Santa Fe (CM - 2007-12) :: 2009 - Engine Sluggish On Acceleration

Experienced sluggish acceleration with their "09" Santa Fe. I have the 2.7 liter 6 cyl. engine and it seems so sluggish when accelerating. I have replaced all the plugs with some best rated ones specific to my model. I have tried one of the best rated fuel system cleaners. It still seems to have no pep, my daughter's 1999 Honda has far more get up and go.

View 7 Replies

Camry :: 2009 LE - VSC Trac Off And Check Engine Light Came On

My sister has a 09 camry le I4 and on her way home her VSC Trac off and check engine light came on. What the cause is ( she checked the gas cap )...

View 4 Replies

Cadillac - Deville :: 2003 - Service Engine Soon Light / Sluggish Acceleration

I have a 2003 Cadillac Deville with about 120,000 miles on it. The SES light came on and I had some maintenance done at STS. The light came back on the night I picked it up. I took it back the next day, they said it was related to the transmission and they do not do transmission repairs. They cleared the light and said if it came back on they could flush the transmission and maybe that would take care of the problem or they suggested I should take it to a transmission repair shop. The error codes are p0741 & p1860. Once in a while at the beginning of a drive I experience a sluggish acceleration, it does not last long( a second or 2) and then runs fine for the remainder of the drive.

View 6 Replies

Camry :: 2009 - Check Engine Light On / Error P0500

Currently I haven't been tweaking anything to my car after driving to go and home I left to go get something to eat and after driving for a few min out of nowhere the engine light, brake and abs comes up. So I freak out a pull over to the nearest gas station and turn my engine off for 2 min and turn it back on and this time only the engine light come up. So I drove to autozone to get it scan and error p0500 comes up. Which means short circuit, vss and poor electricity something I am not exact but is it serious? Like I am freaking out right now.

View 1 Replies

Camry :: 2009 - Check Engine Light Is On And O2 Sensor Dead

My 2009 Camry check engine light is on. Dealer said the two O2 sensor both are dead and need to replace. After dealer reset the check engine light I have driven two days for 50 miles and the check engine light doesn't come back. If the O2 sensor is bad how long does it take for check engine light on again? Is it possible the check engine report on by mistake since two O2 sensors got bad at the exact same time is really rare.

View 13 Replies

F Series :: Sluggish Truck - Check Engine Light Flashing

I have a 98 f-150 with a 4.2 and my check engine light is on and when I'm traveling down the road i notice that when i give it gas the engine feels sluggish and my check engine Light is now flashing.

View 6 Replies

Chevrolet - Malibu :: Car Running Sluggish / Making Noise And Check Engine Light On

I have a 2006 Chevy Malibu 125,000 miles, 2.2 Engine that was running sluggish, noisy like needed oil (checked didn't) and check engine light was on. Took it to a repair shop and told needed an oil change, car still ran sluggish, told to drive it a day or so. Two days later, car wouldn't go over 50 mph, took it back and told needed air filter and mass air flow cleaned. After they did that, they told me the Catalytic converter needed replaced however they don't do that work. Within a week car would not run so had the cat replaced.

Car ran better but still not great. Took it to another place, spark plugs replaced, throttle body cleaned and fuel injector cleaner added to gas.Still the car ran sluggish and was making noise and check engine light was on. Took it to parts store to have code checked on check engine and said error in bank one of oxygen sensor. I replaced that, reset the light and am sure you know, it still runs bad and noisy and check engine light came back on. I am losing power on hills and big hills the engine rattles.

View 5 Replies

Ford 6.7L Power Stroke Diesel :: 2011 F250 Running Sluggish - Check Engine Light Came On

I have a 2011 F250 6.7 that I bought in August of 2010. I have 35K miles on it and it has pretty much been trouble free once I got the firmware update for the shifting issues. I have the local dealership do all of my service work and all updates and service bulletins have been applied. Unfortunately on my way to work this morning the stupid Check Engine Light came on. The dealership has it now - hopefully I will know tomorrow.... I do think it has been running a little sluggish but I am not sure if that is the winter grade diesel (I use PM22-A in every single tank).

View 2 Replies

Ford F-150 (2009-2014) :: 2013 - Check Engine Code P0355 / Cylinder 5 Coil Malfunction

I have a 2013 F150 6.2L and it wont start. It was running great and when I drove it around the corner it just shut down no clunk no warning just bam shut off. I had a engine code P0355 ( which indicated cylinder 5 coil malfunction). changed the coil and it will not fire the engine code has gone away but it will still not fire. I changed the oil just to be safe and no metal shavings in it.... Turns over just fine but will not fire. I added more fuel just to be safe ( thinking maybe I had bad fuel but that didn't work either.

View 3 Replies

Passat (B5) :: V6 Check Engine Light - Misfire In Cylinder 4

I'll try to break this down as best I can. I went to my mechanic this am with a check engine light. My suspicion is 02 sensors. This was confirmed as a problem area, but separate they said I had a spuratic misfire in cylinder 4. With that info, i pulled the plug to inspect (I had just installed new ngks in it and they have 18,000K on em.

I put beldon wires on about 8k ago.) plug looked to be normal, but there was definitely a puddle of oil from the valve cover leaking. Oil went into the cylinder head but I didn't really think that was an issue. Nothing abnormal jumped out at me so I reinstalled plug and checked all wire connections at both ends and called it a day.

Then I drove it. Check engine light flashing. Major performance stutters, etc. I drove it for about 20 miles and hoped it was just the oil raising hell in there and it would burn off eventually. It hasn't gone away yet. Maybe coil pack. Can the single portions of that pack be replaced, all i see them sell is the full three as a unit.

