GTI 337/20th Anniversary :: Passenger Seat Wouldn't Click Back Into Place / Just Bounce
So over the past few months, my passenger side seat has been giving me some issues. When I pull the latch up to get into the back, sometimes the seat wouldn't click back into place when pushing it back down, it would just 'bounce'. After playing with the lever, up +down, eventually it would lock back in place. Yesterday however, I could not get it to lock in place, it just keep popping back up.
The seat also no longer folds forward, it is stuck in the _l position..
Passat (B5) :: 1999 - Driver Side Seat Will Not Lock In Place / Slides Back And Forth
I just purchased a 99 1.8t and the drivers seat will not lock in place. It slides back and forth. I looked underneath and see the gearing but was wondering if this is a problem to where I need to remove the seat to fix or maybe some thing easier.
View 3 RepliesBuick - Riviera :: 1998 - Only Click And No Start When Place The Key In Ignition
We have a lovely 1998 Buick Riviera with less than 140,000 miles. Normally, it runs great but in the last year, it has developed a neurosis. When we try to start it, 98% of the time, it starts immediately. Once in awhile, you can place the key in the ignition, "click" and nothing. It's as if the car were dead. Trying over and over is a waste of time. You have to wait about 5 minutes or so and WHAM! ... it starts right away. Then it will continue to start fine for days and have a relapse. I can usually tell that it is about to happen because there will be a tiny (fraction of a second) gap between the moment we turn the key and the response. It will do this 4-5 times and then "play dead". Wait 5 minutes and no problem. Then it will continue to run fine for days - even weeks.
View 3 RepliesFord Super Duty (1999-2016) :: 2007 F350 - Receiver Would Not Click And Hold The Buckle Of Seat Belt
I need an expert. 2007 Ford F-350 King Ranch and tonight, the wife and I were coming home from friends house and I tried to buckle my seat belt. The receiver would not click and hold the seat belt. Cannot find the replacement. What should I do?
View 13 RepliesFord Super Duty (1999-2016) :: 2009 - Relay Click Under The Dash / Heated Seat Stopped Working
Its and 09, I can hear a relay click under the dash. It has gotten really hot since i bought it in sept to the point where I had to turn it off because I thought it was going to burn my bottom. I am guessing its not an easy fix.
View 4 RepliesCamry :: 07 XLE Passenger Side A-Pillar Trim Piece Will Not Stay In Place?
The pasenger side trim piece that covers the A-pillar air bag in my 07 XLE will not stay in place. It becomes loose and you notice a gap at the top. You can smack it back in place and it appears to snap back in to where it belongs, but 15 minutes of driving and it comes loose again. I have replaced the clip (part number 90950-A8001) that holds it in, but it still just comes loose again a short time later.
View 8 RepliesFord 7.3L Power Stroke (1999-2003) :: Truck Won't Start / Loud Click On Passenger Wheel Well And Then All Electric Completely Dies
Just tried putting a ts6 on my pcm. First time I hooked it back up I just got cranking with no start. So I pulled the pcm terminals really well plugged it back in and got nothing. I do not remember because I was kind of in a hurry if I unplugged the batter cables and back on the second time. I plugged it back in after cleaning terminals and went to start and got nothing. A loud click on passenger wheel well and then all electric in truck completely dies. I hope I didn't fry my pcm. Maybe just blew a fuse or starter relay?
View 6 RepliesLexus GS 2006-11 :: Passenger Airbag Disabled With Heavy Passenger In Seat
135 plus pound passenger with seat belt on. Was intermittent on/off with passenger but now seems always off (off light 'on' ) meaning the passenger airbag is disabled.
I know the es350 was so bad like this that there was a threat of class action. I've read the weight sensor is in the passenger seat rail and you can also do a calibration with a scan tool.
Ford Super Duty (1999-2016) :: 2016 - Passenger Seat Rattles / Vibrates Quite Loudly?
I have a 2016 F250 6.2 XLT CC 4X4 that is mostly stock, except I did put on 18x9 wheels and LT275/70/18 Cooper ST MAXX tires. I have noticed recently on hwy driving and even in town driving, that the passenger seat rattles/vibrates quite loudly. Obviously if there is someone setting in the seat, it is just fine.
Is this a common issue? Is there a quick fix (tightening a couple bolts or replacing a couple clips?) Or should I take this back to the dealer for warranty?
Ford Super Duty (1999-2016) :: F250 - Changed Mounting Frame - Passenger Side Seat Fit On Driver Side?
On the F250 trucks, if I changed the mounting frame under the seat, will the passenger side seat fit on the drivers side? Basically, can I turn a passenger seat into a drivers seat?
View 4 RepliesFord Super Duty (1999-2016) :: Locking Hub Will Not Snap Back In Place?
I did my ball joints, and the drivers side oem manual locking hub was a bear to wiggle out but eventually came. When I put it back in after I finished, the wire retaining ring clicked into place but wasn't seated as far in as the passenger side (I could still see the wire). Didn't think much of it. Drove off. 30 miles later I heard a pop and saw the hub rolling down the road behind me.
Stopped and picked it up, went home managed to find a pair of locking rings i kept off my Dana 50, and I just cannot get it to go far enough in for the snap ring to fully seat in the groove. I tried tapping the axle further in, I tried tapping on the steel part of the hub with a deadblow, but it feels like it's in as far as it will go. Not sure what to do, driving without a locking hub right now.
