Ford 6.7L Power Stroke Diesel :: Steering Box Adjustment Same As Gear Box Adjustment?
I've searched and can only find instructions/details on 6.4L and older Super Duty trucks. The process is the same to adjust the gear box for a 6.7L?
View 5 RepliesCamry :: 2002 V6 - How To Tighten Power Steering Belt
I can't remember how to tighten my power steering belt. I've loosened the 12 mm bolt that locks the PS pump in in place. But how to I increase the tension? This is killing me, because I replaced the timing belt in July. I guess I've since killed the brain cells that I used when i put the power steering belt back on.
View 9 RepliesFord 6.0L Power Stroke Diesel :: Steering Gear Adjustment?
What's the best way to access the adjustment nut I can see it through the wheel well but it looks like I would have to take that off the get to it
View 14 RepliesCamry :: 2002 - After Adding Power Steering Fluid Into Brake Reservoir Make Quick Stop While Letting Off Gas At 40?
2002 camry: my boyfriend just told me he accidentally added power steering fluid to the brake reservoir a couple monthes ago....while i floored it on highway, i only reached 40, when let off gas, car came to a quick stop. later i jacked up rear and was able to turn back tires to rule out e-brake being stuck,when car is in nuetral and pushed (forward or backward) it comes to a stop whithin a foot or so ( it seemed like the brakes were being depressed) possible transmission or brake issue?
View 2 RepliesCherokee :: 2002 Fitting On Top Of Pump With Clip Bracket Is Leaking
I have a 2002 Jeep GC with the 4.7 v8 84k miles.
I noticed that the fitting on top of the pump with the clip bracket is leaking I removed the clip and tightened the nut/fitting. Moved just a bit. The hose is loose in there and I can pull it up and down like I said it's loose. It's weeping PS fluid. Is this suppose to be loose or is there an o ring inside the fitting? I'd like to get this fixed I before it gets too cold out.
Camry :: 2004 - Cannot Get The Axle Carrier / Bearing Bracket Off
Trying to pull the passenger side axle off my 2004 3.3 SE Camry. The whole hub assembly is out of it so I have some room to work.
I can not get the axle carrier /bearing bracket off. This is the bracket that bolts to the block. The c-clip snap ring thing is removed from the the bearing carrier.
So I am jerking on the CV with a slide hammer, numerous times. Not sure if there has been any movement.
Any secrets? Does transmission have to be in neutral to release the axle from tranny or anything like that?
Camry :: 2007 - Brake Rotor Rubbing On Caliper Bracket
I'm working on a 2007 Camry and I had the wheel bearings pressed in & out at a shop. I put everything back together but the driver side rotor is rubbing against the caliper bracket. And there is no air gap between the rotor and bracket so it can spin freely without rubbing. The passenger side is fine, there is a little air gap so the rotor can move freely without rubbing. I don't understand why the driver side rotor is rubbing against the caliper? I checked everything over, the pads and rotor are the correct ones. I also took the pass side caliper bracket and installed it on the driver side and same thing, the rotor still rubs against the bracket.
View 13 RepliesCamry :: 2010 LE Power Steering Fluid Overflow - Steering Very Tight At Low / Parking Speeds
2010 camry LE
A family member did a tune up on the car and did not realize that the power steering reservoir had a HOT and COLD min/max lines. He filled up to the max line for HOT while the car was completely cold. He also filled up with Prestone Power Steering fluid with Stop Leak instead of ATF/DEXIII.
The car was driven a few times for maybe 50 miles in total before I found out about all this and I drained the fluid out to the appropriate levels. However the steering at low/parking speeds is still very tight (tighter than what I used to remember, at least).
Did he royally screw up the power steering system here? What can I do?
Camry :: 2010 LE - Ultra Racing Rear Sway Bar Doesn't Include Bracket?
I got the UR rear sway bar for my 2010 camry LE today, but it only has the bushing but doesn't include the bracket that secures the bushing? Is that OK can I reuse the OEM bracket? or did they not send me everything?
View 3 RepliesCamry :: 2002 - Steering A Bit Off Center After Alignment?
02 Camry. Since it was almost 2 yrs since last alignment, I took it to precision auto tune for a 4 wheel alignment. In retrospect, perhaps I shouldn't have!
Driving straight, the steering wheel seems cocked a wee bit off to the left. This wasn't the case before. I told the tech, he said to drive it for a few and get it back if I feel it's annoying. Is it their mistake? should I ask them to redo it?
