Corolla / Matrix 2009-13 :: 10th Generation Versus 9th Generation
I'm sorting through ECM and CEL issues on a 2006 Corolla. Are these issues still for the 10th Generation? I've driven 1982, 1992, 1996 and 2006 Toyotas w/ no trouble until this one (the 92 was lost in a 20-inch rainstorm in 1995).
View 14 RepliesPassat (B6) :: Air In The Car Not Powerful At All Even On High Settings
So recently my car's air conditioner is just not powerful at all even on "4" . For some reason some of the air seeps out below the dash on the passenger's side. What would cause this problem?
View 9 RepliesGen 4 Prius Fuel Economy :: Differences Between 3rd And 4th Generation?
Curious? Looking for if the generation 4 Prius' has less road noise and better acceleration?
My generation 3 is quite noisy inside.
Camaro :: 1989 - Service Engine Light Comes On
My service engine light comes on after my camero has been running for a little while some times it takes about 1o minutes before it comes on it runs like there's no problems with it. I know there's a way to check it with a paper clip but I forgot what spots to put it in to get the codes. Its a 1989 camero r/s 305 tpi
View 1 RepliesCelica :: Location Of Speed Sensor On 1991 Automatic 5th Generation
What is the location of the speed sensor on a 1991 automatic .. According to Haynes it is under the air filter but know matter how hard i look i cannot locate it .. Could it be that mine is an import from Japan so will have a different location ..
View 5 RepliesCamaro :: 1986 - Check Engine Light Flashes On And Off
I got a 1986 Camaro 5 speed 350 4 barrel carb and the check engine light flashes on and off, when it comes on the engine idles really low and when it goes off it runs normal. I've changed the ignition control module twice already because it wouldn't start. i change the ignition coil because thought that was messing the module up. I hooked a obd ll and 1scanner too the car but wouldn't respond.
View 14 RepliesCamaro :: Engine Starts And Runs Well For About 15-20 Minutes Then Shut Down
Here is my question.. 94 Z28 38K 6spd. Starts right up and runs well, for about 15-20 minutes then will shut down( like the key was turned off) When this happens I have no signal to either the ignition module or to the injectors.
This car was damaged by an idiot that flooded the dist. with coolant doing a flush. They replaced it with a Advance auto remain. This is when the trouble started. I did replace the I/M with an AC OEM Module, no change, verified all wiring from the computer to the Dist. and I/M. All checked out. I am thinking that the cheap remain unit is my problem and am looking to get the MSD Opti spark system to hopefully fix and to prevent this problem from happening again.
I cannot retrieve codes (94 won't flash CEL codes). Is there any other method of diag I could use to verify my suspicions. Oh, there is not response from the Tech either once the engine dies.
Chevrolet - Camaro :: Engine Overheating Warning Light Came On
I keep good maintenance for my car. Just had the 45,000 mile major tune up also. However, the engine overheating light came on the other day - said I should idle until it cooled down. I was just about to park, so I did that and left to do some shopping. When I came back and started the drive home the light came on again and indicated I should stop and turn the engine off. I drove two more blocks and put the car in the garage. I noticed what I thought was some leakage on the garage floor also. Next AM, I had it towed to the dealership since I'd checked the coolant dipstick and it looked EMPTY!. Dealership tested it out and could find nothing wrong - no leaks, no computer faults either. They sent me on my way and neither warning light has come on since. I've kept an eye on the engine temperature gauge and it hovers around 200F - mid range on the gauge. No further problems. Funny thing is, now my A/C seems to operate better!
View 10 RepliesCamaro :: 1998 - How To Reset Service Engine Soon Light
How to reset the service engine soon light at home without hooking it up to a code reader. I've tried disconnecting the battery and that didnt work.
View 1 RepliesChevrolet - Camaro :: Cracked Cylinder - Water Keeps Getting Consumed By The Engine
My '97 camaro has a cracked cylinder. (or something like that; the water keeps getting "consumed" by the engine). my mechanic put something in it that temporarily "sealed" the crack. it bought me more time but now it's not holding on to any water. My question is, can i do this again and is it something i can do myself?
View 5 RepliesChevrolet - Camaro :: Engine Almost Dies For Just A Second Then Revs Up If Just Punch Gas Pedal In Neutral
I just picked up my new 2014 Chevrolet Camaro with the V6 and 6 speed manual transmission. If I just punch the gas pedal when in neutral, the engine almost dies for just a second but then rev's up normally. It seems like a burst of gas chocks out the engine. I have tried the same thing in other Camaro's and the engine rev's up normally as soon as you punch the gas pedal.
View 13 RepliesRegal :: Engine And Transmission Swap - 3.8L 98 To 01?
I want to do an engine swap 98 regal to 01 regal. Both are series 2 3.8L. Should the engine and tranny swap without a huge problem?
View 2 RepliesCelica :: 92 ST Won't Start After Engine Swap
We just did an engine and trans axle swap in my daughter's 92 Celica St with a 90 Celica ST, both engines are 4Axx. When we swapped the engine we reinstalled the 92 intake manifold, fuel rails, injectors, sensors and the thermostat housing with sensors. We installed a new timing belt, and new 'O' rings and grommets on the injectors. When we went to start the car it would not start. How do I eliminate air in the EFI system and rule that out as the cause of the engine not starting?
View 3 RepliesCorolla / Matrix 2009-13 :: Engine Swap 1.8 For 2.4
I have a 2011 corolla. the engine just dont have any pep. is there a way to swap 1.8 for a 2.4 . is it worth the effort. or how can i get more pep without sinking lots into it.
View 14 RepliesAccord :: 2003 / 3.0L Won't Start After Engine Swap
We put in a used engine (2003 Accord 3.0L V6) from a Junkyard over the weekend, and now it won't start. It'll turn over and fire on a couple cylinders, but not enough to start. Doesn't seem to matter if spray a little starting fluid in the Throttle body while trying to start it. It sounds normal while turning over, put in a new timing belt while it was out, and turned it over by hand 6 times to verify correct install before reassembling.
View 3 RepliesPassat (B6) :: Getting Code 1314 After Engine Swap?
Brought my b6 to the shop for engine swap now getting code 1314 and car is still at the shop
View 4 RepliesMetro :: 1992 Engine Swap - Can Change From 3 To 4 Cylinder
Can i change from 3 cyl to 4 cyl 1992 metro....
View 1 RepliesCelica :: 1997 - Engine Swap And Started Once But Now No Spark
I replaced my 7AFE engine in my Celica 1997 1.8 with another 7AFE engine. The replacement engine had a different wiring harness, so I kept my original wiring harness.
After the swap, I started the engine and it stopped by itself after about 30-60 seconds.
Now it wont start. I have fuel, but no spark. I have tried three different distributors.
I have tried to read the fault codes, with connecting TE1 and E1, but no engine light lights up in the dash.
GTI 337/20th Anniversary :: Receiving Awp Engine Codes During Ecu Swap
I am trying to swap my ecu for a chipped one out of an 04 gti 1.8. Both awp engine codes. I programmed the immobilized and the car doesn't start. I am thinking it has the ignition kill feature but the guy who sold it to me doesn't think it does. i was just wondering if the ecu's are compatible even though the part number is different.
View 8 Replies