Ford 7.3L Power Stroke (1999-2003) :: ICP Is Running Low - 460 To 480 At Idle And Bouncing All Over The Place
My ICP is running low, 460 to 480 at idle and bouncing all over the place. It doesn't get above 2500 or so at WOT acceleration the ECM is throwing a "pending" DTC for low ICP. I removed the ICP regulator solenoid coil and cleaned the inside, filled the connector with dielectric grease and reconnected. That worked for a while but it's creeping down again. I'm going to pull the ICP regulator and clean and rebuild it as soon as I figure out how to do it w/o taking the whole HPOP assy off. How to determine if the root cause is the ICP reg. or the HPOP? Regulator duty cycle is running 15-20% at idle and less than 30% the rest of the time which makes me think it's the HPOP.
View 14 RepliesGolf IV R32 :: Reoccurring Squeak And Click Coming From Passenger Side Consistently
There's been a reoccurring squeak and click coming from my passenger side for a while now recently it has been a lot more consistent. For the longest while I'd thought it was my springs/swaybar or something generally just not being tight. Suffice to say I was surprised when I jacked up the front of my car to do an oil change today and happened to catch a glance to the rear while working under there. One of the four subframe bolts in the rear (passenger side, closest to the rear of car, not the one next to the control arms) is apparently no longer doing it's job.
The subframe was hanging free of the body there as though no bolt was there, but upon inspecting the bolt in the subframe itself it is torques to spec (74 lb/ft). So whatever it should be attaching to up in the car is apparently no longer doing it and if I feel around the back of the subframe and rubber bushing I can feel a nut that I suppose should be up in car to accept the thread of the bolt. The hole above the frame doesn't appear broken or deformed, what gives? I've never torques this bolt or removed it, I can only assume the damage was done to it long ago and has just been getting worse ( I've only had the car for a year now). Is there so kind of rivnut type action that I can insert up into the hole, do I need the dealer to fix this for me?
Santa Fe (DM - 2013+) :: Click / Clunk In Front Brakes On Passenger Side
I have a click/clunk in my front brakes, passenger side. Happens mostly braking and turning right into my driveway. It was recently attributed to a strut bearing, but this was not the case, and their replacement didn't fix the problem.
Dealer has said it's a common noise and occurs after service. The only way to stop the noise is to stop lubing the calipers so they drag.
I say they are full of crap. This has now been going on at least 30k km. I have documented it on every oil change that I can remember (always at the dealer). Any way I should be handling it?
Lexus :: Rear Passenger Side Door Randomly Does Not Close When Click On The Alarm
I have a 2000 Lexus RX300. The rear passenger side door randomly does not close when I click on the alarm. When this happens, the alarm does not turn on and then the rest of the alarm system starts acting up until I manually close all the doors and then turn on the alarm. After I do this, the alarm works well. My dad and I opened the door that I am always having trouble with to see if anything was loose, but it all seemed ok. Do the problem is with the door or the alarm?
View 1 RepliesFord Super Duty (1999-2016) :: 2001 F250 - Cannot Get New Brake Pads In Place Because Of Clips
I am replacing my front brakes on my 2001 f250 and I replaced the brake pad retaining clips and now I can not get the new pads in place because of the new clips. what am I doing wrong????
View 9 RepliesSonata I45 (YF - 2011+) :: 2013 - While Locking Extra Click From Passenger Side Rear Doors
My 2013 is 9 months old and over time I've noticed whenever I lock my doors. My passenger side rear door does an extra click. Sounds like it's locking twice, an extra one after the original click.It's not a huge deal, I just hear it every time and I wonder if it could turn into an issue with locking etc.. Don't have a problem bringing it into the dealer for a look.
View 7 RepliesIS F (2008-2014) :: Light Click Pop Noise From Passenger Front Area When Reverse Or Go Forward
When I reverse on flat surface no bumps or anything like that... when I proceed to go forward I get a light click pop noise from my passenger front area I don't know what it might be I will be putting it on a lift to check if anything is loose ...suspension mods are usrs bushing and bc coilovers ...What I should look at would be great. When turning or going over bumps I get no noise what so ever its only when I proceed so go forward after reversing
View 2 Replies4Runner/GX470 :: 1989 V6 - Click Coming From Passenger Side Fender Area When Turn Key Forward
89 v6 4Runner. When I turn the key forward you hear a "click" coming from the passenger side fender area. After a few turns the engine will turn over and away you go. Yesterday for the first time after a few clicks I lost all power to my instrument panel, no dash lights no gauges working and no click, nothing. Stereo, cigarette lighter still had power, even reset my dash clock so it lost all connections as well. Every few turns I would get lights back and turn the key to start and click and dead again. Eventually I bump started the engine, drove home and here I sit.
Relay box by the front fender... this is where the click is coming from, looked at a few posts from yoda tech and one person suggested cutting the no 4 line for the ignition system off the relay box and have it go directly to the pos post for the battery. This will be a closed circuit from the battery post direct to the starter relay yes?
Relay box is probably just getting old and wires are beat up. My electrical is not the best for sure. Can I just clean up the wires going to the relay box(es)?