Ford F-150 (2004-2008) :: Missing And Rough Idle After Changed The Spark Plugs
I changed my spark plugs now I got a miss and rough idle .#2 and 6 seem to be the ones that miss the idle don't change when I unplug the coil , I take coil off and put it next to the motor it sparks ! I put everything 3 plugs and got about 200 miles on them and 3 out of 8 had melt downs and left me on the side of the hwy. I got autolights in it now but it got a miss and rough idle ! Did I not do something right ?
View 7 RepliesSanta FE SM (2001-06) :: Slow Acceleration And Rough Idle After Spark Plugs Changed
Here's the run down:
-bought 6 months ago for cheap because it wouldn't pass smog test
-changed Purge Control Valve (PCV) and it passed
-filled with gas, heard popping noises like a backfire, and coded it read the same "Bank 1 and Bank 2 running lean, like it did before the PCV and then also "Cylinder 3 Misfire" appeared.
-At this point the car started running rough, at idle, and through acceleration...sputtering uphill, and when climbing through the gears.
-Changed the plugs & wires
-NOW, it's cylinder 5 misfiring, and not nearly as bad. It's idling and running rough, acceleration has somewhat come back, but it's definitely not 100%.
Should I start with the PCV again, since it's not starting after I fill the tank, and climbing gears slow? Is there anything else I should be checking?
Camry :: 2008 Toyota CE - P0101 Code After Replacing Spark Plugs
This past Sunday, I replaced the spark plugs on my 2008 Toyota Camry CE, following one of the sticky DIYs. My car has approximately 107,xxx miles.
Last night on my drive home from work my CEL came on. First time seeing a CEL light since my BMW days, . Luckily, I have a OBDII scanner at home and after running the scanner, it gave me the following trouble codes:
- P0101
- P0172
I went ahead cleaned the air filter (I have an Injen SRI installed).
After doing some research on the interwebs, I have concluded that this code has to do with the MAF. Time permitting, I am going to clean the MAF sensor later tonight. In the meantime I reset the CEL, to see if it will come on again.
My only question, which I am unable to find an answer to, is:
Can there be a possibility that the P0101 and P0172 trouble codes be related to me replacing the spark plugs, or is this just a mere coincidence?
Ford F-150 (2004-2008) :: 2005 - Changed Fuel Filter / Spark Plugs / Battery Now Idle Roughly?
I have rough idle problem after changing spark plugs, fuel filter and battery. There was no rough idle problem before this work was done. What could be wrong. Once the speed is above 20 mph it seem to run fine but at stops it vibrates and seem like it may stall!
View 6 RepliesVolvo :: Motor Seems To Burn Out Spark Plugs - Car Running Rough With No Power
Motor seems to burn out spark plugs every month. I was using non volvo sparks. I took car to Volvo dealers and repairers who gave car a diagnostic check but nothing showed up. They told me to use Original Volvo Spark Plugs which I did. The Car went great with no problems for about 3 months thinking problem was fixed. Low and behold the same problem came back.
I changed spark plugs again (original Volvo) and car only ran for 10 ks and then ran very very rough with no power. Motor felt like it was running on a few cylinders. It seem this problem happens mostly in hot weather. Motor also heats up but when cooled down runs well again. I intend to buy new rotor Bosch and Distributer cap and if needed coil.
Camry :: 2009 - Rough Idle / Range Colored Dust In One Of 4 Spark Plug Tubes
I was doing a tune up of my 09 camry with an 2.4L engine due to a rough idle problem i have been having , and I noticed a lot of orange colored dust in one of the 4 spark plug tubes, I mean a lot of it while the other 3 were dust free. I tried my best to clean it out and inspected the spark plugs all seems to be fine. What could be the cause of the dust?
View 9 RepliesCamry :: 2003 - No Spark In Plugs
'03 Solara 4 cyl, 135K repl. Fuel pump, 45# press ok, NO scan tool code(s), turns over fine, no spark 2 plug. Started/ran fine before fuel pump change.
View 10 RepliesNissan - Altima :: 2000 GLE Idling Rough - Motor Gone Because Of Oily Spark Plugs?
Nissan altima gle (2000) and for the past 3 weeks it has not gone over 55. The car was running ok before but was idling rough. A mechanic replaced the intake manifold gasket, the MAF sensor and the fan sensor. I decided to change my spark plugs when I noticed the idling was getting worse. The spark plugs had oil on them and now a month after the new ones are burned (like ashy tip, black thread) and dripping oil again. I think is the oil not letting my car accelerate in the highway. I considered changing the valve gasket, cables and cap for the spark plug. A mechanic told me not to bother because the motor is a lost. Is he right?
View 16 RepliesFord F-150 (2004-2008) :: Spark Plugs Removal?
Sstripped threads using an impact to remove the plugs?
View 4 RepliesCamry :: 2006 Shaking After Replacing New Spark Plugs
I have a 2006 Toyota camry v6 1mz-fe engine. My buddy changed the all 6 spark plugs using Toyota oem denso.
The car drive weird after that. When I am on the stop light, the car is shaking ( coming from the engine area ).
When I am driving 60 mph, it shakes .
Camry :: Broken Wire Harness Spark Plugs
Two of my plugs locking clips broke today on the wire harness side where the coil over plugs into the harness today while changing spark plugs. They will plug back up, but they won't lock together like they are suppose to. How critical is this? It is my wife's car will she break down? I drove the car maybe twelve miles, and everything seemed fine.
