Camry 2012+ :: 2.5 Engine Started Knocking
So our 2012 with 55k miles started knocking and now it's really bad. Started about 5-10k miles ago.
View 14 RepliesCamry 2012+ :: Check Engine Light On When Started The Ignition
Was trying to change my reverse light on my 12 camry. I wanted to make sure the bulbs were working before I put everything back together. I put on the emergency brake put the car in the on position and put the car in reverse. Went to check the bulbs and nothing. Put the old bulbs in, nothing. Started the ignition and noticed that the the check engine light was on and also the P, R, N or D was not showing in the display. Let the car sit for a while and still the the same thing. What happened. All other lights work fine.
View 1 RepliesCamry :: 2005 - Noticeable Knocking After Timing Belt Change
I have a 2005 Toyota Camry with 120K miles that was bought used with 110K. The previous owner did not have the vehicle long and did not know if or when the timing belt had been replaced. I have read several blogs that recommend replacing the timing belt at 60 or 90K. To err on the conservative side I decided just to do it at 120K. Now my problem. Before the timing belt change there was a slight knocking from one of the cylinders. After the belt change the knocking is more pronounced. Q. How concerned should I be that the knocking is more noticeable? Could this be a by-product of the new belt and as it loosens the knocking will subside somewhat? OR, am I looking at valve job or worse?
View 8 RepliesCamry :: 2002 L4 - Knocking Noise When Car Started
I have a 2002 Camry L4 and when ever the car is started it makes a knocking noise. The engine turns off unless I press the gas pedal. This all started after I changed the valve cover gasket myself. I had to change the gasket because the oil had started leaking. I changed the gasket after about 6 months because I wasn't sure what the problem was. The car has about 120,000 miles on it and I have never had this engine rebuilt.
View 14 RepliesPrius (Gen 3) :: 2013 - Engine Knocking After Oil Change?
Just DIY'd the first oil change on my new 2013 Prius at 2100 miles. When I first started the engine after the oil change, it was knocking and sounded a little rough for about 5-10 seconds.
View 19 RepliesSanta FE SM (2001-06) :: Knocking Noise In The Engine After Oil Change
2004 Santa Fe, 2.7 L V6. The oil was changed approx 5-7k miles ago (not really sure as I bought it from someone else) and I just changed it today. There's a new knocking noise in the engine. I used normal castrol GTX oil, 5w-30.
I drove it about 20 miles and the noise is still being made, so it's not a circulation problem.
Camry :: 2002 - Transmission Started To Slip - Fluid Change?
I bought a 2002 camry last month. It has 180k on it, and the previous owner says he never had the trans fluid changed.
It started to slip, so I parked it and I had it towed to a trans shop. Of course, they immediately say I need a trans rebuild.
My house was close, so I drove it home without any issues.
What are the chances that a fluid change will correct this for a little while atleast?
Prius C :: Engine Chugging / Knocking When Started The Car
I just turned 3000 miles on my C. I started the car and the engine chugged and knocked like I have never experienced. I turned off the engine and restarted and no problem.
View 10 RepliesCamry 2012+ :: First Oil Change Should Be Done After How Many Miles?
I bought my wife a new a new Camry a couple of weeks ago.
when should I get the first oil change done? 5,000 miles per the dealership or after the first 1000?
Camry 2012+ :: Change Default From Recirculated Air To Outside Air
new 2014.5 Camry SE owner. Had the car about a week now and I've noticed every time I turn on the car, it defaults to recirculated in-cabin air, even when I've last turned off the car with it set to fresh outside air. Is it possible to change this default, either from recirculated to "last setting", or from recirculated to outside?