View 7 Replies

Chevrolet - S-10 :: Check Engine Light Come On / 4th Cylinder Misfire

2000 Chevy S10 pickup

Had the check engine light come on, and when I checked on the code it gave a 4th cylinder misfire. Autozone instructed me to simply replace my spark plug with a new oem plug.

I replaced the spark plug as instructed. After about an hour of driving, the check engine light goes off and I think, great! Problem solved. However, another hour of driving and the check engine light is back on again, without going away.

I headed back to autozone to get a readout, just to find that it's the same code. So I put another spark plug in. Same result - check engine light goes off after an hour, only to come back on again permanently after another hour.

Now, normally I would think, this must be the spark plug line that needs replacement,however I am sure there must be some clue in the fact that the check engine light turned off for an hour.

By the way, not sure if relevant, but I also found a lot of build up around the spark plug before I initially changed it.In fact, there was so much that I had to scrape around the plug with an awl, and blow out the crud with a compressor,just to get my socket into place without there being crud in the way.

Any clue what that check engine off/on clue might be?

View 6 Replies

Passat (B6) :: Check Engine Light - Cylinder 4 Misfire

Got the flashing check engine light and loss of power for few seconds and then the light stayed still, from time to time it blinks for few secs, usually when I push the gas pedal little bit more but it stays still, flashed only twice in 2 days for seconds. I connected computer (not VAG) and it says "Cylinder 4 misfire". I have app scheduled with my mechanic this Thursday, but still need to commute to work. Is it safe to drive?

View 7 Replies

Prius (2010-12) :: Check Engine Light On Due To Cylinder 1 Misfire

I plugged in a OBD2 reader and its show misfire on Cylinder 1.

I haven't driven the car for 4 days, and when i started the engine this morning, the engine show knocking when the regular engine kicks in (rough). i will be bringing the car in tomorrow (dealer). my car is a 2011 with 16k miles, strange for this to happen so early in age.

View 2 Replies

Santa Fe (CM - 2007-12) :: Cylinder 3 Misfiring And Check Engine Light Came On

i have a 2008 santa fe with a 2.7 61,000 miles 2nd owner ,out of warranty. It started missing and the check engine light came on. I took it to a local parts store who put an analyzer on it an it showed the #3 spark plug was misfiring. I am hoping its the plug. I do my own work but havn`t been able to find a correct sequence to replace the plugs.

View 3 Replies

Elantra XD (2001-06) :: Check Engine Light (cylinder 3 Misfire)

As the title says I have plugged a code reader in and it says "cyclinder three misfire". So I pulled the plugs and good god they were nasty. Some having a gap of 80-90 thousandths of an inch. So I figured the plugs were the source of the problem, thus I replaced them but to my dimise the check engine light is still on, and still reading the same ol' "cyclinder three misfire". I have put 350 miles on it in 24 hours of changing it to allow for proper time of the circuit cycling for the light to change but not sure if it takes longer...?

I also went ahead and checked the plug wires resistance when I had the plugs pulled and they ranged from 1.5-2.5k ohms shortest to longest (cylinder 4-1). And if your curious the magic cylinder three was around 2k ohms for however long that wire is, my guess would be 18 inches. Would this be out of tolerance, I know the norm is 10k ohm for every 12 inches or so...?

My next guess would be replacing the power pack or I guess you car guys call it the "ignition coil"...? I will say that the car does run much smoother after replacing the plugs.

View 5 Replies

Honda - Odyssey :: Cylinder 4 Misfire - Check Engine Light

Honda Odyssey 2005 – 176000 miles. Cylinder 4th Misfire – check engine lightHonda has about 176000 miles. When cold – before warming up – it acts like nothing is wrong – as it gets warmer – to the middle of the temperature gauge – it misfires.And runs rough. Evaluation: Honda Dealership thinks it is a cracked Valve or needs adjustment – they have replaced a spark plug and swapped coils. Not for sure.They think if that is not the case then there could be additional problems.Question: Why does it act normal when cold ? How can we confirm if it is the valve and not cracked head?

View 15 Replies

Ford Excursion :: Check Engine Light And Cylinder 5 Misfire

So when I bought the car, it had a check engine light. I had it checked it said cylinder 5 misfire. I assumed it was the glow plug so I bought it and replaced the glow plugs myself. Check engine light went away for about a day then came back on. Got it checked again and still said cylinder 5 misfire. This is my first diesel and I'm clueless as to what's wrong.

2001 7.3 Limited with 232k miles Bergen County NJ.

View 2 Replies

Accent LC (2000-05) :: CE Light Came On - Sluggish Acceleration

I drive a 2001 Hyundai Accent. About a month a go the CE light came on. at first, the car was driving fine so I thought nothing of it. Then I started noticing that the acceleration was sluggish and when it finally accelerated, it basically slingshot forward. What could be wrong. There's no smell, rattling or anything else. The only thing I noticed was the engine was a bit louder.

View 1 Replies

Lexus GS 2006-11 :: Check Engine Light Came Up - Multi Cylinder Misfire

Bought a 07 GS450h w/ 82k on it last week thursday. car was serviced at 1 dealer it's entire life and battery was changed before I took delivery. After 100 miles of driving check engine light came on and i read 10 codes.

The codes are:
P0300 multi cylinder misfire (6 times)
P0301 cylinder 1 misfire (2 times)
P0303 cylinder 3 misfire (2 times)

Am I just looking at a simple spark plug change or is there something in particular I should look for? Is it worth the effort of bringing it to the dealer to repair?

View 14 Replies