View 8 RepliesFord F-150 (2004-2008) :: 2007 - Spark Plugs Replacement Every 60k?
My '07 had the check engine come in the other day, engine misfire. I took it to the dealer hoping it was a coil, due to the 100,000 mi warranty from Ford I was hoping would be covered. Sadly, and of course, all coils tested fine, turns out 2 plugs were bad. They replaced all 8 plugs, plus a plug boot. Not one plug broke (truck had 80k on it) so no extra cost there. So much more, but peace of mind that all the plugs are new one piece plugs is great. He recommended that they should be replaced every 60k to avoid any issues.
View 7 RepliesFord F-150 (2004-2008) :: 2006 - When To Change Spark Plugs Normally?
I am a newbie here, and also a new owner of a 2006 F150 XLT 4X4 with the 5.4 engine. It has 68K miles on it and looks to have been well cared for. I have a couple questions. First the truck is runnig great, no problems. I have read the threads regarding the spark plug issues and was looking for an opinion about changing them. Should I wait until I have problems, or due to the age of the truck, should I go ahead and attempt it soon? Also, I would like to find a used cap for the bed. I have the 6.5 bed, and wondered what range of years would work with my truck.
View 3 RepliesToyota - Corolla :: 2002 - Tighten Spark Plugs To Same Torque Specifications As Regular Plugs
I am changing my own spark plugs for the first time. I have a spark plug wrench, dielectric grease, anti-seize compound etc.
I have a Haynes manual for my 2002 Toyota Corolla. The book was written before Irridium plugs were used. Should I tighten the spark plugs to the same torque specifications as regular plugs? The book says 158 inch pounds. How do I know I have tightened them to the right amount?
How do I avoid cross threading the spark plugs? What happens if you cross thread the spark plugs (assuming the car seems to be running fine)? Would I need a new engine or expensive repair when it is time to replace the spark plugs again?
Ford F-150 (2004-2008) :: Misfiring On Cylinder 4 - Changing Spark Plugs
2004 5.4L ... Codes indicate a firing issue on #4 cylinder, figure it's the coil pack. They bought truck used a few years ago and plugs have not been changed since they have owned it. I was going to change plugs while I was under the hood. While checking threads on this engine I picked up on plugs being a major job unless you know the tricks. So what tricks do y'all have up your sleeve to keep from breaking plugs?
View 14 RepliesFord F-150 (2004-2008) :: Misses Under Hard Acceleration - Spark Plugs?
I've recently had a small issue with my truck missing under hard load. If you're going around 40 MPH and push it down like merging it will kick back and forth and sputter and then start hitting fine again after a few seconds and move on. Possibly bad sparkplugs and/or wires?
View 3 RepliesCamry :: 2002 SE V6 - Replaced Spark Plugs / Check Engine Light Came On
I recently replaced the spark plugs on my 2002 Camry SE V6 (Gen 5). Let me just say that it was INCREDIBLY DIFFICULT to reach the rear 3 plugs as they sit underneath the intake manifold, way to the rear of the engine compartment. To reach those, I had to unplug some wires reaching on top of the engine, then loosen the intake manifold.
Along the way I broke a tiny air valve that sits underneath intake manifold, and replaced it right away, before starting the car.
When everything was put back together, the car started wonderfully, only to notice the engine light come on. I had the codes checked at the dealer and they indicated a malfunctioning Catalytic Converter and A/F Sensor and some other emissions stuff. Later that day, the VCS/TRAC OFF light came on as well. The service guy at the dealer said those typically come on together with the Check Engine light, which sounds like something he pulled out of somewhere!
The car drives well, no hesitation, no weird behavior, but has no traction control, naturally. While loosening the manifold I had to use a little force to flex it out of place. My guess is that it I may have yanked something out place: may be a wire issue, or a sensor.
Toyota - Camry :: 1996 Frequently Keeps Losing Power To The Spark Plugs
My old 1996 Camry with 2200 cc 4 cylinder engine, frequently keeps losing power to the spark plugs. I have changed the fuel filter and the ignition coil. That did not work. I also noticed that the car was starting when I unplug and replug the primary wire plug to the ignition coil. So I have replaced the primary power plug with a six inch pigtail and a used plug purchased from a salvage yard. This is not working either. The Toyota dealer near my house want to replace the igniter and the Engine Control Module just to be sure that these are not the sources of problem. The dealer did not test these parts. So I refused to replace the parts without a proper test. I would like to test these parts. Is there a test available for the igniter and ECM that could be performed. I have access to a lot of tools. I need a schematic and/or test to test these components.
View 18 RepliesFord F-150 (2004-2008) :: 5.4 Liter Truck - Spark Plugs Coming Loose
I have with my F150 5.4 liter truck. I had the spark plugs replaced about 1 year ago. since then I have had 2 plugs back out and come loose. I would smell a faint gas smell first that would tell me know that it was happening. the first plug was if memory is correct either number 8 0r 7 on bank 2. this time its number 2 on bank 1.
I hope that my mechanic just did not torque the plugs correctly and all I have to do is tighten them. If that's not it. Could the spark plug holes be stripped and have to be re-threaded? And if so how us that done?