front of the back plate up and peek in, but cannot get it to come out. I think something is odd with the models with the retractable sunscreen and reclining seats.
I have scoured the internet endlessly. Closest post I found was "take off the rear side panels (by the back window) and the deck should pop out. There are airbags in there, not very keen on forcing anything.
The car has the "premium" JBL sound system which I found to not be so "premium" and was a serious step down from my last car's factory stereo.
Acura - Integra :: Removing Carbon Build Up On Pistons?
My 87 Acura Integra with 170k gave SMOG reading in CA as below:
NOSpeed Max Meas15 760 87525 542 535
A m/c tells me it is the result of carbon build up on pistons.
Incidentally it gave the following in 2010 - upon retesting without any repair it passed:
NOSpeed Max Meas15 760 65625 542 678
Note: Recent oil change (Mobil 1 High Mileage), tune up, Thermostat, new PCV valve, NGK Plat spark
It is for "NO" - Nitrous Oxide
IS F (2008-2014) :: Black Plastic Shifter Surround?
I haven't been able to find the plastic piece without buying the whole carbon fiber center console.
View 11 RepliesPrius (2004-09) :: Black Plastic Cap For Rear Wiper
My wife had a disagreement with the garage door this morning while trying to back my Prius out that ended with the little plastic cap that covers the joint of the rear washer being broken (It wasn't more serious!). I know it's a minor thing, but I take pristine care of my Prius and I'm a self-admitted OCD.
View 2 RepliesCorolla / Matrix 2009-13 :: Black Specs Of Metal / Plastic In Oil Cap?
Found a small black piece of either plastic or metal about half the size of a fingernail in the oil when checking it last night. When I took the oil cap off it was on the spindle part. About a month ago I saw another same size piece just in the top area just when you take the cap off and look in the oil case.
Its my 2nd round of using 5w20 valvoline full synthetic oil. Im hoping this is just extra sludge/debris being cleaned out? After reading around It sounds like it could be a much more serious problem with bearing, or pistons/rings.
This car has a serious problem with oil consumption, I always try to stay on top of oil levels and am actually taking it in to the dealership to have it Flashed with the latest TSB for it. Just got a new battery, fuel injectors cleaned every 1-2k, throttlebody just cleaned 2k miles ago.
I literally just did an oil change and did a small trip of 300 miles, next morning had a dry start... had to add about 1/4 qt and this morning and then was fine.
Car has 98.5k miles 2009 corolla S
Rodeo :: Black Plastic Piece That Attaches The Handle Has Snapped
I have a 95.5 Isuzu Rodeo, V6, 165k and am having a hell of a time finding parts. Apparently every issue I am having, so is everyone else by the looks of the salvage yards.
Interior door handles. All my doors went to shit within a month of each other. The black plastic piece that attaches the handle has snapped. In all of them.
Also, the tailgate will not disengage. I can press the button in front and you can hear it click, but not catch. The key will not open it either.
The back window motors are out or in the process of going out.
Prius (Gen 3) :: Black Plastic Underneath Front Area Broke
I live in Michigan and we recently had a 8 inch snowfall. While parking my 2010 Prius it bottomed on the snow pile which took two pieces of black plastic off of the underneath front area of my car. I assume the plastic is for aerodynamics.
View 9 RepliesGolf/GTI VI :: Polishing Black Plastic Trim Pieces On The Doors?
I noticed that I have some light scratches on the black plastic trim on outside of the doors (more than likely done by the place that tinted my windows, ). How to buff these out. They are more like micro-scratches and swirl marks more than anything else. I tried car paint polish in a small corner and it had no effect.
View 6 RepliesPrius (Gen 3) :: Removing Lid Cover For Top Cup Holder?
I finally picked up a cell phone cup holder so I could dock the Android and tether the millions of cables (two) for power and audio when I ran into a roadblock. The holder has an expanding base so it can fit into any size cup holder. Perfect! Except that if I try to use it in the "top" cup holder that has the closing lid, it never quite expands to fit because the lid offsets the interior dimensions. The holder fits fine in the lower cup holder, but because of it's size and angle for the phone, it presses it too close to the armrest so it's essentially a no-go.
How to safely and easily remove the lid cover for the top cup holder?
Passat (B7) :: Removing 2.5 Engine Cover?
How to remove the plastic engine cover on the 2.5 liter engine? I am trying to do the "Big 3" but don't want to break the cover.
View 4 RepliesGolf/GTI VI :: Oil Dripping On Plastic Cover When Looking From Engine Bay
This morning after pulling out of the garage, i notice a small wet spot on the floor, went to see what it was and it was oil, its was a wierd shade of red/orange and very clear, def not engine oil. Then looked under a car and saw it where it came from, front driver side, there is a some kind of plastic cover, it was collecting there then dripping out. I can see the oil dripping on the plastic cover when looking from the engine bay? What can it be?
View 4 RepliesPrius (2004-09) :: How To Remove Plastic Rim Cover
I got a piece of cable tie stuck in there.
View 6 Replies