Camry :: XLS Have Pulsation When Brake Pedal Applied
My Camry XLS have pulsation when brake pedal is applied. The pulsation get increased with the speed and very noticeable at 60 -70 mph.
Is it front or rear break issue ? If you think rotors has to be re-surfacesd should I also change pads ?
Cadillac :: 1950 - Front Right Makes A Grinding Noise While Brakes Applied?
1950 cadillac - standard drums on all 4 corners.
I put new wheel cylinders on each drum, and replaced the drivers front hose, as it was clogged. The passenger side I left because it works and doesnt leak. I've cleaned all the brake surfaces, shoes and drums, and bled everything.
When I brake, and only when I brake, the front right makes a grinding noise and the car pulls to the right.
I tried tightening the star wheel today to bring the shoes inward in hopes that would equalize brake pressure up front, but when trying again today, I got that grinding sound still.
There is no scoring or gouges on the shoes, drum, and the inner and outer ball bearings seem fine - round chrome balls with no discoloration, no gouges on the spindles. Granted I don't drive this far at all, especially now that I have this grinding.
How can I really tell if its the ball bearings? It only makes the grind when I am on the brakes.
Prius (2004-09) :: Brakes Makes Pssst Sound When Applied
I have a question: when physical brakes applied (at the end of the slight braking, or when speed is small, or when gasoline engine starts on parking car, or when i apply brakes on parking) i hear light "pssst" sound. It is like sound from back door stay assembly, when i open back door, or like suspension shock adsorber works. My local service bleed the brake fluid, but it doesn't work. When we bleeding rear brakes (left and right) and opens bleeding plug, that noise sounds continuously until we close bleeding plug. And there is no air in old brake fluid... Technician says, that sound is normal, but i also have Toyoyta Prius 20 and there is no noise while pressing brake pedal... I just want to ask: is that sound normal for Prius 30 or not?
View 6 RepliesPassat (B6) :: 2008 - Grinding Sound When Brakes Applied
2008 Passat Komfort Wagon with 34,500 miles. Started to get grinding sound when I applied brakes, which diminishes as I drive. Thought it was rust, but sound is very loud and sounds just like pads are gone and digging into rotors. The brake warning light is not on.
Dealer told me rear caliper was closing unevenly and recommended service---not covered by warranty of course. When I picked-up car same noise as before. The service manager told be that the car was just washed and the rust built up in the last hour---I could believe some built-up, but the sounds made my teeth ache. When we went for a test drive the noise got quiter, but was still apparent. The SM told me this is a "normal" noise. I have had many cars with disc brakes, dating back to a 1960 Jaguar; none have made this "normal" sound.
Accent MC (2006-11) :: Rear Brake Making Grinding Noise When Applied
My right rear brake is making a grinding noise when the brakes are applied. I took the drum off a couple weeks ago and the shoes are just a bit worn. Just getting into the numbers printed on the side of the shoe material.
I could not see any thing that would be making the metal on metal sound. Are there any wear indicators on the OEM shoes?
Elantra HD (2006-10) :: Pedal Jumps Up And Down When Brake Applied
I just put new disc and pads on my girlfriend 2007 elentra and all four little screws broke off the hold the disc so you can work on it but they aren't important apparently.
Heres the problem now the pedal jumps like i have super warped discs on the car doesn't shake or vibrate while driving but then i brake the pedal jumps up and down.
I figured it might have a stuck caliper pin, which I did so I cleaned and lubed them and I have the same problem?
Celica :: 1987 Toyota Brake Pedal Is Going To The Floor When Applied
My 1987 toyota celica brake pedal is going to the floor when I apply the brakes but not all the time,i checked the pads and shoes they are still good i also bled the brakes, I am thinking it is the master cylinder or maybe the master cylinder needs to be bled.
View 1 RepliesDodge - Durango :: 2004 - Brake Pedal Vibrates When Applied
I'm the only owner. Since new the rear brakes have never generated even a fraction of the dust of the front brakes. I have replaced the front and rear pads but never had the rotors turned. The rotors aren't perfectly smooth but they don't have any deep ruts.
Anyway, my brake pedal vibrates when I apply the brakes. And the rear brakes squeak randomly when braking even though there are new pads. I always felt they squeaked because there is not much braking power in the rear.
My Durango stops okay. I'm worried about catastrophic failure because of the vibrating.
Sonata NF (2006-10) :: Noise Like Grinding Sound When Brakes Applied To Stop
I noticed yesterday a sound, like a grinding sound, *sometimes* as I apply the brakes to stop. I'm at 68k. The noise only happens when the brakes are applied so I suspect there is an issue with my brakes again.
Some BACKGROUND info: At around 60k (or 8 months ago roughly), the front pads were replaced after the brakes were squealing and a pulsating brake pedal when stopping. The pads were replaced by a dealer. In addition, both front/rear rotors were turned at the same time. Rear pads had 40% at the time and were not replaced.
