Camry :: 2007 V6 - Wire Unseated From Connector During Ignition Coil Removal
Any easy solution to reseating this wire in the connector? It got yanked out by accident when i was removing an ignition coil under the wiring harness. 2007 camry v6
View 3 RepliesCamry :: Broken Wire Harness Spark Plugs
Two of my plugs locking clips broke today on the wire harness side where the coil over plugs into the harness today while changing spark plugs. They will plug back up, but they won't lock together like they are suppose to. How critical is this? It is my wife's car will she break down? I drove the car maybe twelve miles, and everything seemed fine.
View 8 RepliesCamry :: 2004 - Spark Coil Connector Holding Crack Off?
Scheduled maintenance for changing spark plugs for my Camry 2004 2.4L is either 120k miles, or 144 months (12 years). My Camry reached 12 years first. In removing the coil connectors, 3 of 4 holdowns cracked off. I guess not so surprising after 12 years subject to engine heat. I'm NOT going to replace the connectors. Looking for a patch for this problem? Duct tape will just result in adhesive getting everywhere it shouldn't. Maybe there's a high temperature "crazy glue" I could apply at the connector interface that will last another 12 years, or 120k miles?
Otherwise, I'll use the "hope adhesive". That means I'll just hope the connectors don't work loose at a bad time.
Santa FE SM (2001-06) :: 2004 - Ignition Coil Sparks / Rough Jumping Idle
I have a 2004 SF/2.4 I4. When the car warms up, the ignition coil sparks between the rubber boot and the coil itself, drawing the spark from the plug and resulting in a misfire. This is especially apparent when the A/C is running and the car is idle-ing, resulting in the A/C turning off and a rough jumping idle. Once the car is running this is not noticeable and the A/C turns on.
I have changed the spark plugs to new autolite plugs, and the situation disappeared for a day, but now it is back. I ordered OEM NGK Laser Iridium plugs, I hope they will fix the situation. Why would the A/C matter? Next on the list will be the ignition coil and wire change, but I hope to avoid that.
Mazda :: 1989 - Voltage Buildup On Outside Of Wire Between Distributor And Ignition Coil?
My 89 Mazda B2600i conked out on me suddenly about 10 days ago. My local mechanic replaced the distributor, cap, and rotor and the ignition coil and now it's running again. But starting it up at the mechanic's, I noticed a new faint sound like a clock ticking rapidly. From under the hood it sounds more like an exposed spark plug firing, but fainter.
After driving around to make sure I wasn't imagining it, I had the mechanic take a quick listen and look. He couldn't say for sure what it was, but said it was probably nothing to worry about.Taking a look under the hood at night, I saw lights running along the spark plug wires (continuous) and flashes of light where the spark plugs insert (frequent).
If one terminal of a volt meter is placed on the outside of the wire running from the ignition coil to the distributor and the other held in the air, the voltage rapidly builds up to 4 volts (a few seconds) and then immediately drops back to zero. This happens in roughly the same time frame as the flashes of light where the spark plugs insert, but I can't tell if it's the exact same frequency. What's going on?
Ford F-150 (2004-2008) :: Broken Coil-on-plug Wire Clip?
2007 F-150 Screw 5.4... Successful spark plug change. Well, sort of. I disconnected some of the coil clips/wires from the coils during the operation. Upon installation of the wires/clips, one of the clips did not 'click' into place.
Thinking the clip needed to be pushed/pulled, I bent the clip a bit and it snapped off! Being the slow learner that I am, a second clip also did not 'click' in place, and you know where this is going: I have two broken clips out of 8. After those two, I was much more gentle.
So, can these clips be replaced and/or spliced in? I'm thinking about just using nylon ties to hold them in place. So far, they are staying put just by being pushed in place, but these two do not seem very secure.
In the future, what is the correct way to make sure these things 'snap' back into place if they seem to not want to cooperate?
Here's a picture of the two 'press clips' that broke off....
Ford Wiring/Electrical :: 1976 F100 - Engine Continues To Run And Only Way To Stop It Is To Jerk Coil Wire Off
I have a 1976 Ford F100 with a 302 and my problem is sometimes when my engine is running and I try to cut it off, it continues to run and the only way to stop it is to jerk the coil wire off. This is an intermittent problem. Happens about every 6 or 7 times I drive it. I have replaced the ignition switch and still have the same problem. Pretty sure it is some type wiring or ground issue, just need someplace to start.
View 1 RepliesPassat (B5) :: 2002 1.8T Won't Start With Key But Will Start When Jumping Trigger Wire
So I picked up a 2002 passat 1.8T autotragic from a guy because a shop said it had a bad computer. After bringing it home and talking to some local volkswagen mechanics they said it couldn't be the computer because the car would still crank. I jumped the trigger wires and the car starts right up no problems and runs perfect for sitting for a year. My question is what could be the problem? I changed the ignition switch and replaced the 40amp fuse by the computer. I am trying to flip the car so I am hoping its not a big problem and have to part the car out.
View 3 RepliesF Series :: 87 F150 5.0 - No Spark From Coil
Here we go again. shut my 87 F150 5.0 off when I got to work when it was time to leave no spark from the coil, same as 3 weeks ago. First thing I did was pull the new dist and replace it nothing, so I pulled out the new coil still nothing, its getting power to the coil so I would assume the relay is good .
