Camry :: 2001 - Jerking While Driving And At A Standstill / Stalling
I've got a camry 2001 4cly 2.4l vvti auto with 120 000kms. Recently i had a issue with the car car suddenly jerking while driving and at a stand still and stalling too. i done a bit of scouting around and come to the conclusion the tps has gone (checked on a multimeter) Change it and the car come good till about 1 week ago now it is doing it a lot more frequent.
View 3 RepliesFord - Focus :: 2003 ZX5 Stalling In Reverse
Why my 03 focus zx5 will stall in reverse. I have had the tranny serviced. I can drive it and then let it sit for about an hour and then try to reverse in it and it dies. I have change the mac, tps, iac sensors. I am at a loss for why this is happening. I also changed the pvc hose that runs from the back of the motor to the pvc valve.
View 14 RepliesDodge - Grandcaravan :: 2003 - Stalling In Reverse And First Gear
Our '03 Dodge Grand Caravan has been stalling sometimes in reverse and in first gear when starting to move. This usually only occurs if we hadn't yet driven it that day, or if it has completely cooled.
Put it in reverse and give it a little gas to get out of the spot, turn the wheel, and it stalls.. Park - Restart - Drive, and any attempt to press the gas normally probably results in stalling again. This presents a problem as I get to a stop sign and it stalls while in the middle of an intersection...so there is danger to this problem.
The only way I have found to somewhat thwart the problem is to ever so lightly feather the gas, and I mean I don't even push it, I tap-tap-tap it. This usually results in not stalling, but a slight lunge in acceleration.
There is a check engine light on and the code is for the emissions Evap. solenoid. Does this have anything to do with it? If not, what the heck is going on?!
Ford F-150 - 1997-2003 :: 5.4 Stalling In Drive Only / Reverse Works Fine
2002 f150 7700 with 5.4 triton and 4r100 tranny started chugging under acceleration and now stalls when put in D, 2 or 1. park and neutral are fine and reverse works perfectly.
Now when I put it in drive it chugs and stalls immediately... 1/10 times it will keep running but chug violently like its running out of gas. will get worse and stall if you press the gas. i can light the tires up for a block in reverse however.
Changed coils 1 2 and 3, IAC, bank 1 knock sensor, camshaft position sensor
Ford 7.3L Power Stroke (1999-2003) :: Truck Stalling When Going Into Reverse
This just started happening last week. When I put the truck into reverse, the engine lugs down and dies. It' as if the AT is fully engaging reverse gear with no clutching action. If give the truck a bit of pedal, I can put her in reverse and back up without issue. Going forward into Drive has no issues.
View 8 RepliesFord F-150 - 1997-2003 :: 1994 - Stalling Between 1st And Reverse - Exhaust Leak
I recently got a 2wd 1994 150 straight 6 4.9L, It's been a great truck so far. It drove from New Mexico to California with no issues. Just this morning it started stalling and dying when pulling up to stop lights and putting it in reverse. The truck has 172,000 miles and has a new serp belt, alternator, radiator, and starter. It seems to run just fine on the highway and once it's warmed up it doesn't stall as easily. There is an exaust leak.
View 1 RepliesSanta FE SM (2001-06) :: Stalling / Jerking Or Cutting Out While Driving
I have a 2005 2.0 litre petrol Santa Fe. I recently had it serviced and after this I started to have problems with it suddenly cutting out or stalling momentarily while driving. This happens randomly, sometimes at slow and other times at high speeds, often when accelerating but a couple of times in cruise. It only lasts a second or two and picks up immediately but can sometimes happen a few times in succession. It never happened before the service. The orange check light with the exhaust icon (Malfunction indicator Light?) comes on sometimes but I haven't noticed it all the time. This problem is getting worse, more frequent. I pushed the car a bit today in 4th gear up to about 3500 rpm and it happened quite badly, a few jerks in quick succession with the light coming on then back to normal for the rest of the trip.