Some weeks later the pulsation came back and I went back again and they machined them again. For this current issue I was thinking about taking the car to someplace local (not a dealer) and getting a free brake evaluation of what is going on.
I'm also concerned that all this machining the dealer did to eliminate the pulsation may have decreased the life of the rotors and perhaps they need replacement now.
Sonata NF (2006-10) :: Brake Pedal Sinking If Pressure Applied After A Stop
I have only 42k km or 26 k miles. Brake stops but soft. The brake pedal sink if you apply pressure after a stop. Feels like someone open a valve. The pedal go to very low. I am find the stopping power is poor. Brake fluid is brownish. I hope it is not the master cylinder.
View 20 RepliesSaturn - Ion :: 2003 - Makes Grinding Sound?
This car makes this grinding sound whenever you first start the car in the morning on a cold day and take a left turn. After 5 minutes it won't do it anymore. I can't tell if it's coming from the transmission but that's what one mechanic said. He said it was the transmission but he couldn't target where. His first diagnoses was the struts but that proved incorrect so I'm taking what he says with a grain of salt.
VIDEO WITH SOUND : [URL]......
This car has the notorious GM lawsuit CVT transmission..
Dodge - Caravan :: 2012 - Left Rear Brake Began Making Grinding Noise Only When Applied
I have a 2012 dodge caravan bought new. After about 6000 miles the left rear brake began making a grinding noise, only when applied, every time the car sat more than a few hours, that goes away after about 2-3 miles. It began in winter and continues into the warm and dry days of spring now with 9000 miles total. Had it to dealer twice and inspection found no malfunction so they say its from rust build up because it goes away all the time and is nothing to worry about. It does not occur with the other wheels. My niece has the same van, in same geographic area and does not have this problem. Does this selective rust build up explanation make sense? Previously burned with bad brakes on a caravan, so am skeptical.
View 7 RepliesCamry :: 1995 - Makes Grinding Noise While Accelerating
My car just started making a grinding noise when accelerating. It does not make it while maintaining a constant speed or revving the engine in neutral. I never had this problem before and I am at a loss to explain it. Car is 1995 Camry for what that is worth.
View 4 RepliesToyota - Camry :: Grinding Sound When Turning Light
I recently accidentally drove my Camry into curb in a parking lot. It was only a light, but since then I've noticed a grinding sound ONLY when turning right. Everything else seems fine. I looked under the car and saw the black plastic casing under the car is cracked and it looks like it might be grinding against the left tire, which could cause that noise. I've also heard it could be a bearing, but would that suddenly happen immediately after an encounter with a curb?
I do plan on taking it to the shop, but I have to wait at least a week until I get paid. I'm guessing that should be okay.
Lexus RX 2010-15 :: Brake Pedal Makes A Loud Noise
Our 2013 RX350 has a brake pedal that makes a pretty loud noise when it snaps back after you depress it a little harder and take your foot off. I complained to my SA, and they told me it's normal. It's not a big deal, but any other car I have owned, I have never noticed such a thing.
View 12 RepliesFord Brakes/Suspension :: 2001 F350 - Brake Pedal Go To Floor As Pressure Is Applied - Bad Master Cylinder?
2001 F-350 / 7.3L / 147K ... What are some symptoms of the master cylinder going out? And is there a such thing as a rebuild kit anymore? The pedal has been getting spongier & spongier over the past months. Truck still stops O.K. but you have to brake earlier than I used to. Pedal can go almost to the floor. Pedal continues to go to floor as pressure is applied. Does not go to floor though.
View 4 RepliesTiguan :: Gas Pedal Makes A Creaking Sound When Accelerate / Decelerate?
How hard is it to replace the gas pedal on a 2012 Tiguan SE? My factory gas pedal makes a creaking sound when I accelerate/decelerate. Took it to VW and they are not going to do anything about it.
View 15 RepliesFord Wiring/Electrical :: Driver Side Brake Light Goes Out When Brake Pressure Is Applied
I have a 1962 ford falcon ranchero. The driver side brake light, goes out when brake pressure is applied, but is on when lights are fully on, but even then brake pressure is applied and goes out. Right brake light is fine. And turn signal on right works. But driver side back light goes out when brake pressure is put on and when turn signal is put for left side. Right makes a turn noise left side doesn't. I recently replaced the turn signal switch. So its brand new. But older wires every where else. No cuts anywhere on wires. Fine. And replaced the bulb also.
View 8 RepliesGolf IV / Jetta IV :: Chirping Sound When Brake Applied?
Super annoying problem I can't solve.
Front brakes have a constant chirping sound that goes away when brakes are applied.
New front brakes were installed in November, OEM rotors and pads.
They were quiet as a mouse, until i installed a new set of struts and springs along with 10mm front spacers.
(Yes I am using extended lug bolts).
I took the fronts apart this weekend and lubed the hell out of them, still squeaking.
My next thought is to use some of that CRC disc brake quiet red goo stuff, but I'd rather not use that if i don't have to.