Toyota :: Check Engine Light Went On And Need It To Pass Inspection
The mechanic told me the oxygen sensor needs to be replaced but it is not an essential item. Can this be bypassed in order to have the car pass. Its not a safety issue. My car is a 98 and has 147,000 miles on it. It leaks oil, power steering fluid, the heat does not always work and I am shopping for a new car and do not want to spend money on anything not needed
View 3 RepliesVolvo :: EFI-445 - Cannot Get MIL Light To Stay Off And Car Will Not Pass State Inspection
Can not get MIL light to stay off and car will not pass state inspection. After hooking up laptop to my 96 850GLT and using VOL-FCR the EFI-445 code comes up and also states Pulsed Secondary Air Injection System Pump Signal. Everything seems to be working properly (relays, pump etc.) and vacuum pressure around 18. I have replaced the upstream O2 sensor as my OBD II scanner said that was the problem but after that the scanner was pretty much useless as it lead me in a hundred different areas to check and is getting costly so got the VOL-FCR.
View 8 RepliesInfiniti - Qx4 :: 2000 - Can't Pass Inspection / Engine Light Is On
I've got a 2000 Infiniti Qx4 that I can NOT get to pass inspection. I replaced the engine at 130,000 miles, and since then I've had nothing but problems. I live in TN and I've got to pass emissions testing. The car drives/runs great, no problems. I'm down to code P1105 or something, MAP/solenoid valve... Or maybe it was P10107 or something. Anyways it means the MAF sensor is malfunctioning or I've got bad hoses or electrical connections near the intake. So I replace the MAF. Nope, check engine light still on. I replace the clips on the hoses for the MAF. Nope, still on. I check all the wires n all the hoses. Nope, light still on. Now my mechanic is going on about I might have a bad computer or it might not have accepted the new engine as it was from a different year (still a 3.3L V6 standard of the prior to 2001 model)? My mechanic has been at it for over 2 weeks trying all kinds of stuff but to no avail.
View 4 RepliesCamry :: Remove / Replace Rear Bumper Cover On 2003 Vehicle?
How to remove and possibly replace the rear bumper cover on a 2003 camry?
View 4 RepliesCherokee :: 1996 Jeep - Unable To Get The Vehicle Into Gear
I have a 96 Jeep Cherokee, 2wd, 4 cylinder, manual transmission, I have had some work done on it. Recently, I had the clutch redone, then I had a tune-up and the motor mounts replaced.
After the motor mounts were done, I was unable to get the vehicle into gear. My mechanic adjusted the clutch pedal and it was running as long as I did not put it into reverse. I had driven it about 3 miles from my house, parked it.
Came out to start it a couple of hours later and it would not turn over. It wanted to start but no engagement. I had to have it towed to my house where my mechanic could check it out.
Since that time, we have determined that it is not the fuel pump, we changed out the fuel injectors, replaced the coil, replaced the crankshaft sensor and it is still doing the same thing. Have gone through all the suggested remedies.
Aurora :: Location Of Oxygen Sensors On 1996 Vehicle?
Looking for a diagram of the locations of the oxygen sensors on this vehicle, I am getting miss information from all around saying it has anywhere from 2-4 oxygen sensors and i think it has 3 am i right? two in the front behind the radiator on the exhaust manifold, and 1 somewhere by the catyaltic converter. There isn't a whole lot of manuals out there for these cars.4.0 ltr engine...
View 4 RepliesGmc :: Yukon 1996 - ABS Light Remains On Until The Vehicle Is Shut Off
I have a 1996 GMC Yukon with 243,000 miles on it. It has had the following issue for some time: Start the vehicle, all is well. Put it in gear, begin to roll about 3-5 MPH, can hear the ABS system pulse once, then the ABS light remains on until the vehicle is shut off. This happens 95% of the time. Trying to figure out if this is an issue with a wheel speed sensor, or the ABS unit itself.
View 7 RepliesWindstar :: Oil Light Comes On And Blinks With Knock When 1996 Vehicle Warms Up
1996 3.8 liter is quiet at startup until it warms up then knocking and oil light comes on and blinks with the knock. worst at idle, oil light goes out and knock gets quiet upon acceleration. cruises down highway quietly and no oil light. mechanic said I should check oil pump, 128000 miles. also wiper delay does not work right, wipers just move an inch then stop. I see3 a relay under dash that says DELAY ACC but don't know what it is for
View 7 RepliesFord - Ranger :: 1996 - Engine Shuts Down If Put The Vehicle In Reverse?