I brought it back to the garage who did the service (not a main dealer, nor my usual mechanic) and they ran full diagnostics on it a couple of times. Nothing showed up, no error codes and nothing logged on the car's computer. They tested the emissions and found them to be perfect. They didn't change the fuel filter because it seems to be built into the petrol pump but did put something in the system that is supposed to clear out any deposits or whatever. Not sure what it's called but some sort of fuel additive. That was why I drove it hard today. They suggested doing that to try and clear out the system. Doesn't seem to have worked.
The bottom line is they don't know what's causing this so I'll have to take it to my own mechanic or else the main dealer. I'm wondering what could be the problem. From searching the forum it looks like the symptoms could be consistent with a failing CPS, an oxygen or throttle position sensor or a faulty ignition relay. I also think it could be to do with a clogged fuel filter, dirty petrol or perhaps water in the fuel tank; we've had tons of rain lately and the car is kept outside! Given it started happening after the service I wonder if they could have fitted something wrongly, used a faulty part, maybe a plug, or left something loose/disconnected. They have however gone through it thoroughly to try and find the fault so I imagine they would have turned up something like that.
Santa FE SM (2001-06) :: Jerking / Stalling - Need To Jump Start
Bought a 2006 2.4L Sante Fe a few months ago. Had a couple incidents of it jerking after descending the same hill in our neighbourhood. Have a 6 month warranty so brought it to mechanic. All their "scans" were showing everything working so they guessed at replacing the fuel pump and filter. A week later did the same thing but this time it stalled out and I had to jump start to get it back to garage. My wife scanned the internet and noticed other similar complaints. The crankshaft position sensor seemed to come up as being replaced in these incidences, and apparently the "scan" will not show it as failed if it is still somewhat operable. Based on that, we told the garage to replace it as they literally could not figure out what was wrong with the car, having driven it over several days for it to repeat the jerking and stalling we had experienced. It has only been a few days so here's hoping that was the answer.......
View 1 RepliesAccent LC (2000-05) :: 2002 - Jerking / Stalling While In First And Second Gears If Accelerate Too Quickly
My standard 2002 accent is undriveable and at the mechanic right now (100,000km). For the past few weeks the car has driven very jerky. While in first and second gears if i accelerate too quickly it just jerks/slips and has very little power.
Yesterday the check engine light came on and i got codes P0300, P0302, P0303...misfire in cylinders 2 and 3. Checked this forum and decided to buy new spark plugs (last replaced plugs and wires 1.5 years ago). Got into the car and could go more than a block because it was jerking and then kept stalling. Replaced the sparkplugs and nothing changed. Had it towed to the mechanic...after a few hours he said he had cleaned the exhaust manifold and it was driving fine. I picked it up and a block away it stalled again.
The mechanic now says 3 of my fuel injectors need to be replaced and the fourth will probably go soon and it will be about $700 to fix. Does this sound right for these codes?
I called hyundai parts and they told me each injector is $236...he also told me he doubted they had to be replaced cause he has never seen an accent have fuel injectors replaced and also they rarely sell these injectors, he said it was probably something electrical.
I have found 4 injectors on ebay for $200 but is this really the problem? The mechanic says it is 100% the problem. But from reading the forum I dont think so.
Also wanted to add that i often noticed the smell of burning plastic. Smoke seems to be coming from spark plug area when i notice the smell but nothing looks burnt/melted.
Jetta - Volkswagen :: Jerking / Resetting Clock / All Indicators Flashing On Dash And Stalling
Why my 2002 volkswagen jetta station wagon is jerking, resetting the clock, flashing all the indicators on the dash, and Its stalling. When it start it to drive the transmission won't shift until it runs for about 5-10 minutes. One mechanic said the computer keeps resetting itself. The dealer said I needed a new transmission, but after 5 minutes the transmission shifts. It only has 117,000 miles.
View 19 RepliesCamry :: 2003 LE V6 Stalling With Sulfur Smell
Have a 2003 LE V6 with 95,000 miles on it. It is stalling at stop lights and when pulling into the garage where the smell is noticed. Our mechanic has been unable to replicate the situation.
