Nissan - Altima :: 2010 - Hood Sheet Metal Making Oil Can Buckle Sound

When it's cold and the car heats up, you can hear the hood sheetmetal make an 'oil-can' buckle sound. Happens frequently while running in cold weather. It's not the hood itself, but perhaps the metal underneath. It's noticeably loud.

View 2 Replies

Camry 2012+ :: Sunroof With Popping Sound

It seems that many 2012/2013 Camry owner with sunroof has popping sound issue. Based on reading threads that are already out there it either happens right away or after 10,000+ miles of ownership when outdoor temp gets cold or driving over a bump. What is not clear is, too me, if this issue happens to majority of Camry owner with sunroof or minority. I for one own a 2013 Camry with sunroof with almost 3000 miles on it but I do not have this issue. Was wondering if Camry owner with sunroof can chime here whether or you have this issue and how many miles you have on the vehicle. What percentage of Camry with sunroof are having this issue.

View 14 Replies

Camry 2012+ :: Popping Sound / Slight Jerk When Going Into Reverse?

Sometimes when I go into reverse it feels like it pops into reverse and it doesn't go into reverse smoothly but sometimes it does go into reverse smoothly.

View 10 Replies

Prius (2004-09) :: Driver Side Door Repair - Sheet Metal Rattle

I recently fixed a hollow sounding door rattle that was coming from the outer door skin on my driver's side door. It turned out to be a stiffening rib that was not bonded to the door skin anymore, possibly because of an impact or just age of the vehicle.

After removing the door panel and peeling back the plastic dust guard, I used some adhesive caulk and tapered rubber wedges to brace the stiffener and reattach it to the door skin.

The picture shows the approximate location of the stiffener in between the outer skin and the inner panel support.

View 9 Replies

Camry 2012+ :: 2014 SE I4 Metal Clunk Sound When Reversing Back And Turning Steering Wheel

When I was reversing back and turning the steering wheel. I heard a metal clunk sound and it had happened twice in the past two days. Today happened after I released the parking brake and set it to reverse. What is the problem? Miles on the car is ~30700 miles.

View 2 Replies

Camry :: 2010 - Passenger Side Rear Brakes Making Metal On Metal Sound

At 75K my passenger side rear brakes were making metal on metal sound. I was really surprised as I have always learned that the front brakes take 80% of load and they always go out before the backs. So I took the wheel off and sure enough the pads were metal on metal. Changed everything out. (new rotors). I then went over to the driver side rear brake. Looks brand new. The pistons were barely out. I figured this caliper is bad. (I haven't change yet)

When I drive I can hear a very faint metal on metal sound when I brake. VERY FAINT. So with 75K miles on I figure the front brakes are due. Today I took the wheels off and inspected them. Tons of pad left on both of them. If I didn't know better I would say a brake job had been done very recently. (I've owned the car new so I know they have not had a brake job) However after reading many articles on this site I found a thread where one user said he was changing his front brakes for the first time with 110K on them and the pads still had 10K left in them. So the fact that my front pads are still pristine at 75K may not be a big deal (or not as big as I thought. Also I am not hard on brakes.)

However I'm not sure what is going on. Why would the passenger rear brake be metal on metal at 75K and the three other pads are like new. Is the passenger rear the only one working (or working much harder than the others) meaning the other three are bad? Or is the rear passenger bad and the other three are good? I have a working knowledge of cars but I am by no means a mechanic.

View 14 Replies

Camry :: 2003 / 2.4 - Metal On Metal Sound When Driving Through A Tunnel

I have got this noise which sounds like a light skimming of metal on metal. It sounds like a roller (airport baggage) spinning. It can be heard mostly when driving next to a wall or past parked cars. I suspect it being the bearing in either the water pump, idler pulley or even alternator. The car has 330000 kms but it is serviced regularly in which all fluids have been changed over time. I just want to drive through a tunnel and not hear any non harmonic sounds coming from the front.

View 10 Replies

Camry 2012+ :: 2013 - Metal Flakes In Oil?

Bought a 2013 Camry from local dealer last fall with just over 12k miles on it. I recently did my first oil change and there was sizable metal flakes in the oil pan. I'm not 100% positive they came out of the oil pan. I'm going to change the oil again after 5k and see what it looks like. The car is a Toyota certified vehicle.

At any rate, do you think I should take it in to Toyota and have them look at it? I just want to be covered if there is an issue with the engine later on.

View 5 Replies

Camry 2012+ :: Cleaning Under The Hood - How To Get Metal Back To Shining

So I was doing a little plasti dipping today and in between layers decided to try and clean under the hood. On all the plastic I just used armor all wipes. I didn't take a before pic but I wished it as it was all covered in pollen. Those parts came out great. I was just wondering is there anything I can do to get the metal back to shining?