View 14 RepliesCamry 2012+ :: 2013 SE V6 Oil Change Interval?
i am used to changing the oil & filter in a new car after 700 miles, the thinking was the bad sand castings and after a couple hundred miles some sand and other noogies would fall out of the engine block, heads and other parts. Then begin a 3,000-3,500 miles cycle of oil & filter changes. The dealer where I bought and will have it serviced at, a large Toyota dealership in Henderson, NV., says the oil and filter in this new Camry SE V6 gets changed every 10,000 miles. I know the tolerances are much tighter in 2013 than the 60's & 70's, and this engine uses synthetic oil but that seems a long time between oil & filter changes.
View 14 RepliesCamry 2012+ :: How To Change Toyota Air Filter
I changed the air filter in my wife's 2012 Camry and took pictures and wrote a simple how-to guide so others can see how to do it. Our Camry has the retention clips on the air box but older years may have the 10mm bolts. How to change Toyota Camry Air Filter.
View 5 RepliesPrius (2004-09) :: 2005 - CEL Started Blinking And Engine Shaking / Knocking
Driving home the other day I noticed some vibrations up front. Reminded me of out of balance wheels. Then the check engine light started blinking. Then it was on steady, then blink, then steady... Took it easy the rest of the way home. Code reader said P0138 Oxygen sensor circuit high voltage bank 1 sensor 2, and P0304 Cylinder 4 misfire detected. At home is where I saw the engine shaking and extra noise from it (visions of piston rod slapping around in there). Removed plugs (original? tough to get out!), compression tested all 4 cylinders (130 to 140), new spark plugs (had they been in there for 196K miles?). Start engine and same, shake shake with some extra noises that weren't there before (car just sitting in driveway).
View 6 RepliesCamry 2012+ :: How To Change Dome Light In Toyota Car
I recently had to change the dome light in our 2012 Toyota Camry so I took some pictures and wrote a simple how to guide. The interior light assembly should be the same for 2007-2012. I definitely recommend changing to an LED light while you are at it, they last longer and are brighter. The OEM bulb number is DE3175 but I hear a lot of people like the PUTCO 231125 LED replacement bulb.
The dome light replacement guide is here How to Change Toyota Camry Dome Light .......
Camry 2012+ :: SE V6 - Knocking Noise From Front End When Driving Over Medium Sized Bumps
I drive a 2012 SE V6 with 1600 km in it. Literally brand new car, two days ago I noticed a faint knock when driving normally over medium sized bumps in the road. Sound seems like it is coming from the front drivers side. It's not my first time around the block and wonder if it's suspension related or steering related. It's going to the dealer tomorrow...
View 14 RepliesCamry 2012+ :: 2013 SE - Steering Clunk / Knocking Noise At Slow Speeds
I have a '13 SE that I purchased new last year and recently I've noticed a noise in my steering when I am turning the wheel at slow speeds.
It's like a clunking or knocking noise when I turn the wheel either right or left all the way. I'm totally clueless as to what could cause this sort of noises.
Camry 2012+ :: Remove Bumper To Change Turn Signal Bulb
Thinking about getting a used Camry. Is there any issues with any of the years in the seventh generation Camry? What are some of your likes and dislikes of your car? For example I have been told that on the sixth generation Camry you have to remove the bumper to change the turn signal bulb. I have never had to deal with this, just what I have been told.
View 14 RepliesCamry 2012+ :: Change Source Order On Display - Standard LE Audio
Can change the order of the "Source" on the display? I very rarely use AM. I have to either press the arrow or view all options to see the "BT" option. I would like FM, BT, and Ipod to be the first options I see, when pressing the Source option.
View 2 RepliesCamry 2012+ :: How To Change Toyota Logo Entune Image On Screen
How to change the Toyota Logo that appears on the screen when you start the car? I know there is an option for that in the Settings menu toward the bottom. There is a preset Toyota logo and the user may add more or modify the current one. There is an option to extract from USB, but when I do it says failed.
My usb flash drive is formatted properly, and I do have pictures in there that I would like to put. However, it says to refer to the Toyota User Guide for picture information, but I cannot find it anywhere.
Perhaps my pictures are too big for the screen, so that is why?