Here is the alignment print out picture : [URL] .....
Camry :: 2002 LE V6 - Stiff Steering While Driving And Turning
I have a 2002 Camry LE V6 with 200K on it and have noticed that the steering feels very stiff while driving and turning. I have checked the fluid, air pressure on tires and that is fine.
View 5 RepliesCamry :: 2002 - Steering Wheel And Ignition Locked Up
My steering wheel and ignition locked up 2 days ago. I tried turning the wheel and the ignition at the same time, tried the brakes, tried shifting gears and anything else i could think of. I think the problem might be with the ignition coils, or multiple ones, but i have bypassed that by hot-wiring the car(which was a pain because of all the anti-theft features).
So I have the car running now and it is almost drivable except the steering wheel is locked up. I need to know how to fix this, i have read plenty on it and i think i can break a pin that locks the steering wheel to make it work, but i don't know where this pin is(might be behind the ignitions, or attached to it somewhere). if i could do this without breaking anything that would be great, but if the car will run, I am ok with it begin broken, because i already hot-wired it so I'm not worried about breaking anything unless it will make the car not run.
Phaeton :: Steering Column Adjustment Failure
Been monitoring this excellent forum for a while, having taken the plunge last year. The car is stunning, although I have been waiting for a gremlin or two for a while now and it finally seems to have happened.
Having set up the driving position using the excellent forum guide, all was well. Last week, however, the steering column failed to move out from the dash to the memorized position. I have tried manually, to no avail. All other motion - up, down and away appear to be normal, just the switch or motor that moves the column towards the driver.
Ford Excursion :: 2005 - Steering Box Adjustment?
How many have had luck and results adjusting there steering box.I ajusted mine and it corrected the bad wandering proplem. I just hope this will last.
View 7 RepliesCamry :: 2002 Steering Making Noise After PS Fluid Flush?
I have a 2002 camry and I flushed my power steering fluid today using the following procedure:
- emptied the reservoir
- connected return hose to a bucket
- added new fluid (ATF dexron III - from toyota dealer)
- jacked front wheels
- turned steering wheel side to side till new fluid came out of return line (my reservoir did get empty couple times in the process so air may have went in)
- lowered the vehicle
- reconnected the return line to reservoir
- ran the engine and turned side to side couple times (did not see bubbling and fluid level did not drop)
I took the car for test drive and noticed that my steering wheel was still making noise when turning. Also, when i was turning the wheel side to side with hood open, I noticed a change in the sound. There was a sticking sensation and steam pressure release noise when I locked the wheel on either side.What could be the problem?
Sonata I45 (YF - 2011+) :: Steering Column Adjustment Turns Car Off
On my 2013 GLS i went to adjust the column back to me as my girlfriend drove on saturday night (octoberfest ) and as i pulled it back out the car shut off. i pushed it back in a little and the car started fine and has until i tested the issue again this morning when i got to work. i moved it about half way out and the radio shutoff. moved it a little more and the whole car shut off. it will not start until i push it back in some.
I am thinking that a cannon plug or something is either too short or routed wrong or something to that effect as i have the ignition on the column instead of the push button.
Grand AM :: Broken Steering Adjustment Handle On 1999 Vehicle?
How can I replace a broken steering adjustment handle on a 1999 Grand Am?
View 3 RepliesFord Super Duty (1999-2016) :: Steering Box Adjustment?
on my diesel, the steering box has a larger lock nut on top of another smaller (5/8") nut at the lash screw. I was wondering if the lower 5/8" nut might turn with the upper lock nut if I don't also hold it in place? because if the lower nut is fixed to the cover then I don't have to worry about it. I'd just loosen the upper 17mm lock nut so I can make a minor lash adjustment.
It's just that I didn't expect to see both an upper and a lower nut securing the lash screw. I'm beginning to noticed some minor sector shaft play. being that it's a diesel the fan shroud is basically in the way, if I need to use two tools at once, there's not much room in there for two ratchets with extensions. The reason for my concern is that at center I start to see minor drift/bump steer. Haven't looked too deep in the components just yet.
Ford F-150 (2009-2014) :: Steering Wheel Highest Adjustment?
Is there a way to move the wheel higher than the highest setting? I like to keep the seat at its highest and its difficult getting in and out of the truck.
View 9 Replies