View 4 RepliesVolvo :: No Spark Coming From The Ignition Coil
I have a 1991 Volvo 940 SE with turbo and 162,000 miles
The problem is there is no spark coming from the ignition coil. There is power going to the ignition coil but no spark. The car turns over but doesn't start.
I have replaced the crankshaft sensor and the Ignition Module. The wire that goes from the ignition module to the Ignition Coil has been replaced with a new wire that goes directly from the module to the coil .
Also the coil has been checked and its operating within parameters.
Celica :: 1990 - No Fire / Spark Out Of Coil
My Celica is running great, I drove about 30 miles and the car started hesitating to run, I was in heavy traffic, I could hear rattling sounds which appeared as though they were coming from the heater. I stopped at a stop light and I could tell something was burning out. I have lots of power, car is very fast. I went to the next stop light and the car died, it started and I went to the next stop light with plenty of speed and the car died and would not start again. I tried starting the car for 3 hours, no fire from the coil.
I have no spark out of the coil. I am confident the coil is good. I have 2 coils. I went to the salvage lot and purchased an "igniter" (ignition module). I installed it on my Celica, still no fire out of the coil. I have a relay under the glove box that clicks when I crank over the engine. The engine cranks over very well for over 3 hours. I have an after market alarm. Why do I not have spark out of my coil?
Nissan - NX :: 1991 - Does Not Start / No Spark From Coil
'91 Nissan NX 1600.It does not start., No spark from the coil which I've tried replacing, and the wiring tests fine everywhere before that. It's been sitting like this for going on two years, I think.
Background : Right before this started happening I replaced the clutch disk and flywheel, as well as complete timing, sprockets, guides, even the cover. About a week after that the fuel pump stopped, after I replaced that I hear it prime, but now I have the no spark problem.
Nissan - NX :: 1991 - Won't Start As No Spark Form Coil?
'91 Nissan NX 1600.It does not start., No spark from the coil which I've tried replacing, and the wiring tests fine everywhere before that. It's been sitting like this for going on two years, I think. Background:Right before this started happening I replaced the clutch disk and flywheel, as well as complete timing, sprockets, guides, even the cover. About a week after that the fuel pump stopped, after I replaced that I hear it prime, but now I have the no spark problem.
View 11 RepliesHonda - Accord :: 1997 - Loose Spark Plug Wire
I took a long trip this last weekend and before the return trip I checked the oil and realized I need some. I put two quarts which brought the level just about even with the top mark on the dipstick. the return trip was fine. Next morning I started the car and right away notice that the engine was misfiring. I checked the spark plugs and noticed that one of them was loose and had some oil in it. I checked the oil and now it showed the level to be well above the top mark on the dipstick. Could too much oil cause the spark plug to get dirty, get loose and misfire? This car is a 1997 and has 206,000 miles. This is the first time this has happened. Could the same thing happend with a 1999 Honda Civic?
View 10 RepliesGolf V R32 :: Coil Pack Rust When Changing Spark Plugs
I've been doing the 40k service to my R32, and was in the process of changing the spark plugs.
The first three went smooth with no problems, the next three however.... When I pulled the coil packs off, they were covered in rust and corrosion.
The inside of the block leading down to the spark plug (where the coil pack was) also had rust in it. I haven't pulled those three spark plugs out yet. What caused the rusting?
I assume I need to replace these three coil packs, and clean off the existing spark plugs before removing them. Is that a fair assessment?
I haven't had any trouble with misfiring or stalling. The car has been running great.
Passat (B5) :: 2004 - Spark Plug Coil Pack Removal?
2004 passat 1.8t. How do I remove the coil packs on the top of the spark plugs, so I can repalce the plugs.
I unclipped the wire and unsure how to pull the coil pack off.
No bolts. can turn it and maybe pull, but doesn't budge and don't want to break.
Ford Wiring/Electrical :: Crank But No Start / Not Getting Spark From Coil
1996 Ford F150 5.0 ... New battery, new alternator, new starter, new coil, dis cap good and rotor is good. New plugs and wires. Ignition mod tested good.
Drove a mile from my house and lost power to my engine. Lights and radio work. Just sits there and cranks and cranks. I'm not getting spark from the coil. Don't know a lot about engines.
Ford - Explorer :: Coil Pack Isn't Putting Out Spark To Cylinder 1
1998 Ford Explorer. Coil pack isn't putting out spark to that cylinder. Would the next step be to replace the pack, or might I check something else 1st?
View 5 RepliesFord Wiring/Electrical :: 1986 F250 - No Spark From The Coil
I have an 86 f250 i just bought back with no spark. this truck is not original. used to be a diesel. has a 400 out of 81 f250. had this truck running just fine 4 years ago. sold it to a guy running and bought it back 4 yrs later not running.
Checked all the connection to make sure they r clean. Had the ignition modular tested and tested good. I have 12+ volts from the white and red wire. I have a little over 6 volts at the bat side of the coil. I have no spark from the coil. I notice every time I connect and disconnected the bat cable I will get a spark from the coil. i ran a test light from the tack test sight on the coil and tried to start and the light stayed real dim and never flickered.