What's the fix for a 1996 Ford Ranger when the engine shuts if the vehicle is put in reverse? (It will run in drive, but not in reverse; fuel filter, air filter and vacuum hoses have all been checked).
View 2 RepliesFord - Explorer :: 1996 - Speedometer Goes Exactly To 50 And Stays There When Vehicle Gets Warm
My Explorer speedo works fine for the first bit of riving but when the vehicle gets warm it goes to exactly 50 and stays there.
View 3 RepliesBonneville :: 1996 Vehicle Making Whine Noise When Put Transmission In Reverse Gear
When you put trans in reverse makes whine noise no reverse. The forward gears are fine. Could this be a solenoid problem?
View 1 RepliesPrius (2004-09) :: Safe To Rev Engine While In Inspection Mode?
Is it safe to rev the engine while in inspection mode (forced idle). Someone has a question about checking for valve noise in the top thread about common 2G problems in the maintenance discussion, and I unsure about giving advice concerning revving the engine via the throttle motor. I will mention, I suppose, the check engine light will turn on.
View 3 RepliesElantra MD (2010-15) :: Thumping Noise After Tire Rotation / Brake Inspection
My local dealer had a special on an oil change, tire rotations, and break inspection and my 2011 Elantra GLS auto w/ 20k miles was due so I took it in.
After I got it back I noticed a noise I had never heard before when reaching speeds above 45mph. The best word to describe it would be "thumping".
I figured maybe due to the rotation the tires might need to settle in, but I've drove about 50 miles since getting it back and the noise isn't even slightly going away.
The worse part is my avg. MPG went from easily/consistently being 40+ down to low 38/high 37.
Should I just give it some more time or start to worry the service guys messed something up? Until today it's been the perfect car.
Ford Transmission :: 4R100 Diesel - Missing Chunk By The Inspection Area
[URL] ....
I have a 4R100 diesel trans. with a missing chunk by the inspection area. Is it still safe to run?. The aluminum there is quite thin....
Ford Super Duty (1999-2016) :: Radio Quit Working After Inspection Of MD?
I took my truck in for Maryland State inspection on Monday and got my truck back and the radio no longer works. I checked the fuse on both the back of the radio and the main fuse box and both fuses are still intact. I'm not really sure where to go from here. Any recommendations?
View 2 RepliesFord Super Duty (1999-2016) :: Truck Shuts Down State Inspection Machine
I have been getting inspection stickers at the same place since 07 without any problems,this time they plug her in to test and the truck stalls and the test machine locks up ,happens multiple times.
They find bent pin on OBD plug and fix but still keeps happening. We are baffled it sounds like a short somewhere but there are no codes or check engine lights on.
The only new thing on the truck is a new flatbed with led tail lights and marker lights. The blinkers flash fast from the leds could they be messing with the computer? I'm going to inspect the engine harness today to make sure there's no wires grounding I don't know what else to check...
2002 F350 7.3L ....
Ford 7.3L Power Stroke (1999-2003) :: Transmission Started Pouring Fluid From Inspection Plate
Just pulled into campground pulling 5ver transmission started pouring fluid from inspection plate. Only does when running but it's a gusher. Fluid is nice and red and didn't smell burnt. What should I expect when I have towed to shop?
View 5 RepliesFord Ranger / B-Series :: 1987 - Transmission Leak / Fluid Puking Out Inspection Plate Area
Dad gave me an 87 Ford ranger a couple weeks ago. I love it. Everything works except I'm having transmission leak issues when I drive her more than 30 miles or so.the symptom is fluid puking out inspection plate area. I checked coolant lines today and unfortunately they are working great. I've had a couple suggestions recommending replacement of the front seal our front pump seal (is there a difference?)
View 7 RepliesHonda - Accord :: 92 Won't Pass Emissions
We have a 92 Honda Accord 2.2L We have been trying to get it to pass emissions since October. So far we have replace the gas cap, replaced the O2 sensor and replaced the EGR valve. Here are the readings 25/25 test 50/15 testHC ppm 17 29CO% .07 .20NO ppm 1162 1230 after replacing the O2 sensor but before the EGR the 25/25 side passed reading 1005CO+CO2 % 15 15
View 9 Replies