View 2 RepliesSonata I45 (YF - 2011+) :: Jerking In Reverse And Bucked When Put The Car In Drive
I have 2011 Sonata with just over 3500 miles on it. About three weeks ago I was driving down the road going about 45 mph when my sonata jerked like I had hit a pothole. I pulled over and checked it out and saw that I had not hit anything. When I put the car in reverse it jerked, and when I put it in drive the car bucked badly. After that, it had almost no acceleration as if it didn't want to get out of first or second gear. I took it to the dealership and they were able to recreate the problem and called it an "Intermittent Hard Shifting Transmission."
They told me they had to replace the transmission, which they did. After they replaced it they said the car was still hard shifting. So they replaced the transmission again, and again the problem persisted. Yesterday they told me they were ordering a brand new transmission, blaming the problem on the fact that the previous transmissions were re-manufactured.
I'm waiting to hear back after they install this "new" transmission. Maybe the third time's the charm, but this seems ridiculous.
Golf V R32 :: Chain Noise Coming From Top Of Engine - Jerking In Reverse
When I start up my engine, I hear a chain noise coming from the top of the engine. It's like a belt running chains. Also when I reverse the DSG it's a jerking sensation normal or should i get it fixed by VW.
View 8 RepliesElantra MD (2010-15) :: 2012 GL Jerking Whenever Switch The Gear From Park To Drive Or Reverse / Neutral
I have an Elantra 2012 sedan GL and last year i tried installing HID's. It worked for a whole but then it stopped after. I learned that it wasn't getting enough power so then yesterday I bought a wiring kit to be able to wire my HID to tap to the battery to get more power. Everything was fine till I got to work but when I had to leave work., there was an issue. Whenever i switch the gear from park to drive or reverse or neutral. My car seems to jerk. And when I'm driving and it changes gears, it also jerks. Kind of the same thing how if your driving a manual car and you change gears wrong. This happens when my lights are off. But when i turn them on it then stops. And when i turn it back of it doesn't do it anymore.
View 5 RepliesCamry :: 2003 - Stutter / Kick When Gear Engaging In Reverse
When I reverse (and wait 3 seconds just to ensure the gears are engaged), on occasion I feel a stutter/kick.
To offset it, I will tap the pedal when reversing so its not continuous. What this could be?
Golf IV / Jetta IV :: Engine Stalling Out When Put Into Reverse
So my 2.0 Golf GLS Automatic has been having a few small issues lately.. Started out with engine stalling out when put into into Reverse. I was told to swap out the TB so I did. Didn't fix issue, next I was told alternator, installed a new one & it didn't fix the issue... . I finally decided today to throttle up the RPM's when I put it in reverse & guess what it worked!!! No more vibrations no more stalling (For now anyway). But on the even brighter side it finally gave me codes!!! P0725, P1780, P0740, P1850, & P1544. I know it seems bad but I finally have something to work with!! Only bad thing that really concerns me is that now I feel like I may need a new tranny....
View 4 RepliesFord Excursion :: Stalling In Reverse - Died?
My EX died on me twice today when I put it in reverse. Once at the doctors office and once in my driveway when I got home. Is there any sort of interlock that would cause it to die when I put it in reverse. I replaced the idle control servo not long ago so I am hopeing it is not that although with the crap parts coming from China it is not impossible.
View 14 RepliesFord Transmission :: 1995 F150 Stalling In Reverse?
My 95 f150 stalls in reverse. It goes fine forward and idles fine in reverse but if I give it quite a bit of gas it starts stalling. We've put a new mlps and that didn't fix it. Then they thought it was the convertor so I got the trans rebuilt and still no change. I'm about to pull my hair out over this deal. I don't even have enough power to back up a trailer or back up a hill.
View 11 RepliesAccent MC (2006-11) :: 2007 - CEL Coming On / Stalling When Putting In Reverse
My Accent is a 2007. It regularly has the check engine light come on. They continually claim it's the fuel cap. When it's colder, even when it's been running it continually stalls when your putting it in reverse. They also claim that's not a problem. It's only got 25K on it. So the fact that it's already have problems is rather annoying.
View 5 Replies