View 14 Replies

Golf/GTI VI :: 2012 - Rear Popping / Clunking Sound

I have a 2012 GT lowered on st coil overs. I'm getting a popping/clunking sound coming from the rear. It happens at random times. In turns, going over bumps, straight, and on flat surfaces. I thought it might be the dreaded subframe clunk so I got the Tyrol sport deadset rigid kit and that didn't work. I have tried raising and lowering the car with the coil over adjustments and it makes the noise still. I have also taken the rear coil overs completely off two times to inspect them and all mounts both times using new bolts and retorqued to spec. Also while i had them off I have jerked and pushed on everything they are attached to see if there is any play in anything. I see no signs of anything bumping or rubbing under the back end and the sound is getting worse.

View 4 Replies

Passat (B7) :: 2012 - Rattles / Sounds Like Tapping Against Glass Or Metal On Metal

2012 Passat SEL ... I got new tires put on a few weeks ago and have a new rattle, sounds like glass tapping against glass or metal on metal. It only happens when I'm cruising around 65 mph. From where I am in the drivers seat, it sounds like it's coming from the drivers rear tire area or under/behind the center console/dash board. I know it's not a lot of info, but need to figure out what's going on.

View 1 Replies

Accent RB (2012+) :: Knocking Metal Rattling Sound When Accelerate Up A Hill Or Slight Incline

Since about 5000 km, I have had a knocking metal rattling sound happening when I accelerate up a hill or a slight incline. It has happened a few times on flat road as well just more prevalent on the uphill battles. Now I assumed it was jus something loose that was rattling since I installed a cold air intake and had installed hid lights(I thought the ballast was banging on something). I tried and tried to find the rattle but I had no success. I read up on here about other people suffering the same problem and that running higher octane gas would solve it well I tried 89 and it was still there just not as much and I recently started using 91 and its gone haven't heard it at all.

View 132 Replies

Camry 2012+ :: 2015 XSE V6 - Clicking / Popping Noise?

I bought a 2015 camry xse v6 and it is awesome. There is a clicking/popping noise (mostly popping) coming from the dashboard or the area of middle of the dashboard were the radio and ac controls are. I took it to the dealership but they couldn't figure out the problem, one of the workers told me it might be that the plastic needs to loosen up and to keep on driving it. It does it more often when it is hot outside and it is really annoying.

View 14 Replies

Camry :: 2009 - Metal Rubbing Sound When Turning Left

I have a 2009 Camry that makes a metal to metal rubbing noise when turning left. t is coming from the Front Right passenger side. I recently changed out the bearing and hub on the front right but I still have the noise when turning left. Also, when driving normally and going straight there seems to be somewhat of a dull click click click noise.

View 3 Replies

Camry 2012+ :: Toyota LE - Popping Noise When Go Over Any Bumps Or Turning

I am a owner of a 2012 Toyota Camry LE with 18,000 miles on it. I am having a issue when I go over any bumps, or turning, I hear a popping noise coming from the right rear.

View 4 Replies

Camry 2012+ :: 2015 LE Driver Door Popping When Opening

I just bought a used 2015 Camry LE 3 days ago. I just went to open the driver's door & heard popping as it opened. It's coming from the hinge area. I see posts about older Sienna vans having problems with broken welds causing the sound. Is it possible that a 2015 Camry could have the same problem? It's still under warranty. Are there any TSB's about it? Anything official from Toyota that I can take back to the dealer so they don't try to lube it instead of repair it & try to wait out my warranty?

View 1 Replies

Camry 2012+ :: Popping In Front Driver Side Suspension

I put lowering springs on a few months ago and a pop/clunk has developed. There is a tiny lip of pavement just past my garage door and it clunks as I back out at an angle over it. Worse case I can check the torque on all of the bolts.

View 2 Replies

Sonata NF (2006-10) :: 2007 - Metal On Metal Sound When Turned Right - Wheel Bearing?

I have a 2007 hyundai sonata, this car is my daily driver. I put 180 miles on it a day around trip. Currently has 180,200 miles on it. Last Friday on my trip home when i turned right I heard a metal on metal sound. I slowed down went straight and it went away. Talked to a few people and I think it may be the wheel bearing. Even if I hit a road reflector it starts up. It's the front left wheel. Get on the breaks it goes away.

So my question is... Wheel bearing??? And can I replace the whole hub and fix the problem or do I have to try and press the bearing out?

View 1 Replies

Toyota - Solara :: 2003 - Metal On Metal Sound Near Driver Side Of Engine

I have a 2003 Toyota Solara 4 cyl. auto. transmission. I recently had the head replaced. Now it is making a metal on metal sound near the drivers side of the engine. It makes the sound during idle, when I change gears, and the sound increases when I rev the engine. What could it be?

